Refers to a continuous tone generated in a local exchange terminal through a combination of
two frequencies 350 Hz, and 440 Hz.
A. Busy tone
B. Call waiting tone
C. Dial tone
D. Standard tone

1 Answer

Answer :

B. Call waiting tone

Related questions

Description : The American concert pitch A is equivalent to which if the following frequencies? A. 440 Hz B. 435 Hz C. 260 Hz D. 255 Hz

Last Answer : A. 440 Hz

Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz

Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz

Description : A solar cell of 350 V is feeding power to an ac supply of 440 V, 50 Hz through a 3-phase fully controlled bridge converter. A large inductance is connected in the dc circuit to maintain the dc current at 20 A ... thyristor will be reverse biased for a period of  (A) 125o (B) 120o (C) 60o (D) 55o

Last Answer : A solar cell of 350 V is feeding power to an ac supply of 440 V, 50 Hz through a 3-phase fully controlled bridge converter. A large inductance is connected in the dc circuit to maintain the ... the solar cell resistance is 0.5 Ohm ,then each thyristor will be reverse biased for a period of 125o

Description : What is the standard test tone used for audio measurements? A. 100 Hz B. 500 Hz C. 1000 Hz D. 2000 Hz

Last Answer : C. 1000 Hz

Description : The international pitch A is equivalent to ___ Hz. A. 435 B. 440 C. 260 D. 255

Last Answer : A. 435

Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone

Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz

Description : What is the channel spacing for SITOR frequencies? A. 500 Hz B. 170 Hz C. 300 Hz D. 3 kHz

Last Answer : A. 500 Hz

Description : What is the channel spacing for MF-HF voice frequencies? A. 2.8 kHz B. 500 Hz C. 3.5 kHz D. 3 kHz

Last Answer : D. 3 kHz

Description : Reference noise is ___________. A. a 1000 Hz, -90 dBm tone B. a noise that creates the same interfering effect as a 1000Hz, -90dBm tone C. a noise that creates zero dBrn in a voice channel D. B and C above

Last Answer : D. B and C above

Description : The standard method of controlling the output voltage of a 440 volt, 60 Hz, AC generator is accomplished by adjusting the ____________. A. prime mover speed droop B. number of poles C. alternator field excitation D. load on the alternator

Last Answer : Answer: C

Description : What is the mixing process? A. Distortion caused by auroral propagation B. The combination of two signals to produce sum and difference frequencies. C. The elimination of noise in wideband receiver by phase differentiation D. The elimination of noise in a wideband receiver by phase comparison

Last Answer : B. The combination of two signals to produce sum and difference frequencies.

Description : When shore power is being connected to a ship in dry dock, _____________. A. the ship's generators are paralleled with the shore power to provide continuous power B. proper phase sequence must be ... 450 volts must be supplied from the shore D. exactly 60 Hz must be provided by the terminal

Last Answer : Answer: B

Description : Engaged tone is generated in the: (A) Telephone instrument of calling subscriber (B) Telephone instrument of called subscriber (C) Exchange (D) Repeater

Last Answer : (C) Exchange

Description : The standard test tone A. 0dB B. 10 dBm C. 0 dBm D. 10 dB

Last Answer : C. 0 dBm

Description : ECE Board Exam March 1996 The power of standard test tone is normally ____________. A. 1 dB B. 0 mW C. 1 mW D. 1 W

Last Answer : C. 1 mW

Description : These are used to connect non-ISDN equipment ot ISDN line. A. Digipeaters B. Terminal adapters C. Local repeaters D. Terminal repeaters

Last Answer : B. Terminal adapters

Description : The agreed standard for measuring loudness is the loudness sensation produced by a 1000 Hz sine wave _____ dB above the listener’s threshold of hearing. A. 80 B. 50 C. 30 D. 40

Last Answer : D. 40

Description : What is the channel bandwidth of a standard analogue telephone system? A. 300-500 Hz B. 1200 kHz C. 100-300 Hz D. 300-3400 Hz

Last Answer : D. 300-3400 Hz

Description : ____________ is the out-of-band signaling between toll central offices (Bell System Standard) A. 2,000 Hz B. 800 Hz C. 3,835 Hz D. 3700 Hz

Last Answer : D. 3700 Hz

Description : What does it mean when you dial a number it rings and then goes busy?

Last Answer : answer:Are you ringing: A mobile or landline? Are you calling the same country? What country are you in? Answer the above and I can advise.

Description : The normal concentration of potassium in cells in ng/100 ml is about (A) 100 (B) 200 (C) 350 (D) 440

Last Answer : Answer : D

Description : 151.1% of 151.1 + 151.1 = ? a) 380 b) 400 c) 350 d) 420 e) 440

Last Answer : Answer: a)

Description : The compound interest accrued on an amount of Rs. 25,500 at the end of three years is Rs. 8,440.5.What would be the simple interest accrued on the same amount at the same rate in the same period? a) Rs. 5,450/- b) Rs. 8,750/- c) Rs. 4,350/- d) Rs. 3,650/- e) Rs. 7,650/- 

Last Answer : A = P + Interest = 25500 + 8440.5 = 33940.5 A = P + 1 + (R/100)^3 33940.5 = 25500 a + R/100)^3 a + R/100)^3 = 33940.5 / 25500 a + R/100)^3 = 1.331 a + R/100)^3 = ... R = 10% Simple Interest = Principle Rate Time / 100 = 25500 10 3/100 = 7650 Answer: e)

Description : ………………. Techniques can be used to resolve conflicts, such as competition for resources, and to synchronize processes so that they can cooperate. A) Mutual Exclusion B) Busy Waiting C) Deadlock D) Starvation

Last Answer : A) Mutual Exclusion

Description : …………… is a condition in which there is a set of concurrent processes, only one of which is able to access a given resource or perform a given function at any time. A) Mutual Exclusion B) Busy Waiting C) Deadlock D) Starvation

Last Answer : A) Mutual Exclusion

Description : How does a touch tone receiver differs from pulsed dial receiver? Explain with schematic.

Last Answer : Pulse dialing: 1. Generated through make and break contact. 2. DC Current pulse is generated. 3. Each number is separated by a short pause to prevent overlapping. 4. Codes ... dialing pulse is not misinterpreted as the phone being returned to its on-hook (idle) condition.   

Last Answer : In the telephone, the dial tone has a frequency of 33 Hz.

Description : An entity, relying on the transmission, switching and local distribution facilities of local exchange and inter-exchange operators, and overseas carriers, offers enhanced services beyond those ordinarily ... B. Value-added service provided C. Inter-exchange carrier D. Local exchange carrier

Last Answer : B. Value-added service provided

Description : The latest government regulation in the telecommunication which provides policy for the provision of local exchange carrier service. A. E.O. 546 B. E.O. 109 C. Act 3948 D. E.O. 59

Last Answer : B. E.O. 109

Description : A government regulation in telecommunication which provide policy to improve the provision of local exchange carrier service. A. E.O. 109 B. Act 3846 C. E.O. 59 D. E.O. 546

Last Answer : A. E.O. 109

Description : Refers to one of the front end circuit of a VHF TV superheterodyne receiver which is usually a separate circuit coupled to the mixer. A. Antenna feed B. AGC C. RF amplifier D. Local oscillator

Last Answer : D. Local oscillator

Description : Refers to the first generation of local loop system in telecommunication technology. A. GSM B. DECT C. Analogue cellular D. TACS

Last Answer : C. Analogue cellular

Description : The output voltage of a 440 volt, 60 Hz AC generator is controlled by the ______________. A. load on the alternator B. load on the prime mover C. speed of the prime mover D. exciter output voltage

Last Answer : Answer: D

Description : The following are true about spectral sensitivity of the retina: a. in scotopic conditions, the peak sensitivity of the eye is near 500 nm b. under photopic conditions the peak sensitivity is near 555 nm c ... light the retina has a peak sensitivity near 440 nm to a 25-Hz stimulus d. all above

Last Answer : all above

Description : A 220/440 V, 50 Hz, 5 KVA, single phase transformer operates on 220V, 40Hz supply with secondary winding open circuited. Then (A) Both eddy current and hysteresis losses decreases. (B) Both ... same but hysteresis loss increases. (D) Eddy current loss increases but hysteresis loss remains the same.

Last Answer : (A) Both eddy current and hysteresis losses decreases.

Description : A three-phase, 440 V, 50 Hz ac mains fed thyristor bridge is feeding a 440 V dc, 15 kW, 1500 rpm separately excited dc motor with a ripple free continuous current in the dc link under all operating conditions, Neglecting the ... at half the rated speed is  (A) 0.354 (B) 0.372 (C) 0.90 (D) 0.955

Last Answer : A three-phase, 440 V, 50 Hz ac mains fed thyristor bridge is feeding a 440 V dc, 15 kW, 1500 rpm separately excited dc motor with a ripple free continuous current in the dc link under all operating conditions, Neglecting the losses, the power factor of the ac mains at half the rated speed is 0.354

Description : A 12 -pole, 440 V, 50 Hz, 3 -phase synchronous motor takes a line current of 100 A at 0.8 pf leading. Neglecting losses, the torque developed will be

Last Answer : A 12 -pole, 440 V, 50 Hz, 3 -phase synchronous motor takes a line current of 100 A at 0.8 pf leading. Neglecting losses, the torque developed will be 1165 Nm

Description : If a 220/440 V, 50 Hz, 5 KVA, single-phase transformer operates on 220V, 40Hz supply with secondary winding open circuited: (A) both the eddy current and the hysteresis losses will decrease ... losses will increase (D) eddy current losses will increase but the hysteresis losses will remain the same

Last Answer : If a 220/440 V, 50 Hz, 5 KVA, single-phase transformer operates on 220V, 40Hz supply with secondary winding open circuited: both the eddy current and the hysteresis losses will decrease

Description : What is the function of DDR on Cisco routers? * DDR is dial-on-demand routing. It provides a continuous LAN only connection. * DDR is dial-on-demand routing. It provides routing for high volume ... connection. * DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.

Last Answer : Correct answer: D DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic. It initiates a call to a remote site when there is traffic to transmit

Description : With a single modulating tone, what is the amplitude of the sideband frequencies at 100-percent modulation?

Last Answer : One-half the amplitude of the carrier.

Description : Refers to the duration occupancy period of call during its use. A. Occupancy period B. Traffic time C. Use time D. Holding time

Last Answer : D. Holding time

Description : During the night when the F2 layer combines with F1 layer it falls to what approximate height? A. 250 km B. 350 km C. 300 km D. 400 km

Last Answer : C. 300 km

Description : Can 60 Hz Transformers be Used at Higher Frequencies?

Last Answer : A: Transformers can be used at fre¬quencies above 50 Hz up through 400 Hz with no limitations provided nameplate voltages are not exceeded. However, 50 Hz transformers will have less voltage ... Where better regulation and smaller physical size are required, contact us for special 400 Hz designs.

Description :  High quality music only needs frequencies up to A. 10 Hz B. 15 Hz C. 20 kHz D. 15 kHz

Last Answer : D. 15 kHz

Description : In semi definite system, one of the natural frequencies is found to 15 Hz. The other natural frequency will be A. 15 Hz B. 0 Hz C. 30 Hz D. None of these

Last Answer : B. 0 Hz

Description : Fiber optic cables operate at frequencies near ∙ a. 20 MHz ∙ b. 200 MHz ∙ c. 2G Hz ∙ d. 800 THz

Last Answer : ∙ d. 800 THz

Description : What device measures the angle between two radio frequencies and also the direction of propagation of a wave? A. Densimeter B. Absorption wavemeter C. Goniometer D. Ergometer

Last Answer : C. Goniometer

Description : Space diversity transmission means transmitting and receiving on _______. A. Two or more antennas operating on two different frequencies B. Two or more identical frequencies C. Two or more antennas operating on the same frequency D. Two or more different frequency

Last Answer : C. Two or more antennas operating on the same frequency

Description : Space diversity transmission means transmitting and receiving on A. two or more antennas operating on two different frequencies B. two or more identical frequencies C. two or more different frequencies D. two or more antennas operating on the same frequencies

Last Answer : D. two or more antennas operating on the same frequencies

Description : A dielectric waveguide for the propagation of electromagnetic energy at light frequencies a. Stripline b. Microstrip c. Laser beam d. Fiber optics

Last Answer : d. Fiber optics