What combination of materials is used to patch or build up  damaged areas of boards?

1 Answer

Answer :

Epoxy and fiberglass powder.

Related questions

Description : What is a symptom of a damaged patch cable between a workstation and the wall jack on a UTP network?

Last Answer : Feel Free to Answer

Description : What is the preferred method of repairing cracked runs on boards?

Last Answer : Clinched staple.

Description : In what direction are component leads clinched on single and double-sided boards?

Last Answer : In the direction of the run.

Description : What is one of the major disadvantages of multilayer printed circuit boards?

Last Answer : Difficulty of repair of internal connections.

Description : Name the three methods of interconnecting components in multilayer printed circuit boards.

Last Answer : Clearance hole, plated-through hole, and layer build-up

Description : What is the major disadvantage of printed circuit boards?

Last Answer : Components soldered in place.

Description : List the major advantages of printed circuit boards.

Last Answer : Eliminate heavy chassis and point-to-point wiring

Description : What does the color red indicate on a tty patch panel?

Last Answer : It handles classified information.

Description : What is the function of an antenna patch panel?

Last Answer : To connect an antenna/transmission line to a receiver/transmitter.

Description : What can I build with some leftover 2'x4' boards?

Last Answer : answer:A tree house? Any small children in your life or nearby? Or for something more modest yet still charming? Broccoli house

Description : Damaged or missing termination pads are replaced using what procedure?

Last Answer : Epoxy a replacement pad to the board, set an eyelet, and solder it.

Description : A MOSFET can be damaged by an electrostatic discharge at approximately what minimum potential?

Last Answer : 35 volts.

Description : Why will an ammeter be damaged if connected in parallel with the circuit to be measured?

Last Answer : Since the ammeter has a small resistance compared to the load, it will have very high current if it is connected in parallel. This high current will damage the meter.

Description : What is the relative length of the time constant for the diode capacitor combination in a damper (long or short)?

Last Answer : Short time constant.

Description : What is the most widely used combination-bias system?

Last Answer : The voltage-divider type.

Description : Select the correct combination of the statements (i-iv) regarding the characteristics of certain organisms. (i) Methanogens are archaebacteria which produce methane in marshy areas. (ii) Nostoc is a filamentous blue-green alga which fixes ... iii) (c) (ii), (iii) and (iv) (d) (i), (ii) and (iv).

Last Answer : (d) (i), (ii) and (iv)

Description : Dynamic capabilities refer to: a) the firm's ability to integrate, build, and reconfigure internal and external competences to address rapidly changing environments. b) the link between ... underlie a company's multiple production lines and critically underpin the firm's competitive advantage

Last Answer : the firm's ability to integrate, build, and reconfigure internal and external competences to address rapidly changing environments.

Description : A combination of equipment and controls which handles, stores and retrieves materials withprecision,accuracy and speed under a defined degree of automation is known as ____ a.Automated storage and retrieval system (AS/RS) b.Flexible manufacturing system c.Automated guided vehicle d.None of the above

Last Answer : a.Automated storage and retrieval system (AS/RS)

Description : Column 1,2 and 3 contain starting materials, reaction conditions, and type of reactions, respectively The only CORRECT combination that gives two diff

Last Answer : Column 1,2 and 3 contain starting materials, reaction conditions, and type of reactions, respectively The only CORRECT ... )(i)(S) D. (III)(iii)(P)

Description : Give various photoemissive materials and suggest relevant combination of material for LED to emit Yellow and Green colour.

Last Answer : Various photoemmisive materials are as follows  Zinc Potassium Lead sulphate Sodium Cadmium sulphide Relevant combination of material for LED to emit Yellow colour  1. Gallium Phosphide(GaP) ... 1. Gallium Phosphide(GaP) 2. Aluminum Gallium Indium Phosphide 3. Aluminum Gallium Phosphide

Description : You see a build-up of dust and lint on the take-up reel of a tape recorder. This can cause which of the four types of tape errors?

Last Answer : Signal dropout errors and level errors. The dust and lint on the reel will eventually get onto the tape where it can get between the tape and the recorder’s heads.

Description : I have always had a big build in my lower body. Because of fat phobia I had lipo and am now left with very thin legs and not a toned tush. What is the best way to build up both areas?

Last Answer : After liposuction, shouldn’t you ask your surgeon about suitable exercise? We probably aren’t the best forum.

Description : What is the process that tends to build up the land surface by deposition of solid material in its lower areas, known as? a. Abrasion b. Agglomeration c. Aggradation d. Attrition

Last Answer : c. Aggradation

Description : What is used to tie wire bundles in high-temperature areas?

Last Answer : High-temperature, pressure-sensitive tape.

Description : If magnetic tape is stored in areas with temperature and humidity extremes, what are three types of tape damage that may occur?

Last Answer : Oxide shedding, layer-to-layer sticking, and tape deformation.

Description : What areas of the earth are not normally covered by satellites?

Last Answer : The extreme polar regions

Description : What components may be used to build a basic phase modulator?

Last Answer : A phase-shift network such as a variable resistor and capacitor in series

Description : What are the two most common semiconductor materials used in electronic and electro-optic devices?

Last Answer : Silicon and gallium arsenide.

Description : List the types of materials used in fabricating low-loss, long wavelength optical fibers.

Last Answer : Heavy-metal fluorides, chalcogenide glasses, and crystalline materials.

Description : What are the four most common materials used in semiconductor detector fabrication?

Last Answer : Silicon, gallium arsenide, germanium, and indium phosphide.

Description : What characteristics do all ferromagnetic materials have in common?

Last Answer : The relative ease with which they are magnetized

Description : What are magnetic materials?

Last Answer : Those materials that are attracted by magnets and have the ability to become magnetized.

Description : Magnetic tape is made of what three basic materials?

Last Answer : a. Base material. b. Coating of magnetic oxide particles. c. Glue that bonds the particles to the base.

Description : Besides tungsten, what other materials are used for cathodes in vacu

Last Answer : Thoriated-tungsten and oxide-coated metals.

Description : What materials are commonly used as cushions between cable insulation and metallic armor?

Last Answer : Jute and Asphalt coverings.

Description : State two fundamental properties of insulating materials.

Last Answer : Insulation resistance and dielectric strength.

Description : What are three types of nonmetallic insulating materials that can be used in a high-temperature environments?

Last Answer : FEP, extruded polytetrafluoroethylene, and silicone rubber.

Description : When transporting snowboards on a car roof rack do you face the boards up or down?

Last Answer : It would likely be best to have the bottoms facing upwards if you’re placing them directly on the rack itself. We generally have them in a hard case that holds a few boards which is worth the investment should your boards decide to launch off the top of your car (sadly happened to us once).

Description : The divisional supdt may sanction up to Rs____ in each case for embedding to cash/mail chests, purchase of technical books/maps, painting of letter boxes, sign boards, notice boards etc. a) 400/- b) 1500/- c) 5000/- d) 2500/

Last Answer : a) 400/

Description : Pick up correct statement from the following: (A) Fibre boards are used for thermal and acoustic control (B) Fibre boards are used for light weight standing members (C) Fibre boards are obtained by impregnating a resin product on fibres (D) All the above

Last Answer : Answer: Option D

Description : Pick up the correct statement from the following: (A) Plastics have generally low melting point (B) The coefficient of thermal expansion of plastics is about three times than that of steel (C) ... fibre-glass with phenolic resins has absorption coefficient of about 0.67 (D) All the above

Last Answer : Answer: Option D

Description : What process moves materials through a cell from areas low concentration to areas of high concentration?

Last Answer : active transport

Description : How do you cheer up a friend going through a rough patch?

Last Answer : Tea, jumping in leaf piles, Eddie Izzard’s stand-up comedy (probably some of the best I’ve ever seen), and playing either old video games (Mario Kart especially) or LittleBigPlanet. Just make sure they’re surrounded by friends and people who care about them.

Description : Pear fruit, bottom shriveling-up with yellow looking dust in small patch.

Last Answer : Need Answer

Description : I hav a leak in the rim of my intex blow up & fill up pool how do I find & patch or patch it?

Last Answer : Over fill the pool with air. The more air, the more pressure, the better results for bubbles. Try windex, the dish soap may be to thick for the tiny stream of air. Instructions on how to patch the pool can be found here http://www.ehow.com/how_5642585_patch-intex-pool.html

Description : If given all the materials and tools you need, what is the largest/most complex thing you could build all on your own if given a whole year?

Last Answer : A world dominating empire

Description : Why do we still build and furnish homes with highly flammable materials?

Last Answer : answer:Because the materials we make our homes out of have other characteristics that are valued just as highly as being flameproof. For example most fire doors are still made from wood despite ... stop the person living there filling it with flamable stuff, lighting a cigarette and falling asleep.

Description : What materials are used to build houses in the Caribbean?

Last Answer : Need answer

Description : What materials are used to build lightweight patio gazebos?

Last Answer : Aluminum is probably the best lightweight material to make a frame for a gazebo. You can even get Durawood brand which is aluminum coated to look like wood. EZ-up type canopies are really lightweight, with ... . For the roof, you have a wide variety of choices, from shingles, to siding, to shakes!

Description : Can I use multiple Arduino boards in a single project?

Last Answer : Yes, multiple Arduino boards can be used in a single project by connecting them together through various communication protocols, such as I2C or SPI.