Description : What is a device that provides a method of sampling energy from within a waveguide for measurement or use in another circuit?
Last Answer : Directional Coupler
Description : The size, shape, and dielectric material of a waveguide must be constant throughout its length for energy to move from one end to the other without reflections. What could be the effect in any abrupt change in its size or shape?
Last Answer : Reflections.
Description : At what frequency compared to the cutoff frequency of a waveguide will the wavefronts be reflected back and forth across the guide (setting up standing waves) and no energy
Last Answer : UHF receiving antenna
Description : In a waveguide, what is a frequency that would cause angles of incidence and reflection to be zero degrees?
Last Answer : Critical Frequency
Description : A waveguide may also be terminated in a resistive load that is matched to the characteristic impedance of the waveguide. The resistive load is most often called a _____
Last Answer : Dummy resistor
Description : What travels down a waveguide by reflecting from the side walls in a zigzag pattern?
Last Answer : wavefronts
Description : When microwave energy is passed through a piece of ferrite in a magnetic field, another effect occurs. If the frequency of the microwave energy is much greater than the electron wobble frequency, the plane of polarization of the wavefront is rotated. This is known as
Last Answer : Faraday Rotation Effect
Description : What is the type of mastergroup used for low – capacity microwave systems?
Last Answer : L600
Description : To avoid objectionable noise in a microwave TV link, the SNR should be about:
Last Answer : 25 or more
Description : __________ defines how a user gets control of the channel so as to allow transmission.
Last Answer : channel access
Description : all others to pass unaffected
Last Answer : Ferrite Attenuator
Description : It is the ratio of the power density radiated in a particular direction to the power density radiated to the same point by a reference antenna, assuming both antennas are radiating the same amount of power
Last Answer : directive gain
Description : The line bisecting the major lobe, or pointing from the center of the antenna in the direction of maximum radiation is called _____
Last Answer : line of shoot
Description : he local oscillator and mixer are combined in one device because:
Last Answer : it is cheaper
Description : As light is coupled in a multiport deflective device, the power is reduced by:
Last Answer : 0.5 dB
Description : It is the procedure used to decide which device has the permission to transmit at any given time.
Last Answer : Line control
Description : A _______ is a three-layer device that handles packets based on their logical addresses
Last Answer : router
Description : A _______ is a connecting device that operates in the physical and data link layers of the Internet model.
Last Answer : bridge
Description : A repeater is a connecting device that operates in the _______ layer of the Internet model.
Last Answer : physical
Description : How does a waveguide-type lens focus spherical wavefront microwave energy?
Last Answer : Some wavefronts are accelerated so that all wavefronts exit the lens at the same time
Description : The advantage of periscope antenna in microwave A. Minimize interference to and from other neighboring stations B. Shorten waveguide link C. Reduce tower height D. All of these
Last Answer : B. Shorten waveguide link
Description : The fields surrounding the antenna do not collapse their energy back into the antenna but rather radiate it out in space
Last Answer : radiation field
Description : Propagation mode of microwave in a waveguide is known as _______. A. TM B. TE C. SW D. TEM
Last Answer : B. TE
Last Answer : Waveguide are used mainly for microwave signals because They would be too bulky at lower frequencies.
Description : It is the ratio of the radiated to the reflected energy:
Last Answer : Radiation efficiency
Description : A special type of transmission line that consist of conducting metallic tube through which high frequency electromagnetic energy is propagated
Last Answer : waveguide
Description : If energy is applied at the geometrical center of antenna, the antenna is said to be ___
Last Answer : center-fed
Description : The process of moving from one energy level to another is called __
Last Answer : Absorption
Description : The process of decaying from one energy level to another energy level is called _______
Last Answer : Spontaneous emission
Description : Any energy above the ground state is called ________
Last Answer : excited state
Description : The phase relationship between signaling elements for BPSK is the optimum signaling format and occurs only when two binary signal levels are allowed and when one signal is the exact negative of the other
Last Answer : Antipodal signaling
Description : Packets which is self – contained and travels through the network independent of other packets of the same message by whatever means available
Last Answer : Datagram
Description : In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
Last Answer : AGC, video IF amplifier, RF amplifier
Description : does its best to get a transmission through to its destination, but with no guarantees
Last Answer : best-effort delivery
Description : The magnetic field of an antenna is perpendicular to the earth. The antenna’s polarization ___
Last Answer : is horizontal
Description : The property of interchangeability for the transmitting and receiving operations is known as ____
Last Answer : reciprocity
Description : It is the resistance that, if it replaced the antenna, would dissipate exactly the same amount of power that the antenna radiates
Last Answer : . Radiation resistance
Description : Plots of field strength or power density with respect to the value at a reference point.
Last Answer : relative radiation pattern
Description : The radiation pattern plotted in terms of electric field strength or power density
Last Answer : absolute radiation pattern
Description : The radiation pattern of collinear and a broadside antenna is __
Last Answer : bidirectional
Description : Hertz antenna are predominantly used with frequencies above
Last Answer : 2MHz
Description : The point on the antenna where the transmission line is connected is called _____
Last Answer : feedpoint
Description : The discone antenna is
Last Answer : useful as a UHF receiving antenna
Description : It is the same with directive gain except that the total power fed to the antenna is used and the antenna efficiency is taken into account.
Last Answer : power gain
Description : ____ is a process-to-process protocol that adds only port addresses, checksum error control, and length information to the data from the upper layer.
Last Answer : UDP
Description : ______ are special-interest groups that quickly test, evaluate, and standardize new technologies
Last Answer : Forums
Description : _______ refers to the structure or format of the data, meaning the order in which they are presented.
Last Answer : Semantics
Description : ________ defines how a particular pattern to be interpreted, and what action is to be taken based on that interpretation.
Last Answer : syntax
Description : The effect of a large magnitude of the numerical aperture.
Last Answer : The amount of external light the fiber will accept is greater
Description : It is the figure of merit used to measure the magnitude of the acceptance angle.
Last Answer : numerical aperture