An inversion is: 

a. A decrease of pressure with height 

b. A decrease of temperature with height 

c. An increase of temperature with height 

d. An increase of pressure with height

1 Answer

Answer :

c. An increase of temperature with height

Related questions

Description : An inversion is: a. A decrease of pressure with height b. A decrease of temperature with height c. An increase of temperature with height d. An increase of pressure with height

Last Answer : c. An increase of temperature with height

Description : A flight is to depart from an airport with runway 09 and 27. Surface wind is 270/05; an  inversion is reported at 300 feet with turbulence and wind shear. The wind just above the  ... throttle during the passage through the inversion  d. Depart runway 27 with as steep an ascent as possible

Last Answer : b. Depart on runway 09 with a tailwind

Description : Where is wind shear the greatest? a. Near a strong low level inversion and in the region of a thunderstorm b. Near a valley with wind speeds greater than 35kts c. On the windward side of a mountain d. When the wind is greater than 35kts

Last Answer : a. Near a strong low level inversion and in the region of a thunderstorm

Description : You are flying at a constant FL 290 and a constant mach number. The total temperature increases by 5°. The CAS will: a. Remain approximately constant b. Increase by 10 kts c. Decrease by 10 kts d. Will increase or decrease depending on whether you are above or below ISA

Last Answer : a. Remain approximately constant

Description : What is normally the most effective measure to reduce or avoid CAT effects?  a. Change of flight level  b. Change of course  c. Increase of speed  d. Decrease of speed

Last Answer : a. Change of flight level

Description : With an almost discharged battery there will be: a. A decrease of voltage with increasing load b. Increase of current with decrease of voltage c. Decrease of current with increasing load d. Increase of voltage with increasing load

Last Answer : a. A decrease of voltage with increasing load

Description : Generally, as altitude increases: a. Temperature decreases and density increases b. Temperature, pressure and density decreases c. Temperature and pressure increase and density decreases d. Temperature decreases and pressure and density increase

Last Answer : b. Temperature, pressure and density decreases

Description : A pilot suffering from decompression sickness should: a. Descend to a lower level where the symptoms will disappear and continue the flight at this or a lower level b. Decrease the cabin pressure ... relieve the pain in the affected site d. Land as soon as possible and seek medical assistance

Last Answer : d. Land as soon as possible and seek medical assistance

Description : The isobars drawn on a surface weather chart represent lines of equal pressure:  a. At flight level  b. At height of observatory  c. At a determined density altitude  d. Reduced to sea level

Last Answer : d. Reduced to sea level

Description : Cabin altitude in pressured flight is: a. The altitude corresponding to cabin pressure regardless of aircraft height b. Is presented on a second needle on the aircraft altimeter c. ... pressure equals ambient pressure d. Altitude corresponding to cabin pressure in relation to MSL ISA conditions

Last Answer : a. The altitude corresponding to cabin pressure regardless of aircraft height

Description : What do you call the increase of temperature with height? A. Temperature inversion B. Normal inversion C. Ducting D. Superrefraction

Last Answer : A. Temperature inversion

Description : The effects of carbon monoxide: a. Increases with altitude b. Decreases with altitude c. Increases with increase of density d. Decreases with pressure loss

Last Answer : a. Increases with altitude

Description : An aircraft climbs from an airfield, elevation 1500ft, QNH 1023mb, to FL75. What height does the aircraft have to climb? (Assume 1mb=30ft) a. 6600 ft b. 7800 ft c. 6300 ft d. 6000 ft

Last Answer : c. 6300 ft

Description : The Q code on which height is based on:

Last Answer : QFE

Description : The Q code on which height is based on: a. QNH b. QFF c. QFE

Last Answer : c. QFE

Description : Clearance limit is defined as: a. The flight level to which an aircraft is granted ATC clearance b. The time at which the ATC clearance expires c. The point to which aircraft is granted ATC clearance d. The height below which you will hit the first obstacle

Last Answer : c. The point to which aircraft is granted ATC clearance

Description : Aircraft A flies in VMC with an ATC clearance within a control area. Aircraft B without ATC clearance approaches at roughly the same height on a converging heading. Who has the right of way? a. Aircraft A, regardless of ... A, if B is to the right of him d. Aircraft B, if A is to the left of him

Last Answer : d. Aircraft B, if A is to the left of him

Description : What action should be taken if contact is lost with the runway during a circling approach? a. Descend to Decision Height and if still no contact with the runway, initiate a missed approach b. Land on the instrument runway c. Initiate a missed approach d. Return to the FAF

Last Answer : c. Initiate a missed approach

Description : What is the rule concerning level or height the aircraft should maintain when flying IFR outside controlled airspace unless otherwise directed? a. 2,000 feet above the highest obstacle within 8kms of the ... planned track d. 2,000 feet above the highest obstacle within 8kms of the planned track

Last Answer : b. 1,000 feet above the highest obstacle within 8kms of the estimated position of the aircraft

Description : At what height is the mandatory for one flight deck crew to wear an oxygen mask?

Last Answer : D. 41,000ft

Description : What type of autoland system would be required for the landing to continue following a single failure below alert height? a. Fail soft b. Fail passive c. Fail operational or fail active d. Land 2 system

Last Answer : c. Fail operational or fail active

Description : . At what height is it mandatory for one flight crew deck to wear an oxygen mask? a. 25,000ft b. 32,000ft c. 37,000ft d. 41,000ft

Last Answer : d. 41,000ft

Description : At what height is it mandatory for one flight crew deck to wear an oxygen mask? a. 25,000ft b. 32,000ft c. 37,000ft d. 41,000ft

Last Answer : d. 41,000ft

Description : The greater the pressure gradient the:  a. Closer the isobars and the lower the temperatures  b. Further the isobars will be apart and the higher the temperature  c. Closer the isobars and the stronger the wind

Last Answer : c. Closer the isobars and the stronger the wind

Description : What causes wind? a. Difference in pressure b. Rotation of the earth c. Frontal systems d. Difference in temperature

Last Answer : a. Difference in pressure

Description : For take-off performance calculations, what is taken into account? a. OAT, pressure altitude, wind, weight b. Standard temperature, altitude, wind, weight c. Standard altitude, standard temperature, wind, weight d. Standard temperature, pressure altitude, wind, weight

Last Answer : a. OAT, pressure altitude, wind, weight

Description : A pressure head is subject to the following errors: a. Position, manoeuvre induced, temperature b. Position, manoeuvre induced c. Position, manoeuvre induced, density d. Position, manoeuvre induced, instrument

Last Answer : d. Position, manoeuvre induced, instrument

Description : In the stratosphere, why does temperature increase with increasing height? (a) Conduction. (b) Convection. (c) Greater absorption of ultraviolet radiation at the top of the strato- sphere. (d ... you go up through the strato- sphere, thus the ideal gas law requires temperature to increase too.

Last Answer : Greater absorption of ultraviolet radiation at the top of the strato- sphere.

Description : The best strategy to increase stress tolerance

Last Answer : learning, experience CRM

Description : The best strategies to increase stress tolerance are: a. Planning, experience and self-control (fewer unexpected situation) b. Learning, experience and anticipation c. Learning, experience and CRM d. Planning, experience and CRM

Last Answer : c. Learning, experience and CRM

Description : The station pressure used in surface weather charts is

Last Answer : Qff

Description : The station pressure used in surface weather charts is:  a. QNE  b. QFF  c. QFE  d. QNH

Last Answer : a. QNE

Description : Which constant pressure altitude chart is standard for a 30,065 ft pressure level (FL 300)?  a. 200 hPa  b. 700 hPa  c. 500 hPa  d. 300 hPa

Last Answer : d. 300 hPa

Description : You are cruising at FL 200, OAT is -40°C, sea level pressure is 1033 hPa. Calculate the true  altitude.  a. 20,660 ft  b. 21,740 ft  c. 18,260 ft  d. 19, 340 ft

Last Answer : d. 19, 340 ft

Description : You are flying at FL170. The pressure level which is closest to you is the:  a. 300mb  b. 700mb  c. 500mb  d. 850mb

Last Answer : c. 500mb

Description : If cabin pressure is decreasing, the cabin VSI will indicate

Last Answer : B. Climb

Description : The most likely cause of brake fade is: a. Oil or grease on the brake drums b. Worn stators c. The pilot reducing the brake pressure d. The brake pads overheating

Last Answer : d. The brake pads overheating

Description : The purpose of an accumulator is to: a. Relieve excess pressure b. Store fluid under pressure c. Store compressed gas for tyre inflation d. Remove air from the system

Last Answer : b. Store fluid under pressure

Description : If cabin pressure is decreasing, the cabin VSI will indicate: a. Zero b. Climb c. Descent d. Reducing pressure

Last Answer : b. Climb

Description : A shuttle valve will: a. Allow the accumulator to be emptied after engine shut down b. Reduce pump loading when normal system pressure is reached c. Automatically switched to a more appropriate source of hydraulic supply d. Operate on a rising pressure, higher than the Full Flow relief valve

Last Answer : c. Automatically switched to a more appropriate source of hydraulic supply

Description : When does the engine High Pressure fuel shut off valve close? a. After a booster pump failure b. When the engine fuel switch is selected ‘ON’ during engine start c. When flight idle is selected d. When the engine fuel switch is selected ‘OFF’ during engine shut-down

Last Answer : d. When the engine fuel switch is selected ‘OFF’ during engine shut-down

Description : Which of the following instruments require inputs of both pitot and static pressure? a. Airspeed indicator, machmeter and vertical speed indicator b. Airspeed indicator, vertical speed indicator, altimeter c. Airspeed indicator only d. Airspeed indicator and machmeter

Last Answer : d. Airspeed indicator and machmeter

Description : Maximum Differential pressure: a. Is the maximum authorized pressure difference between the inside of the fuselage and the atmospheric ambient pressure b. Is the absolute pressure provided by the vacuum ... time limit d. Is the absolute pressure the cabin pressure ducting is designed to carry

Last Answer : a. Is the maximum authorized pressure difference between the inside of the fuselage and the atmospheric ambient pressure

Description : When would the negative differential limits be reached/exceeded? a. Rapid descent when AC descends below cabin altitude b. During ground pressure testing c. Rapid ascent when aircraft climbs d. When changing to manual operation

Last Answer : a. Rapid descent when AC descends below cabin altitude

Description : CAS is IAS corrected for: a. Position and instrument error b. Instrument, pressure, and density error c. Relative density only d. Compressibility

Last Answer : a. Position and instrument error

Description :  If you are flying at FL300 in an airmass that is 15*C warmer than a standard atmosphere, what is the  outside temperature likely to be?

Last Answer : 30*C

Description : How would you characterize an air temperature of -55*C at the 200HPA level over western Europe?

Last Answer : WITH IN + 5*C OF ISA

Description : Which of the following statements is an interpretation of the METAR?   00000KT 0200 R14/0800U R16/P1500U FZFG VV001 m03/m03 Q1022 BECMG 0800 =  a. Meteorological visibility 200m, RVR for ... 800m, vertical visibility 100ft, calm, meteorological visibility  improving to 800m in the next 2 hours

Last Answer : d. RVR for runway 14 800m, vertical visibility 100ft, calm, meteorological visibility  improving to 800m in the next 2 hours

Description : How do you calculate the lowest usable flight level? a. Lowest QNH and lowest negative temperature below ISA b. Lowest QNH and highest negative temperature below ISA c. Highest QNH and highest temperature above ISA d. Highest QNH and lowest temperature

Last Answer : a. Lowest QNH and lowest negative temperature below ISA

Description : Given: True track 215; mountain elevation 11,600 ft; local airfield gives qnh as 1035 mb; Required terrain clearance 1500 ft; temparute ISA-15C Which of the following is the minimum flight level considering the temperature?

Last Answer : FL140