Description : The output of a balanced modulator is ____________. A. LSB and USB B. LSB C. USB D. Carrier
Last Answer : A. LSB and USB
Description : Digital transmission provides a higher level of signal quality than analog transmission because A. repeaters regenerate digital pulses and remove distorstion B. digital signals are easier to sample than ... and cannot easily be distorted D. analog signals are continuous and not easily distorted.
Last Answer : A. repeaters regenerate digital pulses and remove distorstion
Description : What is the primary advantage of DSBSC in AM? A. Reduce bandwidth over standard AM B. All of these C. It is simpler to transmit and receive than the standard AM D. No transmitter power is wasted in the carrier
Last Answer : D. No transmitter power is wasted in the carrier
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : An AM transmitter is rated 100W at 100% modulation. How much power required for the carrier? A. 33.33 W B. 66.66 W C. 83.33 W D. 100 W
Last Answer : B. 66.66 W
Description : If the percentage modulation of an AM amplifier is 88% and the modulating signal is 1 volt, the carrier has an amplitude of _______________. A. 1.14 volts B. 0.88 volt C. 1.88 volts D. 0.12 volt
Last Answer : A. 1.14 volts
Description : Three audio waves with 100,200 and 300 volts amplitude respectively, simultaneously modulate a 450 volts carrier. What is the total percent of modulation of the AM wave? A. 69 % B. 115.5 % C. 50% D. 83%
Last Answer : D. 83%
Description : What satellite system parameter represents the quality of a satellite or an earth station receiver? A. Gain-to-Equivalent Noise Temperature Ratio (G/Te) B. Energy of Bit-to-Noise Density Ratio (Eb/No) C. Carrier-to-Noise Density Ratio (C/No) D. Bit energy
Last Answer : A. Gain-to-Equivalent Noise Temperature Ratio (G/Te)
Description : Referred to as an average power from the radio transmitter supplied to the antenna transmission line taken during one radio frequency cycle under no modulation. A. Carrier power B. Rated power C. Peak envelop power D. Mean power
Last Answer : A. Carrier power
Description : Average power of a radio transmitter supplied to the antenna transmission line by a transmitter during one radio frequency cycle taken under the condition of no modulation. A. Peak envelop power B. Rated power C. Carrier power D. Mean power
Last Answer : C. Carrier power
Description : A coherent binary phase shift keyed BPSK transmitter operates at a bit rate of 20 Mbps with a carrier to noise ratio C/N of 8.8dB. Find Eb/No. A. 73 dB B. 62.4 dB C. 81.8 dB D. 8.8 dB
Last Answer : D. 8.8 dB
Description : ECE Board Exam March 1996 Communications code is ____________. A. eight bits per character B. agreed upon in advance between sender and receiver C. the same in all modern computers D. either seven or eight bits per character
Last Answer : B. agreed upon in advance between sender and receiver
Description : What synchronization is provided so that the start and end of message is identified? A. Carrier B. Character C. Bit D. Clock
Last Answer : B. Character
Description : What digital carrier transmits a digital signal at 274.176 Mbps? A. T1 B. T3 C. T2 D. T4
Last Answer : D. T4
Description : How many sidebands are present in the J3E mode? A. Two sidebands and a carrier B. One upper sideband C. One lower sideband D. Two carriers and one sideband
Last Answer : B. One upper sideband
Description : In radio signal emission designation, the fifth symbol means A. Details of signals B. Type of information transmitted C. Nature of multiplexing D. Nature of signal modulating the main carrier
Last Answer : C. Nature of multiplexing
Description : In t-carrier system, t3 has a bit rate of A. 560.160 Mbps B. 44.376 Mbps C. 44.736 Mbps D. 560.106 Mbps
Last Answer : C. 44.736 Mbps
Description : A 1000W carrier is amplitude modulated to a depth of 85%. Calculate the total power of the modulated wave? A. 1361.25 W B. 680.62 W C. 1425 W D. 712.5 W
Last Answer : A. 1361.25 W
Description : How far is the visual carrier from the lowest frequency in the spectrum of a monochrome TV broadcast channel following the NTSC standard? A. 1.5 MHz B. 1.25 MHz C. 4.5 MHz D. 0.25 MHz
Last Answer : B. 1.25 MHz
Description : What is the emission designation of a single sideband reduced carrier signal? A. H3E B. J3E C. R3E D. B8E
Last Answer : C. R3E
Description : What is the channel number of an FM station with a carrier frequency of 99.5 MHz? A. 256 B. 258 C. 257 D. 259
Last Answer : B. 258
Description : In the North American TDM system, what is the transmission rate in Mbps of T3 carrier system? A. 44.736 B. 6.312 C. 3.152 D. 274.176
Last Answer : A. 44.736
Description : ____ system transmits frequency-division-multiplexed voice band signals over a coaxial cable for distances up to 4000 miles. A. T carrier B. X carrier C. L carrier D. F carrier
Last Answer : C. L carrier
Description : What carrier system multiplexes 96 voice band channels into a single 6.312 Mbps data signal? A. T1 carrier system B. T2 carrier system C. T1C carrier system D. T3 carrier system
Last Answer : B. T2 carrier system
Description : What is the carrier frequency of supergroup 10? A. 2724 kHz B. 2356 kHz C. 2108 kHz D. 3100 kHz
Last Answer : D. 3100 kHz
Description : What term is used to describe a spread spectrum communications system in which a very fast binary bit stream is used to shift the phase of an RF carrier? A. Frequency hopping B. Direct sequence C. Binary phase-shift keying D. Phase compandored spread spectrum
Last Answer : B. Direct sequence
Description : What is the term used to describe a spread spectrum communications system where the center frequency if a conventional carrier is altered many time per second in accordance with a pseudo ... hopping B. Direct sequence C. Time-domain frequency modulation D. Frequency compandored spread spectrum
Last Answer : A. Frequency hopping
Description : What is meant by the term modulation index? A. The processor index. B. The ratio between the deviation of a frequency modulated signal and the modulating frequency. C. The FM signal-to-noise ratio. D. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Last Answer : B. The ratio between the deviation of a frequency modulated signal and the modulating frequency.
Description : What is meant by the term deviation ratio? A. The ratio of the audio modulating frequency to the center carrier frequency. B. The ratio of the maximum carrier frequency deviation to the highest ... . D. The ratio of the highest audio modulating frequency to the average audio modulating frequency.
Last Answer : B. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Description : Determine the terrain sensitivity loss for a 4-GHz carrier that is propagating over a very dry, mountainous area. A. -1.25 dB B. -3.05 dB C. -2.01 dB D. -5.01 dB
Last Answer : A. -1.25 dB
Description : In regulation of public telecommunications carrier such as in the evaluation of new entrant, the following consideration shall be given emphasis to _______. A. Legal, technical and citizenship B. ... and kind of service C. Citizenship, capacity and financial D. Technical, legal and financial
Last Answer : D. Technical, legal and financial
Description : What is meant by the term deviation ratio? A. The ratio of the carrier center frequency to the audio modulating frequency B. The ratio of the highest audio modulating frequency to the ... audio modulation frequency D. The ratio of the audio modulating frequency to the center carrier frequency
Last Answer : C. The ratio of the maximum carrier frequency deviation to the highest audio modulation frequency
Description : Type of emission produced by one of the early radio transmitter in trains of damped RF ac waves where its oscillator is coupled to a long wire antenna, normally used in radio telegraph and having sidebands on its carrier. A. Digital emission B. Key emission C. Cycle emission D. Spark emission
Last Answer : D. Spark emission
Description : In radio regulation, the first symbol in the designation of radio emission is ______. A. Bandwidth B. Nature of signal(s) modulation the main carrier C. Type of modulation of the main carrier D. Type of information to be transmitted
Last Answer : C. Type of modulation of the main carrier
Description : What is the first symbol of a radio signal transmission having an amplitude modulated signal carrier, double side band? A. C B. B C. H D. A
Last Answer : D. A
Description : An entity, relying on the transmission, switching and local distribution facilities of local exchange and inter-exchange operators, and overseas carriers, offers enhanced services beyond those ordinarily ... B. Value-added service provided C. Inter-exchange carrier D. Local exchange carrier
Last Answer : B. Value-added service provided
Description : Refers to the first symbol in an emission designation with an amplitude modulated main carrier represented by letter H. A. Single sideband suppressed carrier B. Double sideband full carrier C. Independent sideband D. Double sideband
Last Answer : B. Double sideband full carrier
Description : This is referred to a product of simultaneous frequency and amplitude modulation or a carrier frequency variation which produces unwanted distortion. A. Absorption modulation B. Simultaneous modulation C. Dynamic instability D. Series modulation
Last Answer : C. Dynamic instability
Description : It is an average power of a radio transmitter supplied to the antenna transmission line taken during a long sufficient interval of time and compared with the lowest frequency encountered in the modulation ... operating conditions. A. Carrier power B. Rated power C. Mean power D. Peak envelop power
Last Answer : C. Mean power
Description : In amplitude modulation technique the unmodulated carrier is referred to as having ______. A. 100% modulation B. 0% modulation C. 50% modulated D. Over modulated
Last Answer : B. 0% modulation
Description : Referred to an oscillator signal “leak through” from a properly neutralized amplifier such as a master oscillator power amplifier. A. Carrier B. Stray signal C. Back wave D. Loss wave
Last Answer : C. Back wave
Description : Which of the following is referred to as a radio emission without sidebands A. Analog B. Carrier C. Data D. Voice
Last Answer : B. Carrier
Description : The latest government regulation in the telecommunication which provides policy for the provision of local exchange carrier service. A. E.O. 546 B. E.O. 109 C. Act 3948 D. E.O. 59
Last Answer : B. E.O. 109
Description : A form of single sideband emission where the degree of carrier suppression enable the carrier to be reconstituted and be used for demodulation. A. Half carrier single sideband emission B. Full carrier single sideband emission C. Reduced carrier single sideband emission D. Double sideband emission
Last Answer : C. Reduced carrier single sideband emission
Description : How wide is the spectrum bandwidth of a single GSM carrier? A. 100 kHz B. 200 kHz C. 50 kHz D. 16 kHz
Last Answer : B. 200 kHz
Description : What is the basic qualification of an applicant for public carrier network before a certificate of public convenience or a provisional authority is issued? A. Franchise B. SEC document C. Business permit D. Radio station license
Last Answer : A. Franchise
Description : Which of the following refers to a double side band full carrier? A. A3E B. A3J C. F3 D. R3A
Last Answer : A. A3E
Description : A government regulation in telecommunication which provide policy to improve the provision of local exchange carrier service. A. E.O. 109 B. Act 3846 C. E.O. 59 D. E.O. 546
Last Answer : A. E.O. 109
Description : The sinusoidal carrier is pulsed so that one of the binary states is represented by a carrier while the other is represented by its absence. A. FSK B. ASK C. PSK D. QAM
Last Answer : B. ASK
Description : The product of the power supplied to the antenna and its gain relative to a half-wave dipole in a given direction. A. Peak envelope power B. ERP C. Rated power D. Carrier power’
Last Answer : B. ERP