# The time constant of a series R-C circuit is given by?

The time constant of a series R-C circuit is given by?

The time constant of a series R-C circuit is given by RC.

## Related questions

Description : Time constant for RC circuit formula τ = RC Where, τ = time constant

Last Answer : Time constant for RC circuit formula τ = RC Where, τ = time constant

Description : At very low frequencies a series R-C circuit behaves as almost purely?

Last Answer : At very low frequencies a series R-C circuit behaves as almost purely capacitive.

Last Answer : It is denoted as τ, tau and has the value of 1/RC. We

Description : Time constant of a capacitive circuit?

Last Answer : Time constant of a capacitive circuit increase with increase of capacitance and increase of resistance.

Description : Time constant of a circuit is the time in seconds taken after the application of voltage to each?

Last Answer : Time constant of a circuit is the time in seconds taken after the application of voltage to each 63% of maximum value.

Description : The time constant of the capacitance circuit is defined as the time during which voltage?

Last Answer : The time constant of the capacitance circuit is defined as the time during which voltage rises to 63.2% of its final steady value.

Description : Time constant of an inductive circuit?

Last Answer : Time constant of an inductive circuit increases with increase of inductance and decrease of resistance.

Description : If resistance is 20 Q. and inductance is 27 in a R-L series circuit, then time constant of this circuit will be?

Description : Series rc circuits

Last Answer : Series rc circuits

Description : In a series R-C circuit, with the increase in frequency, current (A) Reduces (B) Increases (C) Does not change (D) Becomes zero

Last Answer : In a series R-C circuit, with the increase in frequency, current Increases

Description : A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

Last Answer : A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is 500 Hz

Description : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Last Answer : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Description : In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of?

Last Answer : In R-L-C series resonant circuit magnitude of resonance frequency can be changed by changing the value of L or C.

Description : In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C?

Last Answer : In an ac series RLC circuit, the voltage across R and L is 20 V; voltage across L and C is 9 V and voltage across RLC is 15 V. What is the voltage across C? 7 V

Description : Parallel rc circuit

Last Answer : Parallel rc circuit

Description : Source free RC circuit 2

Last Answer : Source free RC circuit 2

Description : Source free RC circuit 3

Last Answer : Source free RC circuit 3

Description : Source free RC circuit 4

Last Answer : Source free RC circuit 4

Description : Source free RC circuit 5

Last Answer : Source free RC circuit 5

Description : Source free RC circuit 6

Last Answer : Source free RC circuit 6

Description : Source free RC circuit 7

Last Answer : Source free RC circuit 7

Description : Source free RC circuit 8

Last Answer : Source free RC circuit 8

Description : Series circuit rules

Last Answer : Series circuit rules

Description : Which of the following is true with a series circuit having resistors of different values? A) The total resistance of the circuit is the sum of the individual resistances B) The current across each ... ) The voltage drop across each resistor depends on the value of the resistor D) All the above

Last Answer : Which of the following is true with a series circuit having resistors of different values? A) The total resistance of the circuit is the sum of the individual resistances B) The current across ... voltage drop across each resistor depends on the value of the resistor D) All the above

Description : The series and parallel resonance on L-C circuit differs in that?

Last Answer : The series and parallel resonance on L-C circuit differs in that series resistance needs a low-resistance source for sharp rise in current.

Description : In a series L-C circuit at the resonant frequency the?

Last Answer : In a series L-C circuit at the resonant frequency the current is maximum.

Description : In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value?

Last Answer : In series resonant circuit, increasing inductance to its twice value and reducing capacitance to its half value will increase the selectivity of the circuit.

Description : In a series resonant circuit, the impedance of the circuit is?

Last Answer : In a series resonant circuit, the impedance of the circuit is minimum.

Description : Can An Rc Circuit Be Used As Clock Source For 8085?

Last Answer : Answer :Yes, it can be used, if an accurate clock frequency is not required. Also, the component cost is low compared to LC or Crystal.

Description : The time constant of the servo-mechanism can be decreased by

Last Answer : The time constant of the servo-mechanism can be decreased by decreasing the inertia of the system

Description : The loop equation for a series RLC circuit gives

Last Answer : The loop equation for a series RLC circuit gives

Description : Source transformation Replace the circuit with voltage source in series with a single resistor

Last Answer : Source transformation Replace the circuit with voltage source in series with a single resistor

Description : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the

Last Answer : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the C only

Description : In a series RLC high Q circuit, the current peaks at a frequency  (1) equal to the resonant frequency (2) greater than the resonant frequency (3) less than the resonant frequency (4) equal to half the resonant frequency

Last Answer : In a series RLC high Q circuit, the current peaks at a frequency equal to the resonant frequency

Description : In a series circuit with unequal resistances?

Last Answer : In a series circuit with unequal resistances the highest resistance has the highest voltage drop.

Last Answer : The time of closing the cycle, in modern circuit breakers is 0.003 sec.

Description : Define : i) Diffuse radiation ii) Beam radiation ii) Insolation iv) Solar constant

Last Answer : i) Diffuse radiation: It is the solar radiation which is scattered by the particles in earth's atmosphere and this radiation does not have any unique direction.  ii) Beam radiation: Solar radiation ... from the sun.  OR  It is the average radiation received outside the earth's atmosphere

Description : Define the term solar constant.

Last Answer : Solar energy arrived atmosphere at a constant rate of 1350W/M²

Description : What is meant by energy meter constant?

Last Answer : Energy Meter Constant  A fixed value which is used when converting meter readings to actual energy use, especially when potential transformers and similar types of equipment are used in metering. For example, K=--------rev/Kwh

Description : In a given transformer for a given applied voltage, losses which remain constant irrespective of load changes are?

Last Answer : In a given transformer for a given applied voltage, losses which remain constant irrespective of load changes are hysteresis and eddy current losses.

Description :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS

Last Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Description : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Last Answer : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Description : Give the expression for ABCD constant of T model.

Last Answer : Expression for ABCD constants of T model:

Description : A transfer function has a second order denominator and constant gain in the numerator

Last Answer : A transfer function has a second order denominator and constant gain in the numerator the system has two zeros at infinity

Description : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2 ... 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease

Last Answer : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would increase to a maximum value at α = 0.5 and then decrease

Description : A 3 -phase, fully controlled, converter is feeding power into a DC load at a constant current of 150 A, the rms value of the current flowing through each thyristor of the converter is

Description : When the firing angle a of a single-phase, fully controlled rectifier feeding constant direct current into a load is 30°, the displacement power factor of the rectifier is

Last Answer : When the firing angle a of a single-phase, fully controlled rectifier feeding constant direct current into a load is 30°, the displacement power factor of the rectifier is √3/2

Description : While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then (A) It would over-run the other alternator (B) Its rotor ... (C) Its portion of share in load will increase (D) Its power factor would be decreased.

Last Answer : While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then Its portion of share in load will increase

Last Answer : For constant torque drive armature voltage control speed control method is preferred.

Description : The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as?

Last Answer : The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as pull-in torque.