Used normally, a 150-watt, 120 volt light bulb requires how many amps of current?

1 Answer

Answer :

ANSWER: 1.25 AMPS 

Related questions

Description : If the voltage supplied to the lighting circuit is 110 volts, how much current is used by a 100 watt light bulb? A. 0.08 amps B. 0.91 amps C. 1.10 amps D. 90.9 amps

Last Answer : Answer: B

Description : How much current does a 1500 Watt heater draw if supplied with a 120 Volt source?

Last Answer : ANSWER: 12.5 AMPS

Description : What current is required to light two 75 watt lamps and one 40 watt lamp when connected in series to a 120 volt power source? A. 0.161 amperes B. 0.631 amperes C. 1.583 amperes D. 6.199 amperes

Last Answer : Answer: C

Description : If voltage across a bulb rated 220 volt-100 watt drops by `2.5 %` of its value, the percentage of the rated value by which the power would decrease is

Last Answer : If voltage across a bulb rated 220 volt-100 watt drops by `2.5 %` of its value, the percentage of the rated value ... 20%` B. `2.5%` C. `5%` D. `10%`

Description : What wire size needed for 120 volt 3000 watt load?

Last Answer : AWG # 10 wire on 30 amp circuit.

Description : If there is a reduction in the normally supplied frequency to a 120/240 volt, threephase AC current motor from 60 hertz to 55 hertz, the motor would _____________. A. run at a slower speed B. operate at a lower current C. overheat D. trip off the line

Last Answer : Answer: A

Description : How many lumens in a 150 watt bulb?

Last Answer : A 150 watt halogen bulb will give off somewhere around 2000lumens. These lights may give off up to about 2400 lumens.

Description : Where can I find a 78mm Type J 120 Volt Halogen bulb locally?

Last Answer : answer:Batteries Plus has a ton of lightbulbs and seems to have a few stores in Massachusetts. I don’t see a “Boston” store, but if I remember right there’s not much “Boston” really, it’s all about the smaller neighborhoods and suburbs. Maybe one is close?

Description : Is the filament resistance lower or higher in a 500 watt light bulb than in a 100 watt light? Assume that both bulbs have been designed to operate at 110 volts. 

Last Answer : ANSWER: LOWER

Description : A 100-watt light bulb is left on for 10 hours. Electricity is 10 cents per kilowatt-hour. How much did it cost to operate the light bulb?

Last Answer : ANSWER: 10 CENTS

Description : How much energy in consumed if a 100 watt light bulb is operated for 10 MINUTES?

Last Answer : ANSWER: 60,000 JOULES or 60kJ or 6X104J

Description : For a light detector, responsivity is measured in: a. amps per watt b. µW per amp c. mA per joule d. µsec per µW

Last Answer : a. amps per watt

Description : An LED is operated on a 12 volt automobile circuit. The voltage drop across the LED is 2 volts and the current must be limited to 50 milliamps to prevent its overheating and destruction. What size resistor must be used? w) 60 ohms x) 100 ohms y) 120 ohms z) 200 ohms

Last Answer : ANSWER: Z -- 200 OHMS

Description : An electric clothes dryer is connected to a 100-volt source. How much current does it use if it requires 2,000 watts of electric power?

Last Answer : 20 Amphere

Description : The doorbell on your house requires a 12 volt alternating current. A transformer having a primary winding of 1,600 turns is to be used to step down your house's 110-volt alternating current. How many turns are there on the secondary winding?

Last Answer : ANSWER: 175 TURNS 

Description : Two 100 watt light bulbs are connected in parallel across a 100 volt power supply. The total power developed in the circuit is _______________. A. 200 watts B. 100 watts C. 50 watts D. equal to the product of the amperes times the voltage in each branch

Last Answer : Answer: A

Description : Name the quantities which are measured by the following units. (i) Newton (ii) Joule (iii) Watt (iv) Volt (v) Light year (vi) Angstrom (vii) Acre-foot (viii) Becquerel (ix) Hertz (x) Cusec

Last Answer : Answers: (i) Force (ii) Work Energy (iii) Power of electricity (iv) Potential difference (v) Distance of stars and planets (vi) Length (vii) Volume (viii) Radioactivity (ix) Frequency (x) Rate of flow of water

Description : Which of the following statements is true if a 100 watt lamp and a 75 watt lamp are connected in parallel across a 100 volt power supply? A. The 75 watt lamp will draw as much current as the 100 ... Current flow will be the same across each lamp. D. The 75 watt lamp will have a higher resistance.

Last Answer : Answer: D

Description : Electric current is the flow of electrons through a conductor. The rate of this flow is measured as ___________. A. volts/watt B. amperes/centimetre C. coulombs/second D. ohms/volt

Last Answer : Answer: C

Description : A coil is wound with 400 feet of No. 16 tinned copper wire and connected to a 12 volt battery. What is the current if the resistance per 1000 feet of No. 16 tinned copper wire is 4.26 ohms? A. 4.8 amps B. 7.06 amps C. 10.65 amps D. 11.27 amps

Last Answer : Answer: B

Description : A coil is wound with 200 feet of No. 16 tinned copper wire and connected to a 12 volt battery. What is the current if the resistance per 1000 feet of No. 16 tinned copper wire is 4.26 ohms? A. 1.14 amps B. 7.04 amps C. 10.22 amps D. 14.08 amps

Last Answer : Answer: D

Description : A battery is connected to a circuit containing three resistors in parallel. The values of the three resistors are 2 ohms, 3 ohms, and 6 ohms. What is the voltage of the battery if the total circuit current is 12 amps? A. 2 volts B. 6 volts C. 12 volts D. 24 volt

Last Answer : Answer: C

Description : What is the current through R2 of the circuit illustrated if the resistances of R1 is 2 ohms, R2 is 4 ohms, and R3 is 4 ohms with a 6 volt battery? EL-0021 A. 0.5 amp B. 1.5 amps C. 3.0 amps D. 6 amps

Last Answer : Answer: B

Description : What is the total current in the illustrated circuit with a 6 volt battery if the resistance of R1 is 2 ohms, R2 is 4 ohms, and R3 is 4 ohms? EL-0021 A. 0.6 amp B. 1 amp C. 4 amps D. 6 amps

Last Answer : Answer: D

Description : What is the maximum current allowed to be drawn from the secondary of a 2 KVA step-down transformer with a turns ratio of four to one if connected across a 440 volt line? A. 1.1 amps B. 4.5 amps C. 18.1 amps D. 22.7 amps

Last Answer : Answer: C

Description : What is the maximum allowable primary current of a 2 KVA step-down transformer with a four to one turns ratio if connected across a 440 volt line? A. 1.1 amps B. 4.5 amps C. 18.1 amps D. 27.7 amps

Last Answer : Answer: B

Description : Can I replace a 60 watt incandescent light bulb with a fluorescent or LED bulb that puts out more light than the incandescent?

Last Answer : Light output is measured in lumens, and yes, you can find a fluorescent bulb in lumen output equal to or greater than an incandescent 75 or 100 watt bulb.And it won’t be anywhere near 60 watts, so you are safe.

Description : How much energy does it take to run a 100 watt light bulb for 24 hours?

Last Answer : It is usually measured in kilowatt hours. 100 watt bulb X 24 hours= 2400 watts or 2.4 kilowatt hours.

Description : A 60 watt light bulb runs for 5 seconds how much energy does it use?

Last Answer : 300 j of energy

Description : A homeowner replaces a 65 watt incandescent bulb with a 15 watt compact fluorescent lamp. The light is on 2000 hours a year. If electricity cost 10 cents a kilowatt-hour, how much money is saved on the electric bill in one year? w) $50.00 x) $10.00 y) $5.00 z) $1.00 

Last Answer : ANSWER: X -- $10.00 

Description : About how many times longer would a 10 watt light bulb be able to burn compared to a 100 watt bulb with the same energy?  (A) 10 times longer (B) 100 times longer (C) Same time (D) None of the above

Last Answer : About how many times longer would a 10 watt light bulb be able to burn compared to a 100 watt bulb with the same energy?  (A) 10 times longer (B) 100 times longer (C) Same time (D) None of the above

Description : A 100-watt light bulb turned on for 8 hours uses :  (A) 800 Wh (B) 0.8 kWh (C) 8 kWh (D) None of the above

Last Answer : A 100-watt light bulb turned on for 8 hours uses :  (A) 800 Wh (B) 0.8 kWh (C) 8 kWh (D) None of the above

Description : How many amps does a 1500 watt heater need?

Last Answer : Feel Free to Answer

Description : Which of the following is not a unit of energy? a.Joule b.kW c.N-m d.Electron volt e.Watt-hour

Last Answer : b. kW

Description : What is the amp draw for a 3800 watt 240 volt water heater?

Last Answer : What is the answer ?

Description : The unit of electrical resistance is the _____________. A. ampere B. volt C. watt D. ohm

Last Answer : Answer: D

Description : What is the unit of responsitivity? ∙ a. Ampere/volt ∙ b. Ampere/watt ∙ c. Watt/ampere ∙ d. Volts/ampere

Last Answer : ∙ a. Ampere/volt

Description : Two 220 volt lamps, one of 60 watt and the other of 75 watt are connected in series across a 440 volt supply. The potential difference across 60 watt lamp will be: A) 195 volt B) 220 volt C) 245 volt D) 440 volt

Last Answer : Two 220 volt lamps, one of 60 watt and the other of 75 watt are connected in series across a 440 volt supply. The potential difference across 60 watt lamp will be: 245 volt

Last Answer : Difference between watt and volt and ampere is as follows: Watt Volt Ampere Watt is the unit of power. Volt is the unit of voltage. Ampere is the unit of current. Watts= Volts x Amperes Volts= Watts/ ...

Description : I need a new 12 volt AC adapter; do amps matter?

Last Answer : answer:Amperage does matter. if you do not use the proper amperage for a certain device, it will either fry again or not work at all. i had this problem with an extended volume control on a ... they also have the best selection of AC adapters i have ever seen. they were very helpful at RS.

Description : How many amps is 9 volt battery?

Last Answer : Need answer

Description : An electrical component is connected across a 120 volt 60 hertz AC supply. What is the current drawn by the component if the impedance is 200 ohms? A. 0.01 amperes B. 0.60 amperes C. 1.67 amperes D. 100 amperes

Last Answer : Answer: B

Description : When used for taking resistance measurements, a volt-ohm-milliammeter is normally powered by _____________. A. a hand cranked generator B. internal storage batteries C. the current in the circuit being tested D. a step down transformer

Last Answer : Answer: B

Description : Can you damage your eyes if you look directly at a lit 100 watt bulb?

Last Answer : It all depends on how far away you are, and how much ambient light there is already, But no, even holding your face eight inches away in a dark room won’t do any significant damage. Your pupils will contract so no damage is done.

Description : I have a 60 watt/120v clip-on lamp. What is the highest wattage of compact fluorescent bulb can I safely use in this lamp?

Last Answer : By the way, I mean actual watts on the fluorescent bulb, not replacement-watts. :)

Description : What is the Cost to run a 5 watt led bulb for a year?

Last Answer : Need answer

Description : How much money do you save by using a 20 Watt Compact Fluorescent over an incandescent bulb?

Last Answer : An Energy Star qualified compact fluorescent light bulb can save you around $30 over it's lifetime, paying for its self in about 6 months.

Description : According to the definition of 1 KWh, a 100 watt bulb consumes one unit of electricity in _____. A. 1 Hour B. 5 Hours C. 8 Hours D. 10 Hours

Last Answer : ANSWER: D

Description : According to the definition of 1 KWh, a 100 watt bulb consumes one unit of electricity in _____. A. 1 Hour B. 5 Hours C. 8 Hours D. 10 Hours

Last Answer : ANSWER: D