Description : Consider a source computer(S) transmitting a file of size 106 bits to a destination computer (D)over a network of two routers (R1 and R2) and three links(L1, L2, and L3). L1connects S to R1; L2 connects R1 to ... file from S to D? a. 1005 ms b. 1010 ms c. 3000 ms d. 3003 ms Answer: Option(a)
Last Answer : a. 1005 ms
Description : Which of the following assertions is FALSE about the Internet Protocol (IP)? a. It is possible for a computer to have multiple IP addresses b. IP packets from the same source to the same ... outgoing packets; the route is determined only by the routing tables in the routers on the way
Last Answer : d. The packet source cannot set the route of an outgoing packets; the route is determined only by the routing tables in the routers on the way
Description : For which one of the following reasons does Internet Protocol (IP) use the time-to- live (TTL) field in the IP datagram header? a. Ensure packets reach destination within that time b. ... packets from looping indefinitely d. Limit the time for which a packet gets queued in intermediate routers.
Last Answer : c. Prevent packets from looping indefinitely
Description : In the TCP/IP protocol suite, which one of the following is NOT part of the IP header? a. Fragment Offset b. Source IP address c. Destination IP address d. Destination port number
Last Answer : d. Destination port number
Description : In IPv6, the _______ field inthe baseheader and thesender IP address combineto indicate aunique path identifier for aspecific flow of data. A) flow label B) nextheader C) hoplimit D) destination IP address
Last Answer : flow label
Description : In _______forwarding, the full IP address of a destination isgiven in the routing table. A) next-hop B) network-specific C) host-specific D) default
Last Answer : host-specific
Description : Which one of the following fields of an IP header is NOT modified by a typical IP router? a. Checksum b. Source address c. Time to Live (TTL) d. Length
Last Answer : b. Source address
Description : In virtual circuit network each packet contains ___________ a. full source and destination address b. a short VC number c. only source address d. only destination address
Last Answer : b. a short VC number
Description : In virtual circuit network each packet contains ___________ A. full source and destination address B. a short VC number C. only source address D. only destination address
Last Answer : B. a short VC number
Description : In TCP/IP Reference model, the job of ............... layer is to permit hosts to inject packets into any network and travel them independently to the destination. (A) Physical (B) Transport (C) Application (D) Host-to-network
Last Answer : Answer: Marks to all
Description : Which of the following is not correct in relation to multi-destination routing? a. is same as broadcast routing b. contains the list of all destinations c. data is not sent by packets d. there are multiple receivers
Last Answer : c. data is not sent by packets
Description : Which of the following use routes with packet filtering rules to allow or deny access based on source address, destination address, or port number? 1) Application layer Firewall 2) Packet Filtering Firewall 3) Router enhanced firewall 4) IP enabled firewall
Last Answer : 2) Packet Filtering Firewall
Description : Which of the following use routes with packet filtering rules to allow or deny access based on source address, destination address, or port number? 1 Application layer Firewall 2 Packet Filtering Firewall 3 Router enhanced firewall 4 IP enabled firewall
Last Answer : 2 Packet Filtering Firewall
Description : In packet-filtering router, the following information can be external from the packet header. i) Source IP address ii) Destination IP address iii) TCP/UDP source port iv) ICMP message type v) TCP/UDP destination port A) i, ii, ... iv and v only C) ii, iii, iv and v only D) All i, ii, iii, iv and v
Last Answer : D) All i, ii, iii, iv and v
Description : In packet-filtering router, the following information can be external from the packet header. i) Source IP address ii) Destination IP address iii) TCP/UDP source port iv) ICMP message type v) TCP/UDP destination port A) i, ii ... and v only C) ii, iii, iv and v only D) All i, ii, iii, iv and v
Description : The _______ address in theheader ofa packet in adatagram network normally remains thesame during the entire journeyof the packet. A) source B) destination C) local D) none of the above
Last Answer : destination
Description : The term ________ means that IP provides no error checking or tracking. IP assumes the unreliabilityof the underlying layers and does its best to get a transmission throughto its destination,but with ... ) reliable delivery B) connection-oriented delivery C) best-effort delivery D) noneof the above
Last Answer : best-effort delivery
Description : In _______delivery, both thedeliverer of the IP packet and the destination are on the same network. A) aconnectionless B) a direct C) an indirect D) none of the above
Last Answer : a direct
Description : Length of Port address in TCP/IP is A. 8 bit long B. 4 bit long C. 32 bit long D. 16 bit long
Last Answer : D. 16 bit long
Description : Length of Port address in TCP/IP is a. 8 bit long b. 4 bit long c. 32 bit long d. 16 bit long
Last Answer : d. 16 bit long
Description : Which algorithm is used to decide the path to transfer the packets from source to destination? (1) Routing (2) Pathing (3) Selecting (4) Directing
Last Answer : Routing
Description : What is the size of an IP address? A. 64 bit B. 128 bit C. 16 bit D. 32 bit
Last Answer : D. 32 bit
Description : Suppose transmission rate of a channel is 32 kbps. If there are ‘8’ routes from source to destination and each packet p contains 8000 bits. Total end to end delay in sending packet P is _____. a. 2 sec b. 3 sec c. 4 sec d. 1 sec
Last Answer : a. 2 sec
Description : The ________is a network layer Internet protocol that provides message packets to report errors and other information regarding IP packet processing back to the source: a) Internet Control Message ... Standard Flexible Message Protocol c) Internet Dynamic Chartered Message Protocol d) None of These
Last Answer : a) Internet Control Message Protocol
Description : Which of the following statement is False about the efficiency of the given channel? a. If we want to send big packets on the channel, then Stop and Wait is good choice. b. If length ... is directly proportional to efficiency of channel. d. Efficient might be less if capacity of channel is high
Last Answer : Distance between sender and receiver is directly proportional to efficiency of channel.
Description : If an Ethernet destination address is08:07:06:05:44:33, then this is a ______ address. A) unicast B) multicast C) broadcast D) any of theabove
Last Answer : unicast
Description : f an Ethernet destination address is07:01:02:03:04:05, then this is a ______ address. A) unicast B) multicast C) broadcast D) any of theabove
Last Answer : multicast
Description : Which of the following devices takes data sent from one network device and forwards it to the destination node based on MAC address ? a. Hub b. Modem c. Switch d. Gateway
Last Answer : c. Switch
Description : The program used to determine the round trip delay between a workstation and a destination address is a. Tracert b. Traceroute c. Ping d. Pop
Last Answer : b. Traceroute
Description : ______ eliminates the varying delay times associated withdifferent-size packets. A) X.25 B) Frame Relay C) ATM D) all of theabove
Last Answer : ATM
Description : Station A uses 32 byte packets to transmit messages to Station B using a sliding window protocol. The round trip delay between A and B is 80 milliseconds and the bottleneck bandwidth on the path between A and B ... What is the optimal window size that A should use? a. 20 b. 40 c. 160 d. 320
Last Answer : b. 40
Description : ______ layer is responsible for sending of IP datagrams from the source network to the destination network. A. Application layer B. Transport layer C. Network layer D. Link layer
Last Answer : The correct answer is: C. Network layer The network layer is responsible for routing and forwarding IP datagrams from the source network to the destination network. It provides logical addressing ... at the network layer include IP (Internet Protocol) and ICMP (Internet Control Message Protocol).
Description : _______ inthe data link layer separates a message from one source toa destination, or from other messages going from other sources to other destinations. A) Digitizing B) Controlling C) Framing D) none of the above
Last Answer : Framing
Description : A switchin a datagram network uses arouting tablethat is based on the ______address. A) source B) destination C) local D) none of the above
Description : The ______ layer is responsible for the movementof a signal from its optical source to its optical destination. A) section B) line C) path D) photonic
Last Answer : line
Description : A one-to-one communication betweenone source and one destination is classified as a _______ communication. A) unicast B) multicast C) broadcast D) none of the above
Description : A ________ switch is a multistageswitch with microswitches at each stagethat route the packets based on theoutput port representedas a binary string. A) crossbar B) TSI C) banyan D) none of the above
Last Answer : banyan
Description : What is the main difference between DDCMP and SDLC? a. DDCMP does not need special hardware to final the beginning of a message b. DDCMP has a message header c. SDLC has a IP address d. SDLC does not use CRC
Last Answer : DDCMP does not need special hardware to final the beginning of a message
Description : The sender is a router thathas receiveda datagram destinedfor a host on thesame network. The logical address that mustbe mapped to a physical address is ______. A) thedestination IP address in the datagram ... IP address of therouter found inthe routing table C) either a or b D) noneof the above
Last Answer : thedestination IP address in the datagram header
Description : The sender is a router thathas receiveda datagram destinedfor a host on anothernetwork. The logicaladdress that must be mapped to aphysical address is ______. A) thedestination IP address in the datagram header ... address of therouter found inthe routing table C) either a or b D) noneof the above
Description : If the sender is a host and wants tosend a packet toanotherhost on another network, the logical address that must be mapped to a physical address is ______. A) thedestination IP address in the datagram ... the IP address of therouter found inthe routing table C) either a or b D) noneof the above
Last Answer : the IP address of therouter found inthe routing table
Description : f the sender is a host and wants tosend a packet toanotherhost on the samenetwork, the logical address that must be mapped to a physical address is ______. A) thedestination IP address in the datagram ... the IP address of therouter found inthe routing table C) either a or b D) noneof the above
Last Answer : hedestination IP address in the datagram header
Description : Which of the following statement is incorrect? A. The Addresses Resolution Protocol, ARP, allows a host to find the physicaladdress ofa target host on the samephysical network, given only the target IP address. ... -addresses of our choice to every machine. D. All of theabove E. None of the above
Last Answer : All of theabove
Description : HMP (Host Monitoring Protocol) is: A. a TCP/IP protocol used todynamically bind ahigh level IP Address to alow-level physical hardware address B. a TCP/IP high level protocol for transferring ... used to monitor computers D. a protocol that handles error andcontrol messages E. None of the above
Last Answer : a protocol used to monitor computers
Description : How many bits internet address isassigned to eachhost on a TCP/IP internet which is used in all communications withthehost? A. 16 - bits B. 32 - bits C. 48 - bits D. 64 - bits E. None of the above
Last Answer : 32 - bits
Description : ICMP (Internet Control Message Protocol) is A. a TCP/IP protocol used todynamically bind ahigh level IP Address to alow-level physical hardware address B. a TCP/IP high level protocol for transferring ... to monitor computers D. a protocol that handles error andcontrol messages E. None of the above
Last Answer : a protocol that handles error andcontrol messages
Description : When you ping theloopback address,a packet is sent where? A. On the network B. Down through thelayers of the IP architecture and then up thelayers again C. Across the wire D. through the loopback dongle E. None of the above
Last Answer : Down through thelayers of the IP architecture and then up thelayers again
Description : address use 7 bits for the and 24 bits for the portion of the IP a. address. b. Class A c. Class B d. Class C e. Class D
Last Answer : a. address.
Description : Which of the following OSI layers correspond to TCP/IP's application layer? A) Application B) IP Address C) Session D) All of the above
Last Answer : D) All of the above
Description : DNS can obtain the of host if its domain name is known and vice versa. A) Station address B) IP address C) Port address D) Checksum
Last Answer : B) IP address