what is the source of energy for satellite ?

2 Answers

Answer :

satellites have the solar panels .the efficiency of this panel is very high which can convert Solar energy into electrical energy in very high amount

Answer :

The source of energy for the satellites are its solar panels which generate power by themselves.

But, to reach the orbit , it uses the fuel to push the rocket . It needs fuel to power the rocket into the designated orbit. 

Several liquid propellants are used in the rockets to launch the rockets into space. There after the satellites power themselves by the solar panels.

A large reflective mirrors focus the sun's rays and direct it towards solar panels , hence solar power is produced which is ud=sed to power the internal use of satellite.

Related questions

Description : What is renewable source of energy? State two examples for the same.

Last Answer : Renewable (Primary) Energy sources: It is defined as the sources that can be used again and again for the generation of electrical energy are called renewable.  Following are the some list ... ) and carbon dioxide  6. Geothermal Energy  Geothermal Electricity Production  7. Fuel Cells

Description : Draw the block diagram of satellite sub-system and explain power subsystem.

Last Answer : POWER SUBSYSTEM- This system provides the necessary DC power to the satellite. All communication satellites derive their electrical power from solar cells. There is also a battery backup facility used during ... . to d.c. converter is used to raise the level of low voltages to high voltage.

Description : Sketch block diagram of satellite earth station and state functions of each block

Last Answer : The figure below shows the general block diagram of an earth station capable of transmission, reception and antenna tracking. The following are the major subsystems of ... , possible monitoring of satellite characteristics and occasionally for the measurement of special characteristics. 

Description : Define the term Geostationary satellite:State its advantages.

Last Answer : Geostationary satellite: A geostationary satellite is an earth-orbiting satellite, placed at an altitude of approximately 35,800 kilometers (22,300 miles) directly over the equator, that revolves in ... in transmission because of switching times. 4. The effects of Doppler shift are negligible

Description : Satellite Radio Installation

Last Answer : Satellite radio is so far the most advanced radio service around. XM Satellite Radio and Sirius Satellite Radio are the two competitors providing this service to the United States and Canada. The ... to the LINE OUT port of the satellite radio transmitter and inserted in your cassette slot.

Description : How to Install Satellite Radio

Last Answer : How to Install Satellite Radio If you're often on the road, one great gadget you can have in your car is the satellite radio. It gives more variety, continuous programming without having to look for ... you have a satellite radio. Just follow these steps, and you'll soon have one in your car.

Description : How to Install a Satellite Receiver

Last Answer : How to Install a Satellite Receiver If you love watching television with as many possible channels as you can get, you've probably gotten yourself a satellite receiver and a satellite dish. Here ... the satellite company's introductory prices to determine what kind of programs you're interested in.

Description : Source free RL circuit 8

Last Answer : Source free RL circuit 8

Description : Source free RL circuit 7

Last Answer : Source free RL circuit 7

Description : Source free RL circuit 6

Last Answer : Source free RL circuit 6

Description : Source free RC circuit 2

Last Answer : Source free RC circuit 2

Description : Source free RC circuit 3

Last Answer : Source free RC circuit 3

Description : Source free RC circuit 4

Last Answer : Source free RC circuit 4

Description : Source free RC circuit 5

Last Answer : Source free RC circuit 5

Description : Source free RC circuit 6

Last Answer : Source free RC circuit 6

Description : Source free RC circuit 7

Last Answer : Source free RC circuit 7

Description : Source free RC circuit 8

Last Answer : Source free RC circuit 8

Description : Source free RL circuit 1

Last Answer : Source free RL circuit 1

Description : Source free RL circuit 2

Last Answer : Source free RL circuit 2

Description : Source free RL circuit 3

Last Answer : Source free RL circuit 3

Last Answer : Source free RL circuit 4

Last Answer : Source free RL circuit 5

Description :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

Last Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Description : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :

Last Answer : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is : 200 V

Description : A current controlled voltage source is equivalent to :  (A) series voltage feed -back amplifier (B) shunt current feed -back amplifier (C) shunt voltage feed -back amplifier (D) series current feed -back amplifier

Last Answer : A current controlled voltage source is equivalent to : shunt voltage feed -back amplifier

Description : A network that consists of at least a voltage source or current source is called A) Active network B) Ideal network C) Sourced network D) Outsourced network

Last Answer : A network that consists of at least a voltage source or current source is called Active network

Description : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Last Answer : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Description : what is ideal voltage source?

Last Answer : every voltage source have their own resistance that is called as internal resistance it is because of the resistance of electrodes and electrolytes in the battery interms of other supplyit have ... in universe it means ideal voltage source is this voltage source having internal resistance zero

Description : James May discovers the true source of the Nile. Will you take a few moments to celebrate this historic moment in historic history?

Last Answer : answer:Yes. I shall. I was going to say more, but I think it’s all done now,.

Description : Why Crystal Is A Preferred Clock Source?

Last Answer : Answer :Because of high stability, large Q (Quality Factor) & the frequency that doesn’t drift with aging. Crystal is used as a clock source most of the times.

Description : Can An Rc Circuit Be Used As Clock Source For 8085?

Last Answer : Answer :Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal.

Description : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Last Answer : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Description : Nodal analysis example with voltage source and supernode

Last Answer : Nodal analysis example with voltage source and supernode

Description : Source shifting problem solution

Last Answer : Source shifting problem solution

Description : Source transformation problem solution

Description : Find the current through 4 ohm resistor by source transformation

Description : Find power delivered by voltage source

Last Answer : Find power delivered by voltage source

Description : Source transformation Replace the circuit with voltage source in series with a single resistor

Last Answer : Source transformation Replace the circuit with voltage source in series with a single resistor

Description : Source transformation voltage source to current source and vice versa