Description : The discharge per unit plan area of a sedimentation tank, is generally called A. Over flow rate B. Surface loading C. Over flow velocity D. All the above
Last Answer : ANS: D
Description : The ratio of discharge and plan area of a continuous flow type settling tank, is known (A) Surface loading (B) Overflow (C) Overflow rate (D) All the above
Last Answer : (D) All the above
Description : In a sedimentation tank (length L, width B, depth D) the settling velocity of a particle for a discharge Q, is A. Q/(B × D) B. Q/(L × D) C. Q/L D. Q/(B × L)
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Last Answer : ANS: C
Description : The settlement of a particle in sedimentation tank, is affected by A. Velocity of flow B. Viscosity of water C. Size and shape of solid D. All the above
Description : For a continuous flow type of sedimentation tanks A. Width of the tank is normally kept about 6 m B. Length of the tank is normally kept 4 to 5 times the width C. Maximum horizontal flow velocity is limited to 0.3 m/minute D. All the above
Description : For treating the sewage of a large city, you will recommend A. A sedimentation tank and an activated sludge treatment plant B. A plant consisting of Imhoff tanks with low rate trickling filters C. Sedimentation tanks with high rate trickling filters D. None of these
Last Answer : ANS: A
Description : Normal values of overflow rate for plain sedimentation tank using coagulants, is (A) 750 to 1000 litres/hr/m2 (B) 1000 to 1250 litres/hr/m2 (C) 1250 to 1500 litres/hr/m2 (D) 1500 litres/hr/m
Last Answer : (B) 1000 to 1250 litres/hr/m2
Description : Normal values of overflow rate for plain sedimentation tank, is (A) 250 to 500 litres/hr/m2 (B) 500 to 750 litres/hr/m2 (C) 750 to 1000 litres/hr/m2 (D) 1000 to 1250 litres/hr/m
Last Answer : (B) 500 to 750 litres/hr/m
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above
Description : When drainage to sewage ratio is 20, the peak dry weather flow is A. 20% of the design discharge B. Slightly less than 5% of the design discharge C. Slightly more than 5% of the design discharge D. None of these
Last Answer : ANS: B
Description : The effluent of a septic tank is A. Fit for discharge into any open drain B. Foul and contains dissolved and suspended solids C. As good as that from a complete treatment D. None of these
Description : If L, B and D length, breadth and depth of water in a rectangular sedimentation tank of total discharge Q, the settling velocity, is (A) Q/H (B) Q/D (C) Q/(D × B) (D) Q/(L × B)
Last Answer : (D) Q/(L × B)
Description : The most effective arrangement for diverting excess storm water into a natural drainage, is A. Leaping weir B. Overflow weir C. Siphon spill way D. None of these
Description : Pick up the correct statement from the following: A. The maximum rate of storm runoff is called peak drainage discharge B. Rational method of estimating peak run off, may be used precisely for ... entire area starts contributing to the runoff, is called the time of concentration D. All the above
Description : The gradient of sewers depends upon A. Velocity of flow B. Diameter of the sewer C. Discharge D. All the above
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : For design of sewers, percentage of sewage discharge is assumed A. 65 to 70% B. 70 to 75% C. 75 to 80% D. 85%
Description : For a grit chamber, if the recommended velocity of flow is 0.2 m/sec and detention period is 2 minutes, the length of the tank, is A. 16 m B. 20 m C. 24 m D. 30 m
Description : The settling velocity of the particles larger than 0.06 mm in a settling tank of depth 2.4 is 0.33 m per sec. The detention period recommended for the tank, is A. 30 minutes B. 1 hour C. 1 hour and 30 minutes D. 2 hours
Description : The sewage treatment units in which anaerobic decomposition of organic matter is used, are called A. Imhoff tanks B. Trickling filters C. Sludge sedimentation tanks D. None of these
Description : Normal values of overflow rate for sedimentation tanks using coagulants in litres/hr/m2 , generally range between (A) 250 to 500 (B) 500 to 750 (C) 750 to 1000 (D) 1000 to 1250
Last Answer : (D) 1000 to 1250
Description : Normal values of overflow rate for plain sedimentation tanks in litres/hr/m2 , generally range between (A) 100 to 250 (B) 250 to 500 (C) 500 to 750 (D) 750 to 1000
Last Answer : (C) 500 to 750
Description : In a city the ratio of the drainage to sewage is 20, the percentage discharge passing through non-monsoon periods, is A. 5 B. 10 C. 15 D. 20
Description : Before discharging the foul sewage into rivers, it is generally treated by A. Screening B. Sedimentation C. Oxidation D. All the above
Description : In primary sedimentation, the 0.2 mm inorganic solids get separated if specific gravity is A. 2.25 B. 2.50 C. 2.55 D. 2.65
Description : The normal values of over flow rates for secondary sedimentation tanks, ranges between A. 25,000 to 35,000 litres/sqm/day B. 40,000 to 50,000 litres/sqm/day C. 50,000 to 60,000 litres/sqm/day D. 80,000 to 10,000 litres/sqm/day
Description : The maximum depth of sedimentation tanks, is kept A. 3 m B. 3.5 m C. 4 m D. 4.5 m
Description : Pick up the incorrect statement from the following: A. Septic tanks are horizontal continuous flow type of sedimentation tanks B. Septic tanks are generally provided a detention period of 12 to 36 hours C ... covered and high vent shafts are provided for the escape of foul gases D. None of these
Description : The normal value of over flow rates for plain primary sedimentation tanks, ranges between A. 25,000 to 35,000 litres/sqm/day B. 40,000 to 50,000 litres/sqm/day C. 50,000 to 60,000 litres/sqm/day D. 80,000 to 100,000 litres/sqm/day
Description : The detention period for plain sedimentation water tanks, is usually A. 4 to 8 hours B. 8 to 16 hours C. 16 to 24 hours D. 24 to 36 hours
Description : The normal values of over flow rates for sedimentation tanks using coagulant, ranges between A. 25,000 to 35,000 litres/sqm/day B. 40,000 to 50,000 litres/sqm/day C. 50,000 to 60,000 litres/sqm/day D. 80,000 to 100,000 litres/sqm/day
Description : The detention time (t) of a settling tank, may be defined as the time required for A. A particle to travel along its length B. A particle to travel from top surface to bottom sludge zone C. The flow of sewage to fill the tank D. None of these
Description : Sewer pipes are designed for maximum discharge with 25% to 33% vacant cross-sectional area for A. Unexpected large scale infiltration of stream water B. Unexpected increase in the population C. Under estimates of maximum and average flows D. All of the above
Description : The dimensions of a rectangular settling tank are: length 24 m, width 6 m and depth 3 m. If 2 hour detention period for tanks is recommended, the rate of flow of sewage per hour, is A. 204 cu.m B. 208 cu.m C. 212 cu.m D. 216 cu.m
Description : For design purposes, the normal rate of infiltration of ground water into the sewer, is A. 500 litres/km/cm B. 1000 litres/km/cm C. 1500 litres/km/cm D. 2000 litres/km/cm
Description : Clogging of sewers, is caused due to A. Silting B. Low discharge C. Greasy and oily matters D. All the above
Description : The sewer which collects the discharge from a collecting system and delivers it to a treatment plant, is known A. House sewer B. Lateral sewer C. Branch sewer D. Sewer outfall
Description : A cylindrical ejector having its height 2 m fills after every 10 minutes with a peak sewage discharge of 0.0157 cumec. The diameter of the ejector chamber, is A. 2.30 m B. 2.40 m C. 2.45 m D. 2.50 m
Description : The density of population over 40 hectares is 250/hectare. If water supply demand per day is 200 litres and sewage discharge is 80% of water supply, the sewage flow in sewers of separate system, is A. 0.05552 cumec B. 0.05554 cumec C. 0.05556 cumec D. 0.0556 cumec
Description : If the discharge of a sewer running half is 628 1.p.s., i = 0.001, and n = 0.010, the diameter of the sewer, is A. 1.39 m B. 1.49 m C. 1.59 m D. 1.69 m
Description : Pick up the in-correct statement from the following: A. Manholes are provided in sewer pipes at suitable intervals B. Catch basins are generally provided in sewers for carrying drainage discharge C. Inlets are generally provided in all sewers D. None of these
Description : If the peak discharge of a storm water drain (S.W. Drain) is expected to exceed 150 cumecs, the free board to be provided, is A. 100 cm B. 90 cm C. 80 cm D. 50 cm
Description : The sewer which received discharge from two or more main sewers, is known as A. A trunk sewer B. An outfall sewer C. A main sewer D. An intercepting sewer
Description : ¾th or ¼th extra space is left in sewer pipes at maximum discharge for A. Low estimates of the average and maximum flows B. Large scale infiltration of storm water C. Unexpected increase in population D. All the above
Description : The rational formula for peak drainage discharge, was evolved by A. Fruhling B. Lloyd David C. Kuichling D. All of these
Description : For the open drain (N = 0.025) shown in the below figure, the discharge is A. 26.88 cumecs B. 27.88 cumecs C. 28.88 cumecs D. 29.88 cumecs
Description : The sewer pipes A. Carry sewage as gravity conduits B. Are designed for generating self-cleansing velocities at different discharge C. Should resist the wear and tear caused due to abrasion D. All the above
Description : Pick up the incorrect statement from the following: A. The process of decomposing the organic matter under controlled anaerobic conditions, is called sludge digestion B. Sludge digestion is carried ... contain 75% carbon dioxide D. The gases produced in sludge digestion process, contain 75% methane
Description : Q No: 251 In a sludge digestion tank if the moisture content of sludge V1 litres is reduced from p1 % to p2 % the volume V2 is A. [(100 + P1)/(100 – P2)] V1 B. [(100 – P1)/(100 + P2)] V1 C. [(100 – P1)/(100 – P2)] V1 D. [(100 + P2)/(100 – P1)] V1