As a rule of thumb, what is an acceptable ratio of back-to forward resistance for a diode?

1 Answer

Answer :

Greater than 10 to 1

Related questions

Description : What is the typical back-to-forward resistance ratio of a good-quality diode?

Last Answer : 10-to-1 ratio.

Description : In the right-hand rule for propagation, the thumb points in the direction of the E field and the forefinger points in the direction of the H field. In what direction does the middle finger point?

Last Answer : Direction of wave propagation.

Description : When using an ohmmeter to test a semiconductor diode, you find a low resistance in both the forward and reverse bias directions. This indicates that the diode has a/an ____________. A. open B. short C. good resistive quality D. good capacitive quality

Last Answer : Answer: B

Description : Why does a forward biased diode offer low resistance?

Last Answer : The external voltage over comes the junction potential and provides an easy path for the flow of charges across the junction. Hence it offers low resistance.

Description : A forward potential of 10V is applied to a Si diode. A resistance of 1 KΩ is also in series with the diode. The current is a. 10 mA b. 9.3 mA c. 0.7 mA d. 0

Last Answer : b. 9.3 mA

Description : When the diode is forward biased, it is equivalent to a. An off switch b. An On switch c. A high resistance d. None of the above

Last Answer : b. An On switch

Description : Define dynamic resistance of diode. State, how it is calculated using forward characteristics of diode.

Last Answer : Definition: The resistance offered by the diode to the AC operating conditions is known as the Dynamic resistance' or Incremental resistance' or AC resistance' of a diode. It is ... Dynamic resistance is actually the reciprocal of the slope of the forward characteristics.

Description : A forward potential of 10V is applied to a Si diode. A resistance of 1 KΩ is in series with the diode. The current through the diode is

Last Answer : A forward potential of 10V is applied to a Si diode. A resistance of 1 KΩ is in series with the diode. The current through the diode is 9.3 mA

Description : An ohmmeter used to test for front-to-back resistance of a PN junction diode should produce roughly what ratio? A. 100:01:00 B. 500:01:00 C. 1000:01:00 D. 5000:01:00

Last Answer : Answer: A

Description : When checking a diode with an ohmmeter, what is indicated by two high resistance measurements?

Last Answer : The diode is open or has a high-forward resistance.

Description : The Phalanx bone on my thumb appears as it is pushed forward more than it should be, is there any way to fix it?

Last Answer : What kind of doctor did you go to? You need to go to an othopedic surgeon with all this information.

Description : Is there a rule of thumb in English for which of two equivalent contractions to use [see examples]?

Last Answer : no rule that I can remember. The contraction at the front of the sentence tempts me to guess that you’re an engineer or technical writer. Funny, but I don’t think it would occur to me to state “I’ve not” instead of “I haven’t”. Are you fluent in other languages?

Description : Homeowners insurance question - is there a good rule of thumb about how much personal property insurance one should buy?

Last Answer : Just got my policy also and it had jumped up 200 from last year with no claims on the policy ever. I shopped around and found that AARP had a much lower price. I went with 50% and AARP.

Description : Men in their 30's to 50's - date "rule of thumb": women half their age, plus seven years?

Last Answer : Never heard of such a thing. Is that really some kind of unspoken rule somewhere?

Description : What is an easy rule-of-thumb for ensuring relatively well-balanced daily nutrition?

Last Answer : Michael Pollan, author of __The Omnivore’s Dilemma__ has it down to three sentences: “Eat food. Not too much. Plants mainly.”

Description : Is this general rule of thumb true?

Last Answer : I like bananas. I eat them a lot. I am still alive.

Description : As a rule of thumb ladies go fisrt when you are going upstairs, right? what about when you are going downstairs?

Last Answer : haha i love how all the guys are thinking about etiquette with ladies. i have never really analyzed this stuff myself. but yeah, what you said makes sense. you should go before her (while going downstairs) so you can break the fall. ouch.

Description : Which rule implement for axes Nomenclature? a.Left-hand rule b.Right-Hand Rule c.Thumb Rule d.None of the above

Last Answer : b.Right-Hand Rule

Description : The rule of thumb is that a right hander should wear a watch on the left arm and vice versa. Where did that rule come from?

Last Answer : It comes from being able to look at your watch while writting so you don't loose track of time.

Description : What should be the angle between the thumb (main) finger and the central finger in Fleming’s rule? What does each finger indicate?

Last Answer : The angle between the thumb and the central finger must be 90o. Fore finger indicates direction of magnetic field, thumb indicates direction of mechanical force / motion of conductor and the central finger indicates the direction of induced current or electric current.

Description : Explain ACID rule of thumb for transactions.

Last Answer : A transaction must be: 1. Atomic - it is one unit of work and does not dependent on previous and following transactions. 2. Consistent - data is either committed or roll back, no in-between ... . Durable - the values persist if the data had been committed even if the system crashes right after. 

Description : Explain ACID rule of thumb for transactions.

Last Answer : A transaction must be: 1. Atomic - it is one unit of work and does not dependent on previous and following transactions. 2. Consistent - data is either committed or roll back, no in-between ... 4. Durable - the values persist if the data had been committed even if the system crashes right after.

Description : In Fleming's left hand rule, thumb shows direction of A. current B. field C. motion D. charge

Last Answer : motion

Description : State ‘Cork screw rule’ and ‘Right hand thumb rule’.  

Last Answer : Cork screw rule Direction of magnetic lines of force around a straight current carrying conductor can be determined by these rules. Cork screw rule' says that, the direction of magnetic ... or encircling fingers must be in the direction of magnetic lines of force around the conductor. 

Description : RIGHT HAND THUMB RULE

Last Answer : “By holding a current carrying straight conductor in your right hand then thumb points towards the direction of current and curled fingers around the conductor will give the direction of magnetic field.”

Description : Treating batterers with counseling and therapy would be using which model of domestic violence? a. Political. b. Medical. c. "Rule of thumb". d. Public family.

Last Answer : b. Medical.

Description : The notion that domestic violence is rooted in the society's laws and customs that reinforce male dominance is known as the a. Political model of domestic violence. b. Medical model of domestic violence. c. "Rule of thumb." d. Battered wife syndrome.

Last Answer : a. Political model of domestic violence.

Description : Which of the following statements accurately reflects a rule of thumb upon which the nurse may rely in assessing the patient's fluid balance? a) Minimal intake of 1.5 liters per day If food and fluids are ... 2 liters per day Minimal intake, as a rule of thumb, is less than 2 liters per day.

Last Answer : a) Minimal intake of 1.5 liters per day If food and fluids are withheld, IV fluids (3L/day) are usually prescribed.

Description : Is there a quick rule-of-thumb to estimate a gas side heat-transfer rate inside the tubes of a shell and tube heat exchanger?

Last Answer : If you need to estimate a gas heat transfer rate or see if a program is getting a reasonable gas rate, use the following: h = 75 X Sq. Root(Op. pressure/100) The operating pressure is ... will be lower for the shell side or if there is more than one exchanger. Source: Gulley Computer Associates

Description : IS there a rule of thumb to estimate the footprint of a cooling tower during design phase?

Last Answer : Over the years, this one has seemed to stand the test of time: Every million Btu/h of tower capacity will require approximately 1000 ft2 of cooling tower basin area.

Description : A ____ is a rule of thumb, strategy, trick, simplification, or any other kind of device which drastically limits search for solutions in large problem spaces. A. Heuristic B. Critical C. Value based D. Analytical

Last Answer : A. Heuristic

Description : A heuristic is a rule of thumb------- (a) Strategy (b) Trick (c) Simplification (d) All of above

Last Answer : (d) All of above

Description : A rule-of-thumb for the numbers of organisms required to produce toxins or to produce desired or undesired flavors is one million per ____. a. ounce c. gram b. kilogram d. pound

Last Answer : c. gram

Description : A ____ is a rule of thumb, strategy, trick, simplification, or any other kind of device which drastically limits search for solutions in large problem spaces. A. Heuristic B. Critical C. Value based D. Analytical

Last Answer : A. Heuristic 

Last Answer : While applying Fleming's right-hand rule to And the direction of induced e.m.f., the thumb points towards direction of motion of conductor, if forefinger points along the lines of flux.

Description : Junction breakdown occurs: a) With forward bias b) With reverse bias c) Under high temperature condition d) Because of excess heating of the diode

Last Answer : Ans: B

Description : While testing a semi-conductor diode with an ohmmeter, both the forward and reverse readings are almost in the infinity range. This would indicate that the unit is _____________. A. good B. open C. grounded D. shorted

Last Answer : Answer: B

Description :  A device used to avoid the relay destroying the op-amp is A. diode B. LED C. reverse bias diode D. forward biased diode

Last Answer : reverse bias diode

Description : A light emitting diode emits light only when (a) Reversed biased (b) forward biased (c) unbiased (d) none

Last Answer : (b) forward biased

Description : Forward current through a semi-conductor diode circuit is due to ________ (a) Minority carriers (b) majority carriers (c) holes (d) electrons

Last Answer : (b) majority carriers

Description : Photo diode operates in the _______ condition (a) Forward bias (b) null (c) both a & d (d) reverse bias

Last Answer : (d) reverse bias

Description : Avalanche breakdown in a diode occurs when a. Potential barrier is reduced to zero. b. Forward current exceeds certain value. c. Reverse bias exceeds a certain value. d. None of these

Last Answer : c. Reverse bias exceeds a certain value.

Description : Describe the working of PN junction diode with neat sketch under forward biased condition.

Last Answer : If the p-region (anode) is connected to the positive terminal of the external DC source and nside (cathode) is connected to the negative terminal of the DC source then the biasing ... The large number of majority carriers crossing the junction constitutes a current called as the forward current.

Description : Define i)P-N junction diode ii) Depletion layer iii)Forward bias iv)Reverse bias of P-N junction diode

Last Answer : i)P-N junction diode: It is a semiconductor device in which half of its region is P-type and other half is N-type.  ii) Depletion layer: The region where free electrons and free holes are absent ... and negative terminal is connected to p-side of p-n junction diode, it is said to be reverse bias.

Description : Explain the forward bias characteristics of a P-N Junction diode. 

Last Answer : forward and reverse characteristics of P-N junction diode.

Description : When the diode is forward biased, it is equivalent to

Last Answer : When the diode is forward biased, it is equivalent to An On switch

Description : To turn a UJT ON, the forward bias on emitter diode should be:  1. more than the peak point voltage 2. less than the peak point voltage 3. Equal to the peak point voltage 4. Equal to the stand - off voltage  

Last Answer : To turn a UJT ON, the forward bias on emitter diode should be: more than the peak point voltage 

Description : How much time a diode takes to switch ON in forward bias condition.

Last Answer : t=0 sec.

Last Answer : Yes it can be, and it will act like a normal PN junction diode. The characteristic of ZENER diode is exactly same as PN junction diode in forward Bias.