What is the local oscillator (mixer) frequency of the satellite with an uplink frequency in
GHz band?
A. 3500 MHz
B. 4500 MHz
C. 2225 MHz
D. 2555 MHz

1 Answer

Answer :

C. 2225 MHz

Related questions

Description : A satellite receives an uplink frequency of _______ MHz from a ground station of 3700 MHz. A. 8150 MHz B. 1475 MHz C. 2225 MHz D. 5925 MHz

Last Answer : D. 5925 MHz

Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : Which of the following is the uplink frequency in C-band? A. 5.925 GHz B. 4.2 GHz C. 7.425 GHz D. 3.7 GHz

Last Answer : A. 5.925 GHz

Description : What consists the front-end circuit of a VHF TV superheterodyne receiver? A. Mixer, RF amplifier and AFC? B. RF amplifier, Band pass filter and mixer C. Local oscillator, mixer and RF amplifier D. Local oscillator, AGC and antenna

Last Answer : C. Local oscillator, mixer and RF amplifier

Description : Most satellites operate in which frequency band? A. 30 to 300 MHz B. 300 MHz to 3 GHz C. 3 GHz to 30 GHz D. Above 300 GHz

Last Answer : C. 3 GHz to 30 GHz

Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz

Last Answer : B. 30 to 300 GHz

Description : A radio frequency in the ultra high frequency band of the radio spectrum band. A. 235.50 MHz B. 450.50 MHz C. 150.50 GHz D. 0.31250 GHz

Last Answer : D. 0.31250 GHz

Description : The total space loss of transmission and reception for two ground stations with uplink frequency 8GHz and a downlink of 6 GHz with angle of elevations of 3˚ and 7˚ A respectively is A. 403 dB B. 100 dB C. 20 dB D. 215 dB

Last Answer : A. 403 dB

Description : What is the uplink receiver frequency if the downlink transmitter is on channel 4 (3.84 Ghz)? A. 6.065 GHz B. 6.84 GHz C. 6.65 GHz D. 6.05 GHz

Last Answer : A. 6.065 GHz

Description : An FM receiver whose intermediate frequency is 10.7 MHz, is experiencing image channel interference from a station transmitting on 121.1 MHz. If the local oscillator is tracking above, the receiver is tuned to A. 131.8 MHz B. 110.4 MHz C. 142.5 MHz D. 99.7 MHz

Last Answer : D. 99.7 MHz

Description : The frequency of Ku band for satellite communications. A. 6/4 GHz B. 14/11 GHz C. 12/14 GHz D. 4/8 GHz

Last Answer : B. 14/11 GHz

Description : What establishes the receiver bandwidth? A. RF amplifier B. Mixer C. Local oscillator D. IF amplifier

Last Answer : D. IF amplifier

Description : Refers to one of the front end circuit of a VHF TV superheterodyne receiver which is usually a separate circuit coupled to the mixer. A. Antenna feed B. AGC C. RF amplifier D. Local oscillator

Last Answer : D. Local oscillator

Description : After the IF stages have been aligned, the next stage to align in FM receiver is. A. local oscillator B. limiter stage C. RF amplifier D. mixer stage

Last Answer : A. local oscillator

Description : Tropospheric scatter is a method of sky wave propagation for which of the following frequency bands? A. 300 kHz to 3 MHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 300 MHz to 3 GHz

Last Answer : D. 300 MHz to 3 GHz

Description : Which of the following frequency bands is best suited for sky wave propagation? A. 30 to 300 kHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 3 GHz to 30 GHz

Last Answer : B. 3 MHz to 30 MHz

Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz

Last Answer : B. 15 to 160 Mhz

Description : The Ku-band in the satellite service A. 14/11 GHz B. 30/17 GHz C. 8/7 GHz D. 6/4 GHz

Last Answer : A. 14/11 GHz

Description : The Ku frequency band used in satellite communication (for uplink and downlink) is: (1) 14 GHz and 11 GHz (2) 30 GHz and 20 GHz (3) 70 GHz and 50 GHz (4) 60 GHz and 45 GHz 

Last Answer : The Ku frequency band used in satellite communication (for uplink and downlink) is: 14 GHz and 11 GHz 

Description : What is the typical bandwidth of a satellite band? A. 36 MHz B. 40 MHz C. 70 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : What is the quardband between transponder channels in the commercial C-band for satellite communications? A. 6 MHz B. 36 MHz C. 4 MHz D. 2 MHz

Last Answer : C. 4 MHz

Description : What is the frequency range of C-band? A. 8.5 to 12.5 GHz B. 3.4 to 6.425 GHz C. 12.95 to 14.95 GHz D. 27.5 to 31 GHz

Last Answer : B. 3.4 to 6.425 GHz

Description : What is the frequency range of C-band? A. 10.95 to 14.5 GHz B. 27.5 to 31 GHz C. 3.4 to 6.424 GHz D. 1.53 to 2.7 GHz

Last Answer : C. 3.4 to 6.424 GHz

Description : The signal path from satellite to earth-based receiver. A. Downlink signal B. Uplink signal C. Incident signal D. Reflected signal

Last Answer : A. Downlink signal

Description : The signal path from earth station satellite A. Uplink signal B. Reflected signal C. Incident signal D. Downlink signal

Last Answer : A. Uplink signal

Description : A satellite signal transmitted from a satellite transponder to earth’s station. A. Uplink B. Downlink C. Terrestrial D. Earthbound

Last Answer : B. Downlink

Description : Known as the satellite transmitted signal form a satellite transponder to earth’s station. A. Uplink B. Down link C. RHCP D. Vertically polarized

Last Answer : B. Down link

Description : Satellite signal transmitted from a satellite transponder to earth’s station. A. Vertically polarized B. Uplink C. Downlink D. RHCP

Last Answer : C. Downlink

Description : What noise is observable at frequencies in the range from about 8 MHz to somewhat 1.5 GHz? A. Industrial noise B. Atmospheric noise C. Space noise D. Shot noise

Last Answer : C. Space noise

Description : What noise type is observable between 8 MHz to somewhat above 1.43 GHz or up to 1.5 GHz? A. Solar noise B. Space noise C. Galactic noise D. Cosmic noise

Last Answer : B. Space noise

Description : Coaxial lines are used on those systems operating _______. A. Below 2 GHz B. At 300 MHz C. Above 10KHz D. Above 10GHz

Last Answer : A. Below 2 GHz

Description : Atmospheric noise is less at severe frequencies above A. Audio level B. 30 MHz C. 10 GHz D. 1 GHz

Last Answer : B. 30 MHz

Description : Fiber optic cable operates near _______ frequencies. A. 800 THz B. 20 MHz C. 200 MHz D. 2 GHz

Last Answer : A. 800 THz

Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz

Last Answer : B. 0 to 4 kHz

Description : When the elevation angle of a geostationary satellite is 23˚ and the transmitting frequency is 3840 MHz, what is the free space loss in dB? A. 196 dB B. 200 dB C. 150 dB D. 100 dB

Last Answer : A. 196 dB

Description : Which of the following systems uses frequency band 870-885 MHz as a transmit band of its base station? A. TACS B. NTT C. NMT D. AMPS

Last Answer : B. NTT

Description : Determine from the following radio frequency that falls under the very high frequency band of the radio spectrum. A. 345.00 MHz B. 144.50 MHz C. 235.50 MHz D. 450.00 MHz

Last Answer : C. 235.50 MHz

Description : Which of the following fall under the high frequency band of the radio spectrum? A. 8.2345 MHz B. 150.50 MHz C. 2.4555 MHz D. 35.535 MHz

Last Answer : A. 8.2345 MHz

Description : What is the local oscillator frequency range commercial AM broadcast if it is equal to 455 KHz. A. 540 to 1600 KHz B. 0 to 1600 KHz C. 995 to 2055 KHz D. 0 to 455 KHz

Last Answer : C. 995 to 2055 KHz

Description : he local oscillator and mixer are combined in one device because:

Last Answer : it is cheaper

Description : Describe the functions of mixer and local oscillator in radio receiver

Last Answer : Frequency Mixer:- The function of frequency mixer is to heterodyne signal frequency fs and local oscillator frequency fo. At the output, it produces the difference frequency known as ... local oscillator frequency fo is then mixed with incoming frequency to give intermediate frequency. 

Description : First communication satellites used frequencies of A. 6 GHz for uplink B. 3 GHz for uplink C. 6 GHz for downlink D. 5 GHz for downlink

Last Answer : 6 GHz for uplink

Description : Listed below are four respiratory capacities (i-iv) and four jumbled respiratory volumes of a normal human adult. Respiratory Respiratory capacities volumes (i) Residual volume 2500 mL (ii) Vital capacity 3500 mL (iii)Inspiratory ... c) (iv) 3500 mL, (i) 1200 mL (d) (i) 4500 mL, (ii) 3500 mL

Last Answer : (c) (iv) 3500 mL, (i) 1200 mL

Description : What is the difference in the number of products manufactured by the Company in the year 2009 and 2008 ? (1) 4000 (2) 5500 (3) 3500 (4) 4500 (5) None of these

Last Answer : (5) None of these

Description : What is the free space attenuation of a satellite communications system operating at 36,000 km above the earth at 5.0 GHz? A. 198 dB B. 202 dB C. 142 dB D. 138 dB

Last Answer : A. 198 dB

Description : Which of the following are uplinks in the Ku band? A. 14 to 14.5 GHz B. 11.7 to 12.2 GHz C. 14 to 15.5 GHz D. 11 to 11.5 GHz

Last Answer : A. 14 to 14.5 GHz

Description : State the reason for keeping uplink and downlink frequency different in satellite communication.

Last Answer : Uplink frequency is used for transmission of signals from earth station transmitter to satellite. Downlink frequency is used for transmission of signals from satellite to earth station receiver. ... the same antenna to be used for both receiving and transmitting simplifying satellite hardware.

Description : Approximately what is the frequency limit of the optical fiber? ∙ A. 20 MHz ∙ B. 1 MHz ∙ C. 100 MHz ∙ D. 40 GHz

Last Answer : ∙ D. 40 GHz

Description : What is the frequency limit of a copper wire? ∙ A. approximately 0.5 MHz ∙ B. approximately 1.0 MHz ∙ C. approximately 40 GHz ∙ D. none of the above

Last Answer : B. approximately 1.0 MHz

Description : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly

Last Answer : A 4 GHz carrier is amplitude modulated by a low-pass signal of maximum cut off frequency 1 MHz. lf this signal is to be ideally sampled, the minimum sampling frequency should be nearly 4 Ghz