Regenerators are installed in
(A) Coke ovens
(B) Open hearth furnace
(C) Both (A) & (B)
(D) Neither (A) nor (B)

1 Answer

Answer :

(C) Both (A) & (B)

Related questions

Description : Regenerators are normally provided in the (A) Glass melting furnace (B) Open hearth furnace (C) By product coke ovens (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Regenerators are normally provided in the (A) Glass melting furnace (B) Open hearth furnace (C) By product coke ovens (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Which is a regenerative furnace? (A) Coke oven heating chamber (B) Open hearth furnace (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : An example of recuperative furnace is the (A) Soaking pit (B) Open hearth furnace (C) Coke ovens (D) None of these

Last Answer : (A) Soaking pit

Description : Regenerators are used for waste heat recovery in (A) By-product coke ovens (B) Beehive coke oven (C) Blast furnace stoves (D) Soaking pits

Last Answer : (A) By-product coke ovens

Description : Which of the following is not a directly fired furnace? (A) By-product coke oven (B) Calcination kiln (C) Sintering furnace (D) Open hearth furnace

Last Answer : (A) By-product coke oven

Description : In a furnace operation, which is not preheated? (A) Solid fuels (B) Hydrocarbon containing fuel gases (e.g. coke oven gas, refinery gas etc.) (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : Coke ovens in steel plant are heated by (A) Electricity (B) Blast furnace gas/mixed gas (C) Coke oven gas (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Which is a continuous furnace? (A) Coke ovens (B) Annealing furnace (C) Glass tank furnace

Last Answer : (C) Glass tank furnace

Description : Main use of hard coke produced by high temperature carbonisation is in the (A) Iron blast furnace (B) Cupola in foundries (C) Sinter making (D) Domestic ovens

Last Answer : (A) Iron blast furnace

Description : Neutral atmosphere is maintained in a/an __________ furnace. (A) Cold rolled steel coil annealing (B) Open hearth (C) Soaking pit (D) Walking beam reheating

Last Answer : (A) Cold rolled steel coil annealing

Description : Which furnace employs preheating, heating and soaking zones? (A) Soaking pit (B) Reheating furnace (C) Open hearth furnace (D) Cupola

Last Answer : (B) Reheating furnace

Description : __________ is an indirectly heated furnace. (A) Open hearth furnace (B) Muffle furnace (C) Soaking pit (D) Reheating furnace

Last Answer : (B) Muffle furnace

Description : Thermal efficiency of an open hearth furnace may be about __________ percent. (A) 5 (B) 20 (C) 50 (D) 80

Last Answer : (B) 20

Description : Which is not a hearth furnace? (A) Glass tank furnace (B) Open hearth furnace (C) Cupola

Last Answer : (C) Cupola

Description : Coke oven regenerators are made of __________ bricks. (A) Fire clay (B) Silica (C) Low thermal conductivity (D) High electrical conductivity

Last Answer : (A) Fire clay

Description : The main function of a muffle in the muffle furnace is to (A) Protect the charge from the effects of the products of combustion (B) Smooth out temperature inequalities on the combustion side of the muffle wall (C) Both (A) & (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) & (B)

Description : The heating capacity of muffle furnace depends on the (A) Surface area & emissivity of the stock (B) Properties of the muffle wall (temperature, area, and emissivity) (C) Both (A) & (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) & (B)

Description : Coke ovens in steel plant are heated by (A) Electricity (B) Coke oven gas (C) Mixed gas (D) Both (B) & (C)

Last Answer : (D) Both (B) & (C)

Description : Pick up the correct statement from the following: (A) In basic Bessemer process, the steel heats the converter (B) In open-hearth process, the furnace heats the steel (C) In Siemens process, the impurities of pig iron are oxidised by the oxygen of the ore (D) All the above

Last Answer : Answer: Option D

Description : Unit of furnace loading is (A) Ton stock/hr/m2 hearth area (B) Ton stock/hr (C) Ton stock/m2 hearth area (D) Both (B) and (C)

Last Answer : (A) Ton stock/hr/m2 hearth area

Description : Coke made in narrower by-product coke ovens (as compared to wider ovens) is (A) Less reactive (B) Stronger (C) Smaller in size (D) All (A), (B) & (C)

Last Answer : (D) All (A), (B) & (C)

Description : Phenolic water generated in coke ovens & by-product plant attached to an integrated steel plant containing phenol in concentration of less than 100 mg/litre can be removed by (A) Chlorination (B) Treating in biological oxygen pond (C) Chemical coagulation (D) None of these

Last Answer : (B) Treating in biological oxygen pond

Description : Phenolic water generated in coke ovens & by-product plant of a steel plant are disposed off by (A) Quenching of hot coke (B) Discharging in the river stream (C) Filtration and recycling for cooling coke oven gas (D) None of these

Last Answer : (A) Quenching of hot coke

Description : In Hydrofining catalytic desulphurisation process for sweetening of petroleum products, use of hydrogen (A) Enhances the desulphurisation process (B) Minimises coke formation (C) Both (A) and (B) (D) Neither (A) nor (B

Last Answer : (C) Both (A) and (B)

Description : Prime coking coal is always blended with medium or non- coking coal before carbonisation (A) To check against its excessive swelling during heating, which may exert high pressure and damage coke oven walls (B) Because, it alone produces unreactive coke (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : Coke oven gas produced by high temperature carbonisation of coal (as compared to that produced by low temperature carbonisation), has (A) Higher calorific value (B) Lower hydrogen content (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (D) Neither (A) nor (B)

Description : Operation of blast furnace stove is based on the principles of a __________ furnace. (A) Regenerative (B) Recuperative (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (A) Regenerative

Description : Example of an indirectly heated furnace is (A) Hood annealing furnace (B) Muffle furnace (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) and (B)

Description : Compound coke ovens are those which can be heated by (A) Both steam and electrical power (B) Lean gas (e.g., B.F. gas) (C) Rich gas (e.g., coke oven gas) (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Check valves are installed (A) On the delivery side of the pumping set (B) At the interconnections between polluted water system and a potable water system (C) Both (a) and (b) (D) Neither (a) nor (b)

Last Answer : (C) Both (a) and (b)

Description : Large tonnage of refractory bricks are dried in a (A) Shaft furnace (B) Rotary hearth furnace (C) Tunnel kiln (D) Muffle furnace

Last Answer : (C) Tunnel kiln

Description : If the flame is produced under the hearth and then sweeps up into the heating chamber, this is called a/an __________ furnace. (A) Sidefired (B) Underfired (C) Covered (D) Recirculating

Last Answer : (B) Underfired

Description : An improved and fuel efficient version of the pusher type reheating furnace is the __________ furnace. (A) Walking beam (B) Shaft (C) Tunnel (D) Rotary hearth

Last Answer : (A) Walking beam

Description : The heating capacity of continuous reheating furnace depends upon the (A) Hearth area and furnace temperature (B) Emissivity of the stock (C) Ratio of wall surface to stock surface (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : In India the rails are manufactured by A. Open hearth process B. Duplex process C. Both A & B D. None of These

Last Answer : C [Both A & B]

Description : Beehive coke ovens are made of __________ bricks. (A) Silica (B) Fireclay (C) Silicon carbide (D) Corundum

Last Answer : (A) Silica

Description : In regenerative air preheater (as practised in heating of coke ovens), the heat is transferred (A) Through a metallic wall (B) By direct contact of hot flue gas with air (C) By ... material (like chequor bricks) and then heating the air from this hot material (D) None of these

Last Answer : (C) By heating an intermediate material (like chequor bricks) and then heating the air from this hot material

Description : Beehive coke oven (A) Facilitates by-products recovery (B) Takes 2-3 days for coking of coal but requires no external fuel for heating (C) Gives larger yield of coke (around 85%) as compared to by-product ovens (D) Produces coke with very poor strength

Last Answer : (B) Takes 2-3 days for coking of coal but requires no external fuel for heating

Description : Narrow coke ovens as compared to wider coke ovens (A) Produce smaller coke (B) Produce stronger coke (C) Require less time of carbonisation (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Flue gas from the heating chamber of byproduct coke ovens is removed by (A) Forced draft fan (B) Induced draft fan (C) Steam ejector (D) Natural draft

Last Answer : (D) Natural draft

Description : Heat penetration rate in narrow coke ovens in high temperature carbonisation of coal is around __________ cm/hr. (A) 2.5 (B) 0.5 (C) 10 (D) 20

Last Answer : (A) 2.5

Description : Coking time in narrow by-product coke ovens is around __________ hours. (A) 18 (B) 48 (C) 8 (D) 80

Last Answer : (A) 18

Description : High rate of heating of coke ovens (A) May damage its walls due to abrupt excessive swelling of coal (B) Produces larger size coke (C) Increases the time of carbonisation (D) None of these

Last Answer : (A) May damage its walls due to abrupt excessive swelling of coal

Description : Undercharging of coal in the by-product coke ovens results in (A) Decrease in the c.v. of coke oven gas (B) Increase in its throughput (C) Increase in the c.v. of coke oven gas

Last Answer : (A) Decrease in the c.v. of coke oven gas

Description : Preheating of coal charge for the coke ovens reduces the (A) Time of carbonisation (B) Yield of gas and tar (C) Fuel consumption in coking (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Presence of free moisture in coal during its high temperature carbonisation (A) Reduces the coking time (B) Protects the volatile products from pyrolysis (cracking) in the presence of hot coke and hot oven walls (C) Increases the loss of fine coal dust from the ovens when charging (D) None of these

Last Answer : (B) Protects the volatile products from pyrolysis (cracking) in the presence of hot coke and hot oven walls

Description : Pick out the wrong statement. (A) Nitrogen is normally supplied in fertiliser either in Ammoniacal or the nitrate form, from which the soil takes it up in the form of ammonium ions ornitrate ... nitrate fertiliser is obtained as a by-product in an integrated steel plant having by-product coke ovens

Last Answer : (D) Ammonium nitrate fertiliser is obtained as a by-product in an integrated steel plant having by-product coke ovens

Description : Regenerators as compared to recuperators for the same duty(A) Store smaller quantity of waste heat (B) Are lighter & compact (C) Involve higher initial cost (D) All (A), (B) & (C)

Last Answer : (C) Involve higher initial cost

Description : Gross & net calorific value is the same for (A) Blast furnace gas (B) Coke oven gas (C) L.D. converter gas (D) None of these

Last Answer : (C) L.D. converter gas