Description : At what value of crank angle (roughly), no flow of water from or into the air vessel takes place in case of a double acting reciprocating pump? (A) 40° and 140° (B) 45° and 60° (C) 90° and 80° (D) 20° and 120°
Last Answer : (A) 40° and 140
Description : In any good staircase, the maximum and minimum pitch respectively should be (A) 90° and 0° (B) 75° and 30° (C) 60° and 10° (D) 40° and 25°
Last Answer : Option D
Description : The angle of intersection of a contour and a ridge line, is (A) 30° (B) 45° (C) 60° (D) 90°
Last Answer : (D) 90°
Description : A lemniscate curve will not be transitional throughout, if its deflection angle, is (A) 45° (B) 60° (C) 90° (D) 120°
Last Answer : (A) 45°
Description : In case of full journal bearing, the angle of contact of the bushing with the journal is (A) 60° (B) 90° (C) 180° (D) 360°
Last Answer : (D) 360°
Description : The helix angle in case of closely coiled helical spring is (A) less than 5° (B) 5° to 7° (C) 7° to 10° (D) more than 10°
Last Answer : (D) more than 10°
Description : The helix angle in case of closely coiled helical spring is (A) less than 10° (B) 10° to 15° (C) 15° to 20° (D) more than 20°
Last Answer : (A) less than 10°
Description : For a parallel load on a fillet weld of equal legs, the plane of maximum shear occurs at (a) 22.5° (b) 30° (c) 45° (d) 60°
Last Answer : (c) 45°
Description : A concentric spring consist of two helical compression springs (A) both springs always have right hand helix (B) both springs always have left hand helix (C) both springs always have opposite hand of helices (D) any of the above
Last Answer : (C) both springs always have opposite hand of helices
Description : Plywood is made by bonding together thin layers of wood in such a way that the angle between grains of any layer to grains of adjacent layers is (A) 0° (B) 30° (C) 45° (D) 90°
Last Answer : Answer: Option D
Description : Pick up the correct statement from the following: (A) A wire wound in spiral form, is called a helical spring (B) The pitch of a close coil spring, is very small (C) The angle made by the coil with horizontal, is called the angle of helix (D) All the above
Last Answer : (D) All the above
Description : Customers prefer parking of their vehicles at (A) 90° to aisles (B) 85° to aisles (C) 80° to aisles (D) 75° to aisles
Description : The angle of minimum deviation of an equiangular prism, having a refractive index of 1.732 is (a) 60° (b) 30° (c) 45° (d) 0°
Last Answer : Ans:(a)
Description : The angle in which a cricket ball should be hit to travel maximum horizontal distance is : (1) 60° with horizontal (2) 45° with horizontal (3) 30° with horizontal (4) 15° with horizontal
Last Answer : (2) 45° with horizontal Explanation: This has to do with the equation of a parabola or trajectory which is z = (tane)x 2 cos 9) 2. We can see that if the ball is fired at a 45 degree angle from the ground, the horizontal distance will be a maximum.
Description : For determining the support reactions at A and B of a three hinged arch, points B and Care joined and produced to intersect the load line at D and a line parallel to the load line through A at D'. Distances AD, DD ... reactions at A and B is (A) 30° (B) 45° (C) 60° (D) 90
Last Answer : (D) 90
Description : A well conditioned triangle has no angle less than (A) 20° (B) 30° (C) 45° (D) 60°
Last Answer : (B) 30°
Description : The angle between two plane mirrors of optical square, is (A) 20° (B) 30° (C) 45° (D) 60°
Last Answer : (C) 45°
Description : A projectile is fired at an angle to the vertical. Its horizontal range will be maximum when is (A) 0° (B) 30° (C) 45° (D) 60°
Description : The maximum shear stress occurs on the filament which makes an angle with the horizontal plane equal to (A) 30° (B) 45° (C) 60° (D) 90
Last Answer : (B) 45°
Last Answer : 45° with horizontal
Description : If the angle of incidence formed on a concave mirror at a point is 30° then the angle of reflection will be: (1) 15° (2) 30° (3) 60° (4) 90°
Last Answer : (2) 30° Explanation: The angle between the incident ray and the normal is known as the angle of inci dence. The angle between the reflected ray and the normal is known as the angle of reflection.
Description : The bond angle between carbon atoms in cyclohexane is (a) 60° (b) 90° (c) 109.5° (d) 120°
Last Answer : 109.5°
Description : The bond angle between carbon atoms in cyclohexane is (a) 109°28' (b) 60° (c) 90° (d) 120°
Last Answer : 109°28'
Description : The H–C–H bond angle in ethylene is (a) 60° (b) 120° (c) 90° (d) 180°
Last Answer : 120°
Description : If the long chord and tangent length of a circular curve of radius R are equal the angle of deflection, is (A) 30° (B) 60° (C) 90° (D) 120°
Last Answer : D
Description : ABCD is a regular parallelogram plot of land whose angle BAD is 60°. If the bearing of the line AB is 30°, the bearing of CD, is (A) 90° (B) 120° (C) 210° (D) 270°
Last Answer : (C) 210°
Description : What is the value of included angle of a triangular notch for maximum discharge? (A) 30° (B) 60° (C) 90° (D) 120°
Last Answer : (C) 90°
Description : In case of partial bearing, the angle of contact of the bushing with the journal is usually (A) 120° (B) 180° (C) 45° (D) 360°
Last Answer : (A) 120°
Description : PQRS is a square. A is a point on PS ,B is a point on PQ,C is a point on QR. ABC is a triangle inside square PQRS. Angle abc = 90° . If AP=BQ=CR then prove that angle BAC =45° -Maths 9th
Last Answer : This is the sketch of the question but its hard to answer.
Description : Projectile will attain its maximum range, if it is fired at an angle of A. 30° B. 47° C. 90° D. 45°
Last Answer : 45°
Description : A member is balanced at its end by two inclined members carrying equal forces. For equilibrium the angle between the inclined bars must be (A) 3° (B) 45° (C) 90° (D) 120°
Last Answer : (D) 120°
Description : If the shearing stress is zero on two planes, then the angle between the two planes is (A) 45° (B) 90° (C) 135° (D) 225°
Last Answer : Answer: Option B
Description : The angle between the directions of the failure and the major principal plane, is equal to (A) 90° + effective angle of shearing resistance (B) 90° + half of the angle of shearing resistance (C) 45° - half of the angle of shearing resistance (D) 45° + half of the angle of shearing resistance
Description : Maximum number of vehicles can be parked with (A) Parallel parking (B) 30° angle parking (C) 45° angle parking (D) 90° angle parking
Description : When the width of car parking space and width of street are limited, generally preferred parking system is (A) Parallel parking (B) 45° angle parking (C) 65° angle parking (D) 90° angle parking
Last Answer : Answer: Option A
Description : A ship strikes the berth generally at an angle (A) 90° with the face of the dock (B) 45° with the face of the dock (C) 30° with the face of the dock (D) 10° with the face of the dock
Last Answer : (D) 10° with the face of the dock
Description : When a helical spring is cut into two halves, the stiffness of each half spring will be, (A) Same as original spring (B) Double of original spring (C) Half of original spring (D) One fourth of original spring
Last Answer : (B) Double of original spring
Description : The helix angle is very small about 20. The spring is open coiled spring. a) Yes b) It is closed coiled spring c) That small angle isn’t possible d) None of the listed
Last Answer : b) It is closed coiled spring
Description : Coarse threads have helix angle _____ fine threads. a) Equal to b) Greater than c) Lesser than d) There is no relation
Last Answer : c) Lesser than
Description : Efficiency of the screw depends upon helix angle but does not depend on friction angle. a) True b) False
Last Answer : b) False
Description : Self-locking takes place when a) Coefficient of friction is equal to or greater than the tangent of the helix angle b) Coefficient of friction is lesser than or equal to the tangent of the helix ... friction is equal to or greater than the tangent of the helix angle d) None of the mentioned
Last Answer : c) Coefficient of friction is equal to or greater than the tangent of the helix angle
Description : Melting temperature of DNA is the temperature at which (A) Solid DNA becomes liquid (B) Liquid DNA evaporates (C) DNA changes from double helix into supercoiled DNA (D) Native double helical DNA is denatured
Last Answer : Answer : D
Description : The width (helical diameter) of the double helix in B-form DNA in nm is (A) 1 (B) 2 (C) 3 (D) 4
Last Answer : Answer : B
Description : What is the genetic material in influenza virus? (a) Double helical DNA (b) RNA (c) Single helix DNA (d) None of these
Last Answer : (b) RNA
Description : The structure of DNA is a double helix formed by two strands of DNA sequence. This sequence consists of 4 different nucleotides- Adenine, Thymine, Cytosine and Guanine. How do the nucleotides on one strand interact with the nucleotides on the second strand to maintain the helical shape of DNA?
Last Answer : Complementary Base Pairing. Adenine complementary base pairs with Thymine and Guanine complementary base pairs with Cytosine.
Description : The zone in which transverse bending is likely to occur may be obtained by drawing a line from the (A) 30° (B) 45° (C) 60° (D) None of these
Description : 30°, 60° and 90° connections are made in a directional relay to render the relay (A) Sufficient torque under fault conditions (B) Zero torque under fault conditions (C) Current grading (D) Time grading
Last Answer : 30°, 60° and 90° connections are made in a directional relay to render the relay Sufficient torque under fault conditions
Description : If the centre distance of the mating gears having involute teeth is varied within limits, the velocity ratio (A) Increases (B) Decreases (C) Remains unchanged (D) None of these
Last Answer : (C) Remains unchanged
Description : The value of 2 tan 2 45°+ cos 2 30° − sin 2 60° is (a) 0 (b) 1 (c) -2 (d) 2
Last Answer : (d) 2