An angle of 45° with a chain line may be set out with
(A) Optical square
(B) Open cross staff
(C) French cross staff
(D) Prismatic square
Description : In chain surveying, perpendiculars to the chain line are set out by (A) A theodolite (B) A prismatic compass (C) A level (D) An optical square
Last Answer : (D) An optical square
Description : The following instrument is used to set out a right angle (a) Cross staff (b) Optical staff (c) Prism square (d) None of the above (e) All the above*
Last Answer : e) All the above*
Description : The angle between two plane mirrors of optical square, is (A) 20° (B) 30° (C) 45° (D) 60°
Last Answer : (C) 45°
Description : For taking offsets with an optical square on the right hand side of the chain line, it is held (A) By right hand upside down (B) By left hand upright (C) By right hand upright (D) By left hand upside down
Last Answer : (B) By left hand upright
Description : For determining the support reactions at A and B of a three hinged arch, points B and Care joined and produced to intersect the load line at D and a line parallel to the load line through A at D'. Distances AD, DD ... reactions at A and B is (A) 30° (B) 45° (C) 60° (D) 90
Last Answer : (D) 90
Description : The angle of intersection of a contour and a ridge line, is (A) 30° (B) 45° (C) 60° (D) 90°
Last Answer : (D) 90°
Description : The yield line ultimate moment is obtained when the yield line is --------------- to the direction of the reinforcement [ A ] Parallel [ B ] At right angles. [ C ] Passes through [ D ] Crosses at an angle of 45°
Last Answer : [ B ] At right angles.
Description : PQRS is a square. A is a point on PS ,B is a point on PQ,C is a point on QR. ABC is a triangle inside square PQRS. Angle abc = 90° . If AP=BQ=CR then prove that angle BAC =45° -Maths 9th
Last Answer : This is the sketch of the question but its hard to answer.
Description : The zone in which transverse bending is likely to occur may be obtained by drawing a line from the (A) 30° (B) 45° (C) 60° (D) None of these
Last Answer : Answer: Option B
Description : Which one of the following statements is not correc t? (a) Parallax error is eliminated when there is no change in the staff reading when eye is moved up and down (b) The objective lens is ... (d) The eyepiece need not be adjusted after the first set up when the same surveyor is taking readings
Last Answer : (b) The objective lens is to be focused towards a white or bright background for clear visibility of cross-hairs
Description : Draw sketch and write the procedure for setting offset to the left or right side of suvey line with open cross-staff.
Last Answer : Procedure for setting offset with open cross staff : 1. Keep the ranging rods at point P(fixed on survey line) and at point A1 approximately. 2. The cross staff with stadia rod is fixed ... can be fixed and perpendicular offset AB is said to be set to given survey line PQ in left side.
Description : State the uses of following instruments in survey: i)Cross staff ii) Chain iii) Pegs iv) Arrows
Last Answer : i) Cross-Staff: To set up perpendicular or right angle to given chain line OR to find foot of perpendicular from given object to a chain line. ii) Chain: Chains are used for measuring distances. iii) ... on survey lines. iv) Arrows : They are used to mark the end of each chain during chaining.
Description : A well conditioned triangle has no angle less than (A) 20° (B) 30° (C) 45° (D) 60°
Last Answer : (B) 30°
Description : The direction of steepest slope on a contour, is (A) Along the contour (B) At an angle of 45° to the contour (C) At right angles to the contour (D) None of these
Last Answer : (C) At right angles to the contour
Description : A lemniscate curve will not be transitional throughout, if its deflection angle, is (A) 45° (B) 60° (C) 90° (D) 120°
Last Answer : (A) 45°
Description : The bearings of the lines AB and BC are 146° 30' and 68° 30'. The included angle ABC is (A) 102° (B) 78° (C) 45° (D) None of these
Last Answer : (A) 102
Description : A projectile is fired at an angle to the vertical. Its horizontal range will be maximum when is (A) 0° (B) 30° (C) 45° (D) 60°
Description : A member is balanced at its end by two inclined members carrying equal forces. For equilibrium the angle between the inclined bars must be (A) 3° (B) 45° (C) 90° (D) 120°
Last Answer : (D) 120°
Description : The maximum shear stress occurs on the filament which makes an angle with the horizontal plane equal to (A) 30° (B) 45° (C) 60° (D) 90
Last Answer : (B) 45°
Description : The passive earth pressure of a soil is proportional to (where is the angle of internal friction of the soil.) (A) tan (45° - ) (B) tan (45° + ) (C) tan2 (45° - ) (D) tan2 (45° + )
Last Answer : (D) tan2 (45° + )
Description : Select the incorrect statement. Effective angle of shearing resistance (A) Increases as the size of particles increases (B) Increases as the soil gradation improves (C) Is limited to a maximum value of 45° (D) Is rarely more than 30° for fine grained soil
Last Answer : (C) Is limited to a maximum value of 45°
Description : The active earth pressure of a soil is proportional to (where is the angle of friction of the soil) (A) tan (45° - ) (B) tan2 (45° + /2) (C) tan2 (45° - /2) (D) tan (45° + )
Last Answer : Answer: Option C
Description : If the shearing stress is zero on two planes, then the angle between the two planes is (A) 45° (B) 90° (C) 135° (D) 225°
Description : The earth pressure of a soil at rest, is proportional to (where is the angle of internal friction of the soil) (A) tan (45° - ) (B) tan (45° + ) (C) tan2 (45° - ) (D) None of these
Last Answer : Answer: Option D
Description : A cylindrical specimen of saturated soil failed under an axial vertical stress of 100kN/m² when it was laterally unconfmed. The failure plane was inclined to the horizontal plane at an angle of 45°. The values of cohesion and angle of ... N/mm² and 0° (C) 0.2 N/mm² and 0° (D) 0.05 N/mm² and 45°
Description : The angle between the directions of the failure and the major principal plane, is equal to (A) 90° + effective angle of shearing resistance (B) 90° + half of the angle of shearing resistance (C) 45° - half of the angle of shearing resistance (D) 45° + half of the angle of shearing resistance
Description : The anchorage value of a hook is assumed sixteen times the diameter of the bar if the angle of the bend, is (A) 30° (B) 40° (C) 45° (D) All the above
Description : Maximum number of vehicles can be parked with (A) Parallel parking (B) 30° angle parking (C) 45° angle parking (D) 90° angle parking
Description : When the width of car parking space and width of street are limited, generally preferred parking system is (A) Parallel parking (B) 45° angle parking (C) 65° angle parking (D) 90° angle parking
Last Answer : Answer: Option A
Description : A ship strikes the berth generally at an angle (A) 90° with the face of the dock (B) 45° with the face of the dock (C) 30° with the face of the dock (D) 10° with the face of the dock
Last Answer : (D) 10° with the face of the dock
Description : Plywood is made by bonding together thin layers of wood in such a way that the angle between grains of any layer to grains of adjacent layers is (A) 0° (B) 30° (C) 45° (D) 90°
Description : The helix angle for double helical gears may be made up to (A) 45° (B) 60° (C) 75° (D) 90°
Description : In case of binary distillation, increasing the reflux ratio above optimum does not result in the increase of (A) Area between operating line and 45° diagonal x-y diagram (B) Condenser and reboiler surfaces (C) Tower cross-section (D) None of these
Last Answer : (A) Area between operating line and 45° diagonal x-y diagram
Description : When a mass is rotating in a plane about a fixed point, its angular momentum is directed along: (1) the tangent to the orbit (2) a line perpendicular to the plane of rotation (3) the line making an angle of 45° to the plane of rotation (4) the radius
Last Answer : (2) a line perpendicular to the plane of rotation
Description : To avoid large centering error with very short legs, observations are generally made (A) To chain pins (B) By using optical system for centering the theodolite (C) To a target fixed on theodolite tripod on which theodolite may be fitted easily (D) All the above
Last Answer : (C) To a target fixed on theodolite tripod on which theodolite may be fitted easily
Description : A hollow prismatic beam of circular section is subjected to a torsional moment. The maximum shear stress occurs at (a) inner wall of cross section (b) middle of thickness (c) outer surface of shaft (d) none of these
Last Answer : (c) outer surface of shaft
Description : The imaginary line passing through the intersection of cross hairs and the optical centre of the objective, is known as (A) Line of sight (B) Line of collimation (C) Axis of the telescope (D) None of these
Last Answer : (B) Line of collimation
Description : An R.C.C. beam not provided with shear reinforcement may develop cracks in its bottom inclined roughly to the horizontal at (A) 25° (B) 35° (C) 45° (D) 55°
Description : What kind of organizational structure combines a vertical chain of command with horizontal reporting requirements? (a) Line authority ; (b) Matrix ; (c) Functional ; (d) Line-and-staff
Last Answer : (b) Matrix ;
Description : Which of the following is the employer-employee authority relationship that follows the chain of command? (a) Staff authority ; (b) Referent power ; (c) Line authority ; (d) Functional authority
Last Answer : (c) Line authority ;
Description : Cross-staff is used for (A) Setting out right angles (B) Measuring contour gradient (C) Taking levels (D) Measuring distances
Last Answer : (A) Setting out right angles
Description : Pick up the correct statement from the following: (A) Box sextant is used for the measurement of horizontal angles (B) Cross staff is used for setting out right angles (C) Gradiometer is used for setting out any required gradient (D) All the above
Last Answer : (D) All the above
Description : The angle of minimum deviation of an equiangular prism, having a refractive index of 1.732 is (a) 60° (b) 30° (c) 45° (d) 0°
Last Answer : Ans:(a)
Description : Energy in reflected light : (1) does not depends on the angle of incidence (2) increases with the increase in angle (3) decreases with the increase in angle of incidence (4) becomes maximum for angle of incidence equal to 45°
Last Answer : (2) increases with the increase in angle Explanation: Reflected waves are simply those waves that are neither transmitted nor absorbed, but are reflected from the surface of the medium they encounter. The ... depends on the nature of the surface and the angle at which the wave strikes the surface.
Description : The angle in which a cricket ball should be hit to travel maximum horizontal distance is : (1) 60° with horizontal (2) 45° with horizontal (3) 30° with horizontal (4) 15° with horizontal
Last Answer : (2) 45° with horizontal Explanation: This has to do with the equation of a parabola or trajectory which is z = (tane)x 2 cos 9) 2. We can see that if the ball is fired at a 45 degree angle from the ground, the horizontal distance will be a maximum.
Description : If the resultant vector forms an angle of 45°, then the two components are A. parallel to each other B. perpendicular to each other C. anti parallel to each other D. anti perpendicular to each other
Last Answer : perpendicular to each other
Description : In case of partial bearing, the angle of contact of the bushing with the journal is usually (A) 120° (B) 180° (C) 45° (D) 360°
Last Answer : (A) 120°
Description : Projectile will attain its maximum range, if it is fired at an angle of A. 30° B. 47° C. 90° D. 45°
Last Answer : 45°