Description : A satellite transmitter operates at 4GHz with an antenna gain of 4dBi. The receiver 40000 km away has an antenna gain of 50 dBi. If the transmitter has a power of 8 W, find (ignoring feedline losses and mismatch) the EIRP in dBW. A. 50 B. 69 C. 49 D. 30
Last Answer : C. 49
Description : The presence of standing waves on a transmission line is the result of A. a high level of attenuation on the line. B. terminating the line by a resistive load equal in value to the surge impedance ... input power to below its critical level. D. an impedance mismatch between the load and the line.
Last Answer : D. an impedance mismatch between the load and the line.
Description : What is the result of an impedance mismatch in a waveguide?
Last Answer : Standing waves that cause power losses, a reduction in power handling capability, and an increase in frequency and sensitivity.
Description : Termination means A. result of disconnecting a line from a transmitter B. result of cutting both ends of a conductor C. looking back impedance of a line with no load D. load connected to the output end of a transmission line
Last Answer : D. load connected to the output end of a transmission line
Description : All the power sent down a transmission line from a transmitter can be transferred to an antenna under what optimum conditions?
Last Answer : When the characteristic impedance of the transmission line and the load impedance are equal.
Description : Standing waves occurs due to a) Impedance match b) Impedance mismatch c) Reflection d) Transmission
Last Answer : b) Impedance mismatch
Description : A final amplifier of a radio transmitter draws 250 mA of plate current when the plate supply voltage is 1400 volts. If the plate circuit efficiency is 80% and the transmitter is connected to an antenna having a feed impedance of 70 ohms, ... at the feed-point? A. 4.0 A B. 2.2 A C. 1.25 A D. 2.0 A
Last Answer : D. 2.0 A
Description : Referred to as a ferrite device that can be used in lieu of a duplexer to isolate a microwave transmitter and receiver when both are connected to the same antenna. A. Isolator B. Circulator C. Coupler D. Diode.
Last Answer : B. Circulator
Description : ______ is the first component of any MATV system to received broadcast signals. A. Receiver B. Antenna C. Filter D. Transmitter
Last Answer : B. Antenna
Description : ECE Board Exam March 1996 The capture area of an antenna is directly proportional to the A. frequency of the received signal B. distance between transmitter and receiver C. gain of the antenna D. power density of the signal
Last Answer : C. gain of the antenna
Description : Calculate the noise figure of the receiver whose RF amplifier has an input resistance of 1000Ω and an equivalent shot-noise resistance of 2000Ω, a gain of 25 and load resistance of 125 kΩ. Given that the bandwidth is 1. ... to an antenna with an impedance of 75Ω. A. 30.3 B. 3.03 C. 303 D. .303
Last Answer : A. 30.3
Description : If a transmission line has a power loss of 6 dB per 100 feet, what is the power at the feed point to the antenna at the end of a 200 foot transmission line fed by a 100 watt transmitter? A. 70 watts B. 50 watts C. 25 watts D. 6 watts
Last Answer : D. 6 watts
Description : It is an average power of a radio transmitter supplied to the antenna transmission line taken during a long sufficient interval of time and compared with the lowest frequency encountered in the modulation ... operating conditions. A. Carrier power B. Rated power C. Mean power D. Peak envelop power
Last Answer : C. Mean power
Description : Referred to as an average power from the radio transmitter supplied to the antenna transmission line taken during one radio frequency cycle under no modulation. A. Carrier power B. Rated power C. Peak envelop power D. Mean power
Last Answer : A. Carrier power
Description : Average power of a radio transmitter supplied to the antenna transmission line by a transmitter during one radio frequency cycle taken under the condition of no modulation. A. Peak envelop power B. Rated power C. Carrier power D. Mean power
Last Answer : C. Carrier power
Description : A device that radiates electromagnetic energy and or intercepts electromagnetic radation. A. Antenna B. Transmitter C. Transmission line D. Transceiver
Last Answer : A. Antenna
Description : What is meant by antenna gain? A. The final amplifier gain minus the transmission line losses (including any phasing lines present) B. The ratio of the amount of power produced by the antenna ... D. The numeric ratio relating the radiated signal strength of an antenna to that of another antenna
Last Answer : D. The numeric ratio relating the radiated signal strength of an antenna to that of another antenna
Description : What is included in the total resistance of an antenna system? A. Radiation resistance plus space impedance B. Radiation resistance plus transmission resistance C. Transmission line resistance plus radiation resistance D. Radiation resistance plus ohmic resistance
Last Answer : D. Radiation resistance plus ohmic resistance
Description : Transmission lines when connected to antenna have A. capacitive load B. resistive load whose resistance is less than characteristics impedance C. resistive load at the resonant frequency D. resistive load whose resistance is greater than the characteristic impedance of the line
Last Answer : C. resistive load at the resonant frequency
Description : What is the most likely problem if the transmitter shaft reads 0º when the receiver shaft indicates 180º?
Last Answer : The rotor leads on either the transmitter or the receiver are reversed.
Description : What is the relationship between the transmitter and receiver stator voltages when their rotors are in correspondence?
Last Answer : The voltages are equal and oppose each other.
Description : What is the physical difference between a synchro transmitter and a synchro receiver?
Last Answer : A synchro receiver uses some form of damping to retard excessive oscillations or spinning.
Description : Where should the transmitter spectrum be located with respect to the receiver response curve?
Last Answer : In the center.
Description : Immediately after the transmitter fires, stc reduces the receiver gain to what level?
Last Answer : Zero.
Last Answer : Standing-wave ratio (swr).
Description : What term is used for the end of the transmission line that is connected to a transmitter?
Last Answer : Input end, generator end, transmitter end, sending end, and source.
Description : The actions of the tr and atr circuits depend on the impedance characteristics of what length of transmission line?
Last Answer : Quarter-wavelength section
Description : In swept-frequency testing the impedance of a transmission line, what electrical characteristic is actually being measured?
Last Answer : Swr on the transmission line.
Description : In some cases, it’s also hard to map an object to XML (e.g., an object graph with cyclic references) because there’s actually an impedance mismatch between an object model and an XML model. a) True b) False
Last Answer : True
Description : What connecting link is used to transfer energy from a radio transmitter to its antenna located on
Last Answer : Transmission line.
Description : The total propagation delay time from transmission to reception of signals from a ground transmitter to ground receiver with angle of elevation at 10 degrees respectively is A. 273 ms B. 239 ms C. 275 ms D. 260 ms
Last Answer : A. 273 ms
Description : What is the delay time for satellite transmission from earth transmitter to earth receiver? A. 0.5 s B. 1.0 s C. 5 ms D. 0.25 ms
Last Answer : A. 0.5 s
Description : What type of transmission line is often used to connect a television set to its antenna?
Last Answer : Twin lead.
Description : What term is used for the end of the transmission line that is connected to an antenna?
Last Answer : Output end, receiving end, load end and sink.
Description : An antenna efficiency is computed by using one of the following equations. A. Efficiency = (radiation resistance / transmission resistance) B. Efficiency = (total resistance / radiation resistance) x ... / transmitter output) x 100% D. Efficiency = (radiation resistance / total resistance) x 100%
Last Answer : D. Efficiency = (radiation resistance / total resistance) x 100%
Description : What is meant by the term antenna efficiency? A. Efficiency = effective radiated power/transmitter output x 100% B. Efficiency = radiation resistance/ transmission resistance C. Efficiency = total resistance/radiation resistance x 100% D. Efficiency = radiation resistance/total resistance x 100%
Last Answer : D. Efficiency = radiation resistance/total resistance x 100%
Description : What transmission method uses a stable cw reference oscillator, which is locked in phase with the transmitter frequency?
Last Answer : Pulse-Doppler.
Description : Which of the following statement(s) is/are true concerning the pathophysiology of gas exchange? a. Hypoventilation in relation to perfusion can result in an oxygen saturation of less than 100% ... does not occur under normal circumstances d. The normal arterial oxygen saturation should be 100%
Last Answer : Answer: a, b Under normal conditions, red blood cells in the pulmonary capillaries become fully saturated and oxygen dissolves in plasma resulting in blood PO2 of 100 and O2 saturation of 100%. This ... the fact that normal arterial PO2 is 90-100 mm Hg and the normal O2 saturation is 98%
Description : How can intermodulation interference between two transmitters in close proximity reduced or eliminated? A. Through installing a band-pass filter in the antenna feed line B. Through installing terminated circulator ... high driving power D. By installing a low-pass filter in the antenna feed line
Last Answer : A. Through installing a band-pass filter in the antenna feed line
Description : A single conductor running from the transmitter to the antenna. A. RG-8/U B. Single line wire C. Twin-lead D. MIcrostrip
Last Answer : B. Single line wire
Description : What is meant by the term radiation resistance for an antenna? A. The resistance in the trap coils to received signal B. An equivalent resistance that would dissipate the same amount of power as ... antenna C. The specific impedance of the antenna D. Losses in the antenna elements and feed line
Last Answer : B. An equivalent resistance that would dissipate the same amount of power as that radiated from an antenna
Description : What is the maximum line-of-sight distance between a paging antenna 250 ft high and a pager receiver 3.5ft of the ground? A. 25 km B.25mi C. 70.73 km D. 70.73 mi
Last Answer : B.25mi
Description : What symbol is used to designate the characteristic impedance of a line, and what two variables does it compare?
Last Answer : Z0 and it is the ratio of E to I at every point along the line.
Description : A basic touch screen has three main components. It includes touch sensor, controller and ________ A. transmitter B. receiver C. software driver D. None of the Above
Last Answer : C. software driver
Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration turned opposite of those in the transmitter by design, what corrective action should be taken? EL-0092 A. Reverse the 60 Hz supply ... is needed. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.
Last Answer : Answer: B
Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration were in 180 degree error with those of the transmitter, what corrective action should be taken? EL-0092 A. Reverse the 60 Hz ... is proper operation. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.
Last Answer : Answer: A
Description : If coil 'R1-R2' at the receiver of figure 'A' shown in the illustration were in 180 degree error with respect to that of the transmitter, what corrective action should be taken? EL-0092 A. No action is ... and 'R2'. C. Interchange connections 'S1' and 'S2'. D. Interchange connections 'S1' and 'S3'.
Description : If coils 'R1-R2-R3' at the receiver of figure 'B' shown in the illustration turned opposite of those in the transmitter, what corrective action should be taken to have both turn in the same direction? EL-0092 A ... is needed. C. Interchange leads 'R1' and 'R3'. D. Interchange leads 'R2' and 'R3'.
Last Answer : Answer: C
Description : If coil 'R1-R2' at the receiver of figure 'A' shown in the illustration turned opposite of that in the transmitter, what corrective action should be taken? EL-0092 A. No action is necessary as this is ... . C. Interchange connections to 'S1' and 'S2'. D. Interchange connections to 'S1' and 'S3'.
Last Answer : Answer: D
Description : If coil 'R1-R2' on the transmitter in figure 'A' shown in the illustration is turned 30 degrees clockwise, corresponding coil 'R1-R2' on the receiver should ____________. EL-0092 A. make coils 'S1 ... a higher voltage depending on the turns ratio D. align itself to the same position if free to move