Description : What is the voltage rating of the capacitor ?
Last Answer : : The maximum voltage that the capacitor operates is called the voltage rating of the capacitor. This voltage rating of the capacitor is expressed by the letter V.
Description : The voltage of a capacitor 12F with a rating of 2J energy is a) 0.57 b) 5.7 c) 57 d) 570
Last Answer : a) 0.57
Description : Which of the following precautions should be taken when a blown fuse, rated at 10 amperes, is replaced? A. Short out the fuse before removing it from the circuit. B. Use needle-nose pliers to ... D. Fuses of 10 ampere rating and less are virtually harmless when energized and may be handled freely.
Last Answer : Answer: C
Description : If a fuse of correct size and type blows frequently, ________________. A. try the next higher amperage rating B. try the next lower amperage rating C. look for trouble within the circuit D. reduce the applied voltage 10%
Description : AC and DC generators are similar in that they _____________. A. both generate alternating voltages B. both rectify the voltage before delivery C. are constructed at the same physical size for the same kilowatt rating D. both supply three-phase power
Last Answer : Answer: A
Description : Which of the following characteristics is most critical in determining the size of the cable to be used in a particular circuit? A. voltage rating B. weight per unit length C. current rating D. inductance per unit length
Description : A fuse that blows often should be replaced only with a fuse of _____________. A. the recommended current and voltage rating B. higher current and voltage rating C. higher current and lower voltage rating D. lower current and higher voltage rating
Description : Define the followings. Insulation level, Rated short circuit breaking current, Making current, Short time rating, Impulse withstand voltage, Power frequency withstand voltage .
Last Answer : Insulation level - it is the combination of rated voltage, the corresponding impulse withstand voltage, which together characterize the insulation of the equipment as regards its ability to withstand ... wave of power frequency (50 Hz) which the insulation of equipment should withstand.
Description : If 200w, 100 w and 60 w lamps connected in series with 230V AC , which lamp glow brighter? Each lamp voltage rating is 230V.
Last Answer : Each bulb when independently working will have currents (W/V= I) For 200 Watt Bulb current (I200) =200/230=0.8696 A For 100 Watt Bulb current (I100) =100/230=0.4348 A ... current through it. So minimum power dissipated across it as min current X equal Voltage across =s min power dissipation
Description : What does quality factor depend on in resonance?
Last Answer : A:Quality factor q depends on frequency and bandwidth.
Description : What is the power rating safety factor for the light dimming rheostat shown in the illustration at '77H'? EL-0100 A. 1 B. 2 C. 3 D. 6
Last Answer : Answer: B
Description : Voltage build up in an isolated induction generator depends on A. Capacitor bank value B. Residual magnetism of the rotor iron C. Residual magnetism of the stator iron a) A, B b) A, B, C c) B d) A, C
Last Answer : Ans: A
Description : The value of the capacitance depends upon the________________? A.voltage applied B. thickness of the capacitor plates C. geometry of the capacitor D. dinsity of the capacitor plates
Last Answer : Ans: C
Description : The most inefficient method of voltage reduction, from the standpoint of power loss, even when placed in series with the load, is the use of a/an ____________. A. capacitor B. inductor C. resistor D. transistor
Description : Which of the following statements represents the action of a megohmmeter when testing a small capacitor in good condition? A. The meter pointer should immediately swing to the maximum resistance value ... . D. The meter pointer should immediately swing to a high reading and gradually decrease.
Description : Capacitance in an AC circuit will _____________. A. stop current flow once the capacitor is fully charged B. allow current flow in only one direction C. oppose any change in circuit voltage D. rectify the current
Description : The most inefficient method of voltage reduction from the stand point of power loss, is a/an _____________. A. capacitor in series with the load B. inductor in series with the load C. capacitor and inductor in series with the load D. resistor in series with the load
Last Answer : Answer: D
Description : Capacitors can be used in electric distribution systems to improve power factor. This is accomplished by seesawing energy between the capacitor and the _____________. A. generator B. inductive loads C. resistive loads D. all of the above
Description : What is capacitor? On what factor capacity of a capacitor depends?
Last Answer : Capacitor or condenser is a device to store electrical energy and to release it into the circuit of which the capacitor forms a part. Capacity of a capacitor depends on following factors a. Capacity ... the distance is less the capacity more. c. It depends on the nature of dielectric constant.
Description : On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend? a) Frequency b) Loop gain c) Forward gain d) All of the mentioned
Last Answer : Ans: D
Description : What is the voltage in a 30 and Omega circuit with a power rating of 480W?
Last Answer : Need answer
Description : The capacity of a battery is expressed in terms of A. Current rating B. Voltage rating C. Ampere hour rating D. None of the above
Last Answer : C. Ampere hour rating
Description : What does the voltage rating of a fuse indicate?
Last Answer : The ability of the fuse to quickly extinguish the arc after the fuse element melts and the maximum voltage that cannot jump across the gap of the fuse after the fuse opens.
Description : What is the voltage rating of a switch?
Last Answer : The maximum voltage allowable in the circuit in which the switch is installed.
Description : 4] In operating a 400hz transformer at 50Hz A. Only voltage is reduced in the same proportion as the frequency B. Only KVA rating is reduced in the same proportion as the frequency C. Both voltage and KVA rating are reduced in the same proportion as frequency D. None of the above
Last Answer : B. Only KVA rating is reduced in the same proportion as the frequency
Description : 47 Cross over windings are used in A. Low voltage side of high kVA rating transformers B. Current transformers C. High voltage side of high kVA rating transformers D. High voltage side of low kVA rating transformers
Last Answer : D. High voltage side of low kVA rating transformers
Description : 4 Helical coils can be used on A. Low voltage side of high kVA transformers B. High frequency transformers C. High voltage side of small capacity transformers D. High voltage side of high kVA rating transformers
Last Answer : A) low voltage side of high KVA transformer
Description : The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be : (A) 34.64 kVA (B) 75 kVA (C) 20 kVA (D) None of the above
Last Answer : The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be : 34.64 kVA
Description : To measure insulation resistance of equipments of voltage rating upto 440 V the megger generator must generate (a) 220 V (b) 440 V (c) 500 V (d) None of these
Last Answer : 500 V
Description : The rating of the Transformer __ when the supply frequency is increased: a) Remains unchanged b) Increases c) Decreases d) None of the above
Last Answer : Ans: B
Description : In accordance with Coast Guard Regulations (46 CFR), a circuit breaker located in the machinery space and installed in a 440V AC system must _____________. A. be dependent upon mechanical ... the maximum asymmetrical shortcircuit current available at the point of application D. all of the above
Description : A lead-acid battery can deliver 20 amperes continuously for 10 hours with an ampere-hour rating of ____________. A. 20 B. 40 C. 200 D. 400
Description : In the illustration if BRANCH NO. 1 is a lighting circuit for crew's berthing, Federal Regulations (46 CFR) require the maximum fuse rating for that branch to be _________. EL-0013 A. 80% of the connected load B. 15 amps C. 20 amps D. 30 amps
Description : The illustrated test is being conducted on the motor shown in the illustration, if the lamp lights dimly then ________. EL-0027 A. the bulb needs to be changed to one with a higher wattage rating B. ... D. a ground or partial ground is indicated, a check with a megger should confirm the lamp test
Description : In the illustration if BRANCH NO. 1 is a lighting circuit for crew's berthing, 46 CFR requires the maximum fuse rating for that branch to be _________. EL-0013 A. 15 amps B. 80% of the connected load C. 20 amps D. 30 amps
Description : Using a fuse whose rating is higher than necessary ________. A. endangers the apparatus it is supposed to protect B. reduces the possibility of short circuits C. increases the efficiency of the equipment by allowing more current to be used D. wastes money because they are more expensive
Description : When replacing fuses, always make sure _______________. A. to stand on a rubber mat and use rubber gloves B. to use insulated pliers or screwdriver C. the fuse clips are straight, tight, and in good contact D. to increase the fuse rating 10% to guard against 'nuisance blowing'
Description : Which of the following statements about copper wire sized by the AWG rating is correct? A. Number 12 AWG wire has a higher current rating than number 10 AWG wire. B. Number 10 AWG wire has a higher ... Number 12 AWG wire at 25°C has more resistance per 1000 feet than No. 10 AWG wire at 25°C.
Description : Which of the following statements concerning copper wire sized by AWG numbers is correct? A. Number 12 AWG wire has a higher current rating than 10 AWG wire. B. Number 12 AWG wire at 25°C has more ... dielectric strength than 12 AWG wire. D. Number 12 AWG wire is larger than number 10 AWG wire.
Description : When charging a 100 amp-hour lead-acid battery, ___________. A. the temperature of the electrolyte should not be allowed to exceed 90°F B. the charging rate should be no greater than 125% of the ... nearing full charge and it will be necessary to reduce the charging current to a low finishing rate
Description : As shown in the illustration, the circuit has been on the line for several days when component 'E1' burns out. The operator receives an alarm, switches over 'B' to energize the standby ... than required for the circuit therefore limiting the current through the alarm relay which will not pick up
Description : In three pin plug 6 Amp. 220v AC rating. why earth pin diameter is higher than ohter two pin? what its purpose ?
Last Answer : Because Current flow in the conductor is inversely proportional to the conductor diameter. So if any short circuits occur in the system first high currents bypassed in the Earthling terminal.( R=Pl/a area of the conductor increases resistance value decreases)
Description : Can Transformers be Reconnected as Autotransformers to Increase Their KVA Rating?
Last Answer : ANSWER: Several of standard single phase transformers can be connected as autotransformers. The KVA capacity will be greatly increased when used as an Autotransformer, in comparison to the ... This voltage is normally used for operating fluorescent lamps or similar devices requiring 277 volts
Description : Which type of motor is used in trains, what is the rating of supply used?
Last Answer : A:Dc series is in the trains to get high starting torque while starting of the trains and operating voltage is 1500v dc.
Description : What decides the control transformer VA rating?
Last Answer : Contactor coil VA rating.
Description : What is the rating of switchyard battery charger and batteries?
Last Answer : Switchyard is having Float cum boost charger of 282 V DC maximum and 100 Amps rated charger of six-pulse full wave thyristerised controlled rectifier. Batteries are tubular 220 V DC. +ve plate is made ... minutes. Specific gravity 1110 5 and specific gravity after 10 hrs discharge is 1150 5.
Description : What is the rating of generator PT fuse?
Last Answer : 24 kV, 3.15 Amps.
Description : Based on what factors will you select rating of components for a starter cell?
Last Answer : Factors for selecting rating of components are, a. Capacity of load. b. Type of starting. c. Duty (continuous or intermittent). d. Type of protection. e. Nature of starting (acceleration time is slow or fast).
Description : Two transformers operating in parallel will share the load depending upon their (A) Rating. (B) Leakage reactance. (C) Efficiency. (D) Per-unit impedance.
Last Answer : Ans: A Transformers having higher kVA rating will share more load.
Description : If the length of an antenna is changed from 2.5 meters to 2.8 meters, its resonant frequency will A. increase B. depend on the velocity factor so the resonant frequency can either be increased or decreased C. will be unchanged D. decrease
Last Answer : D. decrease