Diaphragm valves are used for handling __________ fluids.
(A) Corrosive
(B) Viscous
(C) Non-Newtonian
(D) Solid suspended

1 Answer

Answer :

(A) Corrosive

Related questions

Description : A fluid whose apparent viscosity increases with shear rate is termed as the __________ fluid. (A) Newtonian (B) Viscous (C) Dilatant (D) Non-viscous

Last Answer : (C) Dilatan

Description : The damage/deterioration of metals by the __________ action of fluids is called 'erosion'. (A) Abrasive (B) Corrosive (C) Both (A) & (B) (D) Neither (A) nor (B)

Last Answer : (A) Abrasive

Description : Agitated film evaporator is suitable for concentrating __________ liquids. (A) Foaming (B) Viscous (C) Very thin (D) Corrosive

Last Answer : (B) Viscous

Description : In industrial operations fluids with temperature less than __________ are set as the limit for waste heat recovery because of the risk of condensation of corrosive liquids a. 80C b. 100C c. 120C d. 200C

Last Answer : 100C

Description : The Stoke's stream function applies to the (A) Irrotational flow only (B) Ideal/non i viscous fluids only (C) Cases of axial symmetry (D) None of these

Last Answer : (C) Cases of axial symmetry

Description : Isotropic turbulence occurs (A) Where there is no velocity gradient (B) At higher temperatures (C) Only in Newtonian fluids (D) None of these

Last Answer : (A) Where there is no velocity gradient

Description : Pick out the wrong statement. (A) The shear stress at the pipe (dia = D, length = L) wall in case of laminar flow of Newtonian fluids is (D/4L). ∆p (B) In the equation, T. gc = k. ... to motion (D) With increase in the Mach number >0.6, the drag co-efficient decreases in case of compressible fluids

Last Answer : (D) With increase in the Mach number >0.6, the drag co-efficient decreases in case of compressible fluids

Description : Power required for mixing Newtonian fluids is a function of the (A) Speed of impeller, diameter of impeller & viscosity (B) Density & viscosity of fluid only (C) Density of fluid, viscosity of fluid & impeller dia only (D) None of these

Last Answer : (D) None of these

Description : For laminar flow of Newtonian fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, μ = fluid viscosity ) (A) μ (B) 1/μ (C) √μ (D) 1/√μ

Last Answer : (B) 1/μ

Description : Pick out the wrong statement pertaining to fluid flow. (A) The ratio of average velocity to the maximum velocity for turbulent flow of Newtonian fluid in circular pipes is 0.5 (B) The Newtonian ... at the centre of the pipe (C) Navier-Stokes equation is applicable to the analysis of viscous flows

Last Answer : (A) The ratio of average velocity to the maximum velocity for turbulent flow of Newtonian fluid in circular pipes is 0.5

Description : Leidenfrost point is a term concerned with the (A) Condensation of the saturated vapor on a cold surface (B) Concentration of a corrosive solution by evaporation (C) Heat transfer between two highly viscous liquids (D) Boiling of a liquid on a hot surface

Last Answer : (D) Boiling of a liquid on a hot surface

Description : Open pan evaporators are preferred to be used, when the solution to be concentrated is (A) Scaling (B) Highly viscous (C) Corrosive (D) Salty

Last Answer : (B) Highly viscous

Description : Which of the following is the most suitable filter for separation ofabrasive solids suspended in a corrosive liquid? (A) Sand bed filter (B) Plate and frame filter press (C) Vacuum filter (D) Batch basket centrifuge

Last Answer : (C) Vacuum filter

Description : Diaphragm pumps are used to transport (A) Solids (B) Liquids (C) Fluids (D) Slurries

Last Answer : (D) Slurries

Description : Pick out the wrong statement. (A) Packed towers are preferred for vacuum operation, because the pressure drop through the packing is less and they (packings) also lessen the ... of liquid, problem of channelling, loading & flooding is generally encountered in packed towers

Last Answer : (C) Diameter of randomly packed tower is normally more than 1.2 metres

Description : Explain with reason through which side of shell and tube heat exchanges, the following liquids are directed. (i) viscous liquid (ii) high pressure liquid (iii) corrosive liquid

Last Answer : Viscous liquid : Viscous liquid is passed through shell side Reason: because of the presence of baffles in the shell induce turbulence and hence increases heat transfer rate. High pressure liquid: High ... To avoid expensive alloy shells (in order to save the cost of expensive material for shell).

Description : Where diaphragm valves are used?

Last Answer : Answer: Used for low pressure corrosive services as shut off valves.

Description : With neat sketch explain the construction and working of heat exchanger used for handling corrosive liquid.

Last Answer : Graphite block heat exchanger:   Graphite heat exchangers are well suited for handling corrosive fluids. Graphite is inert towards most corrosive fluids and has very high thermal conductivity. Graphite being ... vertical faces direct the service fluid through the exchanger in a cross flow.

Description : Practical fluids (A) Are viscous (B) Possess surface tension (C) Are compressible (D) Possess all the above properties

Last Answer : Answer: Option D

Description : . A fluid which has a linear relationship between the magnitude of applied shear-stress and the resulting rate of deformation is called a/an __________ fluid. (A) Newtonian (B) Non-Newtonian (C) Ideal (D) Incompressible

Last Answer : (A) Newtonian

Description : Sewage sludge is __________ type of non-Newtonian fluid. (A) Dilatant (B) Bingham plastic (C) Pseudo plastic (D) None of these

Last Answer : (B) Bingham plastic

Description : Non-colloidal solution is an example of the __________ fluid. (A) Non-Newtonian (B) Newtonian (C) Dilatent (D) Pseudo-plastic

Last Answer : (B) Newtonian

Description : The fluid velocity varies as the square of the cylindrical pipe diameter, in case of steady state laminar flow at constant pressure drop, for __________ fluid. (A) Newtonian (B) Dilatant (C) Pseudo-plastic (D) Non-Newtonian

Last Answer : (A) Newtonian

Description : The function of skimming tank in sewage treatment is to remove __________ substances. (A) Dissolved solid (B) Suspended solid (C) Oil & fatty (D) Gritty & inorganic

Last Answer : (C) Oil & fatty

Description : Explain the type of multiple effect evaporator feed arrangement used for handling viscous liquid.

Last Answer : Backward feed arrangement  If the liquid is very viscous, then we have to adopt backward feed arrangement. In this arrangement, the feed solution and vapour flow is in opposite direction. Fresh feed is ... Not very common as it need pump. At low values of feed temperature higher economy.

Description : Water is a __________ fluid. (A) Real (B) Ideal (C) Newtonian (D) Non-Newtonian

Last Answer : Answer: Option C

Description : Navier-Stokes equation is useful in the analysis of __________ fluid flow problems. (A) Non-viscous (B) Viscous (C) Turbulent (D) Rotational

Last Answer : (B) Viscous

Description : Applicability of Bernoulli's equation is limited to a/an __________ fluid, that does not exchange shaft work with the surroundings. (A) Incompressible (B) Non-viscous (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : Solid particles separation based on the difference in their flow velocities through fluids is termed as the (A) Clarification (B) Classification (C) Elutriation (D) Sedimentation

Last Answer : (B) Classification

Description : The effect of solid boundary on the fluid flow is confined to the boundary layer, except for fluids (A) Having high viscosities (B) Moving at low velocities (C) Both (A) & (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) & (B)

Description : Rubber latex is an example of a __________ fluid. (A) Pseudo plastic (B) Bingham plastic (C) Dilatent (D) Newtonian

Last Answer : (A) Pseudo plastic

Description : Sewage sludge is an example of the __________ fluid. (A) Bingham plastic (B) Newtonian (C) Pseudo plastic (D) Dilatent

Last Answer : (A) Bingham plastic

Description : The fluid in which the shearing stress within it is proportional to the velocity gradient across the sheared section, is called a __________ fluid. (A) Bingham (B) Newtonian (C) Perfect (D) None of these

Last Answer : (B) Newtonian

Description : Rubber latex is an example of __________ fluid. (A) Dilatants (B) Newtonian (C) Pseudo plastic (D) Bingham plastic

Last Answer : (C) Pseudo plastic

Description : The fluid velocity varies as the cube of the cylindrical pipe diameter in case of steady state laminar flow at constant pressure drop for __________ fluid. (A) Newtonian (B) Pseudo-plastic (C) Dilatent (D) Bingham plastic

Last Answer : (B) Pseudo-plastic

Description : Quicksand is an example of a __________ fluid. (A) Bingham plastic (B) Dilatant (C) Newtonian (D) Pseudo plastic

Last Answer : (B) Dilatant

Description : Paper pulp is an example of __________ fluid. (A) Dilatant (B) Bingham plastic (C) Newtonian (D) Pseudo-plastic

Last Answer : (B) Bingham plastic

Description : For laminar flow of Newtonian fluid in a circular pipe, the velocitydistribution is a function of the distance 'd' measured from the centre line of the pipe, and it follows a __________ relationship. (A) Logarithmic (B) Parabolic (C) Hyperbolic (D) Linear

Last Answer : (B) Parabolic

Description : The fluid velocity varies as the square root of the cylindrical pipe diameter in case of steady state laminar flow at constant pressure drop of __________ fluid. (A) Dilatent (B) Pseudo-plastic (C) Bingham plastic (D) Newtonian

Last Answer : (A) Dilatent

Description : A fluid is termed as the Newtonian fluid, when the shear stress is __________ the velocity gradient. (A) Independent of (B) Inversely proportional to (C) Directly proportional to (D) None of these

Last Answer : (C) Directly proportional to

Description : The diffusivity, DAB (for component A diffusing in B) is equal to the diffusivity DBA (for component B diffusing in A) for a binary mixture of (A) Newtonian liquids (B) Non-Newtonian liquids (C) Ideal gases (D) Real gases

Last Answer : (C) Ideal gases

Description : Pick out the wrong statement. (A) Momentum transfer in laminar flow results from velocity gradient (B) A fluid in equilibrium is not free from shear stress (C) The viscosity of a non-Newtonian fluid is a function of temperature only (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Pick out the correct statement. (A) Human blood is a Newtonian fluid (B) A Newtonian fluid obeys Newton's law of cooling (C) For a non-Newtonian fluid, a straight line passes through the origin in a plot between shear stress and shear gradien

Last Answer : (B) A Newtonian fluid obeys Newton's law of cooling

Description : Which of the following is a Newtonian fluid? (A) Rubber latex (B) Sewage sludge (C) Quicksand (D) Non-colloidal solution

Last Answer : (D) Non-colloidal solution

Description : For a given fluid, as the pipe diameter increases, the pumping cost (A) Decreases (B) Increases (C) Remains the same (D) May increase or decrease, depending upon whether the fluid is Newtonian or non-Newtonian

Last Answer : (A) Decreases

Description : What is a good device to use for obtaining viscosity data for a non-Newtonian fluid?

Last Answer : Consider a rotational viscometer. It will measure the shear rate applied and the subsequent viscosity at the same time. You can also vary the temperature and time the stresses are applied ... shows that this product exhibits a marked shear thinning viscosity profile over the test conditions.

Description : Multistage centrifugal pumps are generally used for (A) High head (B) Low head but high discharge (C) Highly viscous liquid (D) Slurries of high solid concentration

Last Answer : (A) High head

Description : The terminal velocity of a small sphere settling in a viscous fluid varies as the (A) First power of its diameter (B) Inverse of the fluid viscosity (C) Inverse square of the diameter (D) Square of the difference in specific weights of solid & fluid

Last Answer : (B) Inverse of the fluid viscosity

Description : __________ centrifuge is the most suitable for separation of non-friable crystals. (A) Tubular bowl (B) Disc-bowl (C) Perforated horizontal basket continuous (D) Suspended batch baske

Last Answer : (C) Perforated horizontal basket continuous