In a furnace operation, which is not preheated?
(A) Solid fuels
(B) Hydrocarbon containing fuel gases (e.g. coke oven gas, refinery gas etc.)
(C) Both (A) and (B)
(D) Neither (A) nor (B)

1 Answer

Answer :

(C) Both (A) and (B)

Related questions

Description : In practical operation of any furnace, zero oxygen percentage or theoretical CO2 percentage in flue gas is rarely achieved, because of (A) Use of non-preheated combustion air (B) Use of pulverised solid ... of fuel & air and infiltration of air (D) Use of excessive positive draft in the furnace

Last Answer : (C) Imperfect mixing of fuel & air and infiltration of air

Description : Which of the following is not a by-product fuel? (A) Producer gas (B) Blast furnace gas (C) Coke oven gas (D) Refinery gas

Last Answer : (A) Producer gas

Description : Which of the following has the highest gross calorific value? (A) Blast furnace gas (B) Coke oven gas (C) Carburetted water gas (D) Oil refinery gas

Last Answer : (D) Oil refinery gas

Description : Which of the following fuel gases is heavier than air? (A) Blast furnace gas (B) Coke oven gas (C) Natural gas (D) Water gas

Last Answer : (A) Blast furnace gas

Description : . Which of the following fuel gases contains maximum amount of carbon monoxide? (A) Coke oven gas (B) Water gas (C) Blast furnace gas (D) L.D. converter gas

Last Answer : (D) L.D. converter gas

Description : Which is a regenerative furnace? (A) Coke oven heating chamber (B) Open hearth furnace (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : Which of the following fuels is generally not used in thermal power plant boiler firing? (A) Furnace oil, light diesel oil and tar/PCM (B) Pulverised coking coal (C) Coal middling from washeries (D) B.F. gas, coke oven gas and L.D. converter gas

Last Answer : (B) Pulverised coking coal

Description : Out of the following fuels, the difference between gross and net calorific value will be minimum in case of (A) Coke oven gas (B) Water gas (C) Natural gas (D) Blast furnace gas

Last Answer : (D) Blast furnace gas

Description : Which of the following accentuates clinkering troubles on furnace grate burning coal? (A) Low reactivity of carbonised residue containing high proportion of iron & sulphur (B) Low forced draft & fuel bed temperature (C) Thick firebed and preheated primary air (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Which of the following accentuates clinkering trouble on furnace grate burning coal? (A) Low reactivity of carbonised residue containing high proportions of iron & sulphur (B) Low forced draught and fuel bed temperature (C) Thick fire bed and preheated primary air (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Fuel economy in an industrial furnace operation cannot be achieved by the use of (A) Stoichiometric combustion air (B) Non-preheated combustion air (C) Combustion air not enriched with oxygen (D) Recuperators

Last Answer : (A) Stoichiometric combustion air

Description : Which of the following gaseous fuels has the lowest calorific value? (A) Gobar gas (B) Refinery gas (C) Converter gas (D) Blast furnace gas

Last Answer : (D) Blast furnace gas

Description : Coke oven gas produced by high temperature carbonisation of coal (as compared to that produced by low temperature carbonisation), has (A) Higher calorific value (B) Lower hydrogen content (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (D) Neither (A) nor (B)

Description : Fuel used in B.F. stove is (A) Pulverised coal (B) Furnace oil (C) Blast furnace gas/mixed gas (D) Coke oven gas

Last Answer : (C) Blast furnace gas/mixed gas

Description : Coke oven gas is a better fuel than blast furnace gas, because of its higher (A) Calorific value, cleanliness and relatively low distribution cost (due to its low specific gravity) (B) Adiabatic flame temperature ... release rate (thus requiring smaller combustion chamber) (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Which is the heaviest fuel gas out of the following? (A) Blast furnace gas (B) Coke oven gas (C) Water gas (D) Carburetted water gas

Last Answer : (A) Blast furnace gas

Description : Which of the following is a poisonous fuel gas? (A) Coke oven gas (B) Blast furnace gas (C) Natural gas (D) None of these

Last Answer : (B) Blast furnace gas

Description : White flue gas (resembling steam) coming out of the chimney of a thermal power plant indicates that the fuel used in the boiler furnace is (A) Tar (B) Coke oven gas (C) Pitch (D) Pulverised coke

Last Answer : (B) Coke oven gas

Description : For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm3 ), while the C.V. is same on weight basis (i.e., kcal/kg)? (A) Propane and acetylene (B) Propane and LPG (C) Sewage gas and gobar gas (D) B.F. gas and coke oven gas

Last Answer : (A) Propane and acetylene

Description : For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm3) while the C.V. is same on weight basis (i.e., kcal/kg)? (A ... and acetylene (B) Propane and LPG (C) Sewage gas and gobar gas (D) B.F gas and coke oven gas

Last Answer : D) B.F gas and coke oven gas

Description : Mixed gas' used in steel plants is a mixture of (A) B.F. gas and coke oven gas (B) Coke oven gas and converter gas (C) Coke oven gas and L.P.G (D) Blast furnace gas and naphtha vapor

Last Answer : (A) B.F. gas and coke oven gas

Description : Regenerators are installed in (A) Coke ovens (B) Open hearth furnace (C) Both (A) & (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) & (B)

Description : Which furnace employs an I.D. fan for the removal of flue gases from the furnace? (A) Coke oven (B) Blast furnace stoves (C) Beehive coke oven (D) High pressure boiler

Last Answer : (D) High pressure boiler

Description : Prime coking coal is always blended with medium or non- coking coal before carbonisation (A) To check against its excessive swelling during heating, which may exert high pressure and damage coke oven walls (B) Because, it alone produces unreactive coke (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : Moist climate is the most favourable factor in the site selection far a (A) Steel plant (B) Textile factory (C) Petroleum refinery (D) Coke oven battery

Last Answer : (B) Textile factory

Description : Which of the following is not a by-product fuel? (A) Pitch (B) Blast furnace gas (C) Petrol (D) Refinery gas

Last Answer : (C) Petrol

Description : Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace? (A) Increase in calorific value of the fuel (B) Increase in flame temperature (C) Reduction in scale losses (D) Saving in fuel consumption

Last Answer : (A) Increase in calorific value of the fuel

Description : Use of preheated air for combustion of fuel in the furnace, increases the (A) Scale losses of the furnace stock (B) Calorific value of the fuel (C) Flame temperature (D) None of these

Last Answer : (C) Flame temperature

Description : Which of the following is not increased by using preheated combustion air in place of ordinary air at room temperature? (A) Calorific value of the fuel (B) Flame temperature achieved (C) Speed of combustion of fuel (D) Heat transfer rate to the stock in the furnace

Last Answer : (A) Calorific value of the fuel

Description : 'GASOHOL' widely used in Brazil as a motor fuel is a mixture of alcohol and (A) Petrol (B) LPG (C) Light hydrocarbon gases (e.g. butane or propane) (D) None of these

Last Answer : (A) Petrol

Description : Operation of blast furnace stove is based on the principles of a __________ furnace. (A) Regenerative (B) Recuperative (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (A) Regenerative

Description : Which of the following is a rich fuel gas? (A) Producer gas (B) Coal gas from underground gasification of coal (C) Refinery gases (D) None of these

Last Answer : (C) Refinery gases

Description : Coke ovens in steel plant are heated by (A) Electricity (B) Blast furnace gas/mixed gas (C) Coke oven gas (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Dip stick used for measuring the level of petro fuels (e.g. petrol, diesel, fuel oil etc.) in the storage tank is usually made of (A) Brass (B) Copper (C) High carbon steel (D) Aluminium

Last Answer : (A) Brass

Description : Find false statement about effect of sulphur in fuel? (A) It has heating value (B) It helps in electrostatic precipitation of ash in flue gases (C) It leads to corrosion of air heaters, ducting, etc. if flue gas exit temperature is low (D) It erodes furnace walls

Last Answer : (D) It erodes furnace walls

Description : Which of the following has the least calorific value (kcal/Nm3 )? (A) Blast furnace gas (B) Coke oven gas (C) Sewage gas (D) Natural gas

Last Answer : (A) Blast furnace gas

Description : Gross & net calorific value is the same for (A) Blast furnace gas (B) Coke oven gas (C) L.D. converter gas (D) None of these

Last Answer : (C) L.D. converter gas

Description : Which of the following is the most poisonous gas? (A) Coke oven gas (B) Producer gas (C) Blast furnace gas (D) L.D. converter gas

Last Answer : (D) L.D. converter gas

Description : Coke oven gas compared to blast furnace gas is (A) More explosive and inflammable (B) Less poisonous (C) Lighter (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Which of the following has the highest theoretical flame temperature? (A) Blast furnace gas (B) Hydrogen (C) Acetylene (D) Coke oven gas

Last Answer : (C) Acetylene

Description : Which of the following would require maximum amount of % excess air for complete combustion? (A) Coke oven gas (B) Furnace oil (C) Pulverised coal (D) Lump coal (fixed on chain grate)

Last Answer : (D) Lump coal (fixed on chain grate)

Description : The calorific value is the highest out of the following for (A) Producer gas (B) Water gas (C) Coke oven gas (D) Blast furnace gas

Last Answer : (C) Coke oven gas

Description : Blast furnace gas compared to coke oven gas has (A) Lower ignition temperature (B) Narrower limit of inflammability (C) Higher calorific value (D) Lower theoretical flame temperature

Last Answer : (D) Lower theoretical flame temperature

Description : Coke oven gas after passing through return electrostatic tar precipitator (RETP) is used for the (A) Hot scarfing of steel slabs (B) Mixing with blast furnace gas (C) Coke oven battery heating (D) Steel ladle drying

Last Answer : (C) Coke oven battery heating

Description : Which of the following contains least amount of N2? (A) Coke oven gas (B) Blast furnace gas (C) Producer gas (D) Water gas (blue gas)

Last Answer : (A) Coke oven gas

Description : Heat transfer rate to the charge/stock in a furnace does not depend upon the (A) Type of fuels viz. solid, liquid or gaseous (B) Flue gas temperature (C) Emissivity of refractory walls (D) Initial temperature of the charged stock

Last Answer : (A) Type of fuels viz. solid, liquid or gaseous

Description : Out of the following fuels, the difference between the net and gross calorific value is maximum in case of (A) Pitch (B) Fuel oil (C) Blast furnace gas (D) Bituminous coal

Last Answer : (B) Fuel oil

Description : High ash containing coke (A) Produces more slag when used in the blast furnace (B) Has poor strength and abrasion resistance (C) Is desirable in producer gas manufacture (D) None of these

Last Answer : (A) Produces more slag when used in the blast furnace

Description : Compound coke ovens are those which can be heated by (A) Both steam and electrical power (B) Lean gas (e.g., B.F. gas) (C) Rich gas (e.g., coke oven gas) (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Pick out the wrong statement. (A) Addition of methane to the furnace atmosphere reduces decarburising by hydrogen (B) Nitrogen in presence of steam decor-burises high carbon steel, whereas hydrocarbon ... the metal surface) cause nitride formation with increase in surface hardness (D) None of these

Last Answer : (D) None of these