Description : Which of the listed pairs of materials make the best insulators? A. copper and aluminum B. glass and mica C. dry air and a vacuum D. doped silicon and germanium
Last Answer : Answer: B
Description : Which of the following is not a dielectric material? (A) Cotton, silk and paper (B) Asbestos, glass, porcelain and mica (C) Rubber and polymeric resins (D) All refractory materials
Last Answer : Option C
Description : The 'dielectric constant' of dry air or a vacuum is _______. A. 1 B. 10 C. 100 D. 1000
Last Answer : Answer: A
Description : Grease coatings on electrical contact surfaces increase contact resistance and should be removed with a/an _______________. A. small wire brush B. compressed air jet C. clean dry cloth D. 10% solution carbon solvent and water
Last Answer : Answer: C
Description : Write one application for the give dielectric material. (i) Polyvinyl Carbide(PVC) (ii) Glass (iii) Mica (iv) Cotton and Silk
Last Answer : (i) Polyvinyl Carbide(PVC):it is used in insulation of wires and cables in domestic wiring as well as in aircraft and factory wiring (any one) (ii) Glass: 1) Alkaline glasses are used for ... with wax or varnishes are used in windings of magnet coils and small medium sized mechanics (any one)
Description : The dielectric strength of a vacuum or dry air is approximately ________________. A. 450 volts/inch B. 1000 volts/inch C. 20-kv/inch D. 50-kv/inch
Description : Coast Guard Regulations (46 CFR), require that an indicating light at the propulsion control station will operate if overloading or overheating occurs in a _______________. A. forced draft blower motor B. steering gear motor C. fuel pump motor D. condensate pump motor
Description : When a console indicating lamp burns out, attempts to renew it should not be made while maneuvering because _______________. A. the new lamp may be of a higher wattage and cause heat damage to the lens ... D. a socket/wiring fault may cause a ground or short circuit to shut down a vital function
Last Answer : Answer: D
Description : Which of the listed groups of electrical insulation materials is best suited for the highest operating temperatures? A. impregnated cotton and silk B. unimpregnated paper and cotton C. pure glass and quartz D. mica and porcelain with bonding agents
Description : In addition to undercutting the mica, proper maintenance of a D.C. motor's commutator includes _______________. A. side-cutting the copper segments and insulating the slots B. coating the copper surface with light machine ... in an oven at a maximum of 95°C for not over 8 hours D. all of the above
Description : A megger is being used to test the insulation of an AC generator. The resistance value of a dry, clean winding will _____________. A. continue to rise as test potential is maintained, ... , becoming fairly steady after 5-7 minutes D. stabilize after approximately 2-4 minutes of fluctuation
Description : Which of the listed pairs of materials make the best insulators? A. dry air and a vacuum B. tin and lead C. doped silicon and germanium D. paper and oil
Description : Mica is a (A) Dielectric material. (B) Insulating material. (C) Magnetic material. (D) Both insulating and dielectric material.
Last Answer : (D) Both insulating and dielectric material.
Description : Which of the following statements best describes the material known as varnished cambric? A. Felted asbestos sealed with varnish. B. Cotton cloth coated with insulating varnish. C. Rubber ... Paper impregnated with mineral oil, specially wrapped with nonmetallic tape, and coated with varnish.
Description : ____ grippers are used to pick up light weight materials such as paper,cloth etc a.Mechanical grippers b.Adhesive grippers c.Vacuum cup grippers d.Magnetic grippers
Last Answer : b.Adhesive grippers
Description : ____ grippers are used to pick up light weight materials such as paper,cloth etc. (A) Mechanical grippers (B) Adhesive grippers (C) Vacuum cup grippers (D) Magnetic grippers
Last Answer : B
Description : The purpose of 'R6' in the winch circuit shown in the illustration is to _______________. EL-0102 A. maintain dry conditions within the winch brake box B. keep the series field current at ... to assist the winch in stopping D. limit the armature current during lowering operation with heavy loads
Description : Controller contacts should be routinely cleaned by ________. A. blowing with compressed air B. filing with a bastard file C. wiping with a clean dry cloth D. dressing with crocus cloth
Description : Pick out the correct statement. (A) Noise from ball mills can be dealt with by fibre glass lined enclosures (B) Noise from vibrating chutes can be reduced by lining the metallic chute with rubber (C) Noise ... cloth conveyor belts and rubber/plastic covered metallic rollers (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : The purpose of an impressed current cathodic protection system aboard ship is to _______________. A. prevent corrosion of the hull, propeller, rudder and line shafting B. neutralize the vessel's ... the presence of salt air D. maintain a minimum constant alternator load to prevent overheating
Description : Rexine (also called artificial leather), which is used for making table cover, automobile seat cover, shoes etc. is made by coating thick cloth with molten (A) Teflon (B) Bakelite (C) SBR (D) PVC
Last Answer : (D) PVC
Description : Dielectric constant of vacuum is (A) infinity. (B) 100. (C) one. (D) zero.
Last Answer : (C) one.
Description : Which material is NOT available for LOM process? a.Paper b.Plastic c.Metal d.Glass
Last Answer : d.Glass
Description : Which of the substances listed can be used to shield sensitive equipment from static magnetic fields? A. Glass B. Mica C. Bakelite D. Permeable iron
Description : Pick out the correct statement. (A) The capacity and the effectiveness of a screen are the same (B) The capacity and the effectiveness of screen are opposing factors (C) The screening surface of a 'reel' (a ... flour mills) is made of silk bolting cloth supported by wire mesh (D) Both (B) and (C)
Last Answer : (D) Both (B) and (C
Description : Thevelocityfactor of a transmissionline a. depends on the dielectric constant of the material used b. increases the velocity along the transmission line c. is govern by the skin effect d. is higher for a solid dielectric than for air
Last Answer : a. depends on the dielectric constant of the material used
Description : The insulating material used between the commutator segments is normally (a) graphite (b) paper (c) mica (d) insulating varnish
Last Answer : Ans: c
Description : In which of the following industries is mica used as a raw material? (a) Electrical (b) Iron and steel (c) Toys (d) Glass and pottery
Last Answer : Ans:(a)
Description : Which is an amorphous material? (A) Glass (B) Mica (C) Brass (D) Cast iron
Last Answer : (A) Glass
Description : A material in which the atoms are arranged regularly in some directions but not in others, is termed as 'mesomorphous material'; an example of which is (A) Lead (B) Glass (C) Mica (D) Silver
Last Answer : (A) Lead
Description : Seating the brushes on a D.C. motor is first accomplished using ________________. A. a file for cutting the approximate curvature followed by sandpaper for the final fit B. sandpaper with the motor not ... for the finishing cut D. course lapping compound, followed by a medium and then a fine grade
Description : To properly seat the brushes on slip rings, you should use ____________. A. sand paper B. crocus cloth C. emery cloth D. all of the above
Description : Which of the following material of construction may be recommended by a chemical engineer for handling a gaseous chlorine (dry or wet) stream in a fluid flow system? (A) High silicon iron, silicon rubber ... Mild steel and stainless steel (C) Cast iron, tin and aluminium (D) Copper, nickel and Monel
Last Answer : (A) High silicon iron, silicon rubber, Kel-F and Teflon
Description : Routine maintenance of dry-type transformers should include ____________. A. cleaning the windings, if accessible, with a vacuum cleaner or very low pressure air B. measuring and recording the winding ... . making sure that the units are close to bulkheads or corners to protect them from damage
Description : Why do plastic cups and bowls air dry far slower than glass dishes?
Last Answer : I doubt they do. However most plastic containers and cups have some sort of rolled edge on their tops, and that forms a channel which can hold a significant amount of water which pours out when you ... the rolled lip to gravity drain while the cup or bowl does, and this will speed complete drying.
Description : A sand mixture was screened through a standard 10-mesh screen. The mass fraction of the oversize material in feed, overflow and underflow were found to be 0.38, 0.79 and 0.22 respectively. The screen effectiveness based on the oversize is (A) 0.50 (B) 0.58 (C) 0.68 (D) 0.62
Last Answer : (A) 0.50
Description : Paper like thin plastic articles can be produced by (A) Blow moulding (B) Vacuum thermo forming (C) Injection moulding (D) None of these
Last Answer : (B) Vacuum thermo forming
Description : What to do if wet feet fall on dry place of urine ? My niece who is 02 years old. Pisses on the floor of the house. I wiped the place well with a damp cloth twice and then dried in the fan ... I have prayed without washing my feet. Has my prayer been valid ? Was it important to wash your feet ?
Last Answer : : In the case in question, your prayer is valid. Wet feet do not make your feet unclean. This is because after wiping the floor, it dries up and the effects of impurity disappear. (Musannaf Ibn Abi Shaybah 1/431 ; Nasbur Raya 1/26 ; Elaus Sunan 1/398 ; Fatawa Khaniya 1/25 ; Khulasatul Fatawa 1/42)
Description : A 'dielectric' is a/an ________________. A. electrical insulator B. current flow C. good conductor D. semiconductor material
Description : ECE Board Exam March 1996 That dielectric material of an optical fiber surrounding the core A. Cladding B. Armor C. Shield D. Cover
Last Answer : A. Cladding
Description : An air dielectric is replaced with a glass dielectric inside a capacitor of fixed dimensions. Relatively speaking, what will happen to the quantity of charge the capacitor can hold after the glass is inserted?
Last Answer : ANSWER: IT IS INCREASED WITH THE GLASS DIELECTRIC
Description : Referred to the dielectric constant of a transmission line material. A. Inductance and capacitance B. Velocity factor C. Characteristic impedance D. Propagation velocity
Last Answer : B. Velocity factor
Description : Find the dielectric constant for a material with electric susceptibility of 4. a) 3 b) 5 c) 8 d) 16
Last Answer : b) 5
Description : Find the susceptibility of a material whose dielectric constant is 2.26. a) 1.26 b) 3.26 c) 5.1 d) 1
Last Answer : a) 1.26
Description : The size, shape, and dielectric material of a waveguide must be constant throughout its length for energy to move from one end to the other without reflections. What could be the effect in any abrupt change in its size or shape?
Last Answer : Reflections.
Description : When troubleshooting a console circuit card suspected of being faulty, first check for proper voltages to the card and then _______________. A. test transistors or integrated circuits for gain and ... D. de-energize the card and check the printed circuit traces for continuity with an ohmmeter
Description : As shown in the illustration, when the 'speed control' system is in 'SPLIT' _______________. EL-0096 A. Relays #1, #5 and #8 are not used B. the 'slew rated controller' is grounded through Relay ... E/P converters' are bypassed and air is fed directly to the governors via the 'load sharing valve'
Description : Find the acceptance angle of a material which has a numerical aperture of 0.707 in air. a) 30 b) 60 c) 45 d) 90
Last Answer : c) 45
Description : The name of plastic polymer from which combs, toys, bowls etc., can be made, is (1) Polyurethane (2) Polystyrene (3) Metallic polysulphides (4) Teflon
Last Answer : (2) Polystyrene Explanation: Polystyrene is an synthetic aromatic polymer made from the monomer styrene, a liquid petrochemical. It is one of the most widely used plastics. Uses include protective ... containers (such as "clamshells"), lids, bottles, trays, tumblers, and disposable cutlery.
Description : Which of the following is the lowest cost plastic commercially available? (A) Polythene (B) Teflon
Last Answer : (A) Polythene