What is meant by diode ratings?

1 Answer

Answer :

They are the limiting values of operating conditions outside  which operations could cause diode damage.

Related questions

Description : what should be the minimum wattage ratings of R 3 and R 5 ?

Last Answer : R3 = 2 watts; R5 = 6 watts.

Description : What are the three time delay ratings for circuit breakers?

Last Answer : Instantaneous, short time delay, and long time delay.

Description : What are the voltage and current ratings for a fuse designated

Last Answer : a. 125 volts or less, 1/16 ampere b. 250 volts or less, .15 ampere

Description : What are the voltage, current, and time delay ratings for a fuse with the designation

Last Answer : a. 125 volts or less, 1.5 amperes, delay b. 250 volts or less, 1/8 ampere standard

Description : What is the relative length of the time constant for the diode capacitor combination in a damper (long or short)?

Last Answer : Short time constant.

Description : What is the condition of the diode in a series limiter when an output is developed? In a parallel limiter?

Last Answer : Conducting, cutoff.

Description : In the tunnel diode, the tunneling current is at what level when the forbidden gap of the N-type material is at the same energy level as the empty states of the P-type material?

Last Answer : Minimum.

Description : Why is electron flow with the arrow in the symbol of a Zener diode instead of against the arrow as it is in a normal diode?

Last Answer : Because Zener diodes are operated in the reverse bias mode.

Description : During avalanche effect breakdown, what limits current flow through the diode?

Last Answer : an external current-limiting resistor

Description : What is the doping level of an avalanche effect diode when compared to the doping level of a Zener-effect diode?

Last Answer : The doping level of an avalanche effect diode is lower.

Description : What is the name of the simplest type of rectifier which uses one diode?

Last Answer : The half-wave rectifier.

Description : When checking a diode with an ohmmeter, what is indicated by two high resistance measurements?

Last Answer : The diode is open or has a high-forward resistance.

Description : What is the greatest threat to a diode?

Last Answer : Heat.

Description : What type of diode has orange, blue, and gray bands?

Last Answer : 1N368.

Description : What is used to show how diode parameters vary over a full operating range?

Last Answer : A characteristic curve.

Description : What type of bias makes a diode act as a closed switch?

Last Answer : Forward bias.

Description : What type of PN diode is formed by using a fine metal wire and a section of N-type semiconductor material?

Last Answer : Point-contact.

Description : In reference to the schematic symbol for a diode, do electrons flow toward or away from the arrow?

Last Answer : Toward the arrow.

Description : What is the purpose of a PN junction diode?

Last Answer : To convert alternating current into direct current

Description : For a diode to act as a rectifier, should it be connected in series or parallel with the load?

Last Answer : Series.

Description : What term is used to describe the period when the diode is not conducting?

Last Answer : Cutoff.

Description : Describe the output of a laser diode.

Last Answer : The LD's output has a narrow spectral width and small output beam angle.

Description : Why would a laser diode be used in a low-data-rate digital application?

Last Answer : When extremely high transmitter output powers are required.

Description : Is the drive circuitry generally more complex for an LED or a laser diode? Why?

Last Answer : For a laser diode. The laser diode transmitter generally contains output power control circuitry and may contain a TE cooler and some circuitry associated with the TE cooler.

Description : What is the typical back-to-forward resistance ratio of a good-quality diode?

Last Answer : 10-to-1 ratio.

Description : At frequencies above 100 megahertz, the intrinsic (i) region causes a pin diode to act as what?

Last Answer : Variable resistance.

Description : What are the most important advantages of the Schottky barrier diode?

Last Answer : Lower forward resistance and low noise.

Description : What is the capacitive reactance across a point-contact diode as compared to a normal junction diode?

Last Answer : Lower.

Description : During the manufacture of a point-contact diode, what is the purpose of passing a relatively large current from the catwhisker to the silicon crystal?

Last Answer : . To form a small region of p-type material

Description : What causes dc bias energy to be absorbed by avalanche electrons and given up to the microwave field applied to an avalanche transit-time diode?

Last Answer : The negative-resistance property.

Description : What is the junction arrangement of the original avalanche transit-time diode?

Last Answer : Pnin.

Description : What limits the usefulness of high-gain, tunnel-diode frequency converters?

Last Answer : Stability problems.

Description : What is the purpose of the circulator in a tunnel-diode amplifier?

Last Answer : Prevent feedback to the tuned input circuit.

Description : Why is the tunnel diode loosely coupled to the cavity in a tunnel-diode oscillator?

Last Answer : To increase the stability.

Description : The pin diode is primarily used for what purpose?

Last Answer : A switching device.

Description : What determines the frequency of a tunnel-diode oscillator?

Last Answer : The tuned circuit or cavity frequency.

Description : What is the primary difference between a diode and a triode?

Last Answer : The triode contains a third element called the control rid.

Description : A large negative voltage is applied to the plate of a diode, and a largewhat tube parameter has been exceeded?

Last Answer : Peak Inverse Voltage (PIV).

Description : An ac voltage is applied across a diode. The tube will conduct when

Last Answer : Positive.

Description : Before a diode will conduct, the cathode must be what polarity relative

Last Answer : Negative.

Description : Name the two series circuits that exist in a diode circuit.

Last Answer : Filament and plate.

Description : which components act as the filter network in the diode detector?

Last Answer : C1 and R1.

Description : How does the current-diode detector differ from the voltage-diode detector?

Last Answer : The current-diode detector is in parallel with the input and load.

Description : What is the function of the diode in a series-diode detector?

Last Answer : Rectifies the rf pulses in the received signal.

Description : What does the simplest diode detector use to reproduce the modulating frequency?

Last Answer : The modulation envelope.

Description : As a rule of thumb, what is an acceptable ratio of back-to forward resistance for a diode?

Last Answer : Greater than 10 to 1

Description : Prior to substituting a diode, what measurements should you take to determine its condition?

Last Answer : Voltages and resistances.

Description : What is meant by "exciting current" in a transformer?

Last Answer : Exciting current is the current that flows in the primary of a transformer with the secondary open (no load attached).

Description : What is meant is "transformer action"?

Last Answer : The transfer of energy from one circuit to another circuit by electromagnetic induction.

Description : What is meant by the term "multipath"?

Last Answer : A term used to describe the multiple patterns a radio wave may follow.