Description : Lapped splices in tensile reinforcement are generally not used for bars of size larger than (A) 18 mm diameter (B) 24 mm diameter (C) 30 mm diameter (D) 36 mm diameter
Last Answer : Answer: Option D
Description : In cement pressure grouting G.I pipes of diameter …… and ……length, should be fixed in drilled holes a) 12 to 20 mm, 200 mm* b) 12 to 20 mm, 300 mm c) 12 to 25 mm, 500 mm d) 20 to 25 mm, 300 mm
Last Answer : a) 12 to 20 mm, 200 mm*
Description : Pick up the wrong nominal internal diameter of cast iron (spun) pipes in mm from the following: (A) 300 (B) 400 (C) 550 (D) 650
Last Answer : (C) 550
Description : The diameter of a domestic sewer pipe laid at gradient 1 in 100 is recommended (A) 100 mm (B) 150 mm (C) 200 mm (D) 175 mm
Last Answer : (B) 150 mm
Description : Pick up the incorrect statement from the following: (A) The built up covered area at the floor level of any storey of a building is called plinth area (B) The usable covered area of the rooms of ... , pantry, store, lavatory, bath room and glazed veranda, is called floor area (D) None of thes
Last Answer : (D) None of thes
Description : Dado is usually provided in (A) Dining halls (B) Bath rooms (C) Living rooms (D) Verandah
Last Answer : Answer: Option B
Description : Pick up the correct statement from the following: (A) Louvered door is generally provided in bath rooms (B) Flush door is generally provided in dining room (C) Revolving door is generally provided in cinema halls (D) Sliding door is generally provided in show rooms
Last Answer : Answer: Option C
Description : A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun's equation for the above fluid-particle ... fluidisation velocity, VOM is (A) 12 mm/s (B) 16 mm/s (C) 24 mm/s (D) 28 mm/s
Last Answer : (B) 16 mm/s
Description : The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or (A) 12 bar diameters (B) 18 bar diameters (C) 24 bar diameters (D) 30 bar diameters
Description : From distribution main of 50 mm size, number of service pipes of 15 mm size can be taken off are ------ a) 6 b)10 c) 12 e):20*
Last Answer : e):20*
Description : The diameter of longitudinal bars of a column should never be less than (A) 6 mm (B) 8 mm (C) 10 mm (D) 12 mm
Description : An R.C.C. column of 30 cm diameter is reinforced with 6 bars 12 mm placed symmetrically along the circumference. If it carries a load of 40, 000 kg axially, the stress is (A) 49.9 kg/cm2 (B) 100 kg/cm2 (C) 250 kg/cm2 (D) 175 kg/cm
Last Answer : Answer: Option A
Description : The diameter of main bars in R.C.C. columns, shall not be less than (A) 6 mm (B) 8 mm (C) 10 mm (D) 12 mm
Description : The maximum diameter of a bar used in a ribbed slab, is (A) 12 mm (B) 6 mm (C) 20 mm (D) 22 mm
Description : The minimum diameter of longitudinal bars in a column is (A) 6 mm (B) 8 mm (C) 12 mm (D) 16 mm
Description : A reinforced concrete slab is 75 mm thick. The maximum size of reinforcement bar that can be used is (a) 6 mm diameter (b) 8 mm diameter (c) 10 mm diameter (d) 12 mm diameter
Last Answer : (b) 8 mm diameter
Description : The sludge does not contain waste water from A. Bath rooms B. Wash basins C. Kitchen sinks D. Toilets
Last Answer : ANS: D
Description : Why do they still have bath tubs in the hospitals' rooms?
Last Answer : Eh taking a shower standing up is not easy for everyone. A lot of people have an easier time sitting down and bathing. Usually older people. So they are just trying to accommodate everyone.
Description : The liquid wastes from kitchens, bath rooms and wash basins, is not called A. Liquid waste B. Sullage C. Sewage D. None of these
Last Answer : ANS: C
Description : Pipe A can fill a water tank in 8 hours, Pipe B can fill the same tank in 12 hours and Pipe C can empty the tank in 24 hours. If all three pipes are opened together, in how many hours will the tank be completely filled or empty? a) 4.8 hours b) 5 hours c) 5.4 hours d) 6 hours e) 7.2 hours
Last Answer : If all the three pipes are opened together, in one hour they will fill 1/8 + 1/12 – 1/24 = (3+2-1)/24 = 1/6 part of tank. So, to fill it completely it will take 6 hours. Answer is: d)
Description : two pipes X and Y can fill a cistern in 18 hrs and 24 hrs respectively. If both the pumps are opened simultaneously. How much time will be taken to fill the cistern? A) 10hrs 50mints B) 10 hrs 5mints C) 10hrs 17mints D) 10hrs 44mints
Last Answer : C Part filled by x in 1hour = 1/18 Part filled by y in 1 hour = 1/24 Part filled by (x+y) in 1 hour = 1/18 + 1/24 =>4+3/72 =>7/72 The cistern will be full in 72/7 hrs = 10 hrs 17mins.
Description : The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than (A) 18 bar diameters (B) 24 bar diameters (C) 30 bar diameters (D) 36 bar diameters
Description : After cleaning a slow sand filter, the filtered water is not used for (A) 6 hours to 12 hours (B) 12 hours to 18 hours (C) 18 hours to 24 hours (D) 24 hours to 36 hours
Last Answer : (D) 24 hours to 36 hours
Description : The tensile force required to cause an elongation of 0.045 mm in a steel rod of 1000 mm length and 12 mm diameter, is (where E = 2 × 106 kg/cm2 ) (A) 166 kg (B) 102 kg (C) 204 kg (D) 74 kg
Last Answer : (B) 102 kg
Description : If the diameter of the main reinforcement in a slab is 16 mm, the concrete cover to main bars is (A) 10 mm (B) 12 mm (C) 14 mm (D) 16 mm
Description : Which of the following statements is incorrect? (A) Minimum cross sectional area of longitudinal reinforcement in a column is 0.8% (B) Spacing of longitudinal bars measured along the periphery of ... (D) The number of longitudinal bars provided in a circular column should not be less than four
Description : Select the incorrect statement from the following [ A ] Reinforcing bars in a column should not be less than 12 mm in diameter [ B ] The number of longitudinal bars in a circular column should not ... The minimum percentage of longitudinal steel in columns should be 0.8% [ D ] None of the above
Last Answer : [ B ] The number of longitudinal bars in a circular column should not exceed four
Description : The minimum diameter of longitudinal steel should be [ A ] 10 mm [ B ] 12 mm [ C ] 16 mm [ D ] 20 mm
Last Answer : [ B ] 12 mm
Description : Consider the following statements: Maximum slenderness ratio of load-bearing masonry walls for a dwelling having more than two storeys shall not exceed. 1. 12, if lime mortar is used 2. 18, if cement-lime mortar 1:2:9 is used 3. 24, ... ? (a) 1 and 2 only b) 2 and 3 only c) 1 and 3 only d)1, 2 and 3
Last Answer : b) 2 and 3 only
Description : Pipes are laid parallel (A) To increase the capacity of the water supply (B) To provide a means of repairing without closing water supply (C) To meet the requirement of excessive supply (D) All the above
Last Answer : (D) All the above
Description : The cast iron pipes for water supply system are used for (A) Durability (B) Strength (C) Easy connection (D) All the above
Description : The type of pipe commonly used in water supply distribution schemes, is (A) R.C.C. pipes (B) Hume pipes (C) Cast iron pipes (D) G.I. pipes
Last Answer : (C) Cast iron pipes
Description : Air valves are generally provided in pressure pipes of water supply (A) At pipe junctions (B) At summits (C) At low points (D) Near service pipes
Last Answer : (B) At summits
Description : Pick up the correct statement in case of water supply. (A) Pipes laid in trenches and pipes fixed to walls are measured separately (B) Cutting through walls and floors are included with the item (C) Pipes are classified according to their sizes and quality (D) All the above
Description : A compound pipe is required to be replaced by a new pipe. The two pipes are said to be equivalent, if (A) Length of both the pipes is same (B) Diameter of both the pipes is same (C) Loss of ... discharge of both the pipes is same (D) Loss of head and velocity of flow in both the pipes is same
Description : The loss of head due to viscosity for laminar flow in pipes is (where d = Diameter of pipe, l = Length of pipe, v w = Specific weight of the flowing liquid) (A) 4 (B) 8 (C) 16 (D) 32
Description : Pick up the correct statement from the following: (A) All pipes and fittings are classified according to their diameters (B) The diameter of the pipes is the nominal diameter of internal bore (C) All pipes are measured along the centre line of the pipes in metres (D) All the above
Description : The difference in the reservoir level and the lowest point of the water mains is 180 m. The expected pressure due to water hammer is 7.5 kg/cm2 in a pressure conduit of diameter 1 m. Assuming the efficiency of the ... , is (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Last Answer : (C) 20 mm
Description : Two pipes X and Y can fill a bunker in 24 hours. If only pipe X is open then it would take 12 hours longer to fill the bunker. Find how much longer would it take if only pipe Y is open. A) 46hrs B) 32hrs C) 48hrs D) 34hrs
Last Answer : C X= 24+12 = 36 X+Y= 1/24 Y= 1/24 – 1/36 = 3-2/72 = 1/72 Y= 72 X alone= 72-24 = 48 HRS
Description : Two pipe P & Q fill a tab in 5 hrs and 20 hrs respectively. If both the pipes are open then due to the leakage, it took 30mins more to fill the tab. If the tab is full, how long will it take for the leakage alone to empty the tank? A) 28 B) 24 C) 36 D) 12
Last Answer : C Part filled by(P+Q) in 1 hr = 1/5 + 1/20 = ¼ So P & Q together can fill the tank in 4 hrs. Work done by the leak in 1 hr = 1 / 4 - 2/9 Leak will empty the tank in 36 hrs.
Description : A tank has two inlet pipes, A and B, which can fill the tank in 12 hours and 18 hours respectively, and an outlet C which can empty the tank in 9 hour
Last Answer : A tank has two inlet pipes, A and B, which can fill the tank in 12 hours and 18 hours ... time taken right from the start to fill the tank.
Description : Two pipes fills a tank in 12 hours and 15 hours respectively while a third pipe empties the tank in 18 hours. !f all three pipes operate simultaneously, in what time will the tank be full? a) 10 hours b) 10 10/17 hours c) 11 hours d) 9 hours e) 12 1/17 hours
Last Answer : b) 10 10/17 hours
Description : A copper wire 4 mm in diameter is evenly wound about a cylinder whose length is 24 cm and diameter 20 cm so as to cover the surface. -Maths 9th
Last Answer : answer:
Description : A butt weld has been made by MMA in a 50mm thick impact tested steel plate. The welding electrode used was a basic type, 5mm diameter. The measured welding parameters for one of the runs was 250 amps, 24 volts, using DC ... given to calculate the arc energy b) 1.9 kJ/mm c) 1.87 kJ/mm d) 2.0 kJ/mm
Last Answer : d) 2.0 kJ/mm
Description : Compute the maximum shearing stress developed in a phosphor bronze spring having mean diameter of 200 mm and consisting of 24 turns of 20-mm diameter wire when the spring is stretched 100 mm. and G = 42 GPa. a. 51 MPa b. 31.89 MPa c. 80 MPa d. 70 MPa
Last Answer : b. 31.89 MPa
Description : What is the shear stress acting on the outer surface of a hollow shaft subjected to a torque of 100 Nm?(The inner and outer diameter of the shaft is 15 mm and 30 mm respectively.) a. 50.26 N/mm2 b. 40.24 N/mm2 c. 20.120 N/mm2 d. 8.74 N/mm2
Last Answer : c. 20.120 N/mm2
Description : nternal diameter of thimble in conventional type of crucible is? (i) 14-16 mm (i) 16-18 mm (iii) 18-20 mm* (iv) 20-22 mm
Last Answer : (iii) 18-20 mm*
Description : The diameter of hole for 20 dia rivet shall be a) 23 mm b) 18 mm c) 21.5 mm* d) 22 mm
Last Answer : c) 21.5 mm*
Description : End anchorage of bars is taken as the greater of [ A ] Effective depth or 12 times the diameter of bar [ B ] Effective depth or 16 times the diameter of bar [ C ] Effective depth of 24 times the diameter of bar [ D ] Effective depth of 48 times the diameter of bar
Last Answer : [ A ] Effective depth or 12 times the diameter of bar