Description : The inner core ofan optical fiber is _______ in composition. A) glass or plastic B) copper C) bimetallic D) liquid
Last Answer : glass or plastic
Description : ______ cables arecomposed ofa glass or plastic inner core surrounded by cladding, allencasedin an outside jacket. A) Coaxial B) Fiber-optic C) Twisted-pair D) none of the above
Last Answer : Fiber-optic
Description : ……cables are composed of a glass or plastic inner core surrounded by cladding,all encased in an outside jacket. a. Fiber-optic b. Coaxial c. Shield Twisted Pair d. Unshield Twisted-pair
Last Answer : a. Fiber-optic
Description : ______ cable consists of an inner copper core and asecond conductingouter sheath. A) Twisted-pair B) Coaxial C) Fiber-optic D) Shielded twisted-pair
Last Answer : Coaxial
Description : Which of the following uses a very thin glass or plastic fiber through which pulses of light travel? a. Cat 1 b. Optical fiber c. Twisted pair d. Coax
Last Answer : b. Optical fiber
Description : In an optical fiber, the inner coreis _______ the cladding. A) denser than B) less dense than C) the samedensityas D) another name for
Last Answer : denser than
Description : Which of this is not a guided media? a) Fiber optical cable b) Coaxial cable c) Wireless LAN d) Copper wire
Last Answer : c) Wireless LAN
Description : Give two reasons why optical fiber manufacturers depart from the traditional circular core and cladding, low-loss glass fiber design?
Last Answer : To increase performance and reduce cost
Description : The three essential types of fiber commonly used today except: ∙ A. Plastic core and cladding ∙ B. Plastic core and glass cladding ∙ C. Glass core and glass cladding (SCS) ∙ D. Glass core and plastic cladding (PCS)
Last Answer : B. Plastic core and glass cladding
Description : How much power (roughly) a light emitting diode can couple into an optical fiber? a. 100 microwatts b. 440 microwatts c. 100 picowatts d. 10 miliwatts
Last Answer : 100 microwatts
Description : What type of communication media is the most widely usedcabling for data transfer today? A) Cat 5 B) Twisted pair C) Coaxial D) Optical fiber
Last Answer : Cat 5
Description : The physical layer provides __________ a. mechanical specifications of electrical connectors and cables b. electrical specification of transmission line signal level c. specification for IR over optical fiber d. all of the mentioned
Last Answer : d. all of the mentioned
Description : Which transmission media provides the highest transmission speed in a network? a. coaxial cable b. twisted pair cable c. optical fiber d. electrical cable
Last Answer : c. optical fiber
Description : Identify the non suitable medium for 802.3 ethernet? a. A thin coaxial cable b. A twisted pair cable c. A microwave link d. A fiber optical cable
Last Answer : c. A microwave link
Description : Maximum data transfer rate of the optical fiber is……….? a. 50 kbps b. 1000 kbps c. 1000 Mbps d. None of the these
Last Answer : c. 1000 Mbps
Description : The main hardware components of a graphics workstation are …………… A. Thick coax, optical fiber B. twisted pair , thin coax C. twisted, optical fiber D. Thick coax, Thin coax
Last Answer : D. Thick coax, Thin coax
Description : The physical layer provides __________ A. mechanical specifications of electrical connectors and cables B. electrical specification of transmission line signal level C. specification for IR over optical fiber D. all of the mentioned
Last Answer : D. all of the mentioned
Description : What specifications does physical layer provides __________. A. mechanical specifications of electrical connectors and cables B. electrical specification of transmission line signal level C. specification for IR over optical fiber D. all of the mentioned
Description : Which of the following cannot be used as a medium for 802.3 ethernet? a) A thin coaxial cable b) A twisted pair cable c) A microwave link d) A fiber optical cable
Last Answer : c) A microwave link
Description : What kind of transmission medium is most appropriate to carry data in a computer network that is exposed to electrical interferences? a) Unshielded twisted pair b) Optical fiber c) Coaxial cable d) Microwave
Last Answer : b) Optical fiber
Description : The physical layer provides __________ a) mechanical specifications of electrical connectors and cables b) electrical specification of transmission line signal level c) specification for IR over optical fiber d) all of the mentioned
Last Answer : d) all of the mentioned
Description : Which transmission media provides the highest transmission speed in a network? a) coaxial cable b) twisted pair cable c) optical fiber d) electrical cable
Last Answer : c) optical fiber
Description : The inner portion of the fiber cable is called a. Cladding b. Coating c. Inner conductor d. Core
Last Answer : d. Core
Description : The inner portion of the fiber cable is called ∙ a. Cladding ∙ b. Coating ∙ c. Inner conductor ∙ d. Core
Last Answer : ∙ d. Core
Description : In a fiber-optic cable, the signal is propagatedalong theinner core by _______. A) reflection B) refraction C) modulation D) none of the above
Last Answer : reflection
Description : Why bimetallic washers provided in aluminium copper transition joints?
Last Answer : To avoid galvanic corrosion failure.
Description : Is the different angle of entry of light into an optical fiber when the diameter of the core is many times the wavelength of the light transmitted. a. Acceptance angle b. Modes c. Sensors d. Aperture
Last Answer : b. Modes
Description : The core of an optical fiber has a a. Lower refracted index than air b. Lower refractive index than the cladding c. Higher refractive index than the cladding d. Similar refractive index with the cladding
Last Answer : c. Higher refractive index than the cladding
Description : The core of the optical fiber has ______. A. A medium index of refraction B. A lower index of refraction than the cladding C. A lower index of refraction than air D. A higher index of refraction than the cladding
Last Answer : D. A higher index of refraction than the cladding
Description : The different angles of entry of light into an optical fiber when the diameter of the core is many times the wavelength of the light transmitter is known as ________. A. refraction B. sensor C. mode D. emitter
Last Answer : C. mode
Description : ECE Board Exam March 1996 That dielectric material of an optical fiber surrounding the core A. Cladding B. Armor C. Shield D. Cover
Last Answer : A. Cladding
Description : A mode filter is a device that attenuates specific modes propagating in the core of an optical fiber. What mode propagating along single mode fibers do mode filters eliminate?
Last Answer : Second-order mode.
Description : optical launch conditions exists if the launch spot size and angular distribution are larger than that of the fiber core?
Last Answer : Overfilled.
Description : A light ray incident on the optical fiber core is propagated along the fiber. Is the angle of incidence of the light ray entering the fiber larger or smaller than the acceptance angle
Last Answer : Smaller.
Description : A type of index of an optical fiber that has no cladding and whose central core has a non-uniform refractive index. ∙ A. graded index ∙ B. multimode ∙ C. single mode ∙ D. step-index
Last Answer : ∙ A. graded index
Description : A type of index profile of an optical fiber that has a central core and outside cladding with a uniform refractive index ∙ A. multimode ∙ B. graded index ∙ C. step-index ∙ D. single mode
Last Answer : ∙ C. step-index
Description : The graded-index multimode optical fiber has a core diameter of _____ nm. ∙ a. 0.5 ∙ b. 0.05 ∙ c. 0.0005 ∙ d. 5
Last Answer : ∙ a. 0.5
Description : A step-index multimode optical fiber has a core diameter of _____ nm. ∙ a. 0.02 ∙ b. 0.2 ∙ c. 2 ∙ d. 0.002
Last Answer : b. 0.2
Description : A single mode optical fiber has a core diameter of _____ nm. ∙ a. 0.1 ∙ b. 0.01 ∙ c. 0.2 ∙ d. 0.05
Last Answer : a. 0.1
Description : Is the different angle of entry of light into an optical fiber when the diameter of the core is many times the wavelength of the light transmitted. ∙ a. Acceptance angle ∙ b. Modes ∙ c. Sensors ∙ d. Aperture
Description : The core of an optical fiber has a ∙ a. Lower refracted index than air ∙ b. Lower refractive index than the cladding ∙ c. Higher refractive index than the cladding ∙ d. Similar refractive index with the cladding
Description : The claddingwhichsurroundsthe fiber core a. is used to reduce optical interference b. is used to protect the fiber c. acts to help guide the light in the core d. ensures that the refractive index remains constant
Last Answer : c. acts to help guide the light in the core
Description : Light is confined within the core of a simple optical fiber by: (1) Refraction. (2) Total internal reflection at the outer edge of the cladding. (3) Total internal reflection at the core cladding boundary. (4) Reflection from the fiber's plastic coating.
Last Answer : Light is confined within the core of a simple optical fiber by: Total internal reflection at the core cladding boundary.
Description : ________cable consists of two insulated copper wires twistedtogether. A) Coaxial B) Fiber-optic C) Twisted-pair D) none of the above
Last Answer : Twisted-pair
Description : The core of a fiber optic is surrounded by a. Wire braid shield b. Kevlar c. Cladding d. Plastic insulation
Last Answer : c. Cladding
Description : The core of fiber-optic cable is surrounded by ∙ A. wire braid shield ∙ B. Keviar ∙ C. cladding ∙ D. plastic insulation
Last Answer : ∙ C. cladding
Description : The core of a fiber optic is surrounded by ∙ a. Wire braid shield ∙ b. Kevlar ∙ c. Cladding ∙ d. Plastic insulation
Last Answer : ∙ c. Cladding
Description : Optical fibers for telecommunications are typically about _____ mils thick and consists of a glass core, a glass cladding of lower index of refraction, and a protective coating ∙ a. 5 ∙ b. 6 ∙ c. 7 ∙ d. 8
Last Answer : ∙ a. 5
Description : A liquid mixture contains 30% o-xylene, 60% p-xylene and 10%. mxylene (all percentages in w/w). Which of the following statements would be true in respect of this mixture? (A) The mixture exhibits ... : o-xylene 30, p-xylene 60 and m-xyoene 10 (D) The mixture contain optical isomers
Last Answer : (A) The mixture exhibits an azeotrope at 101.3 kPa
Description : Optical Fiber Optical fibers are the fine strands of _____. A. Glass B. Iron C. Calcium D. Mercury
Last Answer : ANSWER: A