Why is tapping done ?

1 Answer

Answer :

Tapping is done at the junction to prevent short circuit accidents , prevent rust and enhance beauty.

Related questions

Description : What is Tapping ?

Last Answer : : Tapping is the systematic wrapping of electrical wire joint space with insulating material or insulating tape.

Description : What is Tapping ?

Last Answer : : Tapping is done with insulating material or insulating tape.

Description : Tapping of rubber trees is usually done in the morning hours. -SST 10th

Last Answer : Latex flows freely in the early morning and there is less chance of rain.

Description : What earthing is done in hilly areas ?

Last Answer : Sheet earthing is done in hilly areas. Shit electrodes are placed by digging trenches on the slopes of the hill.

Description : Why is line transposition done ?

Last Answer : The average inductance value of each line is found to be equal when transposed.

Description : Why High Side Playing is done while doing Open Circuit Test ?

Last Answer : Answer : Rated voltage supply is given on one side of the transformer (usually high side). This supply results in a voltmeter rated voltage connected to the circuit , a no-load current ( Io) in ... side play is used during open circuit testing to find out the core loss using low range instruments.

Description : Why is soldering done ?

Last Answer : Soldering is done to increase the strength and durability of electrical wiring joints and to ensure uninterrupted wiring and protection from corrosive processes due to unforeseen nature.

Description : Why is earthing done ?

Last Answer : Earthing is done to allow the current to flow to the ground during an electrical fault so that the protection device can work to disconnect the faulty circuit.

Description : What is done with electronic oven ?

Last Answer : Food is cooked with electric oven.

Description : What tests can be done with ohm meter ?

Last Answer : Only resistance is measured with ohm meter.

Description : Can someone help me find the gif online that has an unusual breed of cat that comes up to a young girl sitting and gets her attention by tapping her right arm a few times?

Last Answer : The cat could be a Scottish Fold. Sorry, that’s all I got.

Description : Is there such thing as clear plastic tapping screws?

Last Answer : I doubt that plastic is strong enough to make a tapping screw. It would have to be at least as strong as brass (which is a relatively soft metal).

Description : I'm tapping the collective for creative gift ideas! What's a great generic family gift?

Last Answer : Panini grill

Description : Does tapping a can actually reduce fizz?

Last Answer : I don’t see how agitating the can anymore would make it less likely to fizz over.

Description : Does anyone else sometimes have a wreckless tapping problem?

Last Answer : Yes! All the time. I went through a particularly bad week where I was randomly calling people on accident.

Description : Do you click by tapping the trackpad?

Last Answer : I do a bit of each. It just depends on what I’m doing. If I’m clicking and dragging I use the button, but if I’m just clicking I usually tap the trackpad.

Description : Are we truly tapping the collective or just socializing?

Last Answer : Uh, both?

Description : CNC machining centres do not include operations like a.milling b.boring c.welding d.tapping

Last Answer : c.welding

Description : What do you understand by the term ‘Tapping’ and with which crop this term is associated? -SST 10th

Last Answer : When the rubber plants mature into trees after 7 or 8 years they are tapped for rubber sap. ‘V’ shape cut is made in the bark of the tree and a pot is tied round the trunk just below the tip of the cut. It is known as tapping. This term is associated with production of natural rubber.

Description : Hello, I would like to hear the experience and information of others who have experience with listening to a mobile phone. What form can the interception be traced to ... Are there any warning ... seems to be partially interrupted and there is definitely a "sneer" that makes the call impossible. .

Last Answer : It may be caused by something else. You don't know eavesdropping

Description : Hello, I backed off, and maybe lightly knocked on someone's cart behind the car, stood where he had and was not visible .. it's a pity, I climbed up and looked .... someone was sitting in that car ... didn't even say word, so I left. It's possible that the camera caught me. What is threatening me?

Last Answer : When you write - no harm, there is no danger. Still, I think you should have contacted the passenger and explained to him that you felt a slight impact, but after looking, you found no damage. ... of leaving the scene if nothing really happened. It's probably too late to deal with anything now.

Description : When a man and a woman meet?

Last Answer : Perhaps this link will help: http: //zasady.cz/zasady-slusneho-chovani-tykani-a-vykani.php

Description : What is ice tapping?

Last Answer : What is the answer ?

Description : Vena-contracta pressure tapping is at a distance __________ from the position of an orificemeter fitted in a pipe of internal diameter 'd' (A) d (B) 0.5 d (C) 2d (D) 4d

Last Answer : (B) 0.5 d

Description : Pick up the correct statement from the following: (A) Air bubbles in casting produce a dull sound by tapping their surfaces lightly with a hammer (B) Cupola furnace is used for the manufacture of cast iron (C) Red short iron is of no value for welding purpose (D) All the above

Last Answer : Answer: Option D

Description : When a wave propagates on a transmission line, it suffers reflection several times at (a) tapping (b) load end (c) sending end (d) sending and other end (e) all of the above

Last Answer : (d) sending and other end

Description : Which pin system has proven to be the most retentive A. Self tapping threaded pin B. Friction peak pin C. Cemented pin

Last Answer : A. Self tapping threaded pin

Description : Late tapping will cause defect of? (i) Lack of fusion (Heat losses)* (ii) Piping defect (iii) kidney defect (iv) All above are correct

Last Answer : (i) Lack of fusion (Heat losses)*

Description : What will happen if slag is not used above the layer of asbestos powder? (i) Auto tapping* (ii) High welding (iii) Low welding (iv) Nothing will happen

Last Answer : (i) Auto tapping*

Description : Late tapping will cause defect of? (i) Lack of fusion (Heat losses)* (ii) Piping defect (iii) Half moon defect (iv) None of above

Last Answer : (i) Lack of fusion (Heat losses)*

Description : Early tapping will cause defect of? (i) No defect (ii) Inclusion of slag* (iii) Inclusion of aluminium (iv) Inclusion of ferrou

Last Answer : (ii) Inclusion of slag*

Description : What is WP Tapping?

Last Answer : Ans. Means weather proof tapping. WP mains provision of 3 phase. 4 wire OH lines running under COP. WP tapping means tapping supply to lights and fans, circuits under COP at all stations

Description : In an IF amplifier, the IF transformer is provided with tapping to  (a) increase the voltage gain (b) increase the bandwidth of the resonance circuit (c) increase the impedance ... resonance circuit to the following cascaded amplifier (d) increase the quality factor of the resonance circuit 

Last Answer : In an IF amplifier, the IF transformer is provided with tapping to increase the voltage gain

Description : What is the conductivity of molar ?

Last Answer : The density of a solution as cm. When one mole of electrolytic substance is dissolved in it, the conductivity obtained by multiplying it by the relative conductivity of the solution is called molecular conductivity of the solution .

Description : How do I purchase a product ?

Last Answer : From Alibaba you can purchase products by paying MASTER CARD or through bank.

Description : What is an analog signal ?

Last Answer : Signals whose values ​​change continuously are called analog signals. For example- voltage of electricity supplied to the house.

Description : What is Zener Diod ?

Last Answer : Zener diode is a special type of diode which, like ordinary diode, not only conducts current in the forward direction , but also in the opposite direction if the voltage exceeds the level of breakdown ... diode is to use the shunt regulator and the voltage reference as the voltage of the circuit.

Description : What is the multiplying factor of shunt ?

Last Answer : Answer : The ratio of load or matte current to ammeter current is called shunt multiplying power.

Description : What is ammeter shunt ?

Last Answer : A small amount of radial coupling in parallel with the coil to increase the range of ammeter is called ammeter shunt.

Description : What is short circuit current ?

Last Answer : Answer : A fault in an electrical system whose current, before or after the current flows through the load, is combined with one or more phases of neutral current which causes more current to flow than normal. The current is called short circuit current.

Description : What is a current limiting reactor ? How many types and what are they ?

Last Answer : Answer : A current limiting reactor is basically an inductive coil which limits the short circuit current by providing inductive reactance when required. Types: 1. Based on the structure- a) Dry type ... reactor. Basbar reactors are again of 2 types- a) Ring system reactor b) Tiber system reactor

Description : What is the method of diagnosing short circuit current ?

Last Answer : There are three methods for determining short circuit current , namely- 1) Ohmic method 2) Per unit method 3.) Percentage reactance method.

Description : What are symmetrical and asymmetrical faults ?

Last Answer : Symmetrical Fault: The same amount in each phase due to the float in the electrical system. The fault that causes hot current to flow is called semantic fault. Circuit breaker ratings are determined by ... through each fan is called an asymmetrical fault. The relay is set via asymmetrical font.

Description : What is Basbar and Bas Kaplar ?

Last Answer : Basbar : Basbar is basically a sheet or color of copper or aluminum. It is the job of the bus driver to deliver power to one or more lads with power from one or more cables. Bus ... is basically a combination of circuit breaker and isolator. There are fire proof walls around the bus coupler.

Description : Why is the busbar sectionalized ?

Last Answer : Answer : If an error occurs in any part of the busbar, the operation of the entire busbar system will not stop. The maximum success of this system is due to the interconnection of different sections of the circuit and the smooth distribution in the outgoing circuit.

Description : title : _

Last Answer : Basbar is a type of copper and aluminum conductive sheet or mata rod , which collects electrical energy from one or more circuits and distributes that energy through one or more circuits.

Description : Write different font names or different short circuit font names ?

Last Answer : There are two main types of short circuit faults. Namely- 1. Semantic faults and 2. Asymmetrical font Symmetrical fault - a) Short circuit three phases together b) Short circuit asymmetrical fault with three ... result c) Double line to ground font d) Two phase one Circuit and third phase earth.

Description : What is Electrical Fault ? What is the cause of the fault ?

Last Answer : Answer : Fault: When two or more conductors come in contact with each other while operating at normal voltage difference, the result is said to be organized. Causes of Fault: Faults are organized due to ... loss of line c) Lightning charge d) Voltage drop e) Loss of unbalance and stability etc.

Description : What features should a switchgear have ?

Last Answer : Switchgear should have the following characteristics- a) Sensitivity b) Detection ability c) Reliability d) High speed e) Durability. F) Expansion advantage g) Simplicity.

Description : What are the components of switch gear ?

Last Answer : The components of switch gear are: circuit breaker , relay , instrument transformer , housing , conductor etc.