Description : Separation of water or water sand cement from a freshly concrete, is known (A) Bleeding (B) Creeping (C) Segregation (D) Flooding
Last Answer : Answer: Option A
Description : The continuous strain, which the concrete undergoes due to application of external loads is called [ A ] Creep [ B ] Bleeding [ C ] Workability [ D ] Segregation
Last Answer : [ A ] Creep
Description : The workability of concrete is defined as the (a) Ease with which it can be mixed, transported and placed in position in a homogeneous state. (b) Bearing up of cohesion in a mass concrete. (c) Separation of water from the freshly mixed concrete. (d) None of these.
Last Answer : (a) Ease with which it can be mixed, transported and placed in position in a homogeneous state.
Description : The property of fresh concrete, in which the water in the mix tends to rise to the surface while placing and compacting, is called (A) Segregation (B) Bleeding (C) Bulking (D) Creep
Last Answer : Answer: Option B
Description : A concrete using an air entrained cement (A) Has strength less than 10% to 15% (B) Has more resistance to weathering (C) Is more plastic and workable (D) Is free from segregation and bleeding
Last Answer : Answer: Option C
Description : A badly mixed cement concrete results in (A) Segregation (B) Bleeding (C) Honey combing (D) None of these
Description : Pick up the correct statement from the following: (A) Water enables chemical reaction to take place with cement (B) Water lubricates the mixture of gravel, sand and cement (C) Strength of concrete structure largely depends upon its workability (D) All the above
Last Answer : (D) All the above
Description : Separation of coarse aggregates from mortar during transportation, is known (A) Bleeding (B) Creeping (C) Segregation (D) Shrinkage
Description : Slump cone test is used to determine [ A ] Shrinkage of concrete mix [ B ] Creep of concrete [ C ] Workability of concrete mix [ D ] Soundness of concrete
Last Answer : [ C ] Workability of concrete mix
Description : Pick up the correct statement from the following: (A) Continuous grading is not necessary for obtaining a minimum of air voids (B) The omission of a certain size of aggregate is shown by ... in concrete increases the workability but also increases the liability to segregation (D) All the above
Last Answer : Answer: Option D
Description : Pick up the correct statement from the following: (A) Segregation is necessary for a workable concrete (B) Consistency does not affect the workability of concrete (C) If the concrete mix is dry, the slump is maximum (D) None of these
Description : As compared to ordinary Portland cement, use of pozzolana cement (A) Reduces workability (B) Increases bleeding (C) Increases shrinkage (D) Increases strength
Description : The use of air-entraining agents in concretes (a) Increases workability of concrete (b) Decreases bleeding (c) Decreases strength (d) All of these
Last Answer : (d) All of these
Description : During the process of hardening of cement, _______ will takes place [ A ] Bleeding [ B ] Segregation [ C ] Hydration [ D ] All the above
Last Answer : [ C ] Hydration
Description : Excess quantity of water (a) Makes the concrete mix harsh (b) Makes the concrete mix unworkable (c) Causes segregation in concrete (d) Causes bleeding in concrete.
Last Answer : both c&d
Description : Insufficient quantity of water (a) Makes the concrete mix harsh (b) Makes the concrete mix unworkable (c) Causes segregation in concrete (d) Causes bleeding in concrete.
Last Answer : both a&b
Description : The increased cohesiveness of concrete, makes it (A) Less liable to segregation (B) More liable to segregation (C) More liable to bleeding (D) More liable for surface scaling in frosty weather
Description : Workability of concrete is inversely proportional to (A) Time of transit (B) water-cement ratio (C) The air in the mix (D) Size of aggregate
Description : Pick up the correct statement from the following: (A) An increase in water content must be accompanied by an increase in cement content (B) Angular and rough aggregates reduce the workability of the ... The slump of the concrete mix decreases due to an increase in temperature (D) All the above
Description : C.R.R.I. charts are used to obtain a relationship between strength of concrete and (A) Water cement ratio (B) Workability (C) Grading of aggregate (D) Fineness modulus
Description : Workability of concrete mix with low water cement ratio is determined by (A) Tensile strength test (B) Slump test (C) Compaction factor test (D) Flexural strength test
Description : The basic purpose of a retarder in concrete is (A) To increase the initial setting time of cement paste in concrete (B) To decrease the initial setting time of cement paste in concrete (C) To render the concrete more water tight (D) To improve the workability of concrete mix
Description : The workability of concrete is expressed by (a) Water-cement ratio (b) Slump value (c) Compaction factor (d) Both (a) and (b)
Last Answer : (d) Both (a) and (b)
Description : The workability of concrete is mostly influenced by its [ A ] Water cement ratio [ B ] Aggregate cement ratio [ C ] Cement content [ D ] Water content
Last Answer : [ A ] Water cement ratio
Description : Workability of concrete mix with low water cement ratio is determined by [ A ] Tensile strength test [ B ] Slump cone test [ C ] Compaction factor test [ D ] Flexural strength test
Last Answer : [ C ] Compaction factor test
Description : Increase in water content in a cement concrete (i) Increases workability (ii) Increases the strength [ A ] i [ B ] ii [ C ] both (i) and (ii) [ D ] neither (i) nor (ii)
Last Answer : [ A ] i
Description : The lower water cement ratio in concrete, introduces (A) Smaller creep and shrinkage (B) Greater density and smaller permeability (C) Improved frost resistance (D) All the above
Description : Which one of the following statements is not correct with respect to PSC beams? (a) Loss due to shrinkage is proportional to water-cement ratio used in concrete (b) Loss due to creep is ... to the modulus of elasticity of concrete (d) Loss due to friction occurs in post tensioned concrete members
Last Answer : (c) Loss due to elastic deformation is directly proportionally to the modulus of elasticity of concrete
Description : Higher workability of concrete is required if the structure is (A) Made with cement concrete (B) Thick and reinforced (C) Thin and heavily reinforced (D) Thick and heavily reinforced
Description : Workability of concrete is directly proportional to (A) Aggregate cement ratio (B) Time of transit (C) Grading of the aggregate (D) All of above
Description : For constructing a terrazzo floor, Pick up the incorrect statement from the following: (A) A base course is prepared as in cement concrete flooring (B) A 32 mm thick layer of cement concrete ... final grinding is over, oxalic acid mixed with water is spread over and rubbed hard with soft material
Description : Explain two causes of each i) Segregation ii) Bleeding of concrete
Last Answer : Causes of Segregation: 1. Inaccurate water cement ratio. 2. Improper mixing of concrete ingredients. 3. Longer distance transportation. 4. More height of concrete placing. 5. Excessive or over ... Lean mix i.e. less cements content. 5. Delay in finishing of freshly placed concrete mix.
Description : For different layers of cement concrete floor. Pick up the incorrect statement from the following: (A) The lowest layer consists of consolidated ground (B) A 10 cm thick clean sand is laid on consolidated ground (C) ... sand (D) A 10 cm thick cement concrete (1 : 2 : 4) is laid on top layer
Last Answer : Option D
Description : To indicate proper control of consistency of a freshly mixed concrete for pavement construction, the slump should be between (A) 3 to 5 cm (B) 4 to 6 cm (C) 5 to 7 cm (D) 7 to 10 cm
Description : For given workability the grading requiring the least amount of water is one that gives (A) Greatest surface area for the given cement and aggregates (B) Least surface area for the given cement ... weight for the given cement and aggregates (D) Greatest weight for the given cement and aggregates
Description : In order to avoid segregation, the concrete should not be thrown from a height (a) Agree (b) Disagree (c) Not known (d) None of these
Last Answer : (a) Agree
Description : Addition of pozzolana to cement (A) Decreases workability (B) Increases strength (C) Increases heat of hydration (D) None of these
Description : Cement used for normal concrete construction, is obtained by burning a mixture of (A) Siliceous and argillaceous materials (B) Argillaceous and calcareous materials (C) Siliceous and calcareous materials (D) Siliceous, argillaceous and calcareous materials
Description : For given water content, workability decreases if the concrete aggregates contain an excess of (A) Thin particles (B) Flat particles (C) Elongated particles (D) All the above
Description : Proper proportioning of concrete, ensures (A) Desired strength and workability (B) Desired durability (C) Water tightness of the structure (D) All the above
Description : An excess of flaky particles in concrete aggregates (A) Decreases the workability (B) Increases the quantity of water and sand (C) More than 15% are not desirable (D) All the above
Description : Workability of concrete for a given water content is good if the aggregates, are (A) Rounded aggregate (B) Irregular aggregate (C) Angular aggregate (D) Flaky aggregate
Description : Slump test for concrete is carried out, to determine (A) Strength (B) Durability (C) Workability (D) Water content
Description : Workability of concrete for a given water content is good, if the aggregates are [ A ] Rounded [ B ] Irregular [ C ] Angular [ D ] Flaky
Last Answer : [ A ] Rounded
Description : The process of hardening of concrete in the presence of water is called [ A ] Creep [ B ] Hydration [ C ] Shrinkage [ D ] Curing
Last Answer : [ B ] Hydration
Description : Grading of sand causes great variation in (A) Workability of concrete (B) Strength of concrete (C) Durability of concrete (D) All the above
Description : Air entrainment in the concrete increases (A) Workability (B) Strength (C) The effects of temperature variations (D) The unit weight
Last Answer : (A) Workability
Description : Wp and Wf are the weights of a cylinder containing partially compacted and fully compacted concrete. If the compaction factor (Wp/Wf ) is 0.95, the workability of concrete is (A) Extremely low (B) Very low (C) Low (D) High
Description : In order to obtain the best workability of concrete, the preferred shape of aggregate is (A) Rounded (B) Elongated (C) Angular (D) All of the above
Description : If the slump of a concrete mix is 60 mm, its workability is (A) Very low (B) Low (C) Medium (D) High