Description : What carrier system multiplexes 96 voice band channels into a single 6.312 Mbps data signal? A. T1 carrier system B. T2 carrier system C. T1C carrier system D. T3 carrier system
Last Answer : B. T2 carrier system
Description : How many telegraph channels are there in the basic voice band channels? A. 24 B. 96 C. 48 D. 672
Last Answer : A. 24
Description : If the loudness level is 100 phons, what is this in sone unit? A. 100 B. 90 C. 106 D. 96
Last Answer : C. 106
Description : The first Philippine Mabuhay satellite has how many channels? A. 30 B. 24 C. 48 D. 50
Last Answer : A. 30
Description : A certain gas with cp = 0.529Btu/lb°R and R = 96.2ft/lbºR expands from 5 ft and 80ºF to 15 ft while the pressure remains constant at 15.5 psia. a. T2=1.620ºR, ∫H = 122.83 Btu b. T2 = 2°R, ∫H = 122.83 Btu c. ... , ∫H = 122.83 Btu d. T2 = 1°R, ∫H = 122.83 Btu T2= V2(t2)/V1 and ∫H = mcp (T2-T1)
Last Answer : T2=1.620ºR, ∫H = 122.83 Btu
Description : What signal-to-noise ratio is required for satisfactory telephone services? A. 50 dB B. 30 dB C. 40dB D. 20 dB
Last Answer : A. 50 dB
Description : An AM transmitter is rated 100W at 100% modulation. How much power required for the carrier? A. 33.33 W B. 66.66 W C. 83.33 W D. 100 W
Last Answer : B. 66.66 W
Description : What is the phase delay of an 800 Hz voice signal if the phase shift is 15 degrees? A. 1.25 µsec B. 52 µsec C. 83.33 µsec D. 26 µsec
Last Answer : B. 52 µsec
Description : When was the UHF channel (14-83) of television were added? A. 1852 B. 1904 C. 1947 D. 1952
Last Answer : D. 1952
Description : In measuring noise in a voice channel at a 4 dB test point level, the meter reads -70 dBm (F1A weighted), convert the reading to pWp. A. 53 B. 93 C. 63 D. 83
Last Answer : B. 93
Description : ECE Board Exam March 1996 What is the IBM’s asynchronous data link protocol designation? A. 83 B B. 8A1 / 8B1 C. 93 B D. 9A1/ 9B1
Last Answer : A. 83 B
Description : The conversion of digital signal into analog for purposes of transmitting into the telephone line is done through ______. A. ISDN B. Radio C. RS232C D. Modem
Last Answer : D. Modem
Description : What is the typical gain of a rhombic antenna? A. Between 15 to 60 B. Between 20 to 90 C. Between 50 to 75 D. Between 10 to 25
Last Answer : A. Between 15 to 60
Description : The reverberation time of a 184.2 cubic meters broadcast studio is 0.84 sec. Find the absorption effect of the materials used in metric sabines. A. 35.3 B. 10.96 C. 379.8 D. 109.6
Last Answer : A. 35.3
Description : A building which is 64 meters high casts a shadow of length 96 meters. The height of a telephone tower which casts a shadow of 180 meters under similar conditions will be a) 100m b) 120m c) 180m d) 96m
Last Answer : b) 120m
Description : The number of `alpha`-and `beta`-particles emitted in the nuclear reaction, `._(90)Th^(228) to ._(83)Bi^(212)`, respectively are
Last Answer : The number of `alpha`-and `beta`-particles emitted in the nuclear reaction, `._(90)Th^(228) to ._(83)Bi^( ... ` and `1 beta` D. `4 alpha` and `7 beta`
Description : The number of `alpha` and `beta`-particles emitted in the nuclear reaction `._(90)^(210) Th to ._(83)^(212)Bi` are:
Last Answer : The number of `alpha` and `beta`-particles emitted in the nuclear reaction `._(90)^(210) Th to ._(83)^(212 ... `3 alpha, 7 beta` D. `4 alpha, 1 beta`
Description : What number completes this 107 98 90 83 77 68 65?
Last Answer : 72difference decreases by 1 each time9 = 107 - 988 = 98 - 907 = 90 - 836 = 83 - 775 = 77 - 724 = 72 - 683 = 68 - 65
Description : Which Constitutional Amendment a Constitutional status to the Panchayati Raj Institutions in India? a. 90 b. 83 c. 77 d. 73
Last Answer : d. 73
Description : The rated loads of lifting cranes, as percentage of tipping load at specified radius, for crawlermounted and pneumatic tyre-mounted machines would be respectively (A) 80 and 90 (B) 90 and 80 (C) 85 and 75 (D) 75 and 83
Last Answer : (D) 75 and 83
Description : Determine the maximum shearing stress and elongation in a helical steel spring composed of 20 turns of 20-mm-diameter wire on a mean radius of 90 mm when the spring is supporting a load of 1.5 kN. and G = 83 GPa. a. 200 mm b. 105.4 mm c. 150 mm d. 250 mm
Last Answer : b. 105.4 mm
Description : The satellite communications channels in a transponder are defined by the A. LNA B. bandpass filter C. mixer D. input signals
Last Answer : B. bandpass filter
Description : Crosstalk due to incomplete suppression of sidebands or to intermodulation of two or more frequency-multiplexed channels which is unintelligible is classified as A. Impulse noise B. Thermal noise C. Quantizing noise D. Miscellaneous noise
Last Answer : D. Miscellaneous noise
Description : Sources of impulse noise induced in communication channels. A. Erroneous digital coding bit caused by an error on a transmission facility B. Transients due to relay operation C. Crosstalk from dc signaling systems D. All of these
Last Answer : D. All of these
Description : Is the interference coming from other communications channels? A. Jitter B. Crosstalk C. RFI D. EMI
Last Answer : B. Crosstalk
Description : Which standard is utilized in intermodulation noise rates on PCM audio channels? A. CCIT Rec. G.151 B. CCIT Rec. G.172 C. CCIT Rec. G.190 D. CCIT Rec. G.190
Last Answer : B. CCIT Rec. G.172
Description : In SPADE system, how many PCM-encoded voice band channels are there? A. 800 B. 600 C. 300 D. 240
Last Answer : A. 800
Description : How many voice band channels are there in a superjumbo group? A. 600 B. 900 C. 10,800 D. 3,600
Last Answer : C. 10,800
Description : What is the term used to describe a spread spectrum communications system where the center frequency if a conventional carrier is altered many time per second in accordance with a pseudo ... hopping B. Direct sequence C. Time-domain frequency modulation D. Frequency compandored spread spectrum
Last Answer : A. Frequency hopping
Description : What is the typical center frequency spacing between adjacent channels (transponders) in satellites? A. 36 MHz B. 40 MHz C. 500 MHz D. 4 MHz
Last Answer : B. 40 MHz
Description : How many transponder channels are realized in the commercial C-band without frequency re-use? A. 24 B. 12 C. 36 D. 48
Last Answer : B. 12
Description : What is the quardband between transponder channels in the commercial C-band for satellite communications? A. 6 MHz B. 36 MHz C. 4 MHz D. 2 MHz
Last Answer : C. 4 MHz
Description : Assuming a UHF frequency range of 405.0125 MHz to 405.0875 MHz at 25 kHz channeling plan, how many channels can you produce? A. 2.5 ch. B. 2 ch. C. 4 ch. D. 3 ch.
Last Answer : D. 3 ch.
Description : 12 voice channels are sampled at 8000 sampling rate and encoded into 8 bit PCM word. Determine the rate of the data stream. a. 354 kbps b. 750 kbps c. 768 kbps d. 640 kbps
Last Answer : c. 768 kbps
Description : TV channels 2, 4 and 5 are known as ________. A. Mid band UHF B. Low band UHF C. High band VHF D. Low band VHF
Last Answer : D. Low band VHF
Description : Which of the following filters block FM radio band for TV channels (2 to 13)? A. High-pass filter B. Band reject filter C. Low-pass filter D. Band-pass filter
Last Answer : B. Band reject filter
Description : RS-232, RS-449, RS-530, V, 24 and X.21 are examples of ____________. A. standards for interfaces between modems and transmission facilities B. standards for various types of ... for interfaces between terminals and modems D. standards for end to end performance of data communications system
Last Answer : C. standards for interfaces between terminals and modems
Description : How would one squeeze more channels of communication into TDM frames of standard length? A. Shorten the time delay for each channel B. Raise the amplitude C. Add modulators D. Remove the synchronizing pulses
Last Answer : A. Shorten the time delay for each channel
Description : One of the reasons why FDM is being replaced by TDM is A. noise is amplified with voice when an FDM system is used B. it is difficult to place channels side by side C. there is more time than frequency D. Most available frequencies has been used
Last Answer : A. noise is amplified with voice when an FDM system is used
Description : ECE Board Exam March 1996 The number of voice band channels in master group per CCITT standard is __________. A. 300 B. 480 C. 600 D. 12
Last Answer : A. 300
Description : FDM telephone systems accommodate many channels by:
Last Answer : Using multiple levels of multiplexing
Description : Which of the following is not a common application of fiber-optic cable? a. Computer networks b. Long-distance telephone systems c. Closed circuit TV d. Consumer TV
Last Answer : d. Consumer TV
Description : INTELSAT stands for A. Intel Satellite B. International Telephone Satellite C. International Telecommunications Satellite D. International Satellite
Last Answer : C. International Telecommunications Satellite
Description : And ITU-T specification code that deals with the telephone circuits. A. X series B. T series C. V series D. I series
Last Answer : C. V series
Description : ______ is a term in the test language for noise testing in telephone circuits that means a one-syllable word consisting of a consonant, a vowel, and another consonant. A. Logatom B. Nosfer C. Ore D. Belcore
Last Answer : A. Logatom
Description : Three telephone circuits, each having an S/N ratio of 44 dB, are connected in tandem. What is the overall S/N ratio? A. 44 dB B. 39.2 dB C. 41 dB D. 43.52 dB
Last Answer : B. 39.2 dB
Description : Which of the following is not referred to as data terminal equipment? A. Telephone set B. Printers C. Modem D. Computer
Last Answer : C. Modem