If the diameter of a conductor of 10 ohms is doubled, its new resistance would be 2.5 ohms
Description : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes?
Last Answer : If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes 0.4 ohm.
Description : What amount of current will flow through resistance of 10 ohms when it is connected across a potential difference of 20 volts? A.30 amperes B.5 amperes C.10 amperes D.2 amperes
Last Answer : 2 amperes
Description : A resistance of 3.3 M ohms is connected across a 500 V source. The resulting current is approximately? A.15.1 μA B.151 μA C.66 mA D.660 mA
Last Answer : A
Description : If an incandescent lamp of 80 ohms resistance takes a current of 0.75 ampere, what voltage is required to light it? A.45 volts B.60 volts c.23 volts D.None of these
Last Answer : V=IR = 80*0.75 = 60 volts
Description : The resistance of a few meters of wire conductor in closed electrical circuit is?
Last Answer : The resistance of a few meters of wire conductor in closed electrical circuit is practically zero.
Description : The resistance of a conductor varies inversely as?
Last Answer : The resistance of a conductor varies inversely as area of cross-section.
Description : If your multimeter gives a reading in ohms when testing each end of each conductor of a three-conductor cable, this indicates ______________. A. continuity of the conductor B. an infinite resistance C. the presence of a partial ground D. that the conductor is not short circuited
Last Answer : Answer: A
Description : With both ends of a three conductor cable disconnected and arranged without the conductors touching each other, an ohmmeter reading of 'zero' ohms between the ends of one conductor would indicate _____________. A. continuity B. a partial ground C. the resistance is infinite D. a short circuit
Description : List the three factors used to calculate resistance of a particular conductor in ohms.
Last Answer : Length, cross-sectional area, and specific resistance of a unit volume of the substance from which the conductor is made
Last Answer : If the resistance of a conductor does not vary in accordance with Ohm's law it is known as non-linear conductor
Description : How much voltage is needed to produce 2.5 A of current through a 200 ohms resistor? A.50 V B.500 V C.80 V D.8 V
Last Answer : 500 V
Description : When there is 12 mA of current through a 1.2 k ohms resistor, the voltage across the resistor is? A.14.4 V B.1.4 V C.100 V D.10 V
Last Answer : When there is 12 mA of current through a 1.2 k ohms resistor, the voltage across the resistor is? A.14.4 V B.1.4 V C.100 V D.10 V
Description : The turns ratio required to match an 80 ohms source to a 320 ohms load is? A.80 B.20 C.4 D.2
Last Answer : c
Description : Four amperes of current are measured through a 24 ohms resistor connected across a voltage source. How much voltage does the source produce? A.960 V B.9.6 V C.96 V D.8 V
Last Answer : Four amperes of current are measured through a 24 ohms resistor connected across a voltage source. How much voltage does the source produce? A.960 V B.9.6 V C.96 V D.8 V
Description : If three wires of 3 ohms, 9 ohms and 5 ohms respectively are connected in series, what their resultant resistance? A.10 ohms B.12 ohms C.17 ohms D.5 ohms
Last Answer : If three wires of 3 ohms, 9 ohms and 5 ohms respectively are connected in series, what their resultant resistance? A.10 ohms B.12 ohms C.17 ohms D.5 ohms
Description : What is the diameter of a copper wire to be used in a 16 km loop with a dc loop resistance of 100 ohms/km? A. 0.108 cm B. 1.082 cm C. 0.017 cm D. 0.0465 cm
Last Answer : D. 0.0465 cm
Description : When electric current passes through a metallic conductor, its temperature rises. This is due to?
Last Answer : When electric current passes through a metallic conductor, its temperature rises. This is due to collisions between conduction electrons and atoms.
Description : The weight of an aluminium conductor as compared to a copper conductor of identical cross-section, for the same electrical resistance, is?
Last Answer : The weight of an aluminium conductor as compared to a copper conductor of identical cross-section, for the same electrical resistance, is 50%.
Description : Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be?
Last Answer : Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be 10 ohms.
Description : The thickness of insulation provided on the conductor depends on?
Last Answer : The thickness of insulation provided on the conductor depends on the magnitude of voltage on the conductor.
Description : The insulation on a current carrying conductor is provided?
Last Answer : The insulation on a current carrying conductor is provided to prevent leakage of current, to prevent shock.
Description : Heat in a conductor is produced on the passage of electric current due to?
Last Answer : Heat in a conductor is produced due to frictional collision of electrons flow as they conduct current.
Description : The drift speed of electrons in copper wire of diameter and length `l` is `v` . If the potential difference across the wire is doubled, then the new d
Last Answer : The drift speed of electrons in copper wire of diameter and length `l` is `v` . If the potential ... `2upsilon` C. `3upsilon` D. `upsilon//2`
Description : A shaft of diameter d carries two discs at its two ends. The lowest torsional frequency is ω n . If the diameter is doubled, then the lowest torsional frequency becomes A 4ω n B ω n /2 C ω n /4 D 4ω n
Last Answer : D 4ω n
Description : If the diameter of a capillary is doubled, then the rise of water in it will be – (1) two times (2) half (3) four times (4) no change
Last Answer : (2) half Explanation: Radius of a capillary tube is inversely proportional to the height of the liquid column. So, if radius of the tube is doubled, rise of level of water will becomes half ... to flow in narrow spaces without the assistance of, and in opposition to external forces like gravity.
Description : For turbulent flow in a tube, the heat transfer co-efficient is obtained from the Dittus-Boelter correlation. If the tube diameter is halved and the flow rate is doubled, then the heat transfer co-efficient will change by a factor of (A) 1 (B) 1.74 (C) 6.1 (D) 37
Last Answer : (C) 6.1
Description : A sewer has a diameter of 300 mm and slop of 1 in 400. While running full it has a mean velocity of 0.7 m/s. If both the diameter and slope are doubled (to respectively be 600 mm and 1 in 200), what will be the changed mean velocity ... 's formula. (a) 1.59 m/s (b) 2.80 m/s (c) 0.90 m/s (d) 1.00 m/s
Last Answer : (a) 1.59 m/s
Description : If the velocity of flow as well as the diameter of the flowing pipe are respectively doubled through a pipe system in use since long, the head loss will thereafter be (a) Halved (b) Doubled (c) Increased 4 times (d) No change
Last Answer : (b) Doubled
Description : If diameter of a shaft is doubled the power transmitted capacity will be a. Either twice or half b. Four times c. Eight times d. Same
Last Answer : c. Eight times
Description : If the diameter of a capillary is doubled, then the rise of water in it will be (1) two times (2) half (3) four times (4) no change
Last Answer : half
Description : The magnitude of current flowing between two end points of a conductor is proportional to the potential difference between them and is called as: (1) Avogadro's law (2) Rault's law (3) Ohms law (4) Faraday's law
Last Answer : (3) Ohms law Explanation: According to Ohm's Law, the potential difference (V) between two terminals of a current-carrying conductor is directly proportional to the current (I), flowing through it. -For any Study materialContact WhatsApp: 8337932441 Join Telegram- Click here
Description : Ohm's law is valid in case of – (1) semiconductor (2) conductor (3) superconductor (4) insulator
Last Answer : (2) conductor Explanation: Ohm's law states that the current through a conductor between two points is directly proportional to the potential difference across the two points. It defines the relationship between the three fundamental, electrical quantities: current, voltage, and resistance.
Description : Ohm’s law obeyed in - (1) a metallic conductor (2) a semi conductor (3) an electron tube (4) in all of the above
Last Answer : (1) a metallic conductor Explanation: There are, however, components of electrical circuits which do not obey Ohm's law; that is, their relationship between current and voltage (their I–V curve) is nonlinear (or non-ohmic).
Description : Electric current is the flow of electrons through a conductor; the rate of this flow is measured in ___________. A. volts B. amperes C. coulombs D. ohms
Last Answer : Answer: B
Description : Electric current is the flow of electrons through a conductor. The rate of this flow is measured as ___________. A. volts/watt B. amperes/centimetre C. coulombs/second D. ohms/volt
Last Answer : Answer: C
Description : If variable part of annual cost on account of interest and depreciation on the capital outlay is equal to the annual cost of electrical energy wasted in the conductors, the total annual cost will be minimum and the ... (b) Ohm's law (c) Kirchhoffs law (d) Faraday's law (e) none of the above
Last Answer : (a) Kelvin's law
Description : The magnitude of current flowing between two end points of a conductor is proportional to the potential difference between them and is called as: (1) Avogadro’s law (2) Rault’s law (3) Ohms law (4) Faraday’s law
Last Answer : Ohms law
Description : Ohm’s law is valid in case of (1) semiconductor (2) conductor (3) superconductor (4) insulator
Last Answer : conductor
Description : The hot resistance of the bulb's filament is higher than its cold resistance because the temperature co-efficient of the filament is?
Last Answer : This is because resistance of a conductor increases with increase in temperature .
Description : Resistance
Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }
Description : How much resistance is needed to draw 17.6 mA from a 12 volt source? A.212 ohms B.6.8 kohms C.68 ohms D.680 ohms
Last Answer : How much resistance is needed to draw 17.6 mA from a 12 volt source? A.212 ohms B.6.8 kohms C.68 ohms D.680 ohms
Description : How much resistance is required to limit the current from a 12 V battery to 3.6 mA? A.3.3 k ohms B.33 k ohms C.2.2 k ohms D.22 k ohms
Last Answer : How much resistance is required to limit the current from a 12 V battery to 3.6 mA? A.3.3 k ohms B.33 k ohms C.2.2 k ohms D.22 k ohms
Description : The minimum resistance value for a blue, gray, red, silver resistor is? A.612 ohms B.6,120 ohms C.6,800 ohms D.6,460 ohms
Last Answer : The minimum resistance value for a blue, gray, red, silver resistor is? A.612 ohms B.6,120 ohms C.6,800 ohms D.6,460 ohms
Description : An electric heater draws 3.5 A from a 110 V source. The resistance of the heating element is approximately? A.385 ohms B.38.5ohms C.3.1 ohms D.31 ohms
Last Answer : 31ohns
Description : Resistance is measured in? A.henries B.ohms C.hertz D.watts
Last Answer : Ohms
Description : Temperature co-efficient of resistance is expressed in terms of?
Last Answer : Degree celsius
Description : International ohm is defined in terms of the resistance of?
Last Answer : International ohm is defined in terms of the resistance of a column of mercury.
Description : When resistance element of a heater fuses and then we reconnect it after removing a portion of it, the power of the heater will?
Last Answer : When resistance element of a heater fuses and then we reconnect it after removing a portion of it, the power of the heater will increase.
Description : In a lamp load when more than one lamp are switched on the total resistance of the load?
Last Answer : In a lamp load when more than one lamp are switched on the total resistance of the load decreases.
Description : Two bulbs of 500 W and 200 W rated at 250 V will have resistance ratio as?
Last Answer : Two bulbs of 500 W and 200 W rated at 250 V will have resistance ratio as 2 : 5.