Description : In a circuit when the electrical resistance increases the current decrease because it is for the electrons to flow.?
Last Answer : yes
Description : When the voltage remains constant, and the resistance increases in a series circuit, current flow _____________. A. decreases B. remains the same C. increases D. increases by the square
Last Answer : Answer: A
Description : When the voltage remains constant and the resistance is increased in a series circuit, the flow of current _____________. A. increases by the square of the original value B. increases C. remains the same D. decreases
Last Answer : Answer: D
Description : A wattmeter is used to determine ____________. A. the power being consumed by electrical equipment B. partial circuit resistance C. current flowing in a circuit D. voltage existing between two points in a circuit
Description : A galvanometer is an instrument used to measure ___________. A. thickness of galvanized metal B. resistance of electrical wiring insulation C. very small amounts of current or voltage D. quantity of galvans in an electric circuit
Last Answer : Answer: C
Description : When shipboard electrical distribution circuits are connected in parallel, additional parallel circuits will cause the total circuit resistance to _____________. A. increase, causing a drop in the line current B ... an increase in the line voltage D. decrease, causing an increase in the line current
Description : Which of the electrical properties listed will always be the same for each component in a parallel circuit? A. Impedance B. Current C. Resistance D. Voltage
Description : What are three electrical components needed for current flow in basic electrical circuit?
Last Answer : Feel Free to Answer
Description : The function of fuse in an electrical circuit is (a) avoid electric shocks (b) regulate the flow of current (c) break the circuit in case of overloading or short circuiting (d) switch off current
Last Answer : Ans:(c)
Description : Main function of cutout relay in electrical circuit is A. To prevent the reversal of current flow from the battery when dynamo speed (engine speed) reduces. B. To restrict the maximum output at ... deliver current to the battery or to the lightening and ignition circuit. D. None of the above
Last Answer : A. To prevent the reversal of current flow from the battery when dynamo speed (engine speed) reduces.
Description : Maximum current will flow through an electrical circuit in case of___________. A. Ohm’s Law B. open circuit C. parallel circuit D. Short circuit
Last Answer : Maximum current will flow through an electrical circuit in case of Short circuit.
Description : When the current flow through a copper wire increases, its _____________. A. resistance will decrease B. insulation will burn C. temperature will increase D. conductivity will increase
Description : According to Ohm’s law, what happens to circuit current if circuit resistance (a) increases, (b) decreases?
Last Answer : (a) Current decreases (b) Current increases
Description : Copper is often used as an electrical conductor because it _______________. A. has high resistance at low temperatures B. has a highly polished surface C. is able to pass current with little opposition D. holds insulation together well
Description : To limit the current flow through a DC voltmeter to as low a value as possible, the moving coil circuit is provided with a/an _____________. A. high series resistance B. high parallel resistance C. series inductor D. external shunt
Description : An ammeter should be used to measure ___________. A. the voltage between two points in a circuit B. circuit continuity C. current flow in a circuit D. total or partial circuit resistance
Description : What is the current flow through R1 of the circuit illustrated if the resistance of R1 is 2 ohms, R2 is 3 ohms and R3 is 6 ohms with a 12 VDC battery? EL-0021 A. 2 amps B. 4 amps C. 6 amps D. 12 amps
Description : If the resistance of a circuit is cut in half and the applied voltage is kept constant, the current flow will be _____________. A. doubled B. quadrupled C. unchanged D. cut in half
Description : In a simple DC circuit, the resistance is held constant while the applied voltage is halved. Current flow, therefore, will ______________. A. double B. remain the same C. be divided by two D. be divided by four
Description : Which of the following statements concerning a simple parallel resistance circuit is correct? A. The voltage drop across each resistor is the same. B. The total current flow equals the reciprocal ... resistances. D. The total voltage equals the sum of the individual voltages across each resistance.
Description : In a DC series circuit, all the conductors have the same ____________. A. power expended in them B. voltage drop across them C. resistance to current flow D. current passing through them
Description : When troubleshooting electronic equipment, you should use a high impedance multimeter ________________. A. to prevent excess current flow through the meter that would damage it B. for AC measurements only ... being tested D. so as not to load down the circuit and obtain erroneous voltage readings
Description : When electrons flow with Little resistance through a conductor it is called a?
Last Answer : n word pass
Description : What is The flow of electrons through a circuit is called a?
Last Answer : Need answer
Last Answer : Flow of electrons in the circuit constitutes an electric current
Description : Superconductivity is a material property associated with - (1) cooling a substance without a phase change (2) frictionless liquid flow (3) a loss of thermal resistance (4) a loss of electrical resistance
Last Answer : (3) a loss of thermal resistance Explanation: Superconductivity is a phenomenon of exactly zero electrical resistance and expulsion of magnetic flux fields occurring in certain materials, called superconductors.
Description : A bird sitting on a high tension electric wire does not get electrocuted because – (1) it has high resistance (2) the body is earthed (3) it does not form a closed path for the flow of current (4) its feet are good insulators
Last Answer : (3) it does not form a closed path for the flow of current Explanation: Electricity travels from a place of high voltage to low voltage, just as water travels from high elevation to low ... When electricity travels through a body in this fashion, electrocution takes place, and the bird can die.
Description : A bird sitting on a high tension electric wire does not get electrocuted because (1) it has high resistance (2) the body is earthed (3) it does not form a closed path for the flow of current (4) its feet are good insulators
Last Answer : it does not form a closed path for the flow of current
Description : By mistake, a voltmeter is connected in series and an ammeter is connected in parallel, with a resistance in an electrical circuit. What will happen t
Last Answer : By mistake, a voltmeter is connected in series and an ammeter is connected in parallel, with a ... be damaged D. Only the voltmeter will be damaged
Description : The electrical diagram shown in the illustration is used to depict a/an ____________. EL-0015 A. resistance circuit B. inductive circuit C. stepdown circuit D. capacitive circuit
Description : What is the total resistance of the electrical circuit illustrated if the resistance of R1 is 2 ohms, R2 is 4 ohms, and R3 is 4 ohms with a 6 volt battery? EL-0021 A. 0.01 ohms B. 0.10 ohms C. 1.00 ohms D. 10.00 ohms
Description : When working on electrical circuits containing large capacitors, in addition to deenergizing the circuit, which of the listed precautions should also be taken? A. Keep all radio equipment ... capacitor insulation resistance. C. Ground the capacitor terminals. D. Check capacitor circuit polarity.
Description : The resistance of a few meters of wire conductor in closed electrical circuit is?
Last Answer : The resistance of a few meters of wire conductor in closed electrical circuit is practically zero.
Description : Why ABC is considered electro-mechanical computer? A) Because it was invented before electronic computers were developed B) Because there are wheels, drums, bars to rotate and move to produce result C) Because they use the flow of electrons in different component D) None of above
Last Answer : Answer : B
Description : What is the relationship between the flow of electrons and the flow of current ?
Last Answer : The flow of current depends on the flow of electrons. Current flows only when electrons flow.
Description : How many electrons flow through a light bulb each second if the current through the light bulb is A?
Description : Electric current in a metal wire is due to the flow of — (1) Electrons (2) Protons (3) Ions (4) Holes
Last Answer : (1) Electrons Explanation: A solid conductive metal contains mobile, or free electrons, originating in the conduction electrons. When a metal wire is connected across the two terminals of a DC ... the conductor are forced to drift toward the positive terminal under the influence of this field.
Description : Electric current is the flow of electrons through a conductor; the rate of this flow is measured in ___________. A. volts B. amperes C. coulombs D. ohms
Last Answer : Answer: B
Description : Electric current is the flow of electrons through a conductor. The rate of this flow is measured as ___________. A. volts/watt B. amperes/centimetre C. coulombs/second D. ohms/volt
Description : The force that causes free electrons to move in a conductor as electric current flow is called a/an _____________. A. resistant force B. electromotive force C. inductive force D. dielectric force
Description : Barrier potential in a P-N junction is caused by (A) Thermally generated electrons and holes. (B) Diffusion of majority carriers across the junction. (C) Migration of minority carriers across the junction. (D) Flow of drift current.
Last Answer : (B) Diffusion of majority carriers across the junction.
Description : A high voltage applied to a gas discharge tube containing neon gas at very low pressure causes a current to flow through the tube. Which one of the following are the particles that flow towards the ... Are they w) electrons x) protons y) negatively charged neon ions z) positively charged neon ions
Last Answer : ANSWER: Z -- POSITIVELY CHARGED NEON IONS
Description : Electric current in a metal wire is due to the flow of— (1) Electrons (2) Protons (3) Ions (4) Holes
Last Answer : Electrons
Description : Pick out the wrong statement. (A) The controlling resistance in case of heating of air by condensing steam is in the air film (B) The log mean temperature difference (LMTD) for ... a pure fluid at a given pressure from liquid to vapor or vice-versa occurs at saturation temperature
Last Answer : (C) In case of a 1 - 2 shell and tube heat exchanger, the LMTD correction factor value increases sharply, when a temperature cross occurs
Description : The electrical conductivity of a semiconductor increases with increase in temperature because (a) the carrier concentration increases (b) the mobility of carrier increases (c) both carrier concentration and mobility increase (d) the band gap decreases
Last Answer : The electrical conductivity of a semiconductor increases with increase in temperature because the carrier concentration increases
Description : In cell, the current flows in outer circuit from a. Positive terminal to negative terminal and electrons from negative terminal to positive terminal b. Positive terminal to negative ... terminal d. Negative terminal to positive terminal and electrons from positive terminal to negative terminal
Last Answer : a. Positive terminal to negative terminal and electrons from negative terminal to positive terminal
Description : Forward current through a semi-conductor diode circuit is due to ________ (a) Minority carriers (b) majority carriers (c) holes (d) electrons
Last Answer : (b) majority carriers
Description : Velocity of liquid hydrocarbon fuels in a pipeline cannot be measured by magnetic flow-meters, because their __________ is very low/small. (A) Thermal conductivity (B) Electrical conductivity (C) Specific gravity
Last Answer : (C) Specific gravity
Description : Which of the following statements about continuous cardiac output monitoring are true? A. Continuous cardiac output monitoring may unmask events not detected by intermittent cardiac output measurements. ... stroke volume by detecting changes in resistance to a small, applied alternating current.
Last Answer : Answer: AD DISCUSSION: Various techniques are available to measure cardiac output continuously. The advantages of continuous cardiac output monitoring, as compared with intermittent methods, are (1) ... function of the stroke volume, which then can be used to calculate the cardiac output
Description : Moisture absorbed in the windings or condensed on the surface of electrical machinery insulation ________. A. is good for long term preserving since most insulation is organic and contains some amount B. ... D. reduces the amount of current supplied or drawn by the machine so horsepower is limited