What is the maximum power that can be obtained from a microwave tube at 10 GHz?
A. 500 W
B. 10 W
C. 50 W
D. 20 W

1 Answer

Answer :

B. 10 W

Related questions

Description : Part of a microwave link can be approximated by free space conditions. The antenna gain are each 40 dB, the frequency is 10 GHz, and the path length is 80 km. Calculate the receive power for a transmitted power of 10 W? A. 0.871 μW B. 871 μW C. 0.871 mW D. 871 nW

Last Answer : A. 0.871 μW

Description : What is the free space loss, in dB, between two microwave parabolic antennas 38.0 kilometer apart operating at 7.0 GHz? A. 145.6 dB B. 138.5 dB C. 135.5 dB D. 140.89 dB

Last Answer : D. 140.89 dB

Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz

Last Answer : D. 500 MHz

Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz

Last Answer : B. 15 to 160 Mhz

Description : A radio frequency in the ultra high frequency band of the radio spectrum band. A. 235.50 MHz B. 450.50 MHz C. 150.50 GHz D. 0.31250 GHz

Last Answer : D. 0.31250 GHz

Description : The total space loss of transmission and reception for two ground stations with uplink frequency 8GHz and a downlink of 6 GHz with angle of elevations of 3˚ and 7˚ A respectively is A. 403 dB B. 100 dB C. 20 dB D. 215 dB

Last Answer : A. 403 dB

Description : Extra-terrestrial noise is observable at frequencies from A. 0 to 20 KHz B. Above 2 GHz C. 8 to 1.43 GHz D. 5 to 8 GHz

Last Answer : C. 8 to 1.43 GHz

Description : Fiber optic cable operates near _______ frequencies. A. 800 THz B. 20 MHz C. 200 MHz D. 2 GHz

Last Answer : A. 800 THz

Description : What is the front-to-back ratio of an antenna which radiates 500 watts in a northernly direction and 50 watts in a southernly direction? A. 25000 dB B. 10 dB C. 100 dB D. 20 dB

Last Answer : B. 10 dB

Description : What is the frequency range of C-band? A. 10.95 to 14.5 GHz B. 27.5 to 31 GHz C. 3.4 to 6.424 GHz D. 1.53 to 2.7 GHz

Last Answer : C. 3.4 to 6.424 GHz

Description : Atmospheric noise is less at severe frequencies above A. Audio level B. 30 MHz C. 10 GHz D. 1 GHz

Last Answer : B. 30 MHz

Description : A microwave communications system space loss calculation formula is A. 92.4 + 10 log f +20 log d B. 94.2 + 10 log f +20 log d C. 92.4 + 20 log f +20 log d D. 94.2 + 20 log f +20 log d

Last Answer : C. 92.4 + 20 log f +20 log d

Description : What is the free space attenuation of a satellite communications system operating at 36,000 km above the earth at 5.0 GHz? A. 198 dB B. 202 dB C. 142 dB D. 138 dB

Last Answer : A. 198 dB

Description : Most satellites operate in which frequency band? A. 30 to 300 MHz B. 300 MHz to 3 GHz C. 3 GHz to 30 GHz D. Above 300 GHz

Last Answer : C. 3 GHz to 30 GHz

Description : The frequency of Ku band for satellite communications. A. 6/4 GHz B. 14/11 GHz C. 12/14 GHz D. 4/8 GHz

Last Answer : B. 14/11 GHz

Description : What is the local oscillator (mixer) frequency of the satellite with an uplink frequency in GHz band? A. 3500 MHz B. 4500 MHz C. 2225 MHz D. 2555 MHz

Last Answer : C. 2225 MHz

Description : What is the frequency range of C-band? A. 8.5 to 12.5 GHz B. 3.4 to 6.425 GHz C. 12.95 to 14.95 GHz D. 27.5 to 31 GHz

Last Answer : B. 3.4 to 6.425 GHz

Description : What noise is observable at frequencies in the range from about 8 MHz to somewhat 1.5 GHz? A. Industrial noise B. Atmospheric noise C. Space noise D. Shot noise

Last Answer : C. Space noise

Description : What noise type is observable between 8 MHz to somewhat above 1.43 GHz or up to 1.5 GHz? A. Solar noise B. Space noise C. Galactic noise D. Cosmic noise

Last Answer : B. Space noise

Description : Tropospheric scatter is a method of sky wave propagation for which of the following frequency bands? A. 300 kHz to 3 MHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 300 MHz to 3 GHz

Last Answer : D. 300 MHz to 3 GHz

Description : Which of the following frequency bands is best suited for sky wave propagation? A. 30 to 300 kHz B. 3 MHz to 30 MHz C. 30 MHz to 300 MHz D. 3 GHz to 30 GHz

Last Answer : B. 3 MHz to 30 MHz

Description : Determine the terrain sensitivity loss for a 4-GHz carrier that is propagating over a very dry, mountainous area. A. -1.25 dB B. -3.05 dB C. -2.01 dB D. -5.01 dB

Last Answer : A. -1.25 dB

Description : Which of the following are uplinks in the Ku band? A. 14 to 14.5 GHz B. 11.7 to 12.2 GHz C. 14 to 15.5 GHz D. 11 to 11.5 GHz

Last Answer : A. 14 to 14.5 GHz

Description : Which of the following is the uplink frequency in C-band? A. 5.925 GHz B. 4.2 GHz C. 7.425 GHz D. 3.7 GHz

Last Answer : A. 5.925 GHz

Description : What is the uplink receiver frequency if the downlink transmitter is on channel 4 (3.84 Ghz)? A. 6.065 GHz B. 6.84 GHz C. 6.65 GHz D. 6.05 GHz

Last Answer : A. 6.065 GHz

Description : What is the path attenuation between transmitter and receiver at a frequency of 1.2 Ghz and a distance of 11,000 mi? A. 119 dB B. 115dB C. 179dB D. 174dB

Last Answer : C. 179dB

Description : Electromagnetic waves of frequencies arbitrarily lower than 3,000 GHz, propagated in space without artificial guide. A. Space waves B. Terrestrial waves C. Mobile D. Hertzian waves

Last Answer : D. Hertzian waves

Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz

Last Answer : B. 30 to 300 GHz

Description : Coaxial lines are used on those systems operating _______. A. Below 2 GHz B. At 300 MHz C. Above 10KHz D. Above 10GHz

Last Answer : A. Below 2 GHz

Description : The Ku-band in the satellite service A. 14/11 GHz B. 30/17 GHz C. 8/7 GHz D. 6/4 GHz

Last Answer : A. 14/11 GHz

Description : What frequency does oxygen causes excessive attenuation A. 119 GHz B. 183 GHz C. 310 GHz D. 60 GHz

Last Answer : D. 60 GHz

Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz

Last Answer : B. 0 to 4 kHz

Description : A dipole antenna requires to be fed with 20 kW of power to produce a given signal strength to a particular distant point. If the addition of a reflector makes the same field strength available with an input power of 11kW ... Gain referred to this particular dipole). A. 4.75 B. 2.6 C. 1.81 D. 4.24

Last Answer : B. 2.6

Description : What is the frequency limit of an optical fiber? ∙ a. 20 GHz ∙ b. 30 GHz ∙ c. 40 GHz ∙ d. 50 GHz

Last Answer : ∙ c. 40 GHz

Description : It is a measure of the microwave power radiated from an antenna as a function of angular direction from the antenna axis. A. Antenna pattern B. Polarization C. Beamwidth D. Sidelobes

Last Answer : C. Beamwidth

Description : In the American standard, the aural transmitter maximum radiated power is _____ of peak visual transmitter power. A. 10 % B. 30 % C. 20 % D. 40 %

Last Answer : C. 20 %

Description : The maximum power suggested by KBP on 919-1312 AM broadcast station in Metro Manila is A. 10 kW B. 20 kW C. 15 kW D. 5 kW

Last Answer : B. 20 kW

Description : A round viewing window with a 20 centimeter diameter is installed in a tank at the Shedd Aquarium. It is 5 meters below the water surface. The force on the window is approximately: w) 1,500 Newtons x) 10,000 Newtons y) 25,000 Newtons z) 50,000 Newtons

Last Answer : ANSWER: W -- 1,500 NEWTONS

Description : What is the effective radiated power of a repeater with 50 watts transmitter power output, 5 dB feedline loss, 4 dB duplexer and circulator loss, and 7 dB antenna gain? A. 300 W B. 315 W C. 31.5 W D. 69.9 W

Last Answer : C. 31.5 W

Description : What is the effective radiated power of a repeater with 50 watts transmitter power output \, 4 dB feedline loss, 3 dB duplexer and circulator loss, and 6 dB antenna gain? A. 158 W B. 39.7 W C. 251 W D. 69.9 W

Last Answer : B. 39.7 W

Description : A satellite transmitter operates at 4GHz with an antenna gain of 4dBi. The receiver 40000 km away has an antenna gain of 50 dBi. If the transmitter has a power of 8 W, find (ignoring feedline losses and mismatch) the EIRP in dBW. A. 50 B. 69 C. 49 D. 30

Last Answer : C. 49

Description : Ho w many times bigger does the bandwidth of a fiber optic multimode have over a cable? A. 50 times bigger B. 100 times bigger C. 10 times bigger D. 5 times bigger

Last Answer : B. 100 times bigger

Description : The spacing of tube wells should generally be more than ----------from the circle of influence a)10 metre b)50 metre c)100 metre* d) 500 metre

Last Answer : c)100 metre*

Description : If 4 kW in antenna produces 50 μV/m in a receiving antenna, a 15 kW will produce _____. A. 200 μV/m B. 10 μV/m C. 100 μV/m D. 20 μV/m

Last Answer : C. 100 μV/m

Description : What is the typical gain of a rhombic antenna? A. Between 15 to 60 B. Between 20 to 90 C. Between 50 to 75 D. Between 10 to 25

Last Answer : A. Between 15 to 60

Description : For the safety and comfort of factory workers, the sound-intensity level in a certain factory must remain below 85 dB. What is the maximum sound intensity allowed in this factory? A. 3.2 x 10-4 W/m2 B. 3.2 x 10-6 W/m2 C. 3.2 x 10-10 W/m2 D. 3.2 x 10-3 W/m2

Last Answer : A. 3.2 x 10-4 W/m2

Description : Which of the following low noise transistors is commonly used at microwave frequencies? A. MOSFET B. GASFET C. MESFET D. JFET

Last Answer : C. MESFET

Description : The transistor with the lowest noise figure in the microwave region is a A. MOSFET B. Dual-gate MOSFET C. JFET D. MESFET

Last Answer : D. MESFET

Description : A component that samples the microwave signal travelling in one direction down to the transmission line A. Isolator B. Combiner C. Directional coupler D. Attenuator

Last Answer : C. Directional coupler

Description : What is the common up-converter and down-converter IF for microwave communications? A. 60 MHz B. 80 MHz C. 120 MHz D. 70 MHz

Last Answer : D. 70 MHz