Moving tube electrodes apart to decrease interelectrode  capacitance causes an increase in the effect of what property?

1 Answer

Answer :

Transit time

Related questions

Description : What type of feedback is usually caused by the base-to collector interelectrode capacitance?

Last Answer : Degenerative or negative

Description : What type of feedback is usually caused by interelectrode capacitance?

Last Answer : Negative (degenerative) feedback

Description : What happens to the impedance of interelectrode capacitance as frequency increases?

Last Answer : Impedance decreases.

Description : How does the addition of a screen grid in a tetrode reduce interelectrode capacitance?

Last Answer : The interelectrode capacitance (cpg) is divided between two series capacitances; thus, cpg is greatly reduced.

Description : What effect does an increase in capacitance have on a capacitor’s opposition to current flow?

Last Answer : Opposition to current flow decreases.

Description : As the tube filaments in the load heat up, will the circuit current increase or decrease?

Last Answer : Decrease.

Description : Trade-offs between competing effects are necessary for high speed response. Which competing effect (fast transit time, low capacitance, or high quantum efficiency) requires a thin active area?

Last Answer : Fast transit time.

Description : The Doppler effect causes a change in what aspect of rf energy that strikes a moving object?

Last Answer : Frequency.

Description : All of the following are true about neurogenic shock except: A. There is a decrease in systemic vascular resistance and an increase in venous capacitance. B. Tachycardia or bradycardia may be ... Severe head injury, spinal cord injury, and high spinal anesthesia may all cause neurogenic shock.

Last Answer : Answer: C DISCUSSION: Neurogenic shock occurs when severe head injury, spinal cord injury, or pharmacologic sympathetic blockade leads to sympathetic denervation and loss of vasomotor tone. ... of treatment. The use of alpha-adrenergic agonist is infrequently necessary to treat neurogenic shock

Description : The resistance furnace produces heat by the (A) Electric arc struck between electrodes and the charge (B) Flow of current through a heating element (C) Combination of induced current and skin effect (D) None of these

Last Answer : (B) Flow of current through a heating element

Description : When an unknown capacitance is tested with a bridge, what is the value of Cx if R1 equals 70 ohms, R2 equals 150 ohms, and Cs equals 550 microfarads?

Last Answer : 256 microfarads.

Description : When the reverse bias on a varactor is increased, what happens to the effective capacitance?

Last Answer : Capacitance decreases.

Description : A transmission line is said to have distributed constants of inductance, capacitance, and resistance along the line. What units of measurement are used to express these constants?

Last Answer : Inductance is expressed in micro henrys per unit length, capacitance is expressed in picofarads per unit length, and resistance is expressed in ohms per unit length.

Description : . What are two of the three physical factors that determine the values of capacitance and inductance of a transmission line?

Last Answer : (1) Type of line used, (2) dielectric in the line, and (3) length of line.

Description : Should the capacitance of the photodetector be kept small or large to prevent the RC time constant from limiting the response time?

Last Answer : Small

Description : What happens to the value of XC as capacitance increases

Last Answer : XC decreases.

Description : Examine the three capacitors shown below. What is the capacitance of each?

Last Answer : a. 26µF or 260,00pF b. 630pF c. 9600pF

Description : State three factors that affect the capacitance of a capacitor.

Last Answer : a. The area of the plates. b. The distance between the plates. c. The dielectric constant of the material between the plates.

Description : State three factors that affect the capacitance of a capacitor.

Last Answer : a. The area of the plates. b. The distance between the plates. c. The dielectric constant of the material between the plates.

Description : In a multicavity klystron, tuning all the cavities to the same frequency has what effect on the bandwidth of the tube?

Last Answer : The bandwidth decreases.

Description : The electron beam in a CRT is made to sweep from left to right across the screen. What tube element causes this sweeping motion?

Last Answer : The horizontal-deflection plate.

Description : The end of the usefulness of a tr tube is indicated by an increase in what quantity?

Last Answer : Recovery time.

Description : Name the components which greatly increase the weight of vacuum-tube circuitry.

Last Answer : Transformers, capacitors, and resistors.

Description : When a series voltage regulator is used to control output voltages, any increase in the input voltage results in an increase/a decrease (which one) in the resistance of the regulating device.

Last Answer : An increase.

Description : If the impedance of the choke is increased, will the ripple amplitude increase or decrease?

Last Answer : Decrease.

Description : Does a filter circuit increase or decrease the average output voltage?

Last Answer : A filter circuit increases the average output voltage

Description : If you increase the value of the capacitor, will the XC increase or decrease? Why?

Last Answer : It will decrease. Capacitance is inversely proportional to:

Description : If the inductance of a choke-input filter is increased, will the output ripple voltage amplitude (Er) increase or decrease?

Last Answer : Decrease.

Description : When a series voltage regulator is used to control output voltages, any increase in the input voltage results in an increase/a decrease in the resistance of the regulating device.

Last Answer : Increase.

Description : Does a filter circuit increase or decrease the average output voltage?

Last Answer : Increase.

Description : If you increase the value of the capacitor will the XC increase or decrease? Why?

Last Answer : Decrease-Capacitance is inversely proportional to XC.

Description : Will dark current increase or decrease as the temperature of the photodiode increases?

Last Answer : Increase.

Description : Will fiber coupling loss generally increase or decrease if the mode field diameter of a single mode fiber is decreased?

Last Answer : Increase.

Description : The number of modes propagated in a multimode fiber depends on core size and numerical aperture (NA). If the core size and the NA decrease, will the number of modes propagated increase or decrease?

Last Answer : Decrease.

Description : The fiber's normalized frequency (V) determines how many modes a fiber can support. As the value of V increases, will the number of modes supported by the fiber increase or decrease?

Last Answer : Increase.

Description : What causes the negative-resistance property of tunnel diodes?

Last Answer : The tunneling action

Description : What gyro property causes the gyro to remain in a fixed position?

Last Answer : Rigidity.

Description : Capacitance is the property of an electric circuit opposing a change in the _____________. A. current in the circuit B. voltage in the circuit C. inductance in the circuit D. resistance in the circuit

Last Answer : Answer: B

Description : The magnetostatics highly relies on which property? a) Resistance b) Capacitance c) Inductance d) Moment

Last Answer : c) Inductance

Description : . If a single tube pass heat exchanger is converted to two pass, then for the same flow rate, the pressure drop per unit length in tube side will (A) Increase by 1.8 times (B) Decrease by 2 2 (C) Increase by 2 16 (D) Remain unchanged

Last Answer : (C) Increase by 2 16

Description : In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate. (A) Increases (B) Decreases (C) Does not affect (D) May increase or decrease, depends on the type of baffle

Last Answer : (A) Increases

Description : Baffles in the shell side of a shell and tube heat exchanger (A) Increase the cross-section of the shell side liquid (B) Force the liquid to flow parallel to the bank (C) Increase the shell side heat transfer co-efficient (D) Decrease the shell side heat transfer co-efficient

Last Answer : (C) Increase the shell side heat transfer co-efficient

Description : In case of vertical tube evaporator, with increase in liquor level, the overall heat transfer co-efficient (A) Increases (B) Decreases (C) Is not affected (D) May increase or decrease; depends on the feed

Last Answer : (B) Decreases

Description : In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation ... Decrease (C) Remain unchanged (D) Either increase or decrease; depends on the coolant flow rate

Last Answer : (C) Remain unchanged

Description : Reynolds number for water flow through a tube of I.D. 5 cm is 1500. If a liquid of 5 centipoise viscosity and 0.8 specific gravity flows in the same pipe at the same velocity, then the pressure drop will (A) Increase (B) Decrease (C) Remain same (D) Data insufficient to predict pressure drop

Last Answer : (A) Increase

Description : With an increase in size of tube, the rise or depression of liquid in the tube due to surface tension will (A) Decrease (B) Increase (C) Remain unchanged (D) Depend upon the characteristics of liquid

Last Answer : Answer: Option A

Description : The rise or depression of liquid in a tube due to surface tension will increase in size of tube will (A) Increase (B) Remain unaffected (C) May increase or decrease depending on the characteristics of liquid (D) Decrease

Last Answer : Answer: Option D

Description : How far apart are the two holes in a simple directional coupler?

Last Answer : 1/4 wavelength.

Description : In order to increase the sensitivity of a moving coil galvanometer, one should decrease

Last Answer : In order to increase the sensitivity of a moving coil galvanometer, one should decrease A. the strength of ... in its coil D. the area of its coil

Description : If the voltage applied to a moving disk frequency meter decreases, while the applied frequency remains the same, the frequency indication will _____________. A. increase B. decrease C. remain the same D. oscillate

Last Answer : Answer: C