Description : An engine indicator is used to determine the following a. Speed. b. Temperature. c. Volume of cylinder. d. Mean effective pressure and Indicated horse power.
Last Answer : ANSWER d. Mean effective pressure and Indicated horse power.
Description : The knock in diesel engine occurs due to A. instantaneous and rapid burning of the first part of the charge B. instantaneous auto ignition of the last part of the charge C. delayed burning of the last part of the charge D. reduction of delay period
Last Answer : ANSWER : A
Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on
Last Answer : ANSWER : B
Description : Supercharging is the process of a. supplying the engine with air at a density greater than the density of the surrounding atmosphere b. providing forced cooling air c. injecting excess fuel d. raising the exhaust pressure
Last Answer : ANSWER a. supplying the engine with air at a density greater than the density of the surrounding atmosphere
Description : Scavenging air in diesel engine means a. air used for combustion under pressure b. forced air for cooling the cylinder c. burnt air containing products of combustion d. air used for forcing burnt gases out of the engines cylinder during the exhaust stroke
Last Answer : ANSWER d. air used for forcing burnt gases out of the engines cylinder during the exhaust stroke
Description : An engine indicator is used to determine the following A. Speed B. Temperature C. M.E.P D. Volume of cylinder
Last Answer : ANSWER : C
Description : The size of inlet valve of an engine in comparison to exhaust valve is A. more B. less C. same D. varies from design to design
Description : If one cylinder of a diesel engine receives more fuel than others , then for that cylinder the A. exhaust will be smoky B. scavenging occurs C. exhaust temperature will be high D. engine starts overheating
Description : In two stroke engine, which of the following functions are performed at the same time? a. Compression and exhaust b. Intake and Expansion c. Intake and exhaust d. Intake and compression (Ans:c)
Last Answer : The compression ratio in a Compression Ignition (CI) engine is generally in between a. 8 to 13 b. 14 to 23 c. 20 to 28 d. 25 to 32 (Ans:b)
Description : The _____________ sensor, checks the temperature of the ambient air entering the engine for fine tuning the mixture strength. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: d Explanation: The air inlet temperature sensor, checks the temperature of the ambient air entering the engine for fine tuning the mixture strength whereas the engine temperature sensor senses the ... gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : The _____________ sensor, monitors mass or volume of air flowing into the intake manifold for adjusting the quantity of fuel. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: c Explanation: The air flow sensor, monitors mass or volume of air flowing into the intake manifold for adjusting the quantity of fuel while exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : The _____________ sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: a Explanation: The engine temperature sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting while the ... gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : In _____________ sensor, output voltage changes in proportion to air-fuel ratio. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: b Explanation: Only in exhaust gas sensor, output voltage changes in proportion to air-fuel ratio.
Description : _____________ senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio. a) Engine temperature b) Exhaust gas c) Air flow d) Air inlet temperature
Last Answer : Answer: b Explanation: Exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates airfuel ratio while engine temperature sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting.
Description : In a 75 cc engine the parameter cc indicates a. fuel tank capacity b. lubricating oil capacity c. swept volume d. cylinder volume
Last Answer : ANSWER c. swept volume
Description : Octane number of gasoline is obtained by comparing the performance of the engine when running on a mixture of the following hydrocarbons A. ethane and methane B. normal heptane and iso-octane C. iso-heptane and octane D. iso-octane and TEL
Description : If petrol is used in a diesel engine a. higher knocking will occur b. efficiency will be low c. low power will be obtained d. black smoke will be produced
Last Answer : ANSWER a. higher knocking will occur
Description : The area of actual indicator diagram on an air compressor as compared to area of ideal indicator diagram is A. Less B. More C. Same D. Unpredictable
Description : Fuel is injected into the cylinder at the end of ______________ stroke. a) suction b) compression c) expansion d) exhaust
Last Answer : Answer: b Explanation: Fuel is injected into the cylinder at the end of compression stroke and not at suction or expansion stroke.
Description : For same power output and same r, as compared to 2- stroke engines, four stroke SI engines have (a) Higher fuel consumption (b) Lower thermal efficiency (c) Highest exhaust temperatures (d) Higher thermal efficiency
Last Answer : Ans :d
Description : The RMS value of a sine-wave current may also be expressed as the _____________. A. average value B. maximum value C. effective value D. instantaneous value
Last Answer : Answer: C
Description : The volume of air delivered by the compressor is called A. Free air delivery B. Compressor capacity C. Swept volume D. Mean effective pressure
Description : The ratio of work done per cycle to the stroke volume of the compressor is known as A. Compressor capacity B. Compression ratio C. Compressor efficiency D. Mean effective pressure
Last Answer : ANSWER : D
Description : With EFI of diesel engines a) sharp start and stop is not possible b) very high injection pressure can be obtained c) sudden cylinder cut-off is impossible d) diagnostic properties are poor
Last Answer : Answer: b Explanation: Generally, with EFI of diesel engines very high injection pressure can be obtained.
Description : HUCR is the highest compression ratio at which the A. engine can be run B. engine gives maximum output C. engine is most efficient D. fuel can be used in a test engine without detonation
Description : In a battery ignition system, the intensity of spark is A. minimum at low engine speed B. minimum at low engine speed and increases with engine speed C. maximum al low engine speed and decreases with engine speed D. maximum at low engine speed
Description : In a variable speed SI engine, the maximum torque occurs at the maximum (a) Speed (b) Brake power (c) Indicated power (d) Volumetric efficiency
Description : Velocity of flame propagation in SI engine is maximum for a fuel air mixture which is (a) 10% richer than stoichiometric (b) Equal to stoichiometric (c) More than 10% richer than stoichiometric (d) 10% leaner than stoichiometric
Last Answer : Ans :a
Description : A engine will generate maximum torque when it a. runs at maximum speed b. develops maximum power c. runs at lowest speed d. consumes more fuel
Last Answer : ANSWER c. runs at lowest speed
Description : The maximum temperature in the I.C engine cylinder is of the order of a. 500 – 1000 C b. 1000 – 1500 C c. 1500 – 2000 C d. 2000 – 2500 C
Last Answer : ANSWER d. 2000 – 2500 C
Description : As a result of detonation in an I.C engine, following parameter attains a high value A. peak temperature B. peak pressure C. rate of pressure rise D. rate of temperature rise
Description : The _____________ sensor, senses rotation of engine camshaft for speed and timing of injection. a) throttle position b) manifold pressure c) camshaft position d) knock
Last Answer : Answer: c Explanation: The camshaft position sensor, senses rotation of engine camshaft for speed and timing of injection whereas the throttle position sensor, senses the movement of the throttle ... engine intake manifold so that the mixture strength can be adjusted with changes in engine load.
Description : The ___________ sensor, monitors vacuum in the engine intake manifold so that the mixture strength can be adjusted with changes in engine load. a) throttle position b) manifold pressure c) camshaft position d) knock
Last Answer : Answer: b Explanation: The manifold pressure sensor, monitors vacuum in the engine intake manifold so that the mixture strength can be adjusted with changes in engine load and the camshaft position sensor, senses rotation of engine camshaft for speed and timing of injection.
Description : The _____________ sensor, senses the movement of the throttle plate so that the mixture flow can be adjusted for engine speed and acceleration. a) throttle position b) manifold pressure c) camshaft position d) knock
Last Answer : Answer: a Explanation: The throttle position sensor, senses the movement of the throttle plate so that the mixture flow can be adjusted for engine speed and acceleration while the manifold ... the camshaft position sensor, senses rotation of engine camshaft for speed and timing of injection.
Description : The tendency of knocking in CI engine reduces by (a) High self ignition temperature of fuel (b) Decrease in jacket water temperature (c) Injection of fuel just before TDC (d) Decrease in injection pressure
Last Answer : Ans :c
Description : Keeping other parameters constant brake power of diesel engine can be increased by (a) Decreasing the density of intake air (b) Increasing the temperature of intake air (c) Increasing the pressure of intake air (d) Decreasing the pressure of intake air
Last Answer : Ans : c
Description : The fuel in diesel engine is normally injected at pressure of a. 5-10 kg/cm2 b. 20-25 kg/cm2 c 60-80 kg/cm2 d. 90-130 kg/cm2
Last Answer : ANSWER d. 90-130 kg/cm2
Description : Vapour lock is a. complete or partial stoppage of fuel supply due to vaporization of the fuel b. locking of carburetor due to high vapor pressure c. excess fuel supply to the engine d. supply of liquid fuel to the engine
Last Answer : ANSWER a. complete or partial stoppage of fuel supply due to vaporization of the fuel
Description : The back pressure of petrol engine is usually a. 1 ata b. 1.2 ata c. 0.8 ata d. 2 ata.
Last Answer : ANSWER b. 1.2 ata
Description : It is the unbalanced force developed in a turbo jet engine that is caused by the difference in the momentum of the low-velocity air entering the engine and the high velocity exhaust gases leaving the engine. a. Fall b. Lift c. Drag d. Thrust
Last Answer : Thrust
Description : The maximum delivery pressure in a rotary air compressor is A. 10 bar B. 20 bar C. 30 bar D. 50 bar
Description : In a two stage reciprocating air compressor, the suction and delivery pressure are 1 and 4 bar respectively. For maximum efficiency the intercooler pressure is A. 1.5 bar B. 2 bar C. 2.5 bar D. 3 bar
Description : For the same maximum pressure and temperature, what is the relation among the efficiencies of the Otto cycle, the Diesel cycle and the Dual cycle? a. ηDual >ηDiesel >ηOtto b. ηDiesel >ηDual >ηOtto c. ηDiesel >ηOtto >ηDual d. ηOtto >ηDiesel >ηDual
Last Answer : ANSWER b. ηDiesel >ηDual >ηOtto
Description : Efficiency of a Carnot engine is given as 80%. If the- cycle direction be reversed, what will be the value of COP ofreversed Carnot cycle (a) 1.25 (b) 0.8 (c) 0.5 (d) 0.25
Last Answer : Ans: d
Description : In two stroke engine one power occurs in _______ of crank rotation A. 180° B. 360° C. 270° D. 720°
Description : In a naturally aspirated diesel engine, the air is supplied by a A. supercharger B. centrifugal pump C. movement of engine piston D. reciprocating pump
Description : A 5 BHP engine running at full load would consume diesel of the order of A. 0.3 kg/hr B. 1 kg/hr C. 3 kg/hr D. 5 kg/hr
Last Answer : ANSWER ; B
Description : Air fuel ratio at which a petrol engine cannot work is A. 8:1 B. 12:1 C. 15:1 D. 20:1 and less
Description : Air fuel ratio for idling speed of a petrol engine is approximately A. 1:1 B. 5:1 C. 20:1 D. 10:1
Description : The theoretically correct air fuel ratio of a petrol engine is of the order of A. 6:1 B. 10:1 C. 15:1 D. 20:1