can I make a new mussaenda plant, by cutting a branch and putting it in soil?.

1 Answer

Answer :

Need Answer

Related questions

Description : A low branch with a node is bent down and covered with soil in a) Marcotting b) Layering c)Cutting d) Budding

Last Answer : b) Layering

Description : I have an LED Lighting Supplier who is putting their cutting edge LED Lighting in Aramark,Amtekco and Gamon for the Food service and Display caseing and salad bar display ,we would like access to the top Display case Manufactuers or vendors so that I may ?

Last Answer : Try www.displaycasedepot.com/ to get started

Description : After cutting off branch, what can I put on tree to keep branch from returning?

Last Answer : It always good to keep the bottom branches clear to see around and under them for safety reasons. You could spray spectracide to close the cut, but they are always going to try to grow another branch.

Description : If the instructions say to plant the phlox root 1" below the ground, is putting on the ground (no hole) and putting 1" of garden soil on top the same thing?

Last Answer : I think they mean “ground level”, so, no that won’t work.

Description : Curved twisted blades are specially suited for m. Minimum tillage of trashy land at shallow depths n. Dried hard soils o. Cutting and pulverisation in wet sticky clay soil p. For operating on the sides of plant bed

Last Answer : p. For operating on the sides of plant bed

Description : can potato vine be planted by breaking off vine @ putting in soil

Last Answer : Yes, and quite easily. Just cut the plant anywhere on the vine and stick it in the ground. I have many Blackies (purple potato plants), and have transplanted them all over and they've done really well using this method. Just remember to water them for the first 3 or 4 days. Good Luck !

Description : Grillage foundation (A) Is used to transfer heavy structural loads from steel columns to a soil having low bearing capacity (B) Is light and economical (C) Does not require deep cutting as the required base area with required pressure intensity is obtained at a shallow depth (D) All the above

Last Answer : Answer: Option D

Description : In the method of tube boring of soil investigation, the following is essential: (A) A tube of about 2 metres length and 20 cm diameter with a cutting edge (B) A flap valve at the bottom of tube is ... and lowered by 4 thick rope moving over a pulley suspended on a tripod stand (D) All the above

Last Answer : Answer: Option D

Description : In comparison to MB plough, the draft is less in disc plough because a) It roll over the soil instead of sliding b) It has lower contact area c) It has larger cutting edge d) None of these Ans. a

Last Answer : ans a

Description : This type blades in rotary tiller are more effective in cutting weeds and they do not Pulverize the soil much. b. twisted c. straight d. None of the above

Last Answer : Ans- a. ‘L’

Description : is a circular concave revolving steel plate using for cutting and inverting the soil. a. Gang bolt. c. Disc b. Bearing d. None

Last Answer : Bearing 

Description : Select the function of Moldboard plough. a) Lifting the soil. c) Pulverizing the soil b) Cutting the furrow slice d) All of the above

Last Answer :  All of the above

Description : plate used for cutting a inverting the soil. i. Cooper. c) iron ii. Aluminium. d) steel

Last Answer : steel

Description : is the function of mold board plough. a) Cutting the furrow slice b) Lifting the soil c) Pulverizing the soil d) All of the above

Last Answer : All of the above

Description : shaped blades are best suited for i. Minimum tillage of trashy land at shallow depths j. Dried hard soils k. Cutting and pulverisation in wet sticky clay soil l. Working under normal field conditions

Last Answer : i. Minimum tillage of trashy land at shallow depths

Description : Hook type blades best suited for e. Minimum tillage of trashy land at shallow depths f. Dried hard soils g. Cutting and pulverisation especially in wet sticky clay soil h. Working under normal field conditions

Last Answer : f. Dried hard soils

Description : Forces which a tool must overcome in cutting, breaking and moving the soil is called a) Useful soil resistance b) Parasitic force c) Draft of implement d) Pull of implement

Last Answer : a) Useful soil resistance

Description : The side slope of formation in embankment /cutting depends on a) Shearing strength of soil and its angle of repose* b) Angle of repose c) Bearing capacity of the soil d) Optimum moisture content of the soil

Last Answer : a) Shearing strength of soil and its angle of repose*

Description : The remedies to soil erosion are : I. Contour bunding II. Regulation of land use III. Cutting of trees IV. Allowing grazing of animals (1) I, III (2) I, II (3) III, IV (4) II, III

Last Answer :  I, II

Description : when all the flowers fall of do I trim the whole branch down 1 inch from soil I am talking about orcids

Last Answer : Need Answer

Description : A branch of agricultural science which deals with principles and practices of soil, water and crop management.

Last Answer : Ans.Agronomy

Description : Which of the following is a branch of agricultural science which deals with principles and practices of soil, water and crop management. What is the name of the branch? a. Crop production b. Agricultural engineering c. Home Science d. Agronomy

Last Answer : d. Agronomy

Description : Mango fruit fly pupates in — a. Soil b. Fruit c. Leaves d. Branch

Last Answer : a. Soil

Description : Mango fruit fly pupates in — a. Soil b. Fruit c. Leaves d. Branch

Last Answer : a. Soil

Description : what is putting holes in my brocolli plant leaves?

Last Answer : wait until the sun goes down mix up 1 teasp liquid hand soap w 1 qt water mix & spray....might need to reapply

Description : How do I grow a new herb plant from a branch of an existing larger plant?

Last Answer : This seemed like a good, down to earth, guide to it: http://www.nothyme.com/plantpropagation.cfm

Description : A process in which the branch of a plant is cut off in order to produce a flush of new shoots

Last Answer : Ans. Pollarding

Description : The process in which the branch of a plant is cut off in order to produce a flush of new shoots is called [a] Pollarding [b] Lopping [c] Silviculture [d] Pruning [e] Coppice

Last Answer : [c] Silviculture

Description : Will a cutting from a Hypoestes plant make roots?

Last Answer : Need Answer

Description : Has anyone out there bought a new car by first going to local dealers to determine eactly what you want then putting specs online and getting bids from local dealers?

Last Answer : answer:We usually go online first, and find all the comparable cars. We then go to a dealer, and if he tries to sell us something we don't want, we just leave. With the past two new cars we bought ... the best deal possible - from a dealer 75 miles away. I would have never driven that far for a car.

Description : Do you wash new sheets before putting them on the bed?

Last Answer : Yup, always for sheets. Not so much for socks or underpants though.

Description : if there was a software out there what would it be called closing a browser an putting new application really fast on screen?

Last Answer : answer:"New application really fast" is why browser are adding more and more cross-origin protection for loading JavaScript. (Warning: broad vulgarisation) A decade and more ago, cookies were not ... and capture clicks and keyboard keystrokes. Is this the kind of behavior you're thinking about?