What is the data rate in Mbps of a single satellite transponder considering an S/N of 30 dB?
A. 35.8
B. 3.58
C. 358
D. 3580

1 Answer

Answer :

C. 358

Related questions

Description : What is the maximum theoretical data rate of the above problem if one transponder is used for binary transmission? A. 36 Mbps B. 72 Mbps C.18 Mbps D. 144 Mbps

Last Answer : B. 72 Mbps

Description : A coherent binary phase shift keyed BPSK transmitter operates at a bit rate of 20 Mbps with a carrier to noise ratio C/N of 8.8dB. Find Eb/No. A. 73 dB B. 62.4 dB C. 81.8 dB D. 8.8 dB

Last Answer : D. 8.8 dB

Description : What satellite subsystem monitors onboard conditions such as temperature and battery voltage and transmits this data back to a ground station for analysis? A. Communications subsystem B. AKM C. TTC D. Transponder

Last Answer : C. TTC

Description : Designed to receive a signal from a transmitting station on the ground and retransmit it to a receiving station located elsewhere A. Communication satellite B. Repeater C. Relay station D. Transponder

Last Answer : A. Communication satellite

Description : Essentially a satellite ___________ is a radio repeater in the sky A. transponder B. comparator C. duplexer D. billboard

Last Answer : A. transponder

Description : The satellite communications channels in a transponder are defined by the A. LNA B. bandpass filter C. mixer D. input signals

Last Answer : B. bandpass filter

Description : The key electronic component in a communications satellite is the A. telemetry equipment B. on-board computer C. command and control system D. transponder

Last Answer : D. transponder

Description : A satellite signal transmitted from a satellite transponder to earth’s station. A. Uplink B. Downlink C. Terrestrial D. Earthbound

Last Answer : B. Downlink

Description : What is the first passive satellite transponder? A. Sun B. Early Bird C. Score D. Moon

Last Answer : B. Early Bird

Description : Which of the following is the basic component of a communications satellite receiver? A. On-board computer B. Reflector C. Telemetry D. Transponder

Last Answer : D. Transponder

Description : Which of the following satellite subsystem provides stabilization in orbit and senses changes in orientation? A. Attitude control subsystem B. TTC C. AKM D. Transponder

Last Answer : A. Attitude control subsystem

Description : What is the typical satellite transponder bandwidth? A. 24 MHz B. 500 MHz C. 36 MHz D. 48 MHz

Last Answer : C. 36 MHz

Description : What is the quardband between transponder channels in the commercial C-band for satellite communications? A. 6 MHz B. 36 MHz C. 4 MHz D. 2 MHz

Last Answer : C. 4 MHz

Description : Known as the satellite transmitted signal form a satellite transponder to earth’s station. A. Uplink B. Down link C. RHCP D. Vertically polarized

Last Answer : B. Down link

Description : The first passive satellite transponder. A. Early bird B. Score C. Moon D. Sputnik

Last Answer : C. Moon

Description : Satellite signal transmitted from a satellite transponder to earth’s station. A. Vertically polarized B. Uplink C. Downlink D. RHCP

Last Answer : C. Downlink

Description : Three identical circuits having 10 dB signal noise-to-noise ratio each are connected in tandem with each other, what is the overall S/N? A. 5.23 dB B. 14.77dB C. 30 dB D. 40 dB

Last Answer : A. 5.23 dB

Description : What carrier system multiplexes 96 voice band channels into a single 6.312 Mbps data signal? A. T1 carrier system B. T2 carrier system C. T1C carrier system D. T3 carrier system

Last Answer : B. T2 carrier system

Description : The main power sources for a satellite are A. batteries B. solar cells C. fuel cells D. thermoelectric generators 58. The maximum height of an ellip

Last Answer : B. solar cells

Description : What is the free space attenuation of a satellite communications system operating at 36,000 km above the earth at 5.0 GHz? A. 198 dB B. 202 dB C. 142 dB D. 138 dB

Last Answer : A. 198 dB

Description : When the elevation angle of a geostationary satellite is 23˚ and the transmitting frequency is 3840 MHz, what is the free space loss in dB? A. 196 dB B. 200 dB C. 150 dB D. 100 dB

Last Answer : A. 196 dB

Description : What is the approximate path loss from satellite-to-earth station? A. 100 dB B. 150 dB C. 175 dB D. 200 dB

Last Answer : D. 200 dB

Description : Ethernet is baseband system using CSMA/CD operating at A. 20 Mbps B. 10 Mbps C. 30 Mbps D. 40 Mbps

Last Answer : B. 10 Mbps

Description : The noise from an airplane engine 100 ft from an observer is found to have an intensity of 45dB. What will be the intensity when the plane flies overhead at an altitude of 1 mi? A. 10.5 dB B. 34.5 dB C. 35 dB D. 20.5 dB

Last Answer : A. 10.5 dB

Description : You are measuring noise in a voice channel at 7 dB test point level. The meter reads -56 dBm (FIA weighted). What is the reading in dBrnc? A. 20 B. 32 C. 35 D. 25

Last Answer : C. 35

Description : What is the velocity factor for non-foam dielectric 50 or 75 ohm flexible coaxial cable such as RG 8, 11, 58 and 59? A. 2.70 B. 0.66 C. 0.30 D. 0.10

Last Answer : B. 0.66

Description : What is the velocity factor for non-foam dielectric 50 or 75 ohm flexible coaxial cable such as RG 8, 11, 58 and 59? A. 2.70 B. 0.10 C. 0.66 D. 0.30

Last Answer : C. 0.66

Description : What is the number of levels required in a PCM system with S/N ratio of 40 dB? A. 64 B. 128 C. 256 D. 512

Last Answer : B. 128

Description : Three telephone circuits, each having an S/N ratio of 44 dB, are connected in tandem. What is the overall S/N ratio? A. 44 dB B. 39.2 dB C. 41 dB D. 43.52 dB

Last Answer : B. 39.2 dB

Description : Your Western Electric 3A test set meter reading is -23 dBm at at test point level of -8 dB. This is ______ dBrnc0. A. 75 B. 29 C. 30 D. 31

Last Answer : A. 75

Description : In t-carrier system, t3 has a bit rate of A. 560.160 Mbps B. 44.376 Mbps C. 44.736 Mbps D. 560.106 Mbps

Last Answer : C. 44.736 Mbps

Description : In the North American TDM system, what is the transmission rate in Mbps of T3 carrier system? A. 44.736 B. 6.312 C. 3.152 D. 274.176

Last Answer : A. 44.736

Description : Which of the following is not usually a part of a transponder are defined by the A. LNA B. Mixer C. Modulator D. HPA

Last Answer : C. Modulator

Description : How many transponder channels are realized in the commercial C-band without frequency re-use? A. 24 B. 12 C. 36 D. 48

Last Answer : B. 12

Description : Combination of modulator, channel and detector. A. Transceiver B. Discrete channel C. T/R channel D. Transponder

Last Answer : B. Discrete channel

Description : What is the insertion loss of connector type splices for a single mode optical fiber? A. 0.51 dB B. 0.49 dB C. 0.31 dB D. 0.38 db

Last Answer : D. 0.38 db

Description : Insertion loss of connector-type splices for a single-mode fiber cable. A. 0.2 dB B. 0.3 dB C. 0.09 dB D. 0.38 dB

Last Answer : D. 0.38 dB

Description : A reading of -50 dBm on the disturbing pair, and -80 on the disturbed pair equals _____ dB of crosstalk coupling. A. 20 B. 30 C. 60 D. 25

Last Answer : B. 30

Description : What signal-to-noise ratio is required for satisfactory television reception? A. 10 dB B. 30 dB C. 40 dB D. 20 dB

Last Answer : C. 40 dB

Description : The agreed standard for measuring loudness is the loudness sensation produced by a 1000 Hz sine wave _____ dB above the listener’s threshold of hearing. A. 80 B. 50 C. 30 D. 40

Last Answer : D. 40

Description : The signal to noise ratio that is required for a satisfactory television reception. A. 30 dB B. 40 dB C. 10 dB D. 20 dB

Last Answer : B. 40 dB

Description : Determine the gain of a 6 ft. parabolic dish operating at 1800 MHz. A. 30 dB B. 11.2 dB C. 15.5 dB D. 28.17 dB

Last Answer : D. 28.17 dB

Description : What signal-to-noise ratio is required for satisfactory telephone services? A. 50 dB B. 30 dB C. 40dB D. 20 dB

Last Answer : A. 50 dB

Description : What is the height of a satellite in a synchronous equatorial orbit? A. 42000 mi B. 6800 mi C. 22,300 mi D. 35,860 mi

Last Answer : C. 22,300 mi

Description : A satellite transmitter operates at 4GHz with an antenna gain of 4dBi. The receiver 40000 km away has an antenna gain of 50 dBi. If the transmitter has a power of 8 W, find (ignoring feedline losses and mismatch) the EIRP in dBW. A. 50 B. 69 C. 49 D. 30

Last Answer : C. 49

Description : The Ku-band in the satellite service A. 14/11 GHz B. 30/17 GHz C. 8/7 GHz D. 6/4 GHz

Last Answer : A. 14/11 GHz

Description : What digital carrier transmits a digital signal at 274.176 Mbps? A. T1 B. T3 C. T2 D. T4

Last Answer : D. T4

Description : What medium is used by IBM token ring network that operates at either 4 Mbps or 16 Mbps? A. Twisted pair B. Coaxial cable C. Fiber-optic D. Parallel-wire line

Last Answer : A. Twisted pair

Description : A digital carrier facility used to transmit a DSI-formatted signal at 1.544. Mbps. A. T2 B. T1 C. T4 D. T3

Last Answer : B. T1

Description : ECE Board Exam March 1996 The standard that specifies a balanced interface cable that will operate bit rates up to 10 Mbps with in a span distances up to 1200 m. A. RS-423A B. RS-422A C. RS-550A D. RS-449A

Last Answer : B. RS-422A