Description : What is the baseband frequency of standard FDM basic supergroup? A. 312 to 552 kHz B. 300 to 600 kHz C. 60 to 2540 kHz D. 60 to 108 kHz
Last Answer : A. 312 to 552 kHz
Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone
Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : How wide is the spectrum bandwidth of a single GSM carrier? A. 100 kHz B. 200 kHz C. 50 kHz D. 16 kHz
Last Answer : B. 200 kHz
Description : The carrier swing necessary to provide 80% modulation in the FM broadcasting band is __________. A. 150 kHz B. 120 kHz C. 60 kHz D. 75 kHz
Last Answer : B. 120 kHz
Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz
Last Answer : C. 15 to 160 MHz
Description : What is the approximate bandwidth of an FM system with 10 kHz of modulating frequency and a 150 kHz of frequency deviation? A. 300 kHz B. 320 kHz C. 150 kHz D. 200 kHz
Last Answer : B. 320 kHz
Description : What frequency is 10 octaves above 30 Hz? A. 30.72 kHz B. 30 kHz C. 300 Hz D. 307.2 kHz
Last Answer : A. 30.72 kHz
Description : For a sample rate of 40 kHz, determine the maximum analog input frequency A. 30 kHz B. 40 kHz C. 20 kHz D. 10 kHz
Last Answer : C. 20 kHz
Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz
Last Answer : B. 15 to 160 Mhz
Description : A Hertz antenna is operating on a frequency of 2182 kHz and consists of a horizontal wire that is hanged between two towers. What is the frequency of its third harmonic? A. 727 kHz B. 6546 kHz C. 436 kHz D. 6.546 kHz
Last Answer : B. 6546 kHz
Description : An amplifier operating over the frequency range of 455 to 460 kHz has a 200 kΩ input resistor. What is the RMS noise voltage at the input to this amplifier if the ambient temperature is 17˚C ? A. 40 µV B. 4.0 µV C. 400 µV
Last Answer : B. 4.0 µV
Description : In acoustics, if the volume of the room is 200 m3 then at what frequency the coefficient of absorption is measured? A. 120 kHz B. 120 Hz C. 100 Hz D. 150 Hz
Last Answer : B. 120 Hz
Description : A superhet receiver has an IF of 455 kHz and is experiencing image-channel interference on a frequency of 1570 kHz. The receiver is tuned to A. 1115 kHz B. 660 kHz C. 2025 kHz D. 910 kHz
Last Answer : B. 660 kHz
Description : What is the typical frequency used for communicating to submerged submarines? A. 100 Hz B. 500 Hz C. 4 kHz D. 200 Hz
Last Answer : A. 100 Hz
Description : Tropospheric scatter is a method of sky wave propagation for which of the following frequency bands? A. 300 kHz to 3 MHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 300 MHz to 3 GHz
Last Answer : D. 300 MHz to 3 GHz
Description : What is the deviation ratio for an FM-phone signal having a maximum frequency swing of plus or minus 5 kHz and accepting a maximum modulation rate of 3kHz? A. 60 B. 0.16 C. 0.6 D. 1.66
Last Answer : D. 1.66
Description : Which of the following frequency bands is best suited for sky wave propagation? A. 30 to 300 kHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 3 GHz to 30 GHz
Last Answer : B. 3 MHz to 30 MHz
Description : Which of the following frequency bands is best suited for ground wave propagation? A. 30 to 300 kHz B. 300 kHz to 3 MHz C. 3 MHz to 30 MHz D. 30 MHz to 300 MHz
Last Answer : A. 30 to 300 kHz
Description : What is the frequency of a 2-cm sound wave in sea water at 25˚C? A. 76 kHz B. 76 Hz C. 76 MHz D. 76 mHz
Last Answer : A. 76 kHz
Description : Assuming a UHF frequency range of 405.0125 MHz to 405.0875 MHz at 25 kHz channeling plan, how many channels can you produce? A. 2.5 ch. B. 2 ch. C. 4 ch. D. 3 ch.
Last Answer : D. 3 ch.
Description : Assume a frequency range of 405.0125 MHz to 405.0875 MHz and 25 kHz channeling plan, determine the center frequency of the second channel from the lower limit. A. 405.030 MHz B. 405.025 MHz C. 405.050 MHz D. 405.075 MHz
Last Answer : C. 405.050 MHz
Description : Assume a frequency range of 401.000 MHz to 401.050 MHz, if you apply 25 kHz channeling plan, determine the center frequency of the first channel from the lower limit. A. 401.010 MHz B. 401.0125 MHz C. 401.025 MHz D. 401.00625 MHz
Last Answer : B. 401.0125 MHz
Description : If frequency range of 401.000MHz to 401.050MHz has to be channelized at 12.5 kHz between channel, what is the center of its first channel from the lower limit? A. 401.125MHz B. 401.00625MHz C. 401.025MHz D. 401.0125MHz
Last Answer : B. 401.00625MHz
Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz
Last Answer : B. 30 to 300 GHz
Description : What is the local oscillator frequency range commercial AM broadcast if it is equal to 455 KHz. A. 540 to 1600 KHz B. 0 to 1600 KHz C. 995 to 2055 KHz D. 0 to 455 KHz
Last Answer : C. 995 to 2055 KHz
Description : The frequency spectrum of the stereophonic FM signal. A. 67 kHz B. 59.5 to 74.5 kHz C. 19 to 38 kHz D. 30 to 53 kHz
Last Answer : D. 30 to 53 kHz
Description : ECE Board Exam March 1996 What is the purpose of a beat frequency oscillator (BFO)? A. Aid in the reception of weak voice-modulated signals B. Generates a signal, whose frequency is the ... reception D. Generates an output, whose frequency differs from that of the intermediate frequency by 1 kHz
Last Answer : C. Generates a 1kHz note for Morse code reception
Description : The carrier waves used for the radio transmission have frequency upto A. 15 KHz B. 30 KHz C. 90 KHz D. 150 KHz
Last Answer : ANSWER: B
Description : Given an AM radio signal with abandwidth of10 KHzand the highest-frequency component at 705 KHz, what is the frequency of the carrier signal? A) 700 KHz B) 705 KHz C) 710 KHz D) Cannot bedetermined from giveninformation
Last Answer : 700 KHz
Description : How far is the visual carrier from the lowest frequency in the spectrum of a monochrome TV broadcast channel following the NTSC standard? A. 1.5 MHz B. 1.25 MHz C. 4.5 MHz D. 0.25 MHz
Last Answer : B. 1.25 MHz
Description : What is the channel number of an FM station with a carrier frequency of 99.5 MHz? A. 256 B. 258 C. 257 D. 259
Last Answer : B. 258
Description : ____ system transmits frequency-division-multiplexed voice band signals over a coaxial cable for distances up to 4000 miles. A. T carrier B. X carrier C. L carrier D. F carrier
Last Answer : C. L carrier
Description : What term is used to describe a spread spectrum communications system in which a very fast binary bit stream is used to shift the phase of an RF carrier? A. Frequency hopping B. Direct sequence C. Binary phase-shift keying D. Phase compandored spread spectrum
Last Answer : B. Direct sequence
Description : What is the term used to describe a spread spectrum communications system where the center frequency if a conventional carrier is altered many time per second in accordance with a pseudo ... hopping B. Direct sequence C. Time-domain frequency modulation D. Frequency compandored spread spectrum
Last Answer : A. Frequency hopping
Description : What is meant by the term modulation index? A. The processor index. B. The ratio between the deviation of a frequency modulated signal and the modulating frequency. C. The FM signal-to-noise ratio. D. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Last Answer : B. The ratio between the deviation of a frequency modulated signal and the modulating frequency.
Description : What is meant by the term deviation ratio? A. The ratio of the audio modulating frequency to the center carrier frequency. B. The ratio of the maximum carrier frequency deviation to the highest ... . D. The ratio of the highest audio modulating frequency to the average audio modulating frequency.
Last Answer : B. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Description : What is meant by the term deviation ratio? A. The ratio of the carrier center frequency to the audio modulating frequency B. The ratio of the highest audio modulating frequency to the ... audio modulation frequency D. The ratio of the audio modulating frequency to the center carrier frequency
Last Answer : C. The ratio of the maximum carrier frequency deviation to the highest audio modulation frequency
Description : This is referred to a product of simultaneous frequency and amplitude modulation or a carrier frequency variation which produces unwanted distortion. A. Absorption modulation B. Simultaneous modulation C. Dynamic instability D. Series modulation
Last Answer : C. Dynamic instability
Description : It is an average power of a radio transmitter supplied to the antenna transmission line taken during a long sufficient interval of time and compared with the lowest frequency encountered in the modulation ... operating conditions. A. Carrier power B. Rated power C. Mean power D. Peak envelop power
Last Answer : C. Mean power
Description : Referred to as an average power from the radio transmitter supplied to the antenna transmission line taken during one radio frequency cycle under no modulation. A. Carrier power B. Rated power C. Peak envelop power D. Mean power
Last Answer : A. Carrier power
Description : Average power of a radio transmitter supplied to the antenna transmission line by a transmitter during one radio frequency cycle taken under the condition of no modulation. A. Peak envelop power B. Rated power C. Carrier power D. Mean power
Last Answer : C. Carrier power
Description : A carrier signal has ______. A. Constant peak amplitude B. The information C. Frequency range 20-20000 Hz D. A varying amplitude
Last Answer : A. Constant peak amplitude
Description : Which determines the number of sideband components of FM? A. Modulation frequency B. Modulation index C. Carrier frequency D. All of these
Last Answer : B. Modulation index
Description : Frequencies above ______ kHz, are referred to as the radio frequencies. A. 20 B. 2 C. 10 D. 200
Last Answer : A. 20
Description : A simply supported wooden beam 150 cm long and having a cross section 16 cm × 24 cm carries a concentrated load, at the centre. If the permissible stress ft = 75 kg/cm2 and fs= 10 kg/cm2 the safe load is (A) 3025 kg (B) 3050 kg (C) 3075 kg (D) 3100 kg
Last Answer : (C) 3075 kg
Description : The length of a Marconi antenna to operate with 985 kHz is ______. A. 200 ft B. 500 ft C. 250 ft D. 999 ft
Last Answer : C. 250 ft
Description : The noise output of a resistor is amplified by a noiseless amplifier having a gain of 60 and a bandwidth of 20 kHz. A meter connected at the output of the amplifier reads 1mV RMS. If the bandwidth of the amplifier is reduced to ... does the meter read now? A. 0.5 mV B. 0.5 µV C. 5.0 mV D. 5.0 µV
Last Answer : A. 0.5 mV
Description : Atmospheric noise becomes less severe at frequencies A. above 30 MHz B. below 30 MHz C. above 3000 kHz D. below 3000kHz
Last Answer : A. above 30 MHz
Description : At what power level does a 1 KHz tone cause zero interference (144 weighted)? A. 90 dB B. 90 dBm C. -90 dBm D. -90 dBm
Last Answer : D. -90 dBm