Description : What is the typical frequency used for communicating to submerged submarines? A. 100 Hz B. 500 Hz C. 4 kHz D. 200 Hz
Last Answer : A. 100 Hz
Description : What is the channel bandwidth of a standard analogue telephone system? A. 300-500 Hz B. 1200 kHz C. 100-300 Hz D. 300-3400 Hz
Last Answer : D. 300-3400 Hz
Description : If the clock frequency to the circuit shown in the illustration were 2 kHz, what would be indicated at the output of 'FF-C'? EL-0087 A. 250 Hz B. 666 Hz C. 6 kHz D. 16 kHz
Last Answer : Answer: A
Description : In acoustics, if the volume of the room is 200 m3 then at what frequency the coefficient of absorption is measured? A. 120 kHz B. 120 Hz C. 100 Hz D. 150 Hz
Last Answer : B. 120 Hz
Description : Which one of the following units is used to measure intensity of noise? (A) decible (B) Hz (C) Phon (D) Watts/m2
Last Answer : (A) decible
Description : What is the channel spacing for SITOR frequencies? A. 500 Hz B. 170 Hz C. 300 Hz D. 3 kHz
Last Answer : A. 500 Hz
Description : What is the channel spacing for MF-HF voice frequencies? A. 2.8 kHz B. 500 Hz C. 3.5 kHz D. 3 kHz
Last Answer : D. 3 kHz
Description : What frequency is 10 octaves above 30 Hz? A. 30.72 kHz B. 30 kHz C. 300 Hz D. 307.2 kHz
Last Answer : A. 30.72 kHz
Description : Flicker noise is a poorly understood form of noise which may be completely ignored about above ____. A.100 Hz B. 200 Hz C. 400 Hz D. 500 Hz
Last Answer : D. 500 Hz
Description : A tuned circuit has a Q of 100 at its resonant frequency of 500 kHz. Its bandwidth is _____kHz. (A) 50000 (B) 0.2 (C) 600 (D) 5
Last Answer : A tuned circuit has a Q of 100 at its resonant frequency of 500 kHz. Its bandwidth is 5 kHz.
Description : Man perceives sound vibrations in the frequency ranges of – (1) 0 – 5 Hz (2) 6 - 10 Hz (3) 11 - 15 Hz (4) 20 - 20000 Hz
Last Answer : (4) 20 - 20000 Hz Explanation: The frequencies at which a human being can perceive sound vary between 20 Hertz and 20,000 Hertz. It is within these frequency ranges that people can communicate to each other and listen to music.
Description : Man perceives sound vibrations in the frequency ranges of (1) 0 – 5 Hz (2) 6 – 10 Hz (3) 11 – 15 Hz (4) 20 – 20000 Hz
Last Answer : 20 – 20000 Hz
Description : What is the frequency of a 2-cm sound wave in sea water at 25˚C? A. 76 kHz B. 76 Hz C. 76 MHz D. 76 mHz
Last Answer : A. 76 kHz
Description : The frequency-response specification of your tape recorder reads within +/ - 3 dB from 150 Hz to 150 kHz at 60 ips. What does this mean?
Last Answer : The recorder can record all frequencies between 150 Hz and 150 kHz at 60 ips without varying the output amplitude more than 3 dB.
Description : If the clock frequency to the circuit shown in the illustration were 100 kHz, what would be indicated at the output of 'FF-C'? EL-0087 A. 10.1 kHz B. 12.5 kHz C. 805 kHz D. 1010 kHz
Last Answer : Answer: B
Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz
Last Answer : C. 15 to 160 MHz
Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz
Last Answer : B. 15 to 160 Mhz
Description : A periodic signal completes onecycle in 0.001 s. What is thefrequency? A) 1 Hz B) 100 Hz C) 1 KHz D) 1 MHz
Last Answer : 1 KHz
Description : A resonant system has a fundamental frequency of 100 Hz. If the next higher frequency that gives a resonance are 300 Hz and 500 Hz, the system could be (a) A pip open at both ends (b) A pipe ... (c) A string vibrating between two fixed points (d) A pipe open at one end and closed at the other
Last Answer : Ans:(d)
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m and mass of 20 kg? A 12.32 Hz B 4.10 Hz C 6.16 HzD None of the above
Last Answer : C 6.16 Hz
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m and mass of 20 kg? A. 12.32 Hz B. 4.10 Hz C. 6.16 Hz D. None of the above
Last Answer : C. 6.16 Hz
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m and mass of 20 kg? A) 12.32 Hz B) 4.10 Hz C) 6.16 Hz D) None of the above
Last Answer : C) 6.16 Hz
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m and mass of 20 kg? C ( A )12.32 Hz (B) 4.10 Hz ( C )6.16 Hz (D)None of the above
Last Answer : ( C )6.16 Hz
Description : Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m mass of 20 kg? a. 12.32 Hz b. 4.10 Hz c. 6.16 Hz d. None of the above
Last Answer : c. 6.16 Hz
Description : If the phase difference between two points is 120° for a wave with velocity of 360 m/ and frequency 500 Hz, then path difference between the two points is – (1) 1 cm (2) 6 cm (3) 12 cm (4) 24 cm
Last Answer : (4) 24 cm
Description : What is the required quality factor for an SSB filter with the following data: center frequency= 1 MHz, the desired attenuation level of the unwanted sideband= 80 dB and the separation between sidebands= 200 Hz? A. 1,250 B. 12,500 C. 125,000 D. 25,000
Last Answer : C. 125,000
Description : If the phase difference between two points is 120° for a wave with velocity of 360 m/ and frequency 500 Hz, then path difference between the two points is (1) 1 cm (2) 6 cm (3) 12 cm (4) 24 cm
Last Answer : 24 cm
Description : Insert the missing number in the following: 2/3, 4/7, ? , 11/21, 16/31 (A) 10/8 (B) 6/10 (C) 5/10 (D) 7/13
Last Answer : Answer: D 2/3 = 2/2*2-1, 4/7 = 4/4 *2-1, 11/21 = 11/11*2-1, and 16/31 = 16/16*2-1; Therefore 7/13= 7/7*2-1.
Description : In the sequence of numbers 2/3, 4/7, X, 11/21, 16/31 The missing number X is: (A) 8/10 (B) 6/10 (C) 5/10 (D) 7/13
Last Answer : Answer: D
Description : An amplifier operating over the frequency range of 455 to 460 kHz has a 200 kΩ input resistor. What is the RMS noise voltage at the input to this amplifier if the ambient temperature is 17˚C ? A. 40 µV B. 4.0 µV C. 400 µV
Last Answer : B. 4.0 µV
Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone
Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz
Description : If the input to T-flipflop is 100 Hz signal, the final output of the three T-flipflops in cascade is (A) 1000 Hz (B) 500 Hz (C) 333 Hz (D) 12.5 Hz.
Last Answer : (D) 12.5 Hz.
Description : High quality music only needs frequencies up to A. 10 Hz B. 15 Hz C. 20 kHz D. 15 kHz
Last Answer : D. 15 kHz
Description : The external exciting frequency of the system having natural frequency 15 Hz is 10 Hz. The frequency ratio will be A. 1.500 B. 0.667 C. 0.150 D. None
Last Answer : B. 0.667
Description : Value of Prandtl number for water ranges from (A) 1 to 2 (B) 5 to 10 (C) 100 to 500 (D) 1000 to 2000
Last Answer : (B) 5 to 10
Description : What is the bandwidth ofa signal that ranges from 1 MHz to4 MHz? A) 4 MHz B) 1 KHz C) 3 MHz D) none of the above
Last Answer : 3 MHz
Description : When a sine wave has a frequency of 100 Hz in 12 s it goes through? A.1/100 cycle B.12 cycles C.120 cycles D.1,200 cycles
Last Answer : When a sine wave has a frequency of 100 Hz in 12 s it goes through? A.1/100 cycle B.12 cycles C.120 cycles D.1,200 cycles
Description : What is the reference frequency of CCIT phosphomeric noise measurement? A. 800 Hz B. 1000 Hz C. 1500 Hz D. 3400 Hz
Last Answer : A. 800 Hz
Description : What is the reference frequency of CCITT psophometric noise measurement? A. 800 Hz B. 1500 Hz C. 3400 Hz D. 1000 Hz
Description : If a frequency of 16.8 kHz were measured at the output of 'FF-C' of the circuit shown in the illustration, the clock frequency would be _____________. EL-0087 A. 8.4 kHz B. 50.4 kHz C. 134.4 kHz D. 1680.0 kHz
Last Answer : Answer: C
Description : What is the deviation ratio for an FM-phone signal having a maximum frequency swing of plus or minus 5 kHz and accepting a maximum modulation rate of 3kHz? A. 60 B. 0.16 C. 0.6 D. 1.66
Last Answer : D. 1.66
Description : In a PCM system the number of quantization level are 16 and the maximum signal frequency is 4 KHz the transmission bit rate is
Last Answer : In a PCM system the number of quantization level are 16 and the maximum signal frequency is 4 KHz the transmission bit rate is 32 Kbits/sec
Description : While all rivers of Peninsular India flow into the Bay of Bengal, Narmada and Tapti flow into the Arabian Sea because these two rivers: (A) Follow the slope of these rift valleys (B) The ... is tilted towards the west (D) The Indian peninsula south of the satpura ranges is tilted towards east
Last Answer : Answer: A In the Deccan region, most of the major river systems flowing generally in east direction fall into Bay of Bengal. The major east flowing rivers are Godavari, Krishna, Cauvery, Mahanadi, etc. Narmada and Tapti are major West flowing rivers
Description : A 60 Hz, 4 pole turbo generator rated 100 MVA, 13.8 KV has an inertia constant of 10 MJ/MVA. Find the stored energy in the rotor at synchronous speed. (A) 10 MJ (B) 100 J (C) 1000 J (D) 1000 MJ
Last Answer : c
Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz
Last Answer : B. 0 to 4 kHz
Description : Children under the age of 5 can hear up to___________. a)25 Hz b)25 kHz c)20 Hz d)20kHz
Last Answer : b)25 kHz
Description : A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is (A) 0 (B) 2 (C) 4 (D) 6
Last Answer : A piezo-electric type pressure sensor has a sensitivity of 1 mV/kPa and a bandwidth of 300 Hz to 300 kHz. For a constant (dc) pressure of 100 kPa, the steady state output of the sensor in millivolt is 0
Description : If the frequency spectrum of a signal has a bandwidth of500 Hz with thehighest frequency at 600 Hz, what shouldbe the samplingrate, according to the Nyquist theorem? A) 200 samples/s B) 500 samples/s C) 1000 samples/s D) 1200 samples/s
Last Answer : 1200 samples/s
Description : The frequency of a wave travelling at a speed of 500 ms-1 is 25 Hz. Its time period will be ______. (i) 20 s (ii) 0.05 s (iii) 25 s (iv) 0.04 s
Last Answer : (iv) 0.04 s