Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : Reference noise is ___________. A. a 1000 Hz, -90 dBm tone B. a noise that creates the same interfering effect as a 1000Hz, -90dBm tone C. a noise that creates zero dBrn in a voice channel D. B and C above
Last Answer : D. B and C above
Description : What is the channel bandwidth of a standard analogue telephone system? A. 300-500 Hz B. 1200 kHz C. 100-300 Hz D. 300-3400 Hz
Last Answer : D. 300-3400 Hz
Description : Refers to a continuous tone generated in a local exchange terminal through a combination of two frequencies 350 Hz, and 440 Hz. A. Busy tone B. Call waiting tone C. Dial tone D. Standard tone
Last Answer : B. Call waiting tone
Description : What is the optimum reverberation time at 500 to 1000 Hz of an auditorium? A. 0.9 to 1.1 s B. 1.4 to 1.6 s C. 1.5 to 1.6 s D. 1.6 to 1.8 s
Last Answer : D. 1.6 to 1.8 s
Description : The agreed standard for measuring loudness is the loudness sensation produced by a 1000 Hz sine wave _____ dB above the listener’s threshold of hearing. A. 80 B. 50 C. 30 D. 40
Last Answer : D. 40
Description : At what distance is VHF propagation normally limited? A. Around 500 miles B. Around 1500 miles C. Around 2000 miles D. Around 1000 miles
Last Answer : A. Around 500 miles
Description : Flicker noise is a poorly understood form of noise which may be completely ignored about above ____. A.100 Hz B. 200 Hz C. 400 Hz D. 500 Hz
Last Answer : D. 500 Hz
Description : What is the typical frequency used for communicating to submerged submarines? A. 100 Hz B. 500 Hz C. 4 kHz D. 200 Hz
Last Answer : A. 100 Hz
Description : The standard test tone A. 0dB B. 10 dBm C. 0 dBm D. 10 dB
Last Answer : C. 0 dBm
Description : ECE Board Exam March 1996 The power of standard test tone is normally ____________. A. 1 dB B. 0 mW C. 1 mW D. 1 W
Last Answer : C. 1 mW
Description : If the input to T-flipflop is 100 Hz signal, the final output of the three T-flipflops in cascade is (A) 1000 Hz (B) 500 Hz (C) 333 Hz (D) 12.5 Hz.
Last Answer : (D) 12.5 Hz.
Description : The ratio of the level of the modulated output of a transmitter under conditions of standard test modulation to the level of the demodulated output with no modulation applied both measured with the ... . Reference audio output B. None of these C. Audio frequency response D. Residual noise level
Last Answer : D. Residual noise level
Description : The frequency tolerance of an AM radio broadcast station A. 200 Hz B. 2000 Hz C. 20 Hz D. 2 Hz
Last Answer : C. 20 Hz
Description : What is the reference frequency of CCIT phosphomeric noise measurement? A. 800 Hz B. 1000 Hz C. 1500 Hz D. 3400 Hz
Last Answer : A. 800 Hz
Description : A frequency of 3000 Hz has how many octaves above 1000 Hz? A. 1.6 octaves B. 2.1 octaves C. 1 octave D. 3 octaves
Last Answer : A. 1.6 octaves
Description : What is the reference frequency of CCITT psophometric noise measurement? A. 800 Hz B. 1500 Hz C. 3400 Hz D. 1000 Hz
Description : What is the required quality factor for an SSB filter with the following data: center frequency= 1 MHz, the desired attenuation level of the unwanted sideband= 80 dB and the separation between sidebands= 200 Hz? A. 1,250 B. 12,500 C. 125,000 D. 25,000
Last Answer : C. 125,000
Description : What is the channel spacing for SITOR frequencies? A. 500 Hz B. 170 Hz C. 300 Hz D. 3 kHz
Last Answer : A. 500 Hz
Description : What is the channel spacing for MF-HF voice frequencies? A. 2.8 kHz B. 500 Hz C. 3.5 kHz D. 3 kHz
Last Answer : D. 3 kHz
Description : What is the optimum reverberation time at 500 Hz for a cinema? A. 0.8 – 1.2 sec. B. 0.9 – 1.3 sec. C. 0.6 – 0.8 sec. D. 0.45 – 0.55 sec.
Last Answer : A. 0.8 – 1.2 sec.
Description : In sewage, the solids in mg per litre is A. 100 to 500 B. 500 to 1000 C. 1000 to 1500 D. 1500 to 2000
Last Answer : ANS: B
Description : Value of Prandtl number for water ranges from (A) 1 to 2 (B) 5 to 10 (C) 100 to 500 (D) 1000 to 2000
Last Answer : (B) 5 to 10
Description : A sender uses the Stop-and-Wait ARQ protocol for reliable transmission of frames. Frames are of size 1000 bytes and the transmission rate at the sender is 80 Kbps (1Kbps = 1000 bits/second). Size of ... is lost, the sender throughput is __________ bytes/second. a. 2500 b. 2000 c. 1500 d. 500
Last Answer : a. 2500
Description : ____________ is the out-of-band signaling between toll central offices (Bell System Standard) A. 2,000 Hz B. 800 Hz C. 3,835 Hz D. 3700 Hz
Last Answer : D. 3700 Hz
Description : This type of transmission permits communication in the frequency range from 30 to 60 MHz and over distances from about 1000 to 2000 km. A. Troposcatter B. Ionospheric scatter C. Ducting D. Microwave
Last Answer : B. Ionospheric scatter
Description : Type of transmission path that permits communication in the frequency range from 30 to 60 MHz and over distances form about 1000 to 2000 km. A. Ducting B. Ionospheric scatter C. Microwave D. Troposcatter
Description : Which standard is utilized in intermodulation noise rates on PCM audio channels? A. CCIT Rec. G.151 B. CCIT Rec. G.172 C. CCIT Rec. G.190 D. CCIT Rec. G.190
Last Answer : B. CCIT Rec. G.172
Description : ________ is the method of encoding audio signals used in US standard 1544 kbit/s 24 channel PCM systems. A. Shannon’s law B. A-law C. Newton’s law D. Mu-law
Last Answer : D. Mu-law
Description : You are measuring a voice channel at a -4 dB test point level, the meter reads -73 dBm (pure test tone) convert the reading in dBmCO. A. 16 B. 18 C. 22 D. 12
Last Answer : C. 22
Description : If the frequency spectrum of a signal has a bandwidth of500 Hz with thehighest frequency at 600 Hz, what shouldbe the samplingrate, according to the Nyquist theorem? A) 200 samples/s B) 500 samples/s C) 1000 samples/s D) 1200 samples/s
Last Answer : 1200 samples/s
Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz
Last Answer : D. 500 MHz
Description : How many voice signals (4 kHz max.) would fit into a 5 MHz spectrum? A. 1250 B. 500 C. 1000 D. 1500
Last Answer : A. 1250
Description : What is the bandwidth available in the commercial C-band? A. 1000 MHz B. 36 MHz C. 250 MHz D. 500 MHz
Description : What bandwidth is needed to support a capacity of 128 kbps when the signal power to noise power ratio in decibels is 100? A. 19224 Hz B. 3853 Hz C. 19244 Hz D. 3583 Hz
Last Answer : B. 3853 Hz
Description : In acoustics, if the volume of the room is 200 m3 then at what frequency the coefficient of absorption is measured? A. 120 kHz B. 120 Hz C. 100 Hz D. 150 Hz
Last Answer : B. 120 Hz
Description : What volume of the chamber is required to measure absorption coefficient at 100 Hz? A. 125 m3 B. 50 m3 C. 150 m3 D. 352 m3
Last Answer : D. 352 m3
Description : Check supervisor in RMS the standard for test sorting will be a) 500 article per hour b) 800 article per hour c) 1000 article per hour d) 1200 article per hour
Last Answer : a) 500 article per hour
Description : Full scale Ammeter reading is 10 mA, Voltage across Ammeter is 100 mV. Then for 100 A measurements the power loss in the circuit is a) 1 W b) 10 W c) 100 W d) 1000 W
Last Answer : Ans: 10 W*
Description : The National Council on Radiation Protection and Measurements estimates that the average exposure to ionizing radiation tha individual Americans receive annually from ALL sources is about: w) 60 millirem x) 100 millirem y) 360 millirem z) 500 millirem
Last Answer : ANSWER: Y -- 360 MILLIREM
Description : Three audio waves with 100,200 and 300 volts amplitude respectively, simultaneously modulate a 450 volts carrier. What is the total percent of modulation of the AM wave? A. 69 % B. 115.5 % C. 50% D. 83%
Last Answer : D. 83%
Description : A test method of comparing two audio systems by switching inputs so that the same recording is heard in rapid succession over one given system and then the other. A. B test B. A test C. AB test D. C test
Last Answer : C. AB test
Description : A hammer gains 50 Ns momentum in 0.05 sec. The average force on the hammer will be a.500 N b.2000 N c.1500 N d.107 dynes e.1000 N
Last Answer : e. 1000 N
Description : Match the following : [IAS 1999] A. Cotton 1. Rainfall 1000-1500 mm; Temperature 40°-60°C B. Flax 2. Rainfall 1500-2000 mm; Temperature 25°-35°C C. Sugarbeet 3. Rainfall 600-S00 mm; Temperature 5°-18°C D. Jute 4. Rainfall 500-1000 mm; ... 1 3 4 2 (b) 2 3 5 4 (c) 4 5 2 1 (d) 4 3 5 2 shop.ssbcrack.com
Last Answer : Ans: (d)
Description : Average resistance of human body is: a) 500 ohms b) 1000 ohms c) 1500 ohms d) 2000 ohms
Last Answer : Ans: B
Description : Heating value of coal is approximately (A) 1000-2000 kcal / kg (B) 2000-4000 kcal / kg (C) 5000-6500 kcal / kg (D) 9000-10,500 kcal / kg
Last Answer : Ans: C
Description : The maximum temperature in the I.C engine cylinder is of the order of a. 500 – 1000 C b. 1000 – 1500 C c. 1500 – 2000 C d. 2000 – 2500 C
Last Answer : ANSWER d. 2000 – 2500 C
Description : A minimum yearly deposit of ________ is required to open and maintain a PPF account, and a maximum deposit of _____. A. Rs. 500 and Rs 1.50 lakhs B. Rs. 1000 and Rs 2.50 lakhs C. Rs. 2000 and Rs 3.50 lakhs D. Rs. 5000 and Rs 4.50 lakhs
Last Answer : A. Rs. 500 and Rs 1.50 lakhs Explanation: A minimum yearly deposit of Rs. 500 is required to open and maintain a PPF account, and a maximum deposit of Rs.1.5 lakhs (as on Financial year 2015- ... Income Tax Act. The amount can be deposited in lump sum or in a maximum of 12 instalments per year.
Description : For design purposes, the normal rate of infiltration of ground water into the sewer, is A. 500 litres/km/cm B. 1000 litres/km/cm C. 1500 litres/km/cm D. 2000 litres/km/cm
Last Answer : ANS: D