How to find 120v double contact bayonet light bulbs for an antique light fixture from Australia?

Question

How to find 120v double contact bayonet light bulbs for an antique light fixture from Australia?

asked Feb 27, 2022 by anonymous

1 Answer

Related questions

New LED light bulbs: do they emit more or less heat than standard incandescent?

Description : New LED light bulbs: do they emit more or less heat than standard incandescent?

Last Answer : answer:I could not guarantee accuracy, but from what I know LED is cooler. You can find out for sure if you buy one of each, and take turns standing in from of each one.

What should I do when a CFL light bulb shatters?

Description : What should I do when a CFL light bulb shatters?

Last Answer : see this link

How many jellies does it take to change a light bulb?

Description : How many jellies does it take to change a light bulb?

Last Answer : Three. One to take the old one out; another to insist on putting it back in; and a third to argue that there’s no point in arguing. The light remains unchanged..

Any recommendations for dimmable CFLs?

Description : Any recommendations for dimmable CFLs?

Last Answer : Yes they work but they work differently. When dimmed the light is less, obviously, but you don’t seem to get that nice romantic glow you get with normal bulbs at lower levels. Mind you that might just be me.

The illustration shows a fluorescent light fixture. The ends of the lamp alternately glow and become dark, but the tube will not light. The most probable cause is that ____________. EL-0081 A. component 'D' is loose and due to the ship's vibrations makes and breaks contact B. the power system's voltage is fluctuating in and out of the range necessary for proper operation C. component 'A' is shorted and therefore unable to produce the high voltage required to start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Description : The illustration shows a fluorescent light fixture. The ends of the lamp alternately glow and become dark, but the tube will not light. The most probable cause is that ____________. EL-0081 ... start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Last Answer : Answer: C

Is it normal for a light bulb to break and hang from the light fixture by a wire?

Description : Is it normal for a light bulb to break and hang from the light fixture by a wire?

Last Answer : answer:Incandescent bulbs? If so, then yes, they often do that. Turn off the light switch when unscrewing them. If you can’t get the base out, a potato (or in my case a pliers) can assist in getting out the remains. Did you by any chance buy really cheap bulbs?

Sound Technical advice for wiring a room that already has a sconce light for a ceiling fixture?

Description : Sound Technical advice for wiring a room that already has a sconce light for a ceiling fixture?

Last Answer : If the wall is an interior wall then it should be an empty cavity. If it is an old home you may have fire stops inside the walls that will be a dead end when you attempt to fish the wire down. Make ... a good idea to know how much load is already on the circuit if you want to still use the sconce.

Is it easy enough to change an electric light fixture that I can do it without hiring a contractor?

Description : Is it easy enough to change an electric light fixture that I can do it without hiring a contractor?

Last Answer : It can be dangerous my dad does it but you need to turn the power off.

Ceiling Light Fixture?

Description : Ceiling Light Fixture?

Last Answer : form_title= Ceiling Light Fixture form_header= Light up your life with a ceiling light fixture. What is the height of your ceiling?*= _ [50] Do you want to include a ceiling fan? How many light fixtures do you need installed?*= {1, 2, 3, 4, 5, More than 5}

How to Replace an Exterior Light Fixture?

Description : How to Replace an Exterior Light Fixture?

Last Answer : How to Replace an Exterior Light FixtureReplacing an exterior light fixture is not difficult at all and you can do it even if you have limited electrical experience.Cutting the PowerBefore you do any ... . Turn the power back on at the circuit breaker box and test your new fixture connection.

Road Trip ? Crockpot is 265W, 120V and my inverter is 1000w. Will I be ok cooking with it on the road?

Description : Road Trip ? Crockpot is 265W, 120V and my inverter is 1000w. Will I be ok cooking with it on the road?

Last Answer : Inverter will be OK. Will you be running off the battery, or while driving? You don't want a dead battery. Continuous output of 265W means it will use 530W of battery power every hour. 12V x ... Compare that to 530 WattHour for the inverter and you can figure out how many hours to a dead battery.

I have a 60 watt/120v clip-on lamp. What is the highest wattage of compact fluorescent bulb can I safely use in this lamp?

Description : I have a 60 watt/120v clip-on lamp. What is the highest wattage of compact fluorescent bulb can I safely use in this lamp?

Last Answer : By the way, I mean actual watts on the fluorescent bulb, not replacement-watts. :)

If a 120v transformer has 200 turns the secondary winding has 20 turns what is the secondary winding voltage?

Description : If a 120v transformer has 200 turns the secondary winding has 20 turns what is the secondary winding voltage?

Last Answer : 12v

What is the secondary winding voltage if a 120v transformer has 200 turns the secondary winding has 20 turns?

Description : What is the secondary winding voltage if a 120v transformer has 200 turns the secondary winding has 20 turns?

Last Answer : 12 volts

A 1:5 step-up transformer has 120V across the primary and 600 ohms resistance across the secondary. Assuming 100% efficiency, the primary current equals (A) 0.2 Amp. (B) 5 Amps. (C) 10 Amps. (D) 20 Amps.

Description : A 1:5 step-up transformer has 120V across the primary and 600 ohms resistance across the secondary. Assuming 100% efficiency, the primary current equals (A) 0.2 Amp. (B) 5 Amps. (C) 10 Amps. (D) 20 Amps.

Last Answer : I1= V1 /R1 = 120/600 = 0.2 (η = 100%, losses are zero ∴V1 = VR = I1R1)

A 1:5 step-up transformer has 120V across the primary and 600 ohms resistance across the secondary....

Description : A 1:5 step-up transformer has 120V across the primary and 600 ohms resistance across the secondary. Assuming 100% efficiency, the primary current will be: (A) 0.2 Amp. (B) 5 Amps. (C)10 Amps. (D) 20 Amps

Last Answer : C. 10A

Do you remember the smelly green modeling clay that was a fixture of my youth, and is it still available?

Description : Do you remember the smelly green modeling clay that was a fixture of my youth, and is it still available?

Last Answer : I had to make a model of the human brain with that stuff. Went straight into the garbage after it was marked.

What do you call the fixture that cooks use to hang things from?

Description : What do you call the fixture that cooks use to hang things from?

Last Answer : Pot racks

Coast Guard Regulations (46 CFR) require that lighting fixture globes must be protected by guards if the fixtures are located in the ____________. A. steering gear room B. galley C. living quarters D. wheelhouse

Description : Coast Guard Regulations (46 CFR) require that lighting fixture globes must be protected by guards if the fixtures are located in the ____________. A. steering gear room B. galley C. living quarters D. wheelhouse

Last Answer : Answer: A

Mark the incorrect option a) The articles of stock such as plant and machinery, furniture and fixture are classed as “Dead stock” b) Consumable and perishable articles come under the term “Stores” c) Both the A and B d) None of these

Description : Mark the incorrect option a) The articles of stock such as plant and machinery, furniture and fixture are classed as “Dead stock” b) Consumable and perishable articles come under the term “Stores” c) Both the A and B d) None of these

Last Answer : d) None of these

Which type of splice is used to splice a lighting fixture to a branch circuit?

Description : Which type of splice is used to splice a lighting fixture to a branch circuit?

Last Answer : Fixture joint.

Explain general principles of jigs/fixture design

Description : Explain general principles of jigs/fixture design

Last Answer : 1. Before planning the design of a tool, compare the cost of production of the work with present tools with the expected cost of production, using the tool to be made. Confirm that the cost of ... nearly as possible opposite to some bearing point of the work to avoid springing. 11. Round all corners

Enlist general principle of jig and fixture design.

Description : Enlist general principle of jig and fixture design.

Last Answer : General principle of jig and fixture design. 1. The jig and fixture should be as open as possible to minimize chip or burr accumulation and to enable the operator to remove the chips easily with a ... . Inserts 9. Design for safety 10. Sighting surfaces 11. Simplicity in Design 12. Economical

Draw the labelled sketch of turning fixture.

Description : Draw the labelled sketch of turning fixture.

Last Answer : Figure: Back plate of Turning Fixture

State at least eight principles of jigs/ fixture design

Description : State at least eight principles of jigs/ fixture design

Last Answer : The following principles should be considered for design of jigs/ fixtures 1.Rigidity: jigs/ fixtures should be sufficiently stiff/rigid to achieve required accuracy during machining. 2.Fool ... or clearance grooves should be provided for easy removal of metal chips, burrs after machining

Differentiate in between Jig and fixture.

Description : Differentiate in between Jig and fixture.

Last Answer : Difference between jig and fixture.

If we conect a two bulbs in series And if we give double phase without neutral then bulb will glow or not??

Last Answer : Due to no potential difference between the ends of the circiut there is no existance of current

What gauge wire to use in rewiring antique light fixtures?

Description : What gauge wire to use in rewiring antique light fixtures?

Last Answer : Don’t forget that you are limited by the structure of the fixture as to how large a gauge you can use. I would use the absolute largest gauge that will work with any particular fixture to reduce the chances of resistance-built heat.

He scored 12 double centuries in test cricket which is a world record. A. Brian Lara (West Indies) B. Don Bradman (Australia) C. Tendulkar (India) D. Hanif Mohammad (Pakistan)