Description : Suggested or recommended difference in mass to power ratio between ballasted and unballasted tractor is of the order a)10kg/PTO KW b)6kg/PTO kw c)20kg/PTO kw d)30kg/PTO kw
Last Answer : b)6kg/PTO kw
Description : Formula for adding weight (ballast) on tractor tyres working in loose wet soil for good traction a)(km/hr × kg/PTO kw)=540 b)( km/hr × kg/PTO kw)=670 c)( km/hr × kg/PTO HP)=540 d)( km/hr × kg/PTO HP)=670
Last Answer : a)(km/hr × kg/PTO kw)=540
Description : Swinging drawbar is advantageous because it help A. Taking short turn with machine wider than the tractor B. Reduces side draft C. Leaves only small area uncovered at corner of the fied D. All the above
Last Answer : A. Taking short turn with machine wider than the tractor
Description : The cutter bar of a tractor operated mower ordinarily makes: A. Near the front axis B. 40mm towards the real axis C. At the power take off shaft D. Between the two lower Links
Last Answer : D. Between the two lower Links
Description : .Increase length of a land slide of a one bottom right hand mould board plough will a) Increase the amount of offset on tractor b) Decrease the amount of offset c) No affect d) Affect Completely
Last Answer : c) No affect
Description : ASPEE are famous for manufacturing: a) Tractor b) Power tillers c) Ploughs d) Sprayers
Last Answer : d) Sprayers
Description : The first tractor plant in india was set up by : A)hindustan b)hmt C)eicher d)ford
Last Answer : C)eicher
Description : the time taken to plough one acre farm with 35 hp tractor is : A)60 minutes b)75 minutes C)90 minutes d)120 minutes
Last Answer : b)75 minutes
Description : which of the following tractor has the cair cooled engine? A)ford b)eicher C)international d)hmt
Last Answer : b)eicher
Description : Normal consumption of fuep in ltrs/hr. by a 35hp tractor is (A) 2.5 (B)3.0 (C)3.5 (D)4
Last Answer : (B)3.0
Description : GOOD EARTH is one of the important make of (A) tractor (B) electric motor (C) diesel engine (D)power tiller
Last Answer : A) tractor
Description : .An olpad thresher is operated (A) Manually (B)By a pair of Bullocks (C)By a tractor (D)By an electric motor
Last Answer : (B)By a pair of Bullocks
Description : The sound level of an agricultural tractor should not exceed : I. 110 dB J. 100 dB K. 90 dB L. 80 dB
Last Answer : K. 90 dB
Description : The method which depreciates the tractor or machine to zero at the end of its expected life is known as: A. Estimated value B. Sum-of-the digits C. Declining balance D. Straight line
Last Answer : D. Straight line
Description : The cutter bar of a tractor operated mower ordinarily makes: A. 800-1200 strokes/min B. 1600-2000 strokes/min C. 2400-2800 strokes/min D. 3200-3600 strokes/min
Last Answer : A. 800-1200 strokes/min
Description : Recommended capacity of the seed box or hopper for tractor mounted (large size) seed drill is a. 2-10 lit b. 10-60 lit c. 100-150 lit d. 200-300 lit
Last Answer : d. 200-300 lit
Description : Recommended capacity of the seed box or hopper for tractor mounted(small size) seed drill is a. 2-10 lit b. 10-60 lit c. 100-150 lit d. 200-300 lit
Last Answer : c. 100-150 lit
Description : onstant speed governors are used on ∙ Tractor engine diesel ∙ Stationary diesel engine ∙ Petrol engine ∙ None of the above
Last Answer : Stationary diesel engine
Description : variable speed governors are used on ∙ Tractor engine(diesel) ∙ Stationary engine (diesel) ∙ Petrol engine ∙ None of the above
Last Answer : ∙ Tractor engine(diesel)
Description : Stroke bore ratio for tractor engine is (a) 1.25 (b) 1.45 (c) 1.75 (d) 2.00
Last Answer : (a) 1.25
Description : enght of cutter bar for the tractor operated mower or vertical conveyor reaper is..... (a) 1.5-3.0m (b) 3.0-4.5m (c)4.5-5.5m (d) >5.5m
Last Answer : (a) 1.5-3.0m
Description : Capacity of field choppers (chaff cutter) is affected by.... (a) Capacity of the feed mechanism (cross-sectional area) (b) Rate of advance of material through throat considered as to be same linear speed of feed mechanism (c) Density of forage material (d) All of the above
Last Answer : (d) All of the above
Description : V -belt are most suitable for a. less space requirements b. use with adjustable pulley foe speed change c. both (a) and (b) d. none of the above
Last Answer : c. both (a) and (b)
Description : Share for use in sandy soils are made of A)chilled cast iron. B)cast iron C)mild steel. D)gun metal
Last Answer : Share for use in sandy soils are made of A)chilled cast iron. B)cast iron C)mild steel. D)gun metal
Description : Wood is well suited to use as bearing on straw walker cranks in combine due to fact a) Wood corrosion resistance b) Split bearing are needed for practical purpose c) It can take radial as well as thrust loads d) No lubrication is required
Last Answer : b) Split bearing are needed for practical purpose
Description : verticalsuctioninmouldboardploughis______whereashorizontalsuctionis______
Last Answer : .0.3to0.5cm,0.5cm
Description : Byincreasingdiskangle,depthpenetration_____beoverwithofcut_______
Last Answer : .decreases,increases
Description : A paddy transplanter uses either root wash type seedlings or __________ seedlings.
Last Answer : soil bearing
Description : An indigenous plough cuts a _________furrow cross sect
Last Answer : Trapizoidal
Description : The unit of filter medium resistance is________
Last Answer : L^-1
Description : The average working speed of a hand operated chaff fitted with two knives is _________ rev/min.
Last Answer : 35
Description : In a combine harvester the peripheral speed of the cylinder ranges between ________ m/min.
Last Answer : 1200 to 1500
Description : In sprayers , operating pressures below ___________Kpa are undesirable for hydraulic nozzles other than flooding type
Last Answer : 140
Description : Optimum speed for grains like gram,pea,etc.,thresher using power is a) 300-400rpm b) 400-600rpm c) 600-800rpm d) 1100-1200rpm
Last Answer : a) 300-400rpm
Description : Optimum operating cylinder speed for wheat threshing using power operated thresher is a) 300-400rpm b) 400-600rpm c) 600-800rpm d) 1100-1200rpm
Last Answer : d) 1100-1200rpm
Description : Optimum operating cylinder speed for the power operated maize sheller is a) 200-400rpm b) 400-600rpm c) 600-800rpm d) 1000-1200rpm
Last Answer : c) 600-800rpm
Description : Air output of a duster is given by formula a) Q= 60×A×V b)Q= 60×A×(2GH/Y) c) Q= 240×A×h d) all of the above
Last Answer : d) all of the above
Description : Lewis formula is used in the design of a) gears b) clutch c) chain drive d) belt drives
Last Answer : a) gears
Description : Transplanter using soil bearing seedlings are more popular than washed root seedling transplanter because of a) less labour requirement b) lesser plant missing percentage c) higher work rates d) all of the above
Description : Superchargers are driven by A. Electric current from the battery B. Exhaust gases from engine C. Direct connection with the engine power D. None of the above
Last Answer : C. Direct connection with the engine power
Description : Turbo chargers are driven by A. Direct connection with engine power B. Exhaust gases from engine C. Electric current from the battery D. None of the above
Last Answer : B. Exhaust gases from engine
Description : Turbo chargers or super chargers increases engine power by A. 10-20% C. 50-60% B. 20-30% D. 90-100%
Last Answer : A. 10-20%
Description : .When the valves are carried in engine bioel at one side of each cylinder is called A. Valves in head arrangements B. L-head C. I-head D. None of the above
Last Answer : B. L-head
Description : Utility index is a indication of A. Work machine contact hours B. Wear out life of machine C. Operating cost of machine D. Reliability of machine working
Last Answer : A. Work machine contact hours
Description : Alternators are preferred over dynamo because A. Alternators can produce a strong current of 30-40 amperes. B. Alternators don’t required cutout reiny C. Alternators don’t have commutaters D. All of the above
Last Answer : D. All of the above
Description : main function of the current regulator is A. To prevent the reversal flow of current from the battery when dynamo speed is drops. B. To safeguard against flow of high currents to battery when armature develops ... . C. To prevent building up of high voltage in a circuit. D. None of the above
Last Answer : B. To safeguard against flow of high currents to battery when armature develops more current.
Description : Main function of cutout relay in electrical circuit is A. To prevent the reversal of current flow from the battery when dynamo speed (engine speed) reduces. B. To restrict the maximum output at ... deliver current to the battery or to the lightening and ignition circuit. D. None of the above
Last Answer : A. To prevent the reversal of current flow from the battery when dynamo speed (engine speed) reduces.
Description : Weight per unit of drawbar power is generally ranges between a)50-120kg/kw b)120-150kg/kw c)150-250kg/kw d)250-300kg/kw
Last Answer : a)50-120kg/kw
Description : .Fandem wheels are preferred over dual wheels because a) they tends to reduce load on an area by50% b)they tends to reduce soil contact pressure c)reduces sub soil compact ness pressure d)none of the above
Last Answer : a) they tends to reduce load on an area by50%
Description : Dual wheels have disadvantage of a)reducing soil contact pressure and sub soil compact negative pressure b) concentrating load over an area c)reduces load on area by 50% d) none of the above
Last Answer : b) concentrating load over an area