Description : For the 16-PSK and a transmission system with a 10kHz bandwidth, determine the maximum bit rate
Last Answer : 40,000 bps
Description : It is the ratio of the transmission bit rate to the minimum bandwidth required for a particular modulation scheme
Last Answer : Bandwidth efficiency, Information density, or Spectral efficiency
Description : Classification of protocol that interprets a frame of data as a group of successive bit combined into predetermined pattern of fixed length, usually 8 bits each.
Last Answer : Character and Byte-oriented protocols
Description : Category of data transmission if the binary pulse is maintained for the entire bit time?
Last Answer : Return to zero
Description : ____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.
Last Answer : UDP
Description : Dividing the data block by a constant produces a remainder that is used for error detection.
Last Answer : Cyclic redundancy check
Description : The upper pulse rate and information carrying capacity of a cable is limited by:
Last Answer : modal dispersion
Description : Picture frames are repeated at the rate of ___ per second
Last Answer : . 30
Description : A theory that establishes the minimum sampling rate that can be used for a given PCM systems.
Last Answer : Nyquist sampling theorem
Description : The result whenever the sampling rate is less than twice the highest audio frequency.
Last Answer : alias
Last Answer : 30
Description : A theory that establishes the minimum sampling rate that can be used for a given PCM systems
Description : Rate of change of a signal on a transmission medium after encoding and modulation have occurred
Last Answer : baud rate
Description : Data rate at which serial PCM bits are clocked out of the PCM encoder onto the transmission line.
Last Answer : line speed
Description : n T1, it is equal to the reciprocal of the sample rate
Last Answer : Frame time
Description : In the ________ traffic model, the rate of the data flow changes in time, with the changes smooth instead of sudden and sharp.
Last Answer : variable bit rate
Description : The ________ is a function of three values: average data rate, peak data rate, and maximum burst size.
Last Answer : Effective bandwidth
Description : A system where the modulated RF picture and sound carrier signals are distributed in a cable network, instead of wireless system.
Last Answer : CATV
Description : The width of the vertical sync pulse in the Philippine TV system is
Last Answer : 3H
Description : In the Philippine color television system, the intercarrier frequency, in MHz, is
Last Answer : 4.5
Description : The number of frames per second in the Philippine TV system is
Description : What distinguishes digital radio systems from conventional analog communications system?
Last Answer : the nature of the modulating signal
Description : It is a system where the digital signals are placed directly on the coaxial cable.
Last Answer : Baseband
Description : Ethernet is baseband transmission system designed by _____
Last Answer : Robert Metcalfe and David Boggs
Description : The magnetic field of an antenna is perpendicular to the earth. The antenna’s polarization ___
Last Answer : is horizontal
Description : It is the ratio of the power density radiated in a particular direction to the power density radiated to the same point by a reference antenna, assuming both antennas are radiating the same amount of power
Last Answer : directive gain
Description : The property of interchangeability for the transmitting and receiving operations is known as ____
Last Answer : reciprocity
Description : The fields surrounding the antenna do not collapse their energy back into the antenna but rather radiate it out in space
Last Answer : radiation field
Description : It is the ratio of the radiated to the reflected energy:
Last Answer : Radiation efficiency
Description : It is the resistance that, if it replaced the antenna, would dissipate exactly the same amount of power that the antenna radiates
Last Answer : . Radiation resistance
Description : Plots of field strength or power density with respect to the value at a reference point.
Last Answer : relative radiation pattern
Description : The radiation pattern plotted in terms of electric field strength or power density
Last Answer : absolute radiation pattern
Description : The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____
Last Answer : line of shoot
Description : A special type of transmission line that consist of conducting metallic tube through which high frequency electromagnetic energy is propagated
Last Answer : waveguide
Description : If energy is applied at the geometrical center of antenna, the antenna is said to be ___
Last Answer : center-fed
Description : The radiation pattern of collinear and a broadside antenna is __
Last Answer : bidirectional
Description : Hertz antenna are predominantly used with frequencies above
Last Answer : 2MHz
Description : The point on the antenna where the transmission line is connected is called _____
Last Answer : feedpoint
Description : The discone antenna is
Last Answer : useful as a UHF receiving antenna
Description : It is the same with directive gain except that the total power fed to the antenna is used and the antenna efficiency is taken into account.
Last Answer : power gain
Description : ______ are special-interest groups that quickly test, evaluate, and standardize new technologies
Last Answer : Forums
Description : _______ refers to the structure or format of the data, meaning the order in which they are presented.
Last Answer : Semantics
Description : ________ defines how a particular pattern to be interpreted, and what action is to be taken based on that interpretation.
Last Answer : syntax
Description : The effect of a large magnitude of the numerical aperture.
Last Answer : The amount of external light the fiber will accept is greater
Description : It is the figure of merit used to measure the magnitude of the acceptance angle.
Last Answer : numerical aperture
Description : It is a result of photons of light that are absorbed by the atoms of the glass core molecule
Last Answer : infrared absorption
Description : It is caused by valence electrons in the silica material from which the fiber are manufactured.
Last Answer : ultraviolet absorption