**Description :** Nodal Analysis with Voltage Sources dependent voltage source and two supernode

**Last Answer :** Nodal Analysis with Voltage Sources dependent voltage source and two supernode

**Description :** Nodal analysis example with voltage source and supernode

**Last Answer :** Nodal analysis example with voltage source and supernode

**Description :** Find current through resistor using nodal analysis

**Last Answer :** Find current through resistor using nodal analysis

**Description :** State the applications and specification of (i) Resistor (ii) Capacitor (iii)Inductor

**Last Answer :** Application of resistor: 1.Resistors are used in high frequency instrument. 2.Resistor is used in power control circuit. 3.It is used in DC power supplies. 4.Resistors are used ... DC Current 3.Electromagnetic Interference (EMI) 4.Magnetic Saturation Flux Density 5.Curie Temperature

**Description :** Define resistor and draw symbol of variable resistor.

**Last Answer :** Resistor: A resistor is an electrical component that limits or regulates the flow of electrical current in an electronic circuit. Symbol of variable resistor:

**Description :** Source transformation Replace the circuit with voltage source in series with a single resistor

**Last Answer :** Source transformation Replace the circuit with voltage source in series with a single resistor

**Description :** Which of the following is NOT a non-linear resistor? A) Varistor B) Precision resistor C) NTC thermistor D) PTC thermistor

**Last Answer :** Which of the following is NOT a non-linear resistor? A) Varistor B) Precision resistor C) NTC thermistor D) PTC thermistor

**Description :** A resistor in which the resistance changes exponentially with change in temperature is called as A) Potentiometer B) Phototransistor C) Varactor D) Thermistor

**Last Answer :** A resistor in which the resistance changes exponentially with change in temperature is called as Thermistor

**Description :** A 1000Ohm, 1 Watt resistor can safely pass a current of

**Last Answer :** A 1000 Ohm, 1 Watt resistor can safely pass a current of 30 mA

**Description :** In a 5 bit weighted resistor D/A converters, the resistor value corresponding to LSB is 40 kΩ, and the resistor value corresponding to MSB will be (A) 0.4 kΩ (B) 3 kΩ (C) 2.8 kΩ (D) 2.5 kΩ

**Last Answer :** In a 5 bit weighted resistor D/A converters, the resistor value corresponding to LSB is 40 kΩ, and the resistor value corresponding to MSB will be 2.5 kΩ

**Description :** An open resistor, when checked with an ohm-meter reads?

**Last Answer :** An open resistor, when checked with an ohm-meter reads infinite.

**Last Answer :** Standard resistor is made from maganin.

**Description :** If the 12 Ohm resistor draws a current of 1 A as shown in the figure, the value of resistance R is

**Last Answer :** If the 12 Ohm resistor draws a current of 1 A as shown in the figure, the value of resistance R is

**Description :** To determine the polarity of the voltage drop across a resistor, it is necessary to know?

**Last Answer :** To determine the polarity of the voltage drop across a resistor, it is necessary to know direction of current through the resistor.

**Description :**

**Last Answer :** https://youtu.be/fgQTs-1hq7Q

**Description :** Nodal analysis problem two current source

**Last Answer :** Nodal analysis problem two current source

**Description :** What is branch?

**Last Answer :** A path which connects two node is called branch.

**Description :** What is node?

**Last Answer :** A point in a circuit where two or more circuit elements are joined it is called node.

**Description :** What is active and passive network?

**Last Answer :** Active network is a network which contain one or more than one EMF source. An active network consists of an active element like battery or transistor. Passive network is a ... contain any source of energy. Passive network consists of passive element like resistance, inductance and capacitance.

**Description :** In the circuit shown below, the current through the inductor is,

**Last Answer :** .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

**Last Answer :** What do you mean by parameter?! In the Z-transform we find zeros and poles of a system,so we can find the revergence area of a system

**Description :** A tree of a network graph consists of (A) (n-1) nodes (B) n branches (C) one or two nodes left in isolated position (D) no closed paths

**Last Answer :** The dual of a tree is sometimes called a maze Itconsists of spaces connected by links in the same way that the tree consists of nodes connected by treebranches. Duals cannot be formed for every graph. ... Consequently, only planar graphs have duals.

**Description :** To neglect a voltage source, the terminals across the source are _____

**Last Answer :** To neglect a voltage source, the terminals across the source are short circuited

**Description :** To find current in a resistance connected in a network, Thevenin's theorem is used VTH = 20 V and RTH = 5 Ω. The current through the resistance: (1) is 4 A (2) is 4 A or less (3) is less than 4 A (4) May be 4 A or less or more than 4 A

**Last Answer :** To find current in a resistance connected in a network, Thevenin's theorem is used VTH = 20 V and RTH = 5 Ω. The current through the resistance: is less than 4 A

**Description :** Two two-port networks are connected in cascade. The combination is to be represented as a single two-port network. The parameters of the network are obtained by multiplying the individual a. z-parameter matrix b. h-parameter matrix c. y-parameter matrix d. ABCD-parameter matrix

**Last Answer :** A

**Description :** In a graph, the number of independent loops is 6 and the number of independent cut sets is 5, The total number of branches in the graph is A) 9 B) 12 C) 10 D) 11

**Last Answer :** In a graph, the number of independent loops is 6 and the number of independent cut sets is 5, The total number of branches in the graph is 11

**Description :** A voltage signal 10 Sinwt is applied to the circuit with ideal diodes, as shown in figure. The maximum and minimum values of the output waveform vout of the circuit are respectively

**Last Answer :** A voltage signal 10 Sinwt is applied to the circuit with ideal diodes, as shown in figure. The maximum and minimum values of the output waveform vout of the circuit are respectively +4V and-7V

**Description :** In a series RLC circuit at resonance, the magnitude of the voltage developed across the capacitor A) Is always zero B) Can never be greater than the input voltage C) Can be greater than the input ... input voltage D) Can be greater than the input voltage, and is in phase with the input voltage

**Last Answer :** In a series RLC circuit at resonance, the magnitude of the voltage developed across the capacitor Can be greater than the input voltage, however, it is 90° out of phase with the input voltage

**Description :** Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then . A) The bulbs together consume 100 W B) The bulbs together consume 50 W C) The 60 W bulb glows brighter D) The 40 W bulb glows brighter

**Last Answer :** Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then . The bulbs together consume 50 W

**Description :** A unit step voltage is applied at t = 0 to a series RL circuit with zero initial conditions A) It is possible for the current to be oscillatory B) The voltage across the resistor at t ... The energy stored in the inductor in the steady state is zero D) Theresistor current eventually falls to zero

**Last Answer :** A

**Description :** A passive two port network is in a steady state. Compared to its input, the steady state output can never offer A) Higher voltage B) Lower impedance C) Greater power D) Better regulation

**Last Answer :** A passive two port network is in a steady state. Compared to its input, the steady state output can never offer Greater power

**Description :** Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is

**Last Answer :** Consider the star network shown in figure. The resistance between terminals A and B with C open is 6 ohms, between terminals B and C withAopen is 11 ohms and between terminals C andAwith B open is 9 ohms. Then RA, RB, RC respectively is 2, 4,7

**Description :** The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the current through the 1 micro farad capacitor is A) 0A B) 1A C) 1.25A D) 5A

**Last Answer :** The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the current through the 1 micro farad capacitor is 1A

**Description :** As shown in the figure, 1 ohm resistance is connected across a source that has a load line v + i = 100. The current through the resistance is A) 25 A B) 50 A C) 100 A D) 200A

**Last Answer :** As shown in the figure, 1 ohm resistance is connected across a source that has a load line v + i = 100. The current through the resistance is 50 A

**Description :** The number of chords in the graph of the given circuit will be

**Last Answer :** The number of chords in the graph of the given circuit will be 3

**Description :** The time constant for the given circuit is A) 1/9 S B) 1/4 S C) 4S D) 9S

**Last Answer :** The time constant for the given circuit is 4S

**Description :** As a network contains only independent current sources and resistors then if the values of all resistors are doubled then the values of the node voltages are (A) will become half (B) will ... (D) cannot be determined unless the circuit configuration and the values of the resistors are known.

**Last Answer :** As a network contains only independent current sources and resistors then if the values of all resistors are doubled then the values of the node voltages are will become double

**Description :** Consider the following statement for a 2-port network 1. Z11 =Z22 2. h12 = h21 3.Y12 = -Y21 4.BC - AD = -1 then the network is reciprocal if and only if (A) 1 and 2 are correct (B) 2 and 3 are correct (C) 3 and 4 are correct (D) 4 alone is correct.

**Last Answer :** Consider the following statement for a 2-port network 1. Z11 =Z22 2. h12 = h21 3.Y12 = -Y21 4.BC - AD = -1 then the network is reciprocal if and only if (A) 1 and 2 are correct (B) 2 and 3 are correct (C) 3 and 4 are correct (D) 4 alone is correct.

**Description :** When the graph of a network has six branches with three tree branches then the minimum number of equations required for the solution of the network is (A) 2 (B) 3 (C) 4 (D) 5

**Last Answer :** When the graph of a network has six branches with three tree branches then the minimum number of equations required for the solution of the network is 3

**Description :** With n nodes and b branches a network will have (A) (b+n) links (B) b - n +1 links (C) b -n-1 links (D) b + n + 1 links

**Last Answer :** With n nodes and b branches a network will have b - n +1 links

**Description :** A transmission line is terminated at its characteristic impedance. The reflection coefficient is (a) 1 (b) –1 (c) 0 (d) ∞

**Last Answer :** A transmission line is terminated at its characteristic impedance. The reflection coefficient is 0

**Description :** In a series RLC circuit operating below the resonant frequency the current (a) I leads Vs (b) I lags Vs (c) I is in Phase with Vs (d) None of these

**Last Answer :** In a series RLC circuit operating below the resonant frequency the current I leads Vs

**Description :** Norton's equivalent of a circuit consists of a 1. Constant current generator with parallel impedance 2. Constant current generator in series with an infinite resistance 3. Constant current generator in parallel with high impedance 4. Constant current generator in series with low impedance

**Last Answer :** Norton's equivalent of a circuit consists of a Constant current generator with parallel impedance

**Description :** In application of superposition theorem, one is required to solve as many circuits as there are 1. Nodes 2. Branches 3. Meshes 4. Sources

**Last Answer :** In application of superposition theorem, one is required to solve as many circuits as there are Sources

**Description :** A passive 2-port network is in a steady state, compared to its input, the steady state output can never offer (a) Higher voltage (b) Lower impedance (c) Greater power (d) Better regulation

**Last Answer :** A passive 2-port network is in a steady state, compared to its input, the steady state output can never offer Greater power

**Description :** Which of the following theorems can be applied to any network linear or non-linear, active or passive, time variant or time invariant? (a) Thevenin Theorem (b) Norton Theorem (c) Telligen Theorem (d) Superposition Theorem

**Last Answer :** Which of the following theorems can be applied to any network linear or non-linear, active or passive, time variant or time invariant? (a) Thevenin Theorem (b) Norton Theorem (c) Telligen Theorem (d) Superposition Theorem

**Description :** If the number of branches in a network is 'B', the number of nodes is 'N' and the number of dependent loops is 'L', then the number of independent node equations will be (a) N+L–1 (b) B–1 (c) B–N (d) N–1

**Last Answer :** N+l-

**Description :** In a pure resistive circuit, the average power Pavg is ______ the peak power Pmax. (1) Double (2) One-half of (3) One-fourth (4) Equal to

**Last Answer :** In a pure resistive circuit, the average power Pavg is One-half of the peak power Pmax.