Can i use a head gasket I bought for a 2.5L 4 cylinder be used on a 3.5L?

1 Answer

Answer :

No - the bore for the cylinders are different

Related questions

Description : What is the tightening of cylinder head bolt on KIA NAZA RIA 2.5L GASOLINE ENGINE?

Last Answer : Need answer

Description : Car has leaking head gasket? More info wanted?

Last Answer : Here are instructions on how to seal leaking head gaskets with sealant products.

Description : I'm not sure if my head gasket it blown but will adding sealant just to make sure hurt it in anyway?

Last Answer : Check the radiator; make sure that’s working. Check oil and antifreeze levels. Make sure there are no leaks. Check fans.

Description : How can I be sure that my car's head gasket has blown?

Last Answer : A blown head gasket will cause the car to overheat easily, and coolant viscosity may increase. This may also indicate a leak in the cooling system, but a simple pressure test should be able to tell ... head gasket so it is best if you get an opinion from a trained mechanic before you do anything.

Description : How do you fix a head gasket I'm a car?

Last Answer : your a car

Description : How much does a blown head gasket cost to repair?

Last Answer : The approximate cost for a head gasket or engine repair may range from 700 to 900 dollars. This is a fairly costly repair. Most commercial auto repair shops do offer discounts for members and repair packages ... Jiffy Lube, AAA, Wal-Mart, Pep-Boys, and Costco for the best prices. Hope that helps!

Description : On a 2001 Olds Inirque 3.5l Where is the crankshaft position sensor a circuti and b circuit located?

Last Answer : Need Answer

Description : 1 mole of a real gas changes it state from state-A(2bar, 3L, 100 K) to state -B (2bar, 5L, 200 K) at constant pressure and finally to state-C (3bar, 1

Last Answer : 1 mole of a real gas changes it state from state-A(2bar, 3L, 100 K) to state -B (2bar, 5L, 200 K) at ... U_(AC) = 2200 J` D. `DeltaU_(AC) = 1770 J`

Description : How many ml in 2.5l?

Last Answer : Need answer

Description : How many times is 250 contained 3.5l?

Last Answer : 0

Description : Should I just keep bleeding the car coolant system or get the gasket fixed?

Last Answer : I am by no means or stretch of the imagination an auto mechanic, but it does seem to me that running the water pump dry for any length of time is going to be damaging to it. Isn't the ... get that gasket looked into - and maybe consider replacing the water pump at the same time for good measure.

Description : change oil pan gasket in 1996 ford truck

Last Answer : Need Answer

Description : change valve cover gasket on nissan pickup

Last Answer : Need Answer

Description : How do you change oil pan gasket 1995 Chevy S-10 truck?

Last Answer : Need to know if it is the 4.3 or the 2.2 engine and if it is 2wheel drive or 4 wheel drive.

Description : How do you change oil pan gasket 1995 Chevy S-10 truck?

Last Answer : Need to know if it is the 4.3 or the 2.2 engine and if it is 2wheel drive or 4 wheel drive.

Description : Where online can I go to purchase a pressure cooker gasket?

Last Answer : Since there are many types of cookers, The Pressure Cooker Outlet has many varieties to choose from. Visit them at www.pressurecooker-outlet.com

Description : Is there any way to replace a pressure cooker gasket?

Last Answer : Yes, you can purchase pressure cooker gaskets online at the company's website. Most of them are fairly simple to replace.

Description : i have 1999 honda accord automatic trans leaking fluid but work perfect somebody told me you need gasket between trans and engine is that wrightif it is how much cost ?

Last Answer : Gaskets are critical to proper operation. If you lose to much fluid your transmission will overheat and it will ruin the transmission. Unless you have several thousands of dollars lying around, I ... but this is better than the thousands it would cost to replace or rebuild the entire transmission.

Description : Repair Refrigerator Gasket?

Last Answer : Replacing your refrigerator gasket is good for the environment and your energy bills. It makes your refrigerator run more efficiently, and keeps your food fresher, longer! There are only a few ... steps you can save energy and food by improving the efficiency of this important kitchen appliance.

Description : What is the average price of a rubber gasket?

Last Answer : This will depend on what type of gasket you need and what it is for. I came up with .44 cents as an average starting price. www.gasketstogo.com

Description : Before working on an electric cargo winch master switch or controller, you should _____________. A. spray the gasket surface with a solvent B. drain condensate from the box C. open the circuit breaker in the power supply and tag D. heat the switch box to remove any moisture

Last Answer : Answer: C

Description : Which of the damages listed can occur to the components of a winch master control switch, if the cover gasket becomes deteriorated? A. Overheating of the winch motor. B. Contamination of lube oil. C. Sparking at the winch motor brushes. D. Rapid corrosion of switch components.

Last Answer : Answer: D

Description : What are the precautions to store the Gasket?  

Last Answer : a) Stress free storage b) No folding c) No reuse d) Replace with same thickness 

Description : What type of gasket and adhesive are used in transformer? 

Last Answer : Gasket – Neoprene based rubberised cork type RC70-C. (IS4253) Adhesive –Dunlop adhesive S-758 These are recommended by TELK 

Description : What Is Gasket? Where It Is Used?

Last Answer : It is sealing member between two flanges. Uses: 1. Water Line, Gas Line, Air Line used CAF Gasket. 2. RTJ - High Pressure Line. 3. Chemical Line - Rubber Gasket and Teflon Gasket. 4. ... Metallic, Metallic and Graphite. 5. Impregnated Gasket - Valve Sealing Gasket. 6. Spiral Wound - Steam Line.

Description : What is he required surface finish for raised or flat faced gasket surfaces? a) 63 µ in. b) 125 µ in-250 µ in. c) 250 µ in-400 µ in. d) 400-500 µ in.

Last Answer : b) 125 µ in-250 µ in.

Description : What is the maximum surface roughness for tongue and groove and small male and female gasket surfaces? a) 63 µ in b) 125 µ in c) 250 µ in d) 400 µ in

Last Answer : b) 125 µ in

Description : When a raised face flange gasket surface is machined to a flat face surface, does the flange still comply with ASME B31.3? a) No. b) Yes. c) Yes, provided the flange meets thickness requirements for flat faced flanges per ASME B31.3. d) Yes, if approached by the flange committee.

Last Answer : c) Yes, provided the flange meets thickness requirements for flat faced flanges per ASME B31.3.

Description : A flanged joint is composed of all but which of the following? a) The flange b) The bolts. c) The assembly method d) The gasket.

Last Answer : b) The bolts

Description : How to Change a Refrigerator Gasket

Last Answer : How to Change a Refrigerator Gasket If your refrigerator isn't cooling properly, it must be because the gasket is not intact enough. Over time, a refrigerator gasket can become damaged, and when it does, it's ... . If it does, you're in luck, but if not, have the appliance checked by a professional.

Description : How to Change a Refrigerator Gasket ?

Last Answer : How to Change a Refrigerator Gasket If your refrigerator isn't cooling properly, it must be because the gasket is not intact enough. Over time, a refrigerator gasket can become damaged, and when it does, it's ... . If it does, you're in luck, but if not, have the appliance checked by a professional.

Description : State any four requirements of gasket

Last Answer : Requirement of Gasket: Gaskets are used to provide a tight fitting joint between two surfaces. For example, the joint between cylinder head and block. 1. Conformity: - The gaskets must be able ... Provision of apertures: - The gasket must have apertures for any studs, bolts, opening etc.

Description : How do I remove the cylinder head on a Chev Spark?

Last Answer : If one had manuals for each 100,000,s of vehicle on the road, wewould need sites like this, right?

Description : What are the torque settings for Kia 2700 cylinder head and tappet clearance?

Last Answer : Feel Free to Answer

Description : Seek time is A) time to position the head over proper track B) time to position the head over proper sector C) time to position the head over proper cylinder D) none of above

Last Answer : Answer : A

Description : Seek time is a. time to position the head over proper track b. time to position the head over proper sector c. time to position the head over proper cylinder d. none of above

Last Answer : time to position the head over proper track

Description : A cylinder head temperature gauge measures: a. The temperature of the hottest cylinder b. The temperature of all the cylinders and gives an average reading c. The temperature of the coolest cylinder d. The temperature of the two cylinders furthest away from each other divided by two

Last Answer : a. The temperature of the hottest cylinder

Description : The EGT indication on a piston engine is used: a. To control the cooling air shutters b. To monitor the oil temperature c. To assist the pilot to adjust the fuel mixture d. To indicate cylinder head temperature

Last Answer : c. To assist the pilot to adjust the fuel mixture

Description : Seek time is a. time to position the head over proper track b. time to position the head over proper sector c. time to position the head over proper cylinder d. none of above

Last Answer : a. time to position the head over proper track

Description : A cylinder head temperature gauge measures: a. The temperature of the hottest cylinder b. The temperature of all the cylinders and gives an average reading c. The temperature of the coolest cylinder d. The temperature of the two cylinders furthest away from each other divided by two

Last Answer : a. The temperature of the hottest cylinder

Description : The EGT indication on a piston engine is used: a. To control the cooling air shutters b. To monitor the oil temperature c. To assist the pilot to adjust the fuel mixture d. To indicate cylinder head temperature

Last Answer : c. To assist the pilot to adjust the fuel mixture

Description : .When the valves are carried in engine bioel at one side of each cylinder is called A. Valves in head arrangements B. L-head C. I-head D. None of the above

Last Answer : B. L-head

Description : An engine is called I or valve in head engine when a) Valve are immediately above the cylinder b) Both valves are on one side c) Both valves are on opposite direction d) None of the above

Last Answer : d) None of the above

Description : Consider a disk queue with request for input/output to block on cylinders  98, 183, 37, 122, 14, 124, 65, 67  in that order. Assume that disk head is initially positioned at cylinder 53 and moving ... and 252 cylinders (B) 640 and 236 cylinders (C) 235 and 640 cylinders (D) 235 and 252 cylinders

Last Answer : Answer: 236 and 208 cylinders Explanation: SSTF Initial head position =53 The closest queue to initial head position=65 head moves from 53 to 65=12 head moves from 65 to 67=2 head moves from 67 ... 122=24 head moves from 122 to 124=2 head moves from 124 to 183=59 Total head movement=208 

Description : Consider a disk queue with I/O requests on the following cylinders in their arriving order: 6,10,12,54,97,73,128,15,44,110,34,45 The disk head is assumed to be at cylinder 23 and moving in the direction ... . The disk head movement using SCAN-scheduling algorithm is: (1) 172 (2) 173 (3) 227 (4) 228

Last Answer : (2) 173