Description : Atmospheric noise becomes less severe at frequencies A. above 30 MHz B. below 30 MHz C. above 3000 kHz D. below 3000kHz
Last Answer : A. above 30 MHz
Description : What noise is observable at frequencies in the range from about 8 MHz to somewhat 1.5 GHz? A. Industrial noise B. Atmospheric noise C. Space noise D. Shot noise
Last Answer : C. Space noise
Description : Atmospheric noise or static is not a great problem A. at frequencies below 20 MHz B. at frequencies below 5 MHz C. at frequencies above 30 MHz D. at frequencies above 1 MHz
Last Answer : C. at frequencies above 30 MHz
Description : The band of frequencies least susceptible to atmospheric noise and interference is: A. 30 – 300 kHz B. 300 – 3000 kHz C. 3 – 30 MHz D. 300 – 3000 MHz
Last Answer : D. 300 – 3000 MHz
Description : Fiber optic cable operates near _______ frequencies. A. 800 THz B. 20 MHz C. 200 MHz D. 2 GHz
Last Answer : A. 800 THz
Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz
Last Answer : B. 15 to 160 Mhz
Description : What noise type is observable between 8 MHz to somewhat above 1.43 GHz or up to 1.5 GHz? A. Solar noise B. Space noise C. Galactic noise D. Cosmic noise
Last Answer : B. Space noise
Description : Extra-terrestrial noise is observable at frequencies from A. 0 to 20 KHz B. Above 2 GHz C. 8 to 1.43 GHz D. 5 to 8 GHz
Last Answer : C. 8 to 1.43 GHz
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : Most satellites operate in which frequency band? A. 30 to 300 MHz B. 300 MHz to 3 GHz C. 3 GHz to 30 GHz D. Above 300 GHz
Last Answer : C. 3 GHz to 30 GHz
Description : Tropospheric scatter is a method of sky wave propagation for which of the following frequency bands? A. 300 kHz to 3 MHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 300 MHz to 3 GHz
Last Answer : D. 300 MHz to 3 GHz
Description : Which of the following frequency bands is best suited for sky wave propagation? A. 30 to 300 kHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 3 GHz to 30 GHz
Last Answer : B. 3 MHz to 30 MHz
Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz
Last Answer : B. 30 to 300 GHz
Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz
Last Answer : D. 500 MHz
Description : What is the local oscillator (mixer) frequency of the satellite with an uplink frequency in GHz band? A. 3500 MHz B. 4500 MHz C. 2225 MHz D. 2555 MHz
Last Answer : C. 2225 MHz
Description : A radio frequency in the ultra high frequency band of the radio spectrum band. A. 235.50 MHz B. 450.50 MHz C. 150.50 GHz D. 0.31250 GHz
Last Answer : D. 0.31250 GHz
Description : Coaxial lines are used on those systems operating _______. A. Below 2 GHz B. At 300 MHz C. Above 10KHz D. Above 10GHz
Last Answer : A. Below 2 GHz
Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz
Last Answer : B. 0 to 4 kHz
Description : Electromagnetic waves of frequencies arbitrarily lower than 3,000 GHz, propagated in space without artificial guide. A. Space waves B. Terrestrial waves C. Mobile D. Hertzian waves
Last Answer : D. Hertzian waves
Description : Which of the following is designated as the international distress, safety and calling frequency for radio telephony for stations of the maritime mobile service when using frequencies in the authorized bands between 156 and 174 MHz? A. 165.8 MHz B. 156.8 MHz C. 158.6 MHz D. 168.5 MHz
Last Answer : B. 156.8 MHz
Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz
Last Answer : C. 15 to 160 MHz
Description : The ratio of the level of the modulated output of a transmitter under conditions of standard test modulation to the level of the demodulated output with no modulation applied both measured with the ... . Reference audio output B. None of these C. Audio frequency response D. Residual noise level
Last Answer : D. Residual noise level
Description : Where is the noise generated that primarily determines the signal-to-noise ratio in a VHF (150 MHz) marine-band receiver? A. In the ionosphere B. In the receiver rear end C. In the receiver front end D. In the atmosphere
Last Answer : C. In the receiver front end
Description : Which of the following low noise transistors is commonly used at microwave frequencies? A. MOSFET B. GASFET C. MESFET D. JFET
Last Answer : C. MESFET
Description : Which of the following types of noise becomes of great importance at frequencies? A. Shot noise B. Random noise C. Impulse noise D. Transit-time noise
Last Answer : D. Transit-time noise
Description : When no signal is being received, the loudspeaker is not entirely silent as a result of the presence of A. parasitic oscillations in some of the receiver stages. B. negative feedback in each stage. C. spurious frequencies as a result of improper neutralization. D. internal receiver noise.
Last Answer : D. internal receiver noise.
Description : What is the mixing process? A. Distortion caused by auroral propagation B. The combination of two signals to produce sum and difference frequencies. C. The elimination of noise in wideband receiver by phase differentiation D. The elimination of noise in a wideband receiver by phase comparison
Last Answer : B. The combination of two signals to produce sum and difference frequencies.
Description : Emission on a frequency or frequencies immediately outside the necessary bandwidth which result from the modulation process except spurious emission. A. Radiation B. Noise C. Out of the band D. Interference
Last Answer : C. Out of the band
Description : One of the reasons why FDM is being replaced by TDM is A. noise is amplified with voice when an FDM system is used B. it is difficult to place channels side by side C. there is more time than frequency D. Most available frequencies has been used
Last Answer : A. noise is amplified with voice when an FDM system is used
Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone
Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz
Description : The Ku-band in the satellite service A. 14/11 GHz B. 30/17 GHz C. 8/7 GHz D. 6/4 GHz
Last Answer : A. 14/11 GHz
Description : The full range of VHF frequencies used for communications is: a. 3 to 30 MHz b. 88 to 108 MHz c. 108.0 to 139.95 MHz d. 118.0 to 136.975 MHz
Last Answer : d. 118.0 to 136.975 MHz
Description : Which standard is utilized in intermodulation noise rates on PCM audio channels? A. CCIT Rec. G.151 B. CCIT Rec. G.172 C. CCIT Rec. G.190 D. CCIT Rec. G.190
Last Answer : B. CCIT Rec. G.172
Description : What is meant by the term modulation index? A. The processor index. B. The ratio between the deviation of a frequency modulated signal and the modulating frequency. C. The FM signal-to-noise ratio. D. The ratio of the maximum carrier frequency deviation to the highest audio modulating frequency.
Last Answer : B. The ratio between the deviation of a frequency modulated signal and the modulating frequency.
Description : What is the effect in over modulated amplitude modulated radio broadcasting transmission? A. Interference to adjacent channel B. Higher fidelity C. Increase noise D. Higher audio signal
Last Answer : A. Interference to adjacent channel
Description : The major cause of atmospheric or static noise are A. Thunderstorms B. Airplanes C. Meteor showers D. All of these
Last Answer : A. Thunderstorms
Description : What is the primary cause of atmospheric noise? A. Thunderstorm B. Lightning C. Thunderstorm and lightning D. Weather condition
Last Answer : B. Lightning
Description : Indicate the noise whose sources are in category different from that of the other three? A. Solar noise B. Cosmic noise C. Atmospheric noise D. Galactic noise
Last Answer : C. Atmospheric noise
Description : Atmospheric noise is known as _______noise. A. static B. cosmic C. solar D. lunar
Last Answer : A. static
Description : Which noise is produced by lighting discharges in thunderstorms? A. White noise B. Extraterrestrial noise C. Industrial noise D. Atmospheric noise
Last Answer : D. Atmospheric noise
Description : _________ is measured on a circuit when it is correctly terminated but does not have any traffic. A. White noise B. Galactic noise C. Impulse noise D. Atmospheric noise
Last Answer : A. White noise
Description : What do you call the random noise seen on radar display screen? A. Impulse noise B. Atmospheric noise C. Grass D. Johnson noise
Last Answer : C. Grass
Description : What is the major cause of atmospheric or static noise? A. Sunspots B. Airplanes C. Meteor showers D. Thunderstorm
Last Answer : D. Thunderstorm
Description : What range of frequencies are usually referred to as audio frequencies for humans? w) 0 to 20 Hertz x) 20 to 20,000 Hertz y) 200 to 200,000 Hertz z) 10,000 to 30,000 Hertz
Last Answer : ANSWER: X -- 20 TO 20,000 HERTZ
Description : What is the spectrum of stereophonic FM signal? A. 19 to 38 kHz B. 30 to 53 kHz C. 59.5 to 74.5 kHz D. 88 to 108 MHz
Last Answer : B. 30 to 53 kHz
Description : What is the most commonly used intermediate frequency of radar receivers? A. 40 MHz B. 60 MHz C. 70 MHz D. 30 MHz
Last Answer : D. 30 MHz
Description : Which of the following frequency bands is best suited for ground wave propagation? A. 30 to 300 kHz B. 300 kHz to 3 MHz C. 3 MHz to 30 MHz D. 30 MHz to 300 MHz
Last Answer : A. 30 to 300 kHz
Description : What is the actual length in feet of a one-quarter wavelength of a coax with a velocity factor of 0.68 to 30 MHz? A. 19.26 B. 5.6 C. 17.82 D. 16.97
Last Answer : B. 5.6
Description : Determine the gain of a 6 ft. parabolic dish operating at 1800 MHz. A. 30 dB B. 11.2 dB C. 15.5 dB D. 28.17 dB
Last Answer : D. 28.17 dB