What type of temperature coefficient material does not  produce increased heat in response to increased current flow?

1 Answer

Answer :

Zero-temperature coefficient.

Related questions

Description : Which temperature coefficient indicates a material whose resistance increases as temperature increases?

Last Answer : Positive.

Description : For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it (A) Decreases the pressure drop (B) ... the outlet temperature of cooling medium (C) Increases the overall heat transfer coefficient (D) None of these

Last Answer : (C) Increases the overall heat transfer coefficient

Description : Define the term negative temperature coefficient.

Last Answer : It is the decrease in a semiconductor’s resistance as temperature rises.

Description : Define the temperature coefficient of resistance.

Last Answer : The amount of increase in the resistance of a 1-ohm sample of the conductor per degree of temperature rise above 0º C

Description : The critical radius of insulation for a spherical shell is (where, K = thermal conductivity of insulating material h0 = heat transfer coefficient at the outer surface) (A) K/h0 (B) 2K/h0 (C) h0 /K (D) h0 /2K

Last Answer : (B) 2K/h0

Description : What is a measure of the ability of a material to conduct heat?  A. Specific heat capacity  B. Coefficient of thermal expansion  C. Coefficient of thermal conductivity  D. Thermal conductivity

Last Answer : Thermal conductivity

Description : Full activation of the sympathetic nervous system, as in maximal exercise, can produce all of the following responses except (a) Bronchial relaxation (b) Decreases intestinal motility (c) Increased renal blood flow (d) Mydriasis (e) Increased heart rate (tachycardia)

Last Answer : Ans: C

Description : What is the effect on motor speed if the field current is increased?

Last Answer : Motor will slow down.

Description : If the current was increased to 4 amps, what would be the voltage drop across each resistor in the circuit described in question 17?

Last Answer : E1 = 80 volts. E2 = 240 volts. E3 = 320 volts

Description : In a system, the damping coefficient is - 2. The system response will be (a) Undamped (b) Oscillations with decreasing magnitude (c) Oscillations with increasing magnitude (d) Critically damped

Last Answer : In a system, the damping coefficient is - 2. The system response will be Oscillations with increasing magnitude

Description : What type filter is used to block the passage of current for a narrow band of frequencies, while allowing current to flow at all frequencies above or below this band?

Last Answer : . Band-reject.

Description : What type of bias requires constant current flow through the cathode

Last Answer : Cathode biasing.

Description : Sepsis causes a marked metabolic response. Which of the following statement(s) is/are true concerning the metabolic response to sepsis? a. Oxygen consumption is increased in the face of infection ... d. The extent of increase in oxygen consumption relates to the severity of the infection

Last Answer : Answer: a, c, d Oxygen consumption is usually elevated in the infected patient. The extent of this increase is related to the severity of the infection, with peak elevations reaching 50% ... suggest that the metabolic rate increases 10% to 13% for each elevation of 1°C in central temperature

Description : (True or False) The larger the current required to produce full-scale deflection of the meter coil, the better the sensitivity of the meter.

Last Answer : False.

Description : How much must the fpa plate current vary to produce 100- percent modulation in a plate modulator?

Last Answer : Between 0 and nearly two times its unmodulated value.

Description : The length of a wire is increased by 1 mm on the application of a certain load. In a wire of the same material but of twice the length and half the radius, the same force will produce an elongation of (a) 0.5 mm (b) 2 mm (c) 4 mm (d) 8 mm

Last Answer : (d) 8 mm

Description : What effect does flux leakage in a transformer have on the coefficient of coupling (K) in the transformer?

Last Answer : it causes K to be less than unity (I).

Description : What effect does flux leakage in a transformer have on the coefficient of coupling (K) in the transformer?

Last Answer : it causes K to be less than unity (I).

Description : What is meant by the coefficient of coupling?

Last Answer : The ratio of the fines of force produced by one coil to the lines of force that link another coil. It is never greater than one.

Description : Will an optical fiber's attenuation coefficient vary with changes in wavelength?

Last Answer : Yes.

Description : The temperature coefficient of resistance of the material of a wire is `0.00125^(@)C^(-1)`. Its resistance at `27^(@)C` is `1 Omega`. At what temperat

Last Answer : The temperature coefficient of resistance of the material of a wire is `0.00125^(@)C^(-1)`. Its resistance at ... K B. 1100 K C. 1400 K D. 1127 K

Description : The existing resistance of a conductor is dependent upon its length, cross-sectional area, _____________. A. temperature and insulation B. material and insulation C. resistive coefficient and material D. material and temperature

Last Answer : Answer: D

Description : A semiconductor device made out of a material having very high temperature coefficient of resistance is

Last Answer : A semiconductor device made out of a material having very high temperature coefficient of resistance is Thermistor

Description : In the tunnel diode, the tunneling current is at what level when the forbidden gap of the N-type material is at the same energy level as the empty states of the P-type material?

Last Answer : Minimum.

Description : Choose the most important factor on which the heat conducted through a wall in a unit time will depend on? (A) Thickness of the wall (B) Area of the wall perpendicular to heat flow (C) Material of the wall (D) Temperature difference between the two surfaces of the wall

Last Answer : (D) Temperature difference between the two surfaces of the wall

Description : Steady state one dimensional heat flow by conduction as given by Fourier's low does not assume that (A) There is no internal heat generation (B) Boundary surfaces are isothermal (C) Material is anisotropic (D) Constant temperature gradient exists

Last Answer : (C) Material is anisotropic

Description : When hot liquid is poured into a thick glass tumbler, it cracks because glass – (1) is a bad conductor of heat so only inner surface expands (2) has high temperature coefficient of expansion (3) has a very low specific heat (4) has low temperature coefficient of expansion

Last Answer : (1) is a bad conductor of heat so only inner surface expands Explanation: When hot liquid is poured into a thick glass tumbler, it cracks because glass is a bad conductor of heat so only inner surface expands.

Description : For a heat exchanger, will the overall heat transfer coefficient increase along with an increase in LMTD (log mean temperature difference) around the unit?

Last Answer : The overall heat transfer coefficient is generally weakly dependent on temperature. As the temperatures of the fluids change, the degree to which the overall heat transfer coefficient will be affected depends ... with temperature as I've noted and the U-value will decrease over time with fouling).

Description : When hot liquid is poured into a thick glass tumbler, it cracks because glass : (1) is a bad conductor of heat so only inner surface expands (2) has high temperature coefficient of expansion (3) has a very low specific heat (4) has low temperature coefficient of expansion

Last Answer :  is a bad conductor of heat so only inner surface expands 

Description : What is the name of the emf generated in the primary that opposes the flow of current in the primary?

Last Answer : . Self-induced or counter emf

Description : What effect does an increase in capacitance have on a capacitor’s opposition to current flow?

Last Answer : Opposition to current flow decreases.

Description : When used for ac current control, during which alternation of the ac cycle does the TRIAC control current flow?

Last Answer : During both alternations.

Description : During avalanche effect breakdown, what limits current flow through the diode?

Last Answer : an external current-limiting resistor

Description : Name the two types of current flow in a semiconductor.

Last Answer : Electron flow and hole flow.

Description : What condition must exist on both the limiter and quadrature grids for current to flow in a gated-beam detector?

Last Answer : Both grids must be positively biased

Description : When a Triac is properly gated, what is/are the direction(s) of current flow between anodes 1 and 2?

Last Answer : Current is allowed to flow in either direction.

Description : What is the effect of current flow through the coil in a d’Arsonval meter movement?

Last Answer : A magnetic field is generated around the coil and the attraction of this field with the permanent magnet causes the coil to move

Description : Current flow in a cell with no external load.

Last Answer : Current flow in a cell with no external load.

Description : An ammeter should always be connected so that current will flow into what terminal and out of what terminal?

Last Answer : Negative, positive

Description : What component of the D’Arsonval meter movement completes the circuit for current flow to the coil?

Last Answer : Hairspring.

Description : Is the current flow through an inductor directly proportional or inversely proportional to its inductance value?

Last Answer : Directly proportional.

Description : For absorbing a sparingly soluble gas in a liquid, the (A) Gas side co-efficient should be increased (B) Liquid side coefficient should be increased (C) Gas side co-efficient should be decreased (D) Liquid side co-efficient should be decreased

Last Answer : (B) Liquid side coefficient should be increased

Description : The void ratio of a soil sample decreases from 1.50 to 1.25 when the pressure is increased from 25 tonnes/m2 to 50 tonnes/m2 , the coefficient of compressibility is (A) 0.01 (B) 0.02 (C) 0.05 (D) 0.001

Last Answer : (A) 0.01

Description : The capacity of a spring to store energy is called the spring form co-efficient. Stiffness of a spring is measured by the (A) Ability to absorb shock (B) Capacity to store energy (C) Ratio of the wire & coil diameters (D) Load to produce unit deflection

Last Answer : Option D

Description : The inside heat transfer co-efficient in case of turbulent flow of liquid in the tube side in a 1-2 shell and tube heat exchanger is increased by __________ times, when the number of tube passes is increased to 8. (A) 2 0.8 (B) 4 0.8 (C) 4 0.4 (D) 2 0.4

Last Answer : (B) 4 0.8

Description : What component in an amplifier circuit tends to limit the low-frequency response of the amplifier?

Last Answer : The coupling capacitor (C3).

Description : What compone What components What components can be used to increase the high frequency response of an amplifier?

Last Answer : Peaking coils.

Description : What is the major factor that limits the high-frequency response of an amplifier circuits?

Last Answer : The capacitance of the circuit.

Description : What are the factors that limit the frequency response of a transistor amplifier?

Last Answer : The capacitance and inductance of the circuit and the interelectrode capacitance of the transistor.

Description : select the correct response from the choices given in the parentheses. Q-20. In a closed-loop configuration the output signal is determined by (the input signal, the feedback signal, both).

Last Answer : Both the input signal and the feedback signal.