Description : A receiver is located 64 km from a space wave transmitting antenna that is 100 meters high. Find the required height of the receiving antenna. A. 36 meters high B. 64 meters high C. 100 meters high D. 182.25 meters high
Last Answer : A. 36 meters high
Description : A final amplifier of a radio transmitter draws 250 mA of plate current when the plate supply voltage is 1400 volts. If the plate circuit efficiency is 80% and the transmitter is connected to an antenna having a feed impedance of 70 ohms, ... at the feed-point? A. 4.0 A B. 2.2 A C. 1.25 A D. 2.0 A
Last Answer : D. 2.0 A
Description : How far away is the radio horizon of an antenna 100ft high? A. 14.14 mi B. 40km C. 14.14 km D. 40 mi
Last Answer : A. 14.14 mi
Description : The length of a Marconi antenna to operate with 985 kHz is ______. A. 200 ft B. 500 ft C. 250 ft D. 999 ft
Last Answer : C. 250 ft
Description : If a transmitting antenna is 100 meters high and a separate receiving antenna is 64 meters high, what is the maximum space wave communication distance possible between them? A. 18 km B. 72 km C. 164 km D. 656 km
Last Answer : B. 72 km
Description : A satellite transmitter operates at 4GHz with an antenna gain of 4dBi. The receiver 40000 km away has an antenna gain of 50 dBi. If the transmitter has a power of 8 W, find (ignoring feedline losses and mismatch) the EIRP in dBW. A. 50 B. 69 C. 49 D. 30
Last Answer : C. 49
Description : What is the path attenuation between transmitter and receiver at a frequency of 1.2 Ghz and a distance of 11,000 mi? A. 119 dB B. 115dB C. 179dB D. 174dB
Last Answer : C. 179dB
Description : If a transmission line has a power loss of 6 dB per 100 feet, what is the power at the feed point to the antenna at the end of a 200 foot transmission line fed by a 100 watt transmitter? A. 70 watts B. 50 watts C. 25 watts D. 6 watts
Last Answer : D. 6 watts
Description : ECE Board Exam March 1996 The capture area of an antenna is directly proportional to the A. frequency of the received signal B. distance between transmitter and receiver C. gain of the antenna D. power density of the signal
Last Answer : C. gain of the antenna
Description : Calculate the noise figure of the receiver whose RF amplifier has an input resistance of 1000Ω and an equivalent shot-noise resistance of 2000Ω, a gain of 25 and load resistance of 125 kΩ. Given that the bandwidth is 1. ... to an antenna with an impedance of 75Ω. A. 30.3 B. 3.03 C. 303 D. .303
Last Answer : A. 30.3
Description : For a space wave transmission, the radio horizon distance of a receiving antenna with a height of 64 meters is approximately A. 8 km B. 32 km C. 64 km D. 256 km
Last Answer : B. 32 km
Description : The angle of elevation of the antenna beam is 20°. Calculate the transmission-path distance for an ionospheric transmission that utilizes a layer of virtual height 200 km. Use flat-earth approximation. A. 966 km B. 2100 km C. 1100 km D. 405 km
Last Answer : C. 1100 km
Description : For a space wave transmission, the radio horizon distance of a transmitting antenna with a height of 100 meters is approximately: A. 10 km B. 40 km C. 100 km D. 400 km
Last Answer : B. 40 km
Description : What is the end impedance of a half-wave dipole? A. 73 Ω B. 72 Ω C. 250 Ω D. 2500 Ω
Last Answer : D. 2500 Ω
Description : The input terminal impedance at the center of a folded dipole antenna is A. 72 Ω B. 300 Ω C. 50 Ω D. 73 Ω
Last Answer : B. 300 Ω
Description : The noise from an airplane engine 100 ft from an observer is found to have an intensity of 45dB. What will be the intensity when the plane flies overhead at an altitude of 1 mi? A. 10.5 dB B. 34.5 dB C. 35 dB D. 20.5 dB
Last Answer : A. 10.5 dB
Description : Anitha travels 400 km by bus at 70 km/hr, 600 km by train at 80km/hr, 250 km by bike at 60 km/hr and 50 kn by car at 40 km/hr. what is the average speed for the total distance? a) 68.45 b) 69.45 c) 67.45 d) 69.77
Last Answer : D Total distance = (400+250+50+600)km =1300 km Total time taken = (400/70 + 600/80+250/60+50/40) hrs =(40/7 +60/8+25/6+5/4) =(24*40)+(21*60)+(28*25)+(42*5) / 168 =960+1260+700+210 / 168 =(3130 / 168) Average speed =(1300*168 / 3130) km/hr =218400/3130 =69.77 km/hr
Description : ECE Board Exam March 1996 When the transmitting and receiving antennas are in line-of-sight of each other, the mode of propagation is ________ wave. A. space or direct B. ground C. surface D. sky
Last Answer : A. space or direct
Description : I'm build a 4500sq ft pad with a 5ft elevation, how much dirt will I need?
Last Answer : Need Answer
Description : _________ detects the satellite signal relayed from the feed and converts it to an electric current, amplifies and lower its frequency. A. Horn antenna B. LNA C. Satellite receiver D. Satellite dish
Last Answer : B. LNA
Description : A receiver connected to an antenna whose resistance is 50 Ω has an equivalent noise resistance of 30Ω. Calculate its equivalent noise temperature if the noise figure is equal to 1.6. A. 17.4 K B. 174K C. 1.74K D. 17K
Last Answer : B. 174K
Description : What consists the front-end circuit of a VHF TV superheterodyne receiver? A. Mixer, RF amplifier and AFC? B. RF amplifier, Band pass filter and mixer C. Local oscillator, mixer and RF amplifier D. Local oscillator, AGC and antenna
Last Answer : C. Local oscillator, mixer and RF amplifier
Description : Which of the following parts of the radio receiver represent the component that extracts the desire RF signal from the electromagnetic wave? A. AF amplifier B. Antenna C. Detector D. Crystal
Last Answer : B. Antenna
Description : Refers to one of the front end circuit of a VHF TV superheterodyne receiver which is usually a separate circuit coupled to the mixer. A. Antenna feed B. AGC C. RF amplifier D. Local oscillator
Last Answer : D. Local oscillator
Description : What do you call the single booster installed on the antenna dish of satellite receiver? A. Low noise amplifier B. Single amplifier C. Noise amplifier D. Rectifier
Last Answer : A. Low noise amplifier
Description : Referred to as a ferrite device that can be used in lieu of a duplexer to isolate a microwave transmitter and receiver when both are connected to the same antenna. A. Isolator B. Circulator C. Coupler D. Diode.
Last Answer : B. Circulator
Description : ______ is the first component of any MATV system to received broadcast signals. A. Receiver B. Antenna C. Filter D. Transmitter
Description : Collects very weak signal from a broadcast satellite A. Satellite dish B. LNB C. Yagi-Uda antenna D. Satellite receiver
Last Answer : A. Satellite dish
Description : ECE Board Exam March 1996 What is the purpose of the receiver's squelch circuit? A. To overcome fluctuations in the level the RF signal arriving at the receiver antenna B. To prevent ... signals D. To prevent amplified noise from reaching the loudspeaker during the absence of an incoming signal
Last Answer : D. To prevent amplified noise from reaching the loudspeaker during the absence of an incoming signal
Description : ECE Board Exam March 1996 A receiver connected to an antenna whose resistance is 50 ohms has an equivalent noise resistance of 30 ohms. What is the receiver’s noise temperature? A. 754 K B. 464 K C. 174 K D. 293 K
Last Answer : C. 174 K
Description : A shunt-fed quarter-wavelength Marconi antenna A. has maximum RF impedance to ground at its feedpoint B. has a current null at its feedpoint C. has a zero DC resistance to ground D. has zero RF resistance to ground
Last Answer : C. has a zero DC resistance to ground
Description : Which of the cable length has the highest attenuation? a. 1 km b. 2 km c. 95 ft d. 5500 ft
Last Answer : b. 2 km
Description : What is the orbit height of a GPS satellite? A. 10,898 nmi B. 10,898 mi C. 10,898 km D. 10, 898 m
Last Answer : A. 10,898 nmi
Description : If L is the length of vehicles in metres, C is the clear distance between two consecutive vehicles (stopping sight distance), V is the speed of vehicles in km/hour, the maximum number N of vehicles/hour, is (A) N = 1000 V / (L + C ... ) / 1000 V (C) N = 1000 L / (C + V) (D) N = 1000 C / (L + V)
Last Answer : Answer: Option A
Description : What is the estimated medium wind loading in the Philippines for antenna tower design? A. 300 kph B. 100 kph C. 200 kph D. 250 kph
Last Answer : C. 200 kph
Description : What is the estimated medium wind loading in the Philippines for antenna tower design? A. 200 kph B. 250 kph C. 300 kph D. 100 kph
Last Answer : A. 200 kph
Description : The maximum head that can be developed by a single impeller is __________ ft. (A) 25 (B) 100 (C) 250-300 (D) 1000
Last Answer : (C) 250-300
Description : The sound power level of a jet plane flying at a height of 1 km is 160 dB. What is the maximum sound pressure level on the ground directly below the plane assuming that the aircraft radiates sound equally in all directions? A. 59.1 dB B. 69.1 dB C. 79.1 dB D. 89.1 dB
Last Answer : D. 89.1 dB
Description : A loudspeaker cabinet has an internal volume of 5,184 in3 (84,950 cm3 ). It has a port area on the baffle of 50 in2 (322.58cm2 ) and a thickness of 0.70 in (18 mm). What is the Helmholtz resonance, in hertz, of this loudspeaker enclosure? A. 250 Hz B. 245 Hz C. 240 Hz D. 255 Hz
Last Answer : C. 240 Hz
Description : During the night when the F2 layer combines with F1 layer it falls to what approximate height? A. 250 km B. 350 km C. 300 km D. 400 km
Last Answer : C. 300 km
Description : A radio communications link is to be established via the ionosphere. The maximum virtual height of the layer is 100 km at the midpoint of the path and the critical frequency is 2 MHz. The distance between stations is 600 ... optimum working frequency? A. 6.32 MHz B. 2.1 MHz C. 5.4 MHz D. 1.8 MHz
Last Answer : C. 5.4 MHz
Description : Part of a microwave link can be approximated by free space conditions. The antenna gain are each 40 dB, the frequency is 10 GHz, and the path length is 80 km. Calculate the receive power for a transmitted power of 10 W? A. 0.871 μW B. 871 μW C. 0.871 mW D. 871 nW
Last Answer : A. 0.871 μW
Description : The total propagation delay time from transmission to reception of signals from a ground transmitter to ground receiver with angle of elevation at 10 degrees respectively is A. 273 ms B. 239 ms C. 275 ms D. 260 ms
Last Answer : A. 273 ms
Description : Which of the following is not one of the natural ways a radio wave may travel from transmitter to receiver? A. Ground wave B. Micro wave C. Sky wave D. Space wave
Last Answer : B. Micro wave
Description : ECE Board Exam March 1996 A car horn outdoors produces a sound intensity level of 90 dB at 10 ft away. At this distance, what is the sound power in watt? A. 12 W B. 0.12 W C. 0.012 W D. 1.2 W
Last Answer : C. 0.012 W
Description : If the count of Echinochloa in weedy check is 70 and that in a treatment 25/m2, weed control efficiency will be a). 54.3% b). 64.3% c). 73.4% d). 79.6%
Last Answer : b). 64.3%
Description : What limits the sensitivity of a receiver? A. The power supply of the receiver B. The power output of a transmitter C. The noise floor of the receiver D. The distance between the transmitter and receiver
Last Answer : C. The noise floor of the receiver
Description : Which antenna does not use the ground? A. Marconi B. Yagi C. Hertz D. Rhombic
Last Answer : B. Yagi
Description : One of the following is not a reason for the use of an earth mat A. impossibility of a good ground connection B. provision of an earth for the antenna C. protection of personnel working underneath D. improvement of the radiation pattern of the antenna
Last Answer : C. protection of personnel working underneath
Description : Indicate which of the following reasons for using metal counterpoise with antennas is false. A. Impossibly of a good ground connection B. Protection of personnel working underneath C. Provision of an earth for the antenna D. Rockiness of the ground itself
Last Answer : B. Protection of personnel working underneath