Description : For the construction of cement concrete floor, the maximum permissible size of aggregate, is (A) 4 mm (B) 6 mm (C) 8 mm (D) 10 mm
Last Answer : Answer: Option D
Description : For reinforced concrete work, aggregates having a nominal size of -------- are generally used [ A ] 20 mm [ B ] 40 mm [ C ] 50 mm [ D ] 60 mm
Last Answer : [ A ] 20 mm
Description : The 28 days cube strength of mass concrete using aggregates of maximum size 5 cm for gravity dams should be (A) Between 150 to 300 kg/cm2 (B) Between 350 to 600 kg/cm2 (C) Between 150 to 500 kg/cm2 (D) Below 200 kg/cm2
Description : For batching 1:3:6 concrete mix by volume, the ingredients required per bag of 50 kg cement, are: (A) 70 litres of sand and 120 litres of aggregates (B) 70 kg of sand and 140 litres of ... C) 105 litres of sand and 140 litres of aggregates (D) 105 litres of sand and 210 litres of aggregates
Description : If aggregates completely pass through a sieve of size 75 mm and are retained on a sieve of size 60 mm, the particular aggregate will be flaky if its minimum dimension is less than (A) 20.5 mm (B) 30.5 mm (C) 40.5 mm (D) 50.5 mm
Last Answer : Answer: Option C
Description : The maximum permissible size of aggregates to be used in casting the ribs of a slab, is (A) 5 mm (B) 7.5 mm (C) 10 mm (D) 15 mm
Description : A hollow shaft of 1 m length is designed to transmit a power of 30 kW at 700 rpm. The maximum permissible angle of twist in the shaft is 1o. The inner diameter of the shaft is 0.7 times the outer diameter. The modulus of ... shaft is _______. (a) 43 to 45 (b) 50to 60 (c) 70 to 80 (d) 85 to 100
Last Answer : (a) 43 to 45
Description : For testing compressive strength of cement, the size of cube used is (A) 50 mm (B) 70.6 mm (C) 100 mm (D) 150 mm
Last Answer : B
Description : If 50 kg of fine aggregates and 100 kg of coarse aggregates are mixed in a concrete whose water cement ratio is 0.6, the weight of water required for harsh mix, is (A) 8 kg (B) 10 kg (C) 12 kg (D) 14 kg
Description : Minimum required water cement ratio for a workable concrete, is (A) 0.30 (B) 0.40 (C) 0.50 (D) 0.60
Last Answer : Answer: Option B
Description : Pozzolana cement is used with confidence for construction of (A) Dams (B) Massive foundations (C) R.C.C. structures (D) All the above
Last Answer : (D) All the above
Description : The percentage of the aggregate of F.M. 2.6 to be combined with coarse aggregate of F.M. 6.8 for obtaining the aggregates of F.M. 5.4, is (A) 30 % (B) 40 % (C) 50 % (D) 60 %
Last Answer : (C) 50 %
Description : Which of the following cements is suitable for use in massive concrete structures such as large dams? (A) Ordinary Portland cement (B) Low heat cement (C) Rapid hardening cement (D) Sulphate resisting cement
Description : When each particle of aggregates is thinly coated with cement paste, a heterogeneous solid is formed, which is known as (A) Hydration (B) Gel (C) Concrete (D) None of these
Description : The ratio of various ingredients (cement, sand, aggregates) in concrete of grade M 200, is (A) 1 : 2 : 4 (B) 1 : 3 : 6 (C) 1 : 1½ : 3 (D) 1 : 1 : 2
Last Answer : (C) 1 : 1½ : 3
Description : While designing an air entrained concrete (A) Water cement ratio is reduced (B) Proportion of aggregates is reduced (C) An allowance for the entrained air is made (D) All the above
Description : Pick up the correct statement from the following: (A) The weight of ingredients of concrete mix, is taken in kilograms (B) Water and aggregates are measured in litres (C) 20 bags of cement make one tonne (D) All the above
Description : For a good concrete (A) Aggregates should be hard and durable (B) Water should be free from organic materials (C) Cement should be sufficient to produce the required strength (D) All the above
Description : According to Water-Cement Ratio Law, the strength of workable plastic concrete (A) Depends upon the amount of water used in the mix (B) Does not depend upon the quality of cement mixed with aggregates (C) Does not depend upon the quantity of cement mixed with aggregates (D) All the above
Description : Pick up the correct statement from the following: (A) An increase in water content must be accompanied by an increase in cement content (B) Angular and rough aggregates reduce the workability of the ... The slump of the concrete mix decreases due to an increase in temperature (D) All the above
Description : For preparing ordinary concrete, the quantity of water used, is (A) 5% by weight of aggregates plus 20% of weight of cement (B) 10% by weight of aggregates plus 10% of weight of cement (C) ... aggregates plus 30% of weight of cement (D) 30% by weight of aggregates plus 10% of weight of cement
Description : Pick up the correct statement from the following: (A) Water cement paste hardens due to hydration (B) During hardening cement binds the aggregates together (C) Cement provides strength, durability and water tightness to the concrete (D) All the above
Description : Concrete mainly consists of (A) Cement (B) Aggregates (C) Water (D) All the above
Description : If the various concrete ingredients i.e. cement, sand and aggregates are in the ratio of 1:3:6, the grade of concrete, is (A) M 100 (B) M 150 (C) M 200 (D) M 250
Last Answer : Answer: Option A
Description : Concrete gains strength due to (A) Chemical reaction of cement with sand and coarse aggregates (B) Evaporation of water from concrete (C) Hydration of cement (D) All the above
Description : Pick up the correct statement from the following: (A) Plain cement concrete is equally strong in compression as well as in tension (B) Slump test is performed to check concrete strength (C ... D) Fineness modulus is the index number expressing the relative sizes of both coarse and fine aggregates
Last Answer : Option D
Description : The inert mineral material used for the manufacture of mortars and concrete is (a) Cement (b) Water (c) Aggregates (d) Admixture
Last Answer : (c) Aggregates
Description : Concrete gains strength due to [ A ] Chemical reaction of cement with sand and coarse aggregates [ B ] Evaporation of water from concrete [ C ] Hydration of cement [ D ] All the above
Last Answer : [ C ] Hydration of cement
Description : Shrinkage in concrete can be reduced by using (i) Low water cement ratio (ii) More amount of cement in the concrete (iii) Presaturated aggregates [ A ] i [ B ] i and ii [ C ] i and iii [ D ] i, ii and iii
Last Answer : [ C ] i and iii
Description : The maximum permissible differential settlement, in case of foundations in clayey soil, is usually limited to (A) 10 mm (B) 20 mm (C) 30 mm (D) 40 mm
Description : Which of the following statement is correct (a) The maximum size of coarse aggregate should not exceed one fourth of the minimum dimension of the plain concrete member. (b) The maximum size of coarse ... aggregates of 40mm, 20mm and 10mm sizes are commonly used for concrete works (d) All the above
Last Answer : (d) All the above
Description : The sum of the percentage of tricalcium silicate and dicalcium silicate for Portland cement varies from. (a) 50 to 60% (b) 60 to 70% (c) 70 to 80% (d) 80 to 90%
Last Answer : (c) 70 to 80%
Description : The process of mixing, transporting, placing and compacting concrete using Ordinary Port land Cement should not take more than (A) 30 minutes (B) 40 minutes (C) 60 minutes (D) 90 minutes
Description : If a concrete column 200 200 mm in cross-section is reinforced with four steel bars of 1200 mm2 total cross-sectional area. Calculate the safe load for the column if permissible stress in concrete is 5 N/mm2 ... 15 Ec (A) 264 MN (B) 274 MN (C) 284 MN (D) 294 MN
Last Answer : (C) 284 MN
Description : Permissible width of crack at the surface of concrete for „moderate‟ environmental conditions according to IS : 456-2000 is [ A ] 0.1 mm [ B ] 0.2 mm [ C ] 0.3 mm [ D ] 0.4 mm
Last Answer : [ B ] 0.2 mm
Description : In slump test, each layer of concrete is compacted by a steel rod 60 cm long and of 16 mm diameter for (A) 20 times (B) 25 times (C) 30 times (D) 50 time
Description : Standard disc plough diameter size is A. 40 to 60 cm C. 70 to 90 cm B. 60 to 90 cm D. 50 to 70 cm
Last Answer : 60 to 90 cm
Description : The size of fine aggregates does not exceed (A) 2.75 mm (B) 3.00 mm (C) 3.75 mm (D) 4.75 mm
Description : Gravels (A) Are cohesionless aggregates (B) Vary in size between 2 to 20 mm (C) Never swell when they come into contact with water (D) All the above
Description : The size of fine aggregates does not exceed [ A ] 2.75 mm [ B ] 3.75 mm [ C ] 4.75 mm [ D ] 5.75 mm
Last Answer : [ C ] 4.75 mm
Description : Which of the following statements regarding cash flow patterns (for time periods 0, 1, 2, 3, and 4) is correct? A. The sequence of -Rs.100, Rs.50, Rs.40, Rs.60, and Rs.50 is a non-conventional cash ... -Rs.50, Rs.50, Rs.70, Rs.60, and -Rs.150 potentially has at most two internal rates of return.
Last Answer : B. The sequence of -Rs.100, Rs.600, -Rs.1,100, Rs.600, and Rs.20 potentially has a maximum of two internal rates of return.
Description : The proportion of coarse aggregates to fire aggregates in structural concrete is usually [ A ] 0.50 - 1.25 [ B ] 1.25 - 4.50 [ C ] 1.50 - 2.50 [ D ] 0.25 - 0.75
Last Answer : [ C ] 1.50 - 2.50
Description : A district road with a bituminous pavement has a horizontal curve of 1000 m for a design speed of 75 km ph. The super-elevation is (A) 1 in 40 (B) 1 in 50 (C) 1 in 60 (D) 1 in 70
Description : Percentage content of silica in window glass, is (A) 40 to 45 (B) 50 to 55 (C) 60 to 65 (D) 70 to 75
Description : In verandah floors outward slope is (A) 1 in 40 (B) 1 in 50 (C) 1 in 60 (D) 1 in 70
Description : For dam construction the size of aggregates are (a) 40mm (b) 50mm (c) 60mm (d) 75mm
Last Answer : (a) 40mm
Description : Percentage of pozzolanic material containing clay upto 80% used for the manufacture of pozzolana cement, is (A) 30 % (B) 40 % (C) 50 % (D) 60 %
Last Answer : (A) 30 %
Description : If water required for 1 bag of cement is 30 litres, the water cement ratio is: (A) 0.40 (B) 0.50 (C) 0.60 (D) None of these
Description : The strength of brick masonry in 1:6 cement mortar, is (A) 20 tonnes/m2 (B) 40 tonnes/m2 (C) 50 tonnes/m2 (D) 60 tonnes/m
Description : The strength of durability of concrete depends upon. (a) Size of aggregates (b) Grading of aggregates (c) Moisture contents of aggregates (d) All of these.
Last Answer : (d) All of these.