What are the functions of a converter-comparator group?

1 Answer

Answer :

The comparator compares the signal strengths from the  receivers and the converter converts the frequency-shift rf signal into  a tty set dc loop control signal.

Related questions

Description : The conversation speed of an analog to digital converter is maximum with the following technique. (A) Dual slope AD converter. (B) Serial comparator AD converter. (C) Successive approximation AD converter. (D) Parallel comparator AD converter.

Last Answer : (D) Parallel comparator AD converter.

Description : In successive approximation converter input to the comparator is through (A) DAC (B) Latch (C) Flip-flop (D) Sample and hold circuit

Last Answer : In successive approximation converter input to the comparator is through DAC 

Description : The number of comparators required in a 3-bit comparator type analog to digital converter is  A) 2 B) 3 C) 7 D) 8 

Last Answer : Number of comparators =2^n -1= 2^3 -1=7

Description : A digital voltmeter uses an A/D converter which needs a start pulse, uses an analog comparator and has a relatively fixed conversion time independent of the applied voltage. The A/D ... Successive Approximation Converter .b) Digital Ramp Converter c) Digital Slope Converter d) All the above

Last Answer : A digital voltmeter uses an A/D converter which needs a start pulse, uses an analog comparator and has a relatively fixed conversion time independent of the applied voltage. The A/D converter is : -  Successive Approximation Converter 

Description : What does a lighted LED indicate on a logic comparator?

Last Answer : A difference in logic states between the reference IC and the IC under test.

Description : The first converter is also known by what other name?

Last Answer : Front end.

Description : What is the output frequency of an upper-sideband parametric-frequency converter?

Last Answer : The sum of the input frequency and the pump frequency.

Description : What is the function of a converter?

Last Answer : Converts the audio signal to dc pulses.

Description : What is the discharge rate for the capacitor in a pcm converter?

Last Answer : It will discharge to one-half its value between pulses.

Description : What happens to a comparator when both inputs are equal?

Last Answer : What you're talking about here is an op-amp configured in open loop mode - no feedback resistor, so the output swings + or -, generally in opposition to the higher value on the inputs. ... are completely equal, because of thermal variations, quantum effect, and other non-ideal aspects of a circuit.

Description : What is a comparator ?

Last Answer : A comparator is a type of circuit that compares signal or voltage levels.

Description : In a series wound motor, the current passing through the field windings is also passing through the _____________. A. armature B. shunt field C. reactance comparator D. laminations

Last Answer : Answer: A

Description : Essentially a satellite ___________ is a radio repeater in the sky A. transponder B. comparator C. duplexer D. billboard

Last Answer : A. transponder

Description : What do you mean by comparator

Last Answer : A comparator is a special combinational circuit designed primarily to compare the relative magnitude of two binary numbers.

Description : Which one is used to determine the colour of petroleum products? (A) Colour comparator (B) Saybolt chromometer (C) Cleveland apparatus (D) None of these

Last Answer : (A) Colour comparator

Description : What are the characteristics of a comparator?

Last Answer : 1.Speed of operation 2.Accuracy 3.Compatibility of the output

Description : What are the applications of comparator?

Last Answer : 1.Zero crossing detector 2.Window detector 3.Time marker generator 4.Phase detector

Description : What is a comparator?

Last Answer : A comparator is a circuit which compares a signal voltage applied at one input of an opamp with a known reference voltage at the other input. It is an open loop op - amp with output + Vsat .

Description : Differentiate Schmitt trigger and comparator.

Last Answer : comparator. 1. It compares the input signal with references voltage then yields the output voltage 2. It need not consist of feedback 3. comparator output need not to besquare wave Schmitt ... reference points namely UTP<P. 2. It employs positive feedback 3. Its output is square wave.

Description : Which of the following circuit is used as a 'Memory device' in computers? 1) Rectifier 2) Flip-Flop 3) Comparator 4) Attenuator

Last Answer : 2) Flip-Flop

Description : Colour comparator is used to measure the (A) pH value (B) Electrode potential (C) Colour intensity (D) None of these

Last Answer : Option A

Description : A controller essentially is a A. Sensor B. Clipper C. Comparator D. Amplifier

Last Answer : C. Comparator

Description : Design and explain a comparator to compare two identical

Last Answer : words. • Two numbers represented by A = A3A2A1A0 & B = B3B2B1B0 • If two numbers equal P = Ai Bi • Obtain the logic Expression. • Obtain the logic diagram.

Description : What do you mean by comparator?

Last Answer : A comparator is a special combinational circuit designed primarily to compare the relative magnitude of two binary numbers.

Description : Which of the following circuit is used as 'Memory device' in computers ? (1) Rectifier (2) Flip-Flop (3) Comparator (4) Attenuator

Last Answer : Flip-Flop

Description : Describe block diagram of digital comparator and write truth table of 2 bit comparator.

Last Answer : Digital comparator is a combinational circuit which compares two numbers, A and B; and evaluates their relative magnitudes. The outcome of the comparison is given by three binary variables which indicate whether A ... Depending on the result of comparison one of these outputs will go high.

Description : State any two application of each of following i) Comparator ii) Zero Crossing Comparator

Last Answer : Application of Comparator:  1. Null detectors: A null detector is one that functions to identify when a given value is zero. Comparators can be a type of amplifier distinctively for null comparison ... detector controls the switching so that it occurs at close to zero voltage of the cycle.

Description : In a control system, the comparator measures the difference between (a) output and input (b) output of controller and system (c) actual and desired performance (d) input and error signal  

Last Answer : B

Description : The output Y of a 2-bit comparator is logic 1 whenever the 2-bit input A is greater than the 2-bit input B. The number of combinations for which the output is logic 1, is  (A) 4 (B) 6 (C) 8 (D) 10

Last Answer : The output Y of a 2-bit comparator is logic 1 whenever the 2-bit input A is greater than the 2-bit input B. The number of combinations for which the output is logic 1, is 6

Description : Which circuit is used as amplitude comparator?

Last Answer : Schmitt trigger circuit is used as amplitude comparator.

Description : The number of comparators required in a 4 bit comparator type ADC is (A) 16 (B) 15 (C) 17 (D) 12

Last Answer : The number of comparators required in a 4 bit comparator type ADC is 15

Description : One input terminal of high gain comparator circuit is grounded and a sinusoidal voltage is applied to the other input. The output of comparator will be___________.

Last Answer : One input terminal of high gain comparator circuit is grounded and a sinusoidal voltage is applied to the other input. The output of comparator will be a square wave.

Description : What is meant by negative converter group in a cycloconverter?

Last Answer : The part of the cycloconverter circuit that permits the flow of current during negative half cycle of output current is called negative converter group.

Description : What is meant by positive converter group in a cycloconverter?

Last Answer : The part of the cycloconverter circuit that permits the flow of current during positive half cycle of output current is called positive converter group.

Description : Waveforms are described in terms of what two functions?

Last Answer : Amplitude and time.

Description : Waveforms are described in terms of what two functions?

Last Answer : Amplitude and time.

Description : What test equipment is designed to generate, modify, or measure a range of parameters of electronic functions of a specific nature required to test a single system or equipment?

Last Answer : Special-purpose electronic test equipment.

Description : What are the two functions of the servo motor in the system

Last Answer : To move the load and provide feedback data to the error detector.

Description : What types of diagrams are the most convenient from which to learn the basic Functions of a circuit?

Last Answer : Block or single-line diagram.

Description : What is a central set of programs called that manages the execution of other programs and performs common functions like read, write, and print?

Last Answer : Operating system.

Description : In first generation computers, internal processing functions were measured by what division of time?

Last Answer : Thousandths of a second (millisecond).

Description : What are computers called that combine the functions of both analog and digital computers?

Last Answer : Hybrid computers.

Description : Magnetic tape recorders can have up to three different heads installed. What are the three functions performed by a recorder's heads?

Last Answer : Record, reproduce, and erase.

Description : The control electronics component of a floppy or hard disk drive performs what three main functions?

Last Answer : a. Spins the disk at the correct speed. b. Moves the heads across the recording surface. c. Tells the write/read heads when to write data and when to read it.

Description : Hard disk drive transports contain the electromechanical parts that perform what three functions?

Last Answer : a. Rotates the hard disk platters. b. Writes data to and reads data from the disk platters

Description : What are the three functions of the magnetic heads on a magnetic recording device?

Last Answer : a. Record the signal onto the recording medium. b. Reproduce the signal from the recording medium. c. Erase the signal from the recording medium.

Description : Name two functions of the base of a vacuum tube.

Last Answer : It serves as a mounting for the tube elements and as the terminal connectio

Description : What four basic functions must a receiver perform?

Last Answer : Reception, selection, detection, and reproduction.

Description : What are the functions of cryptographic equipment?

Last Answer : To code or decode messages.

Description : What are the functions of a multicoupler?

Last Answer : Patching and filtering and permits the multiple use of receivers and/or transmitters on a single antenna.