Description : For the open drain (N = 0.025) shown in the below figure, the discharge is A. 26.88 cumecs B. 27.88 cumecs C. 28.88 cumecs D. 29.88 cumecs
Last Answer : ANS: C
Description : The width of a rectangular sewer is twice its depth while discharging 1.5 m/sec. The width of the sewer is A. 0.68 m B. 0.88 m C. 1.36 m D. 1.76 m
Description : The sewage discharge in a detritus tank of a treatment plant is 576 litres/sec with flow velocity of 0.2 m/sec. If the ratio of width to depth is 2, the depth is A. 100 cm B. 110 cm C. 120 cm D. 150 cm
Description : If the peak discharge of a storm water drain (S.W. Drain) is expected to exceed 150 cumecs, the free board to be provided, is A. 100 cm B. 90 cm C. 80 cm D. 50 cm
Last Answer : ANS: A
Description : Which one of the following statements regarding septic tanks is wrong? A. A gap of 7.5 cm between the bottom of the covering slab and the top level of scum is provided B. The outlet invert level is kept ... . The minimum width of septic level is 90 cm D. The depth of tank is kept equal to its width
Last Answer : ANS: D
Description : The dimensions of a rectangular settling tank are: length 24 m, width 6 m and depth 3 m. If 2 hour detention period for tanks is recommended, the rate of flow of sewage per hour, is A. 204 cu.m B. 208 cu.m C. 212 cu.m D. 216 cu.m
Description : In a sedimentation tank (length L, width B, depth D) the settling velocity of a particle for a discharge Q, is A. Q/(B × D) B. Q/(L × D) C. Q/L D. Q/(B × L)
Description : Drop manholes are the manholes A. Without entry ladders B. Without manhole covers C. With depths more than 3.5 m D. Having drains at different levels
Description : Maximum permissible velocity 1.5 m/sec, is adopted in drains A. With beds of rocks and gravels B. Lined with stones C. Both A. and B. D. Neither A. nor B.
Description : Self-cleansing velocity is A. Velocity at dry weather flow B. Velocity of water at flushing C. Velocity at which no accumulation remains in the drains D. Velocity of water in a pressure filter
Description : In a grit chamber of a sewage treatment plant, A. Flow velocity 0.15 m to 0.3 m/sec is kept B. Depth of 0.9 m to 1.20 m is kept C. One minute of detention period is kept D. All the above
Description : For a continuous flow type of sedimentation tanks A. Width of the tank is normally kept about 6 m B. Length of the tank is normally kept 4 to 5 times the width C. Maximum horizontal flow velocity is limited to 0.3 m/minute D. All the above
Description : Pick up the correct statement from the following: A. The boning rod is used for checking the levels of the sewer inverts B. Manhole covers are made circular for the convenience of the cleaning staff C. A manhole is classified as shallow manhole if its depth is less than 0.9 m D. All the above
Description : A manhole is classified as shallow if its depth is between A. 0.4 to 0.5 m B. 0.5 to 0.7 m C. 0.7 to 0.9 m D. 0.9 to 1.20 m
Description : You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at A. Full depth B. Half full C. Two third full D. Three fourth full
Last Answer : ANS: B
Description : In circular sewers if depth of flow is 0.2 times the full depth, the nominal gradient, A. Is only provided B. Is doubled C. Is trebled D. Is not enough
Description : The detention time of a circular tank of diameter d and water depth H, for receiving the sewage Q per hour, is A. d² (0.011d + 0.785H)/Q B. d (0.022d + 0.085H)/Q C. d (0.785d + 0.011H)/Q D. d (0.285d + 0.011H)/Q
Description : The settling velocity of the particles larger than 0.06 mm in a settling tank of depth 2.4 is 0.33 m per sec. The detention period recommended for the tank, is A. 30 minutes B. 1 hour C. 1 hour and 30 minutes D. 2 hours
Description : The width of a settling tank with 2 hour detention period for treating sewage 378 cu m per hour, is A. 5 m B. 5.5 m C. 6.5 m D. 7 m
Description : For laying a sewer line in a trench of 2 m width, an offset line is marked on the ground parallel to the given centre line at a distance of A. 100 cm B. 120 cm C. 140 cm D. 160 cm
Description : Pick up the correct statement from the following: A. The circular section of sewers provides maximum hydraulic mean depth B. The circular sewers are provided for separate sewerage system C. The circular sewers work efficiently if the sections run at least half full D. All the above
Description : If is the diameter of upper circular portion, the overall depth of a standard egg shaped section, is A. D B. 1.25 D C. 1.5 D D. 1.75 D
Description : The maximum depth of sedimentation tanks, is kept A. 3 m B. 3.5 m C. 4 m D. 4.5 m
Description : If the depth of partial flow in a sewer of diameter 2 m, is 50 cm, its wetted perimeter is A. B. /2 C. /3 D. 2 /3
Description : The angle subtended by the surface of sewer water with partial flow, at sewer centre is 120°, the depth of sewerage is A. 20 cm B. 25 cm C. 40 cm D. 50 cm
Description : Boussinesq’s equation for ascertaining unit pressure at a depth on sewers due to traffic loads, is A. pt = 3H3p/2 Z5 B. pt = 2H3p/3 Z5 C. pt = 3H3p/2Z5 D. pt = 2 3p/3Z5
Description : A circular sewer section is preferred to because A. It is cheaper in construction B. It provides maximum area for a given perimeter C. It provides maximum hydraulic mean depth D. All the above
Description : weight of water, the hydraulic mean depth of the sewer and the bed slope w is the unit of the sewer, then the tractive force exerted by flowing water, is A. w r S S B. w r1/2 C. w r S D. w r2/3
Description : If is the diameter of upper circular portion, the overall depth of New Egg shaped sewer section, is A. 1.250 D B. 1.350 D C. 1.425 D D. 1.625 D
Description : If the depth of flow in a circular sewer is 1/4th of its diameter D, the wetted perimeter is A. /2 B. /4 C. /3 D. D
Description : For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is A. 10 cm B. 12 cm C. 15 cm D. 18 cm
Description : The Brake Horse power of the motor (efficiency 60%) required for a pump of capacity 0.075 cumec for a total lift of 12 m, is A. 10 B. 15 C. 20 D. 25 Q No: 44 Aerobic bacterias A. ... presence of free oxygen B. Consume organic matter as their food C. Oxidise organic matter in sewage D. All the above
Description : The drainage area of a town is 12 hectares. Its 40% area is hard pavement ( K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration ... 60) the maximum run off is A. 0.10 cumec B. 0.12 cumec C. 0.15 cumec D. 0.20 cumec
Description : The minimum diameter of sewer to be adopted is A. 10 cm B. 12.5 cm C. 15 cm D. 25 cm
Description : The design period of sewage treatment works in normally A. 5 – 10 years B. 15 – 20 years C. 30 – 40 years D. 40 – 50 years
Description : The minimum recommended diameter of sewers, is A. 5 cm B. 10 cm C. 15 cm D. 20 cm
Description : In a city the ratio of the drainage to sewage is 20, the percentage discharge passing through non-monsoon periods, is A. 5 B. 10 C. 15 D. 20
Description : The bottom of the sewage inlet chamber of septic tanks, is provided an outward slope A. 1 in 5 B. 1 in 10 C. 1 in 15 D. 1 in 20
Description : If q is the average sewage flow from a city of population P, the maximum sewage flow A. Q = [(4 + )/(18 + )] q B. Q = [(18 + P)/(4 + )] q C. Q = [(18 + )/(4 + )] q D. Q = [(5 + )/((15 + )] q
Description : Bottom openings 15 cm × 15 cm in the standing baffle wall are provided A. 15 cm c/c B. 22.5 cm c/c C. 30 cm c/c D. 50 cm c/c
Description : The usual width of side drains along Highways in hilly region, is (A) 50 cm (B) 60 cm (C) 70 cm (D) 100 cm
Last Answer : Answer: Option B
Description : The rate of accumulation of sludge per person per year, is A. 10 litres B. 15 litres C. 20 litres D. 25 litres
Description : The minimum diameter of a sewer is kept A. 10 cm B. 15 cm C. 20 cm D. 25 cm
Description : Q No: 101 are available in size Stoneware sewers A. 10 cm B. 15 cm C. 20 cm D. All the above
Description : 11. Acid regression stage of sludge digestion at a temperature 21°C extends over a period of A. 15 days B. 30 days C. 60 days D. 90 days
Description : For 3.25 × 10-2 cumecs discharging from a well, a pump is installed to lift water against a total head of 30 m. The minimum required horse power, is (A) 10 H.P. (B) 15 H.P. (C) 18 H.P. (D) 20 H.P.
Last Answer : (D) 20 H.P.
Description : The ratio of maximum sewage flow to average sewage flow for mains up to 1 m in diameter, is A. 1.5 B. 2.0 C. 3.0 D. 4.0
Description : In septic tanks, A. Free board of 0.3 m may be provided B. The baffles or tees are extended up to top level of scum C. The clear space between the baffle top and covering slab is about 7.5 cm D. All the above
Description : The ________ of the product mix refers to how closely related the various product lines are in end use, production requirements, distribution channels, or some other way. A. Consistency B. Depth C. Width D. Length
Last Answer : A. Consistency
Description : Pick up the correct statement from the following: A. The sewer pipes of sizes less than 0.4 m diameter are designed as running full at maximum discharge B. The sewer pipes of sizes greater than 0.4 m ... discharge C. The minimum design velocity of sewer pipes is taken as 0.8 m/sec D. All the above