What is the main disadvantage of series generators?

1 Answer

Answer :

Output voltage varies as the load varies

Related questions

Description : What is the main disadvantage of a series motor?

Last Answer : It must have a load connected to avoid damage from excess speed.

Description : What is the main disadvantage of parallel transfer?

Last Answer : Requires more circuitry.

Description : What is the main disadvantage of a conventional full-wave rectifier?

Last Answer : Peak voltage is half that of the half-wave rectifier.

Description : What is the main disadvantage of the conventional full wave rectifier?

Last Answer : The peak voltage is half that of a half-wave rectifier.

Description : What is the main disadvantage of PROM?

Last Answer : If a mistake is made and entered, it cannot be corrected or erased.

Description : What is the main disadvantage of using fiber-optic cables?

Last Answer : High attenuation.

Description : What is the main disadvantage of the rhombic antenna?

Last Answer : It requires a large antenna site.

Description : What is the main disadvantage of pulse-position modulation?

Last Answer : It requires synchronization between the transmitter and receiver.

Description : What is the disadvantage of using a double receiver instead of two individual receivers?

Last Answer : If one of the receivers goes bad the entire unit must be replaced.

Description : Name a disadvantage of sine-wave oscillator synchronizers.

Last Answer : It requires additional shaping circuits.

Description : Name a disadvantage of sine-wave oscillator synchronizers.

Last Answer : . It requires additional shaping circuits.

Description : What is the major disadvantage of printed circuit boards?

Last Answer : Components soldered in place.

Description : What is the major disadvantage of an fm signal as compared to an AM signal?

Last Answer : Wide bandpass.

Description : What is a disadvantage of agc?

Last Answer : Weak signals produce bias, which could result in no usable receiver output.

Description : How is the disadvantage of the Gramme-ring armature overcome in the drum-wound armature?

Last Answer : By winding the armature in a way that places the entire coil where it is exposed to maximum flux.

Description : What is a disadvantage of a direct-current system with respect to supply voltage?

Last Answer : the dc voltage must be generated at the level required by the load.

Description : What is the primary disadvantage of the pointer arrangement for indicating coil rotation?

Last Answer : Coil balance.

Description : What is the primary disadvantage of the pointer arrangement for indicating coil rotation?

Last Answer : Coil balance.

Description : What is a major disadvantage of a carbon microphone?

Last Answer : Background hiss resulting from random changes in the resistance between individual carbon granules.

Last Answer : Antenna-to-ground capacitance can cause the oscillator frequency to vary.

Description : What are report program generators used for?

Last Answer : To generate programs to print detail and summary reports of data files.

Description : What is the basic difference between the primaries of ac and dc rate generators?

Last Answer : The method of primary excitation (ac and permanent magnet).

Description : Motors, switches, voltage regulators, generators, etc., are a few examples of emi sources. What type of emi comes from these sources?

Last Answer : Man-made.

Description : Range-marker generators produce pulses based on what radar constant?

Last Answer : The radar mile (12.36 microseconds).

Description : What are the two classifications of wave generators according to their output waveshapes?

Last Answer : Sinusoidal and nonsinusoidal.

Description : What term applies to the use of two or more generators to supply a common load?

Last Answer : Parallel operation.

Description : What are the three classifications of dc generators?

Last Answer : Series-wound, shunt-wound, and compound-wound

Description : Lap windings are used in generators designed for what type of application?

Last Answer : Higher load currents are possible

Description : Why are drum-type armatures preferred over the Gramme ring armature in modern dc generators?

Last Answer : Drum-type armatures are more efficient, because flux lines are cut by both sides of each coil.

Description : Generators convert mechanical motion to electrical energy using what principle?

Last Answer : Magnetic induction

Description : In signal generators, what device is used to regulate the voltage of the output signal?

Last Answer : Attenuator.

Description : Ships’ generators produce 450-volt, three-phase, ac power; however, most equipment uses 117-volt, single-phase power What transformers and connections are used to convert 450- volt, threephase power to 117-volt, single-phase power?

Last Answer : A method of generating oscillations, a method of turning the oscillations on and off (keying), and an antenna to radiate the energy.

Description : What is the main advantage of a series motor?

Last Answer : High torque (turning force) at low speed.

Description : Which of the methods listed is used to maintain the division of load between two compound-wound, DC generators operating in parallel? A. The shunt fields are interconnected. B. The shunt ... generators are connected in series. D. The equalizer connection parallels the series fields of all machines.

Last Answer : Answer: D

Description : When two generators are on the line and are sharing the load equally, they are said to be operating in _____________. A. frequency B. series C. parallel D. resonance

Last Answer : Answer: C

Description : An equalizing connection between two compound-wound DC generators when paralleled, serves to _____________. A. reverse the polarity of the incoming generator as the series field weakens B. automatically ... the series field of the incoming generator D. parallel the series fields of the generators

Last Answer : Answer: D

Description : Which of the methods listed is used to maintain equal load sharing between two compound wound DC generators operating in parallel? A. The shunt fields are interconnected. B. The shunt field rheostats ... are connected in series. D. The series fields of both generators are connected in parallel.

Last Answer : Answer: D

Last Answer : If  equalising bar is connected to the 2 DC generators  the current will be equal in 2 generators irrespective of parallel connection so that we connect equaliser bar

Description : What was the main disadvantage of vacuum tubes? A) They were larger in size B) They consumed a lot of electricity C) They produced heat and often burned out D) The operation cost was high

Last Answer : Answer : C

Description : The main disadvantage of 'Radio' as an Advertisement medium is ____________ 1. No visual information 2. Narrow coverage 3. High cost 4. All of these 5. None of these

Last Answer : No visual information

Description : The main disadvantage of hard water, is  (A) Greater soap consumption  (B) Scaling of boilers  (C) Corrosion and incrustation of pipes  (D) All the above 

Last Answer : (D) All the above 

Description : The main disadvantage of line organisation, is (A) Rigid structure (B) Extraordinary delay in communications (C) Top level executions over work (D) All the above

Last Answer : (D) All the above

Description : What is the main disadvantage of Lamont boiler ? a. Less flexible in design b. Low heat transfer rate c. Formation of bubbles d. Low steam generation capacity

Last Answer : c. Formation of bubbles

Last Answer : The main disadvantage of the Ward-Leonard control method is high initial cost, high maintenance cost, low efficiency at light loads.

Description : What is the main disadvantage of phase advancers?

Last Answer : It cannot be used for motors below 20 H.P.

Description : Multiple grounds have developed and were initialy indicated by the grounddetecting system as one ground. The FIRST step in locating the grounds is to _____________. A. examine the main bus bars ... no longer indicates any grounds C. change over generators D. check each circuit with a megohmmeter

Last Answer : Answer: B

Description : A ground is indicated by the ground-detecting system on the main electrical switchboard. The FIRST step in locating the actual ground is to _____________. A. close all circuit breakers in ... ground detection system indicates normal C. change over generators D. check each circuit with a megohmmeter

Last Answer : Answer: B

Description : Undervoltage trips are frequently installed on switchboard circuit breakers to trip ____________. A. out generators in the event of severe arcing or sparking B. out generators when there is reversal of power ... , but continues to run D. out generators when there is low voltage in the main circuit

Last Answer : Answer: D

Description : Modern DC generators are fitted with commutating poles to _____________. A. prevent motorizing B. reduce sparking C. reduce the load on the main poles D. reduce spring pressure on the brushes

Last Answer : Answer: B