Description : Solids which conduct electricity at higher temperature but not at lower temperature are called (1) super-conductor (2) metallic-conductor (3) semi-conductor (4) insulator
Last Answer : (3) semi-conductor Explanation: Semiconductors are insulators at low temperatures and reasonably good conductors at higher temperatures. As temperature increases, the semiconductor material becomes a better and better conductor.
Last Answer : semi-conductor
Description : In reactions involving solids and liquids (where change in volume is negligible), the heat of reaction at constant pressure as compared to that at constant volume is (A) More (B) Less (C) Same (D) Unpredictable; depends on the particular reaction
Last Answer : (C) Same
Description : In a laboratory test run, the rate of drying was found to be 0.5 x 10 - 3 kg/m2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry ... of the solids from 0.3 to 0.2 (dry basis) is (A) 2000 (B) 4000 (C) 5000 (D) 6000
Last Answer : (C) 5000
Description : Pick out the wrong statement. (A) Different solids have different equilibrium moisture curves (B) Total condenser or reboiler is considered equivalent to one theoretical plate in McCabe-Thiele method of ... (D) Even a forced draft cooling tower cannot cool water below the wet bulb temperature
Last Answer : (C) Heat removal load on cooler remains constant, even with increase of the reflux ratio in a distillation column
Description : Kopp's rule is used to calculate the heat capacity of (A) Solids (B) Liquids (C) Gases (D) All (A), (B) & (C)
Last Answer : (A) Solids
Description : Metalloids (A) Are good conductor of heat & electricity (B) Act as electron donors with metals & as electron acceptor with non metals (C) Are not necessarily solids at room temperature ... & non-metallic properties to some extent and are exemplified by elements like germanium, silicon & boron
Last Answer : D) Are compounds that exhibit both metallic & non-metallic properties to some extent and are exemplified by elements like germanium, silicon & boron
Description : Solids and liquids have (a) one value of specific heat (ft) two values of specific heat (c) three values of specific heat (d) no value of specific heat (e) one value under some conditions and two values under other conditions.
Last Answer : Answer : a
Description : n a chemical factory where dyes are made, wet cake at 30 OC consisting of 60% moisture is put in a dryer to obtain an output having only 5% moisture, at atmospheric pressure. In each batch about 120 ... dryer and the dryer efficiency is 80%. Latent heat of steam at 4 kg/cm2 is 520 kcal/kg.
Last Answer : Given that Qty of material dried per batch - 120 Kgs Moisture at inlet - 60% a. The quantity of moisture removed per batch. Water quantity in a wet batch - 120 x 0.6 = 72 Kgs. Quantity of bone dry ... - 48/0.95 = 50.5 Kgs. Equivalent water in a dry batch - 50.5 - 48 = 2.5 Kgs.
Description : How does the diffusion rate of solids increase ?
Last Answer : Applying heat increases the diffusion rate of solids.
Description : The basic filtration equation is given as dt/dV = (µ/A ∆P). [(α .CV/A) + Rm], where, V is volume of the filtrate; A is the filtration area, a is specific cake resistance, μ is viscosity of ... produced? Neglect filter medium resistance, Rm; assume incompressible cake. (A) 10 (B) 20 (C) 25 (D) 30
Last Answer : (B) 20
Description : 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 10 -3 kg/m2 .s. The initial ... moisture/kg dry solid). (A) 0.5 (B) 0.05 (C) 0.1 (D) 0.15
Last Answer : (C) 0.1
Description : A small dairy farm daily produces 100 kilograms of average quality buffalo milk and sells it to an organised dairy at the rate of Rs. 100 per kilogram of total solids contained in the milk. How much would be the daily gross ... (D) Between Rs. 1,000 and Rs. 1,100 (E) Between Rs. 1,650 and Rs. 1,850
Last Answer : (B) Between Rs. 1,250 and Rs. 1,400
Description : Is the ability to conduct heat a physical property?
Last Answer : The ability to conduct heat does not involve a chemicalreaction, so it can't be a chemical property. Therefore, it is aphysical property.
Description : What material is light and can conduct heat well?
Last Answer : What is the answer ?
Description : Elements that do not conduct electricity and heat which tends to accept electrons?
Last Answer : Non-Metals
Description : Elements that conduct electricity and heat which tends to lose electrons are called?
Last Answer : Metals
Description : Why is moist heat more versatile than dry heat? a. It More Easily Penetrates Materials. b. Water Molecules Conduct Heat Better Than Air c. It Denatures Proteins By Changing Their Structure And Chemical Bonds d. A-C Are Correct
Last Answer : d. A-C Are Correct
Description : What is a measure of the ability of a material to conduct heat? A. Specific heat capacity B. Coefficient of thermal expansion C. Coefficient of thermal conductivity D. Thermal conductivity
Last Answer : Thermal conductivity
Description : What term describes a device used to conduct heat away from a component?
Last Answer : A thermal shunt.
Description : Which material conduct heat and electricity:
Last Answer : Solid
Description : Equilibrium-moisture curves of different solids (A) Are different (B) Are same (C) Depend on the humidity of the gas (D) None of these
Last Answer : (A) Are different
Description : In case of constant underflow extraction operation, the __________ atall solute concentration. (A) Solids are drained to the same extent (B) Ratio of the insoluble to solution is constant (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : For a temperature difference `DeltaT=20.0^(@)C`, one slab of material conducts `10.0W//m^(2)` , another of the same shape conduct `20.0W//m^(2)`. What
Last Answer : For a temperature difference `DeltaT=20.0^(@)C`, one slab of material conducts `10.0W//m^(2)` , another of the ... C. `20/3 W//m^(2)` D. none of these