At what points along a transmission line will a neon lamp glow the brightest?

Question

At what points along a transmission line will a neon lamp glow the brightest?

asked Aug 20, 2021 by anonymous

1 Answer

Related questions

Description : Neon Glow Sticks

Last Answer : Glow sticks are not only useful in different party situations, the neon light they emit also open doors to artistry and creative expressions. Although a glow stick cannot be recharged, the glow lasts for a ... , so why ingest it? The newer glow sticks being produced today are said to be non-toxic.

After turning on the fluorescent lamp shown in the illustration, you note that the ends of the tube alternately glow and becomce dark without illuminating the center. The most obable cause for this is that ____________. EL-0081 A. component 'D' is loose and due to the ship's vibrations makes and breaks contact B. the power system's voltage is fluctuating in and out of the range necessary for proper operation C. component 'A' is shorted and therefore unable to produce the high voltage required to start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Description : After turning on the fluorescent lamp shown in the illustration, you note that the ends of the tube alternately glow and becomce dark without illuminating the center. The most obable cause for ... the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Last Answer : Answer: C

The illustration shows a fluorescent light fixture. The ends of the lamp alternately glow and become dark, but the tube will not light. The most probable cause is that ____________. EL-0081 A. component 'D' is loose and due to the ship's vibrations makes and breaks contact B. the power system's voltage is fluctuating in and out of the range necessary for proper operation C. component 'A' is shorted and therefore unable to produce the high voltage required to start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Description : The illustration shows a fluorescent light fixture. The ends of the lamp alternately glow and become dark, but the tube will not light. The most probable cause is that ____________. EL-0081 ... start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Last Answer : Answer: C

During start-up of the circuit shown in the illustration, it is noted that the ends of component 'C' alternately glow and become dark without the tube illuminating. The most probable cause for this is that ____________. EL-0081 A. component 'D' is loose and due to the ship's vibrations makes and breaks contact B. the power system's voltage is fluctuating in and out of the range necessary for proper operation C. component 'A' is shorted and therefore unable to produce the high voltage required to start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Description : During start-up of the circuit shown in the illustration, it is noted that the ends of component 'C' alternately glow and become dark without the tube illuminating. The most probable cause ... start the lamp D. component 'B' contacts are opening and closing thus prohibiting sufficient current flow

Last Answer : Answer: C

If one lamp is connected between two phases will it glow or not?

Description : If one lamp is connected between two phases will it glow or not?

Last Answer : A:If the voltage between the two phase is equal to the lamp voltage then the lamp will glow. When the voltage difference is big it will damage the lamp and when the difference is smaller the lamp will glow depending on the type of lamp.

If 200w, 100 w and 60 w lamps connected in series with 230V AC , which lamp glow brighter? Each lamp voltage rating is 230V.

Description : If 200w, 100 w and 60 w lamps connected in series with 230V AC , which lamp glow brighter? Each lamp voltage rating is 230V.

Last Answer :  Each bulb when independently working will have currents (W/V= I)  For 200 Watt Bulb current (I200) =200/230=0.8696 A  For 100 Watt Bulb current (I100) =100/230=0.4348 A  ... current through it. So minimum power dissipated across it as min current X equal Voltage across =s min power dissipation

If one lamp connects between two phases it will glow or not?

Description : If one lamp connects between two phases it will glow or not?

Last Answer : If the voltage between the two phases is equal to the lamp voltage then the lamp will glow.  When the voltage difference is big it will damage the lamp and when the difference is smaller the lamp will glow depending on the type of lamp.

A transmission line is said to have distributed constants of inductance, capacitance, and resistance along the line. What units of measurement are used to express these constants?

Description : A transmission line is said to have distributed constants of inductance, capacitance, and resistance along the line. What units of measurement are used to express these constants?

Last Answer : Inductance is expressed in micro henrys per unit length, capacitance is expressed in picofarads per unit length, and resistance is expressed in ohms per unit length.

To measure incident power, you must rotate the coupler detector of the wattmeter so that the arrow indicating power flow points toward which end of the transmission line?

Description : To measure incident power, you must rotate the coupler detector of the wattmeter so that the arrow indicating power flow points toward which end of the transmission line?

Last Answer : Load.

What term is used for the ability of a spot on a CRT screen to continue to glow after the electron bean has struck it and moved away?

Description : What term is used for the ability of a spot on a CRT screen to continue to glow after the electron bean has struck it and moved away?

Last Answer : Persistence.

The circuit illustrated represents a single phase AC ground detecting system. If a ground occurs on line 'B', which of the lamps will burn the brightest? EL-0008 A. X B. Y C. Both will be equal brightness. D. both will go out.

Description : The circuit illustrated represents a single phase AC ground detecting system. If a ground occurs on line 'B', which of the lamps will burn the brightest? EL-0008 A. X B. Y C. Both will be equal brightness. D. both will go out.

Last Answer : Answer: A

The distance from a radar set to a target measured along the line of sight is identified by what term?

Description : The distance from a radar set to a target measured along the line of sight is identified by what term?

Last Answer : Range.

A lamp is hanging along the axis of a circular table of radius r. at what height should the lamp be placed above the table so that the intensity of il

Description : A lamp is hanging along the axis of a circular table of radius r. at what height should the lamp be placed above the table so that the intensity of il

Last Answer : A lamp is hanging along the axis of a circular table of radius r. at what height should the lamp be placed ... is `(1)/(8)` of that at its centre ?

What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?

Description : What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?

Last Answer : Pulse width

The actions of the tr and atr circuits depend on the impedance characteristics of what length of transmission line?

Description : The actions of the tr and atr circuits depend on the impedance characteristics of what length of transmission line?

Last Answer : Quarter-wavelength section

What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?

Description : What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?

Last Answer : Pulse width.

Is it possible for a transmission line to operate improperly at certain frequencies and properly at others?

Description : Is it possible for a transmission line to operate improperly at certain frequencies and properly at others?

Last Answer : Yes, it is quite common.

What are the two common causes of transmission-line deterioration?

Description : What are the two common causes of transmission-line deterioration?

Last Answer : Corrosive effects of salt water and weather extremes.

What is the result of an impedance mismatch between a receiver or transmitter and its transmission line or antenna?

Description : What is the result of an impedance mismatch between a receiver or transmitter and its transmission line or antenna?

Last Answer : High vswr, which equates to poor reception or a loss of power output.

On an open-ended transmission line, the voltage is always zero at what distance from each end of the line?

Description : On an open-ended transmission line, the voltage is always zero at what distance from each end of the line?

Last Answer : One-fourth the distance from each end of the line.

Two types of waves are formed on a transmission line. What names are given to these waves?

Description : Two types of waves are formed on a transmission line. What names are given to these waves?

Last Answer : Incident waves from generator to load. Reflected waves from load back to generator.

All the power sent down a transmission line from a transmitter can be transferred to an antenna under what optimum conditions?

Description : All the power sent down a transmission line from a transmitter can be transferred to an antenna under what optimum conditions?

Last Answer : When the characteristic impedance of the transmission line and the load impedance are equal.

Describe the leakage current in a transmission line and in what unit it is expressed.

Description : Describe the leakage current in a transmission line and in what unit it is expressed.

Last Answer : The small amount of current that flows through the dielectric between two wires of a transmission line and is expressed in micro ohms per unit length.

. What are two of the three physical factors that determine the values of capacitance and inductance of a transmission line?

Description : . What are two of the three physical factors that determine the values of capacitance and inductance of a transmission line?

Last Answer : (1) Type of line used, (2) dielectric in the line, and (3) length of line.

What must the physical length of a transmission line be if it will be operated at 15,000,000 Hz?

Description : What must the physical length of a transmission line be if it will be operated at 15,000,000 Hz?

Last Answer : . λ = 20 meters

What are the three types of line losses associated with transmission lines?

Description : What are the three types of line losses associated with transmission lines?

Last Answer : Copper, dielectric, and radiation.

What type of transmission line is often used to connect a television set to its antenna?

Description : What type of transmission line is often used to connect a television set to its antenna?

Last Answer : Twin lead.

What term is used for the end of the transmission line that is connected to an antenna?

Description : What term is used for the end of the transmission line that is connected to an antenna?

Last Answer : Output end, receiving end, load end and sink.

What term is used for the end of the transmission line that is connected to a transmitter?

Description : What term is used for the end of the transmission line that is connected to a transmitter?

Last Answer : Input end, generator end, transmitter end, sending end, and source.

In swept-frequency testing the impedance of a transmission line, what electrical characteristic is actually being measured?

Description : In swept-frequency testing the impedance of a transmission line, what electrical characteristic is actually being measured?

Last Answer : Swr on the transmission line.

What is the main advantage of using a time-domain reflectometer (tdr) to test a transmission line?

Description : What is the main advantage of using a time-domain reflectometer (tdr) to test a transmission line?

Last Answer : Tdr will indicate the nature of and the distance to or location of any faults.

Why is the physical length of a coaxial cable transmission line shorter than its electrical length?A. Skin effect is less pronounced in the coaxial cable B. RF energy moves slower along the coaxial cable C. The surge impedance is higher in the parallel feed line D. The characteristic impedance is higher in the parallel feed line

Description : Why is the physical length of a coaxial cable transmission line shorter than its electrical length? A. Skin effect is less pronounced in the coaxial cable B. RF energy moves slower along the ... higher in the parallel feed line D. The characteristic impedance is higher in the parallel feed line

Last Answer : B. RF energy moves slower along the coaxial cable

Thevelocityfactor of a transmissionline a. depends on the dielectric constant of the material used b. increases the velocity along the transmission line c. is govern by the skin effect d. is higher for a solid dielectric than for air

Description : Thevelocityfactor of a transmissionline a. depends on the dielectric constant of the material used b. increases the velocity along the transmission line c. is govern by the skin effect d. is higher for a solid dielectric than for air

Last Answer : a. depends on the dielectric constant of the material used

For enhancing the power transmission in along EHV transmission line, the most preferred method is to

Description : For enhancing the power transmission in along EHV transmission line, the most preferred method is to connect a (A) Series inductive compensator in the line (B) Shunt inductive compensator at the ... (C) Series capacitive compensator in the line (D) Shunt capacitive compensator at the sending end

Last Answer : For enhancing the power transmission in along EHV transmission line, the most preferred method is to connect a Series capacitive compensator in the line

What is the brightest flashlight money can buy?

Description : What is the brightest flashlight money can buy?

Last Answer : I have a MAX-Light and it is 2,000,000 (two-million) candlepower and can shine several miles.

The brightest moon of the year?

Description : The brightest moon of the year?

Last Answer : we are getting a big snow storm, yaaaaaaaaaaaa

What is the smallest, yet brightest, consumer flashlight out there?

Description : What is the smallest, yet brightest, consumer flashlight out there?

Last Answer : try some of the dive lights like pelican or UK lights. Boy can they pack a punch

I am nothing, I am everything. I am perfect dark, I am the brightest lights. I am hungry, I am full. I am nowhere, I am everywhere. I am unseen, I am watched by millions. What am I? -Riddles

Description : I am nothing, I am everything. I am perfect dark, I am the brightest lights. I am hungry, I am full. I am nowhere, I am everywhere. I am unseen, I am watched by millions. What am I? -Riddles

Last Answer : The universe.

Which is the brightest planet? -General Knowledge

Description : Which is the brightest planet? -General Knowledge

Last Answer : answer:

Which is the brightest planet? -General Knowledge

Description : Which is the brightest planet? -General Knowledge

Last Answer : answer:

What is the brightest planet? -General Knowledge

Description : What is the brightest planet? -General Knowledge

Last Answer : answer:

Which is the brightest planet visible from Earth? -General Knowledge

Description : Which is the brightest planet visible from Earth? -General Knowledge